• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.8 no.2
• /
• pp.9-15
• /
• 2012

The objective of this study is to investigate the influence on the heating performance for a water-to-water 10RT ground source heat pump by using the water switching and refrigerant switching method. The test of water-to-water ground source heat pump was measured by varying the compressor speed, load side inlet temperature, and ground heat source side temperature. The heating capacity and COP of the heat pump increased with increasing ground heat source temperature. As a result, compared to a refrigerant switching method, the water switching method with counter flow improves the heating capacity and COP by approximately 5% in average, respectively.

• Journal of Korean Society for Atmospheric Environment
• /
• v.32 no.2
• /
• pp.208-215
• /
• 2016

Pinic acid (PA) and cis-pinonic acid (CPA) in the atmospheric particulate matter with an aerodynamic diameter of less than or equal to a nominal $10{\mu}m$ ($PM_{10}$) were analyzed for the samples collected during the period of April 2010 to April 2011 at Jongro in Seoul. Both pinic acid and cis-pinonic acid showed higher seasonal average concentrations in summer (PA; $18.9ng/m^3$, CPA; $16.0ng/m^3$) than winter (PA; $5.3ng/m^3$, CPA; $5.9ng/m^3$). They displayed a seasonal pattern associated with temperature reflecting the influence on emissions of ${\alpha}-pinene$ and ${\beta}-pinene$ from conifers and their photochemical reaction. These results were confirmed through Pearson correlation coefficient between CPA, PA and $O_3+NO_2$, temperature. CPA was only correlated with n-alkanes ($C_{29}$, $C_{31}$, $C_{33}$) from biogenic source. PA was correlated with n-alkanes ($C_{29}$, $C_{31}$, $C_{33}$), n-alkanoic acid ($C_{20}$, $C_{22}$, $C_{24}$) from biogenic source and n-alkanes ($C_{28}$, $C_{30}$, $C_{32}$), and n-alkanoic acid ($C_{16}$, $C_{18}$) from anthropogenic source. These results showed that the formation of PA and CPA from ${\alpha}-pinene$ and ${\beta}-pinene$ is related to organic compounds from biogenic source. And it is possible for PA to be effected by organic compounds from anthropogenic source.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.1E
• /
• pp.31-37
• /
• 2001

Matched Field Processing (MFP) is a successive process of correcting mismatches between true and assumed parameters by matching the measured acoustic field data with numerically simulated data which we call replica. The MFP is widely used both in geo-acoustic parameter inversions and in source localizations. Whether a certain parameter can be inverted effectively or whether a source can be localized correctly depends on the amount of the influence that a parameter has on the acoustic field during the matching process. Sensitive parameters can be better estimated than the less sensitive ones in MFP. On the contrary, the sensitive parameters affect adversely on the source localization results when they have uncertainties. In this paper, a sensitivity index is defined based upon the field variation resulting from the perturbed parameters. Numerical test results show that the index behaves in accordance with the results of source localization under a mismatched environment and also with the inversion solutions.

• Journal of information and communication convergence engineering
• /
• v.8 no.1
• /
• pp.103-106
• /
• 2010

In this paper, the delay times were evaluated to develop highly reliable time-to-digital converter(TDC) in analog and digital delay element structures. The delay element can be designed by using current source or inverter. In case of using inverter, the number of inverter has to be controlled to adjust the delay time. And in case of using current source, the current for charging and discharging is controlled. When the current source is used the delay time of the delay element is not sensitive with varying the channel width of CMOS. However, when the inverter is used the delay time is directly related to the channel width of CMOS. Therefore to obtain good reliability in TDC circuit the delay element using current source is more stable compared to inverter in the viewpoint of the variation of fabrication process.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.5 no.6
• /
• pp.544-551
• /
• 2000

