• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2013년도 전력전자학술대회 논문집
• /
• pp.516-517
• /
• 2013

신재생 에너지의 비중 확대와 보급이 늘어남에 따라, 국가 간, 도시 간의 송전이 중요한 이슈로 대두 되고 있다. 위와 같은 요구 조건을 만족시키기 위해서 초고압 직류 송전의 개발이 필요하다. 초고압 직류송전(HVDC)에는 전류형과 전압형으로 나뉘는데. 각 HVDC에서 사용되는 Valve는 실제 운전 전에 여러 가지 방법으로 검증이 필요하다. 합성 시험회로 설비(Synthetic Test Circuit = 이하 STC)는 전류형 HVDC에서 사용되는 주요 전력변환 장치로, Thyristor Valve의 동작을 실제 동작 조건에 맞추어 동작을 시켜, 동작의 신뢰성을 검증하는 시험 설비이다. 본 논문에서는 전류형 HVDC Valve의 Operational Test를 위한 STC의 보호기능에 대해 기술하고 있다. 합성시험회로는 2상 초퍼와 6 펄스 사이리스터 컨버터를 사용하였고 설계된 보호기능은 PSCAD를 사용하여 검증하였다. HVDC Valve Operational Test시 합성시험회로 내에서 발생할 수 있는 사고 상황을 상정하고 그에 따른 보호 기능을 모의하였다.

• 한국자동차공학회논문집
• /
• 제2권3호
• /
• pp.75-84
• /
• 1994

In general direct-operated pressure reducing valves have been gardly applied to a dynamic control system such as active suspension control because of their poor control stability. But they are more robust than pilot-operated type and do not need pilot control flow. In this paper development of a new direct-operated proportional pressure reducing valve for low-band type active suspension control is reported. By means of a special damper directly linked to the valve spool, the control stability could be effectively improved without drawback in response time. The linearity error was less than $\pm$3.5%. Applied to an experimental active suspension system the new valve showed the $-90^{\circ}$ phase delay at 4Hz with 20% sinusoidal signal input and could control the suspension system with almost same performance as that with a pilot-operated type valve.

• 한국자동차공학회논문집
• /
• 제12권1호
• /
• pp.1-9
• /
• 2004

The general method which changes sub-cooling of refrigerant is to control the expansion valve in the state of mixing with liquid and gas phase. In this study, the performance of vehicle air conditioning system is to control either changing the expansion valve or adding the sub condenser. Therefore, this research finally is tested in case of the fourth test procedure, the second test was suitable for a valve opening area due to adjusting valve slope in comparison with the other test. The other test except for the second test happened to do liquid back due to the excessively liquified refrigerant into the system. In conclusion, the second test was appeared not to be influenced upon liquid back, and it is to expect positive performance by controlling an expansion valve. Therefore, it will be also useful to research for an increase of compressor efficiency Performance improvement of an air conditioner is to reinforce the suction performance of the evaporator and increase the sub-cooling, which make use of the sub-cooling system.

• 한국전자통신학회논문지
• /
• 제10권1호
• /
• pp.73-80
• /
• 2015

화학공장과 같이 위험지역에 설치된 밸브장치는 폭발의 위험을 방지하기 위해 방화 방폭장치로 밀폐되어 있다. 본 논문에서는 방폭장치로 인해 외부전원장치를 사용할 수 없는 밸브장치에 적외선센서와 Zigbee 센서를 이용하여 위험지역의 밸브의 열림도를 측정하여 개폐여부를 확인하고, 밸브 개폐 작동시간을 로그화하여 운전 관리자가 공장을 관리 통제할 수 있는 저전력 모니터링 시스템을 제안한다. 전력관리기능을 적용하기 위해 개선된 비동기LPL 알고리즘을 적용한 전력제어 릴레이보드를 개발하고, 이를 적용한 방폭형 지능형 밸브시스템과 공장 밸브 개폐모니터링 시스템을 설계하고 이를 구현 및 테스트 하였다.

• 드라이브 ㆍ 컨트롤
• /
• 제12권4호
• /
• pp.48-53
• /
• 2015

This paper deals with the flow characteristics of a reed valve analyzed using computational dynamics(CFD) for optimal design. The seat sizes of the valve are modeled asØ6[mm] and Ø8[mm] to compare the flow characteristics. The inlet boundary condition is entered at 10[kPa], 15[kPa], 20[kPa], and 30[kPa] and the outlet boundary condition is set to the atmospheric pressure. The flow coefficient(C) and pressure loss coefficient(K) are calculated from the results of flow analysis. From the analysis results, it was confirmed that the flow coefficient of a reed valve having a seat size of Ø6[mm] is greater than that having a seat size of Ø8[mm], and the coefficient of pressure loss of a valve with a seat size of Ø6[mm] is lower than the Ø8[mm] size valve.

