• Journal of the Korean Society of Safety
• /
• v.35 no.3
• /
• pp.96-104
• /
• 2020

The numerical simulations were conducted to investigate the thermal-fluid phenomena occurred inside the experimental apparatus during a PCCS, used to remove heat released in accidents from a containment of light water nuclear power plant, operation. Numerical simulations of the flow and heat transfer caused by wall condensation inside the containment simulation vessel (CSV), which equipped with 18 vertical heat exchanger tubes, were conducted using the commercial computational fluid dynamics (CFD) software ANSYS-CFX. Shear stress transport (SST) and the wall condensation model were used for turbulence closure and wall condensation, respectively. The simulation using the actual size of the apparatus. However, rather than simulating the whole experimental apparatus in consideration of the experimental cases, calculation resources, and calculation time, the simulation model was prepared only in CSV. Selective simulation was conducted to verify the effects of non-condensable gas(NC gas) concentration, CSV internal pressure, and wall sub-cooling conditions. First, as a result of the internal flow of CSV, it was observed that downward flow due to condensation occurred surface of the vertical tube and upward flow occurred in the distant place. Natural convection occurred actively around the heat exchanger tube. Due to this rising and falling internal flow, natural circulation occurred actively around the heat exchanger tubes. Next, in order to check the performance of built-in condensation model using according to the non-condensable gas concentration, CSV internal flow and wall sub-cooling, the heat flux values were compared with the experimental results. On average, the results were underestimated with and error of about 25%. In addition, the influence of CSV internal pressure and wall sub-cooling was small, but when the condensate was highly generated due to the low non-condensable gas concentration, the error was large compared to the experimental values. This is considered to be due to the nature of the condensation model of the CFX code. However, in spite of the limitations of CFD, it is valid to use the built-in condensation model of CFD for PCCS performance prediction from a conservative perspective.

• Asian Pacific Journal of Cancer Prevention
• /
• v.17 no.10
• /
• pp.4671-4675
• /
• 2016

Background and aim: Pancreatic cancer is the fourth leading cause of cancer-related death worldwide, with an overall 5-year survival of <5% mainly due to presence of advanced disease at time of diagnosis. Therefore development of valid biomarkers to diagnose pancreatic cancer in early stages is an urgent need. This study concerned the sensitivity and specificity of serum ICAM 1 versus CA 19-9 in differentiation between pancreatic cancer and healthy subjects and acohort of patients with chronic pancreatitis with a focus on assessing validity in diagnosis of early stages of pancreatic cancer. Methods: A cohort of 50 patients with histologically diagnosed pancreatic tumors, 27 patients with chronic pancreatitis, and 35 healthy controls were enrolled. Serum samples for measurement of CA19-9 and I-CAM 1 were obtained from all groups and analyzed for significance regarding diagnosis and disease stage. Results: At a cut off value of (878.5 u/ml) I-CAM 1 had 82% and 82.26% sensitivity and specificity for differentiation between cancer and non-cancer cases, with higher sensitivity and specificity than CA19-9 at different cut offs (CA19-9 sensitivity and specificity ranged from 64-80% and 56.4 - 61.2% respectively). The AUC was 0.851 for I-CAM and 0.754 for CA19-9. Neither of the markers demonstrated significance for distinguishing between early and late cancer stages. Conclusion: ICAM 1 is a useful marker in differentiation between malignant and benign pancreatic conditions, and superior to CA19-9 in this regard. However, neither of the markers can be recommended for use in differentiation between early and late stage pancreatic cancers.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.11
• /
• pp.1645-1652
• /
• 2016

FTN(Faster-Than-Nyquist) signaling is a method of transmitting symbols at rates faster than the Nyquist rate in the same bandwidth by overlapping transmission pulses. The transmission power of the FTN signal is greater than that of the Nyquist signal, because the number of symbols in the FTN signal is larger than that in the Nyquist signal for the same time interval. Hence, to evaluate the performance of an FTN-based transmission system properly, the performance evaluation criterion should be carefully set, and conversion formulas among the criteria which are used in Nyquist-based system should also be applied attentively. In this paper, the performance evaluation criteria of the FTN-based transmission system is analyzed and a valid way to set the criteria is proposed.

• Food Science of Animal Resources
• /
• v.35 no.4
• /
• pp.466-472
• /
• 2015

A rapid and simple analytical method, using liquid chromatography tandem mass spectrometry (LC-MS/MS), was developed to detect myo-inositol (MI) in infant formulas. For protein removal: acid hydrolysis and lipid removal through organic solvent extraction. The operating conditions for instrumental analysis were determined based on previously reported analogous methods that used LC-MS/MS. Quantitative analysis was used for the detection limit test, infant formula recovery test, and standard reference material (SRM) 1849a to verify the validity of our LC-MS/MS analytical method, which was developed to quantify MI. For validation, the results of our method were compared with the results of quantitative analyses of certified values. The test results showed that the limit of detection was 0.05 mg/L, the limit of quantitation was 0.17 mg/L, and the method detection limit was 17 mg/kg. The recovery test exhibited a recovery between 98.07-98.43% and a relative standard deviation between 1.93-2.74%. Therefore, the result values were good. Additionally, SRM 1849a was measured to have an MI content of 401.84 mg/kg and recovery of 98.25%, which is comparable to the median certified value of 409 mg/kg. From the aforementioned results, we judged that the instrumental analysis conditions and preparation method used in this study were valid. The rapid analytical method developed herein could be implemented in many laboratories that seek to save time and labor.

• Journal of Digital Convergence
• /
• v.16 no.8
• /
• pp.99-107
• /
• 2018

The purpose of the study compares the difference between the carriers' reported large consumption emotion of customers in regards to the appearance of the crew. The research method was conducted for 15 days from March 11 to 25, 2018, and the number of valid samples was 289 in total. The results of the study showed that customers differ in the influence of perceived consumption sentiment between full service carrier and low cost carrier on uniform of flight attendant. Consumer sentiments perceived by low cost carriers are comfortable, familiar, and lively, and these results have proven that they are distinguished from low cost carriers by being clean, sophisticated, and large. The results of this study are significant when the airline has changed the crew uniform at the right time and considered it to be a marketing tool that is important to the image change of the company.

• Journal of Sensor Science and Technology
• /
• v.11 no.5
• /
• pp.273-278
• /
• 2002

An intrusion-sensitive capability of multimode graded-index (GRIN) optical fibers under bending has been investigated. In this system, the data light is transmitted in the fundamental mode while alarm monitor light is launched in a high-order mode at the same time. An attempted intrusion to drain data by bending the fiber results in greater attenuation of a monitor signal in higher order modes, thereby setting off an alarm at the receiver. Light propagation in a multimode graded-index fiber is also analyzed theoretically when the fundamental mode is selectively excited and the fiber is bent around a constant radius mandrel. The bending generates coupling between the various modes of the fiber. Power transitions of the fundamental mode by changing the bending radius were also analyzed numerically using program simulation. It is shown that Asawa-Taylor model[4] is valid up to 1cm of the radius of curvature of the fiber bend.

• Journal of Periodontal and Implant Science
• /
• v.37 no.3
• /
• pp.637-646
• /
• 2007

Implants placed immediately after tooth extraction have been shown to be a successfully predictable treatment modality. Several clinical papers suggest that placing implants immediately after tooth extraction may provide some advantages: reduction of the number of surgical procedures or patient visits, preservation of the dimensions of alveolar ridge, and shortening of the interval between the removal of the tooth and the insertion of the implant supported restoration. In this case report, three patients received single immediate implant placements to replace a maxillary anterior tooth at the time of extraction. As the three cases were somewhat different, treatment protocols had to be modified as follows: Case 1. Immediate implant placement with healing abutment connection. Case 2. Immediate implant placement with immediate provisionalization. Case 3. Immediate implant placement with Guided Bone Regeneration(GBR). Every implant of these cases was placed in proper position buccolingually, mesiodistally and apicocoronally, The procedures following implantation such as immediate provisionalization and GBR were free of problem. Healing of each case was uneventful. In all cases, treatment outcomes were mostly satisfactory and the results maintained during follow-up periods. However, one case (Case 3) showed some papilla loss due to failure in delicate soft tissue handling during surgery. This papilla loss was compromised by prosthetic means. In conclusion, immediate implant placement in the fresh extraction socket can be a valid and successful option of treatment in aesthetic area. Moreover, this treatment protocol seems to maintain the preexisting architecture of soft and hard tissues in most cases.

• Geotechnical Engineering
• /
• v.14 no.3
• /
• pp.95-108
• /
• 1998

Downhole testing and seismic CPT (SCPT) have been widely used to evaluate stiffness profiles of the subgrade. Advantages of downhole testing and SCPT such as low cost, easy operation and a simple seismic source have got these testings more frequently adopted in site investigation. For the automated analysis of downhole testing and SCPT, the concept of interval measurements has been practiced. In this paper. a new inversion procedure to deal tilth the interval measurements for the automated downhole testing and SCPT (including a newlydeveloped continuous SCPT) is proposed. The forward modeling in the new inversion procedure incorporates ray path theory based on Snell's law. The formulation for the inversion analysis is derived from the maximum likelihood approach, which estimates the maximum likelihood of obtaining a particular travel time from a source to a receiver. Verification of the new inversion procedure was performed with numerical simulations of SCPT using synthesized profiles. The results of the inversion analyses performed for the synthetic data show that the new inversion analysis is a valid procedure which enhances Va profiles determined by downhole testing and SCPT.

• Journal of The Korean Association For Science Education
• /
• v.17 no.1
• /
• pp.93-101
• /
• 1997

The purpose of this study is to develop a test of earth science inquiry abilities using structured items. To develop a more valid and reliable instrument factual data was used, and most of the previous studies regarding inquiry teaching method and inquiry evaluation were consulted. The model developed in this study is composed of 5 stages; recognizing problems and generating hypotheses, designing inquiry, pursuiting inquiry, interpreting data, and drawing conclusion. Also, in this study 10 science inquiry abilities; recognizing problems, generating hypotheses, controlling variables, designing experiments, performing experiments, transforming data, inferencing, predicting, conclusing, and generalizing were clearly defined. The test developed in the study, Test of Earth Science Inquiry Abilities, includes 25 multiple-choice (five-choice) items and requires testing time of 50 minutes. The content validity of items, objectivity of scoring keys and clarity of items were checked by 7 experienced specialists in science education and earth science. The developed test were investigated and revised through three field tests. According to the results of the third field trial, test reliability (Cronbach $\alpha$) was 0.62, difficulty index was 0.54 and index of discrimination was 0.35. Also, the developed Test of Earth Science Inquiry Abilities showed a correlation coefficient of 0.53 with TIPS. Therefore, the development of Test of Earth Science Inquiry Abilities using structured items satisfied the reliability and validity requirements for general assessment instruments for students' earth science inquiry abilities.

• Korean Journal of Social Welfare
• /
• v.58 no.4
• /
• pp.313-339
• /
• 2006

The purpose of this study is to analysis empirically the socio-structural causes of working poor. This study used raw data of of Korea National Statistical Office from 1982 to 2004, and put in operation time series multiple regression analysis to use socio-economic factors of macro-economy environment, labor market, distribution system. Contrary to assertion of growth-concentrated people, economic growth rate has had significantly positive effect on the change of working poor size. In the growth period there has been trickle down effect of economic growth, but in the post-Fordism period there has not been valid circular relation. Recent introduction of the U. S. type capitalism resulted in negative phenomenon like aggravation of income distribution, deterioration of employment quality, enlargement of working poor. And there rise a question on socio-economic durability due to de-compensation on intra-institution. It is necessary to grope transition to the high road social market model - that is stable and sustainable - correspond to Korea that is stable and sustainable.