• Journal of Korean Society of Water and Wastewater
• /
• v.33 no.6
• /
• pp.457-467
• /
• 2019

Because non-point source pollution is very closely related to hydrological characteristics, its importance is highly emphasized nowadays along with accelerating climate change. Especially for Korea, the non-point source pollution and its control are entirely depending on runoff, precipitation, drainage, land use or development, based on geographical and topographical reasons of Korea. Many studies reported the physical (e.g., apparatus- and natural-type facilities, etc.) and chemical methods (e.g., organic and inorganic coagulants, etc.) of controling non-point pollutant source pollution, however, those are needed to be reconsidered along with climate change causing the unexpected patterns and amounts of precipitation and strengthen complexity of social community. The objectives of this study are to assess recent situations of non-point source pollution in Korea and its control means and to introduce possible effective ways of non-point source pollution against climate change in near future.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.11 no.2
• /
• pp.205-214
• /
• 1999

The objective of this paper is to investigate the thermal properties of TMA clathrate compound applicable to cold storage system for building air-conditioning. Especially, the test tube experiments are performed by comparing and analyzing the temperature of phase change, specific heat and subcooling characteristic according to the variation of density, temperature of heat source and charging quantity in TMA clathrate compound. The results are summarized as follows:1) $-15^{\circ}C$ is not proper as the temperature of heat source because the temperature of subcooling is above $8.3^{\circ}C$ 2) temperature of phase change is dropped as the temperature of heat source is lower, 3) the effect of subcooling suppression with about 8$^{\circ}C$ is confirmed when the temperature of heat source is $-10^{\circ}C$ in case of 26, 27, and 30wt%, while the temperature of subcooling is about $0^{\circ}C$ when the temperature of heat source is $-15^{\circ}C$ in case of 25, 26 and 30wt%. Thus, the effect of subcooling suppression is greater as the temperature of heat source is lower. Additionally, the concentrative study is needed on mass concentration causing the phase change without subcooling phenomenon when the temperature of heat source is $-15^{\circ}C$. Thus, it is concluded that TMA clathrate compound has enough thermal properties as the cold storage medium for building air-conditioning.

• Journal of Korean Society for Atmospheric Environment
• /
• v.8 no.4
• /
• pp.229-239
• /
• 1992

A receptor model application was performed by using a chemical mass balance (CMB) model to identify and apportion the specific source of airborne organic pollutants, particularly polynuclear aromatic hydrocarbons (PAHs). Source profiles of PAHs produced from the combustion of fossil fuels for CMB modeling were prepared by measuring them in emission gases. The emission sources which were examineed for the development of PAH source profiles are a coal-fired furnace using Yontan, a bunker-C iol heating boiler, and gasoline-and diesel engine automobiles. The ambient concentrations of PAHs were determined at four sites in Daejon city in 1991 with a seasonal variation. Wintertime air samples contained more extractable organic matter than summertime samples. The results of CMB modeling were various depending on the sampling sites and seasons, but the emission from bunker-C oil heating boliers was the predominant factor to affect local air quality throughout the year.

• Proceedings of the KIEE Conference
• /
• 1989.07a
• /
• pp.24-27
• /
• 1989

In the case of analyzing electric machinery by finite element method, so far, magnetic current was selected as a driving source. But terminal voltage is a driving source in real systems, and magnetic current is varied according to variation of load conditions. Therfore, in this paper magnetic flux distribution of linear induction motor was analized by using kirchhoff's second law with voltage as a driving source, and magnetic current was calculated.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.36 no.7
• /
• pp.462-469
• /
• 1987

A metal gate MOSFET with source/drain regions self-aligned to gate region is proposed. The proposed MOS transistor is fabricated by utilizing the higher oxidation rate of source/drain regions with high doping concentration when compared with channel region with moderate doping. The thick oxide on the source/drain regions reduces the gate and drain(source) overlap capacitance down to that of a self-aligned polysilicon gate device while allowing the use of a metal gate with much lower resistivity than the more commonly used polycrystalline silicon. A ring oscillator composed of 15 inverter stages has been computer simulated using SPICE. The results of the simulation show good agreement with experimental measurement confirming the fast switching speed of propesed MOSFET.

• Steel and Composite Structures
• /
• v.16 no.5
• /
• pp.533-557
• /
• 2014

In this study, the performances of the SMRF building equipped with energy dissipating devices are studied. Three types of these structures with different heights are considered. The Added Damping and Stiffness (ADAS) devices are used as energy dissipating devices in these structures. The behavior of these structures with ADAS devices subjected to near source ground motions are investigated. Three SMRF buildings with five, ten and fifteen-story, with ADAS devices were chosen. The nonlinear time history analysis was used by applying the near source ground motions with PERFORM 3D.V4 and conclusions are drawn upon an energy criterion. The effect of PGA variation and height of the frames are also considered based on the energy criterion.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.13 no.6
• /
• pp.576-580
• /
• 2013

We investigate the enhanced effects of asymmetry ratio variations of the source and drain area in silicon (Si) field-effect transistor (FET). Photoresponse according to the variation of asymmetry difference between the width of source and drain are obtained by using the plasmonic terahertz (THz) wave detector simulation based on technology computer-aided design (TCAD) with the quasi-plasma 2DEG model. The simulation results demonstrate the potential of Si FETs with asymmetric source and drain structures as the promising plasmonic THz detectors.

• Atmosphere
• /
• v.18 no.4
• /
• pp.493-506
• /
• 2008

In order to examine the variational features of Asian dust outbreak in recent years, observed WMO synop data were employed for the period from 1996 to 2007. We first divided Asian dust source regions into four subregions; 1) Taklamakan, 2) Gobi, 3) Inner Mongolia-Manchuria and 4) Loess, and the meteorogical variables such as wind speed, precipitation and threshold wind speed observed during the Asian dust outbreak period were compared with those during non-Asian dust period. The results showed that temporal variation of occurrence frequency of dust outbreak had a strong positive correlation with the frequency of strong wind speed and low precipitation in each of the 4 source regions. Spatial distributions of frequency of dust occurrence after 2002 showed increasing trend in Gobi and Inner Mongolia-Manchuria but decreasing trend in Loess region. This is showing a shift in main source region toward Northwest, especially since 2003.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.15 no.2
• /
• pp.31-37
• /
• 2001

This paper propose ZVS-HB type resonant DC/DC converter have earth different output characteristics using division ratio, not only a source division function but a resonant function and soft switching technique(ZVS, ZCS) instead of conventional source division capacitor. Circuit analysis generally described using normalized parameters most of characteristics with division ratio of source division capacitor. Also, this paper citified a rightfulness of characteristic analysis in comparison with a theoretical values and a experimental values obtain from experiment using Power-MOSFET.

• Proceedings of the KIEE Conference
• /
• 2003.11c
• /
• pp.720-723
• /
• 2003

Electric stimulation of teeth is used for assessing pulp vitality. Because of very high and wide range of impedance of the enamel, electric pulp testers use high voltage, high output impedance and alternative current source. Most pulp testers use voltage stimulation method and their stimulating threshold levels significantly depend on each individual. Therefore, a constant current stimulator is necessary to minimize the effect of wide variation in enamel thickness. In this study, we constructed a constant current source type of pulp tester with the maximum current of 150 uA.