In this paper, 3-phase hybrid series active power filter for compensate current harmonics, voltage drop and unbalanced voltage in the network presented. The proposed system is implemented with a space vector modulation voltage source inverter and a high pass filter connected in parallel to the power system. Here the load is six-pulses thyristor rectifier. The phase angle detected in order to generation reference voltage at load terminal is synchronized with the positive sequence component of the unbalanced source by using symmetrical component transformation. The proposed system has an function harmonic isolation between source and load, voltage regulation, and unbalance compensation. Therefore, what the power system is improved quality, the source current is maintained as a nearly sinusoidal waveform and the load voltage is regulated with a rated voltage regardless of the source variation condition. To verify the validity of the proposed compensating system, the computer simulation and experiment are carried out.

• The KSFM Journal of Fluid Machinery
• /
• v.15 no.3
• /
• pp.57-63
• /
• 2012

Effects of coolant pre-cooling and fuel pre-heating on the performance of a combined cycle using a F-class gas turbine were investigated. Coolant pre-cooling results in an increase of power output but a decrease in efficiency. Performance variation due to the fuel pre-heating depends on the location of the heat source for the pre-heating in the bottoming cycle (heat recovery steam generator). It was demonstrated that a careful selection of the heat source location would enhance efficiency with a minimal power penalty. The effect of combining the coolant pre-cooling and fuel pre-heating was also investigated. It was found that a favorable combination would yield power augmentation, while efficiency remains close to the reference value.

• Journal of Ocean Engineering and Technology
• /
• v.9 no.2
• /
• pp.71-74
• /
• 1995

A numerical model capable of simulating a 2-D airfoil flying over in the vicinity of the waves is discussed. Instead of treating the problem as a heaving oscillation one above the rigid flat wall, sources are distributed on the prescribed wave profile. The wave deformation due to the airfoil is assumed to be negligible and treated as a rigid undulated wall. The source and vortex are distributed on the surface of the foil. It is found that the variation of $C_L$ with wave steepness in severe and that the lift variation due to waves decreases as the wing height above the water surface increases.

• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.13 no.2
• /
• pp.22-29
• /
• 2017

This study is performed to performance of the combined system the GSHP (Ground Source Heat Pump) system with the Earth tube system using EnergyPlus program. The Earth tube system using fan is characteristics as supply lower (higher) air temperature than outdoor air temperature in cooling and heating seasons, the GSHP system is characteristics as small indoor air temperature variation range. As the results of Earth tube + GSHP system simulation, GSHP power can be reduced than the GSHP single operation as 17.3% in cooling seasons and 32.5% in heating seasons, the GSHP design capacity can be replaced more small size.

• Communications for Statistical Applications and Methods
• /
• v.13 no.3
• /
• pp.701-718
• /
• 2006

In cancer microarray experiments, the experimenter or patient which is nested in each experimenter often shows quite heterogeneous error variability, which should be estimated for identifying a source of variation. Our study describes a Bayesian method which utilizes clinical information for identifying a set of DE genes for the class of subtypes as well as assesses and examines the experimenter effect and patient effect which is nested in each experimenter as a source of variation. We propose a Bayesian multilevel mixed effect model based on analysis of covariance (ANACOVA). The Bayesian multilevel mixed effect model is a combination of the multilevel mixed effect model and the Bayesian hierarchical model, which provides a flexible way of defining a suitable correlation structure among genes.

• Journal of the Semiconductor & Display Technology
• /
• v.4 no.3 s.12
• /
• pp.1-4
• /
• 2005

Silicon oxynitride films were deposited using ammonia as a nitrogen source via PECVD (plasma enhanced chemical vapor deposition) to study the physical properties of the films. Silane and nitrous oxide were used as silicon and oxygen sources, respectively. The composition of the silicon oxynitride films was well controlled by changing the ratios of the sources and confirmed by XPS. The silicon oxynitride films with high oxygen content showed bigger compressive stress and less refractive index, while the values of surface roughness were around 1 nm, irrespective of the variation of the source ratios.