• 전기학회논문지
• /
• 제57권7호
• /
• pp.1175-1180
• /
• 2008

Recently agriculture has been intelligenced and automatized because the number of agricultural population is reduced, and the various agricultural machine is developed and utilized actively, In these agricultural automation system, the solenoid valve is widely used for the supply of water and fertilizer to the plant and soil. In this solenoid valve system, AC excitation solenoid valve is widely used because of economic merit and simple system scheme. However, the instantaneous chattering vibration and noise of plunger caused by the alternative MMF variation is very important performance characteristics. In order to reduce vibration the DC excitation solenoid valve is sometimes applied for the high-end applications. In this case, the control circuit is essential to control DC excitation current. It may causes the cost increase and system complexity and it is not suitable for the outdoor agricultural machine. In this paper, the electromagnetic structural improvement of AC solenoid valve is studied to reduce the dynamic vibration and noise. As an economical solution, the shading coil is additionally implemented to the conventional solenoid valve. As a result of this study, the vibration and acoustic noise is largely reduced by the compensating MMF of shading coil and it is verified by the test of prototype.

• 드라이브 ㆍ 컨트롤
• /
• 제18권2호
• /
• pp.9-19
• /
• 2021

The spool displacement signal of a directional control valve, including the servo valve, can be considered as the standard signal to measure dynamic characteristics. When the spool displacement signal is not available, the velocity signal of a metering cylinder piston can be used. In this study, the frequency response characteristics of the metering cylinder are investigated for the spool displacement input. The transfer functions of the servo valve-metering system are derived taking into consideration the oil inertia effect in the transmission lines. The theoretical results of the transfer functions are verified through computer simulations and experiments. The oil inertia effect in the transmission lines was found to have a very significant effect on the bandwidth frequency of the servo valve-metering cylinder system. In order to more precisely measure the dynamic characteristics of a servo valve, the metering cylinder should be set up to minimize the oil inertia effect by increasing the inner diameters of the transmission lines or shortening their lengths.

• Journal of Mechanical Science and Technology
• /
• 제19권8호
• /
• pp.1621-1631
• /
• 2005

In this paper, making the best use of the features of the electro-rheological (ER) valve, a two-port pressure control valve using ER fluids is proposed and manufactured. The ER-Valve characteristics are evaluated by changing the intensity of the electric field and the number of electrode. As only with electrical signal change to the ER-Valve in which ER fluid flowing, ER fluid flow is controlled, so development of simple ER-Valves have been tried. The ER-Valves and pressure drop check method are considered to be applied to the fluid power industry. Using the manufactured pressure control valve, a one-link manipulator with FHA (Flexible Hydraulic Actuator) is driven. As a result, it is experimentally confirmed that the pressure control valve using ER fluids is applicable to use in driving actuator. If it applies characteristics of the ER fluids, it will be able to apply in the control system for the ER Valve which occurs from industrial controller. After having durability test, shear stress increased regularly because of starch particles crushed by pump and particle size that was almost the same. Moreover, Ra of copper electrode increased about 1.56 times rather than before those of performing durability test, and Rz increased about 2.2 times.

• 대한의용생체공학회:의공학회지
• /
• 제19권1호
• /
• pp.47-52
• /
• 1998

인공판막의 부작용을 크게 줄일 수 있을 것으로 기대되는 보조판막을 개발하기 위해서 생체외에서 판엽운동과 혈역학을 분석하였다. 보조 판막은 추출한 돼지 판막에서 판엽의 일부를 절개한 후 심낭을 이식하여 재건하였다. 심낭은 글루타르알데히드 완충용액으로 처리한 후 금속목드를 이용하여 판엽모양을 재생시켰다. 제작한 보조판막은 모의순환장치에서 성능을 평가하였다. 35mm 카메라를 이용하여 순간운동 모양을 촬영하였고 압력강하와 심박출량을 측정하여 분석하였다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제23권2호
• /
• pp.236-243
• /
• 1999

This study deals with the application of high speed on-off valves to an electro-hydraulic servo indexing system incorporated electro-hydraulic servo valces. Comparing with the electro-hydraulic servo valve the high speed on-off valve has some merits. Which included low price robustness to the oil contamination and dircect control without D/A converter. The considered sys-tem of this study is controlled by pulse width modulation(PWM) of the control law which is pro-duced by a PID controller which is used broadly in industrial equipments. The dynamic character-istics corresponding to variations of system parameters such as inertia moment system gain and supply pressure are investigated by computer simulation and experiment. Consequently the availability of the application of high speed on-off valve to servo indexing system instead of electro-hydraulic servo valve is confirmed.