• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.2
• /
• pp.417-422
• /
• 2010

When memory devices are exposed to space environments, they suffer various effects such as SEU(Single Event Upset). Memory systems for space applications are generally equipped with error detection and correction(EDAC) logics against SEUs. In this paper, several error detection and correction codes - RS(10,8) code, (7,4) Hamming code and (16,8) code - are analyzed and compared with each other. Each code is implemented using VHDL and its performances(encoding/decoding speed, required memory size) are compared. Also the failure probability equation of each EDAC code is derived, and the probability value is analyzed for various occurrence rates of SEUs which the STSAT-3 possibly suffers. Finally, the EDAC algorithm for STSAT-3 is determined based on the comparison results.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.9 no.3
• /
• pp.633-637
• /
• 2005

In this contribution, we developed and improved an existing GF (Galois field) dividing algorithm by suggesting a novel architecture for a finite field divider, which is frequently required for the error correction applications and the security-related applications such as the Reed-Solomon code, elliptic curve encryption/ decryption, is proposed. We utilized the VHDL language to verify the design methodology, and implemented the architecture on an FPGA chip. We suggested the n-bit lookup table method to obtain the throughput of 2m/n cycles, where m is the order of the division polynomial and n is the number of the most significant lookup-bits. By doing this, we extracted the advantages in achieving both high-throughput and less cost of the gate areaon the chip. A pilot FPGA chip was implemented with the case of m=4, n=2. We successfully utilized the Altera's EP20K30ETC144-1 to exhibit the maximum operating clock frequency of 77 MHz.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.3
• /
• pp.496-502
• /
• 2006

The complexity of IC has rapidly increased as VLSI fabrication technology has grown up quickly. This paper proposes verification methods for data conflicts and protocol between IPs for SoC with coverage metrics. The high-level events is defined to cooperation between blocks or process statement in HDL, or a sequence of performing a job compared to low-level event. They are classified into two categories, resource conflicts and protocol or specification-dependent conflicts. And two coverage metrics used for code coverage in low-level event are proposed to verify the hish-level events. The events of resource conflicts can be detected by using statement coverage metric if global signal or variable has flags in a testbench program, and protocol-dependent events can be checked by data flow metric or path metric.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.12A
• /
• pp.1333-1339
• /
• 2004

In IS-95 and IMT-2000 systems using variable code rates and constraint lengths, this paper limits code rate 1/2 and constraint length 3 and states the effective reduction of PM(Path Metric) and BM(Branch Metric) memories and arithmetic comparative calculations with appling PVSL(Prototype Vector Selecting Logic) and LVQ(Learning Vector Quantization) in neural network to simplify systems and to decode forwardly. Regardless of extension of constraint length, this paper presents the new Vierbi decoder and the appied algorithm because new structure and algorithm can apply to the existing Viterbi decoder using only uncomplicated application and verifies the rationality of the proposed Viterbi decoder through VHDL simulation and compares the performance between the proposed Viterbi decoder and the existing.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.35C no.6
• /
• pp.48-55
• /
• 1998

In this work, the testable CAM(Content Addressable Memory) is designed to perform the test effectively by inserting the ECC(Error Checking Circuit) inside the CAM. The designed CAM has the circuit which is capable of testing the functional faults in read, write, and match operations. In general the test circuit inserted causes the increase of total circuit area, Thus this work, utilizes the new MTA code to reduce the overhead of an area of the built-in test circuit which has a conventional parallel comparator. The designed circuit was verified using the VHDL simulator and the layout was performed using the 0.8${\mu}{\textrm}{m}$ double metal CMOS process. About 30% reduction of a circuit area wad achieved in the proposed CAM using the XOR circuit

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.34C no.2
• /
• pp.1-11
• /
• 1997

We developed a base station modulator ASIC for CDMA digital cellular system. In CDMA digital cellular system, the modulation is performed by convolutional encoding and QPSK with spread spectrum. The function blocks of base station modulator are CRC, convolutional encoder, interleaver pseudo-moise scrambler, power control bit puncturing, walsh cover, QPSK, gain controller, combiner and multiplexer. Each function block was designed by the logic synthesis of VHDL codes. The VHDL code was described at register transfer level and the size of code is about 8,000 lines. The circuit simulation and logic simulation were performed by COMPASS tools. The chip (ES-C2212B CMB) contains 25,205 gates and 3 Kbit SRAM, and its chip size is 5.25 mm * 5,45 mm in 0.8 mm CMOS cell-based design technology. It is packaged in 68 pin PLCC and the power dissipation at 10MHz is 300 mW at 5V. The ASIC has been fully tested and successfully working on the CDMA base station system.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.38 no.6
• /
• pp.82-92
• /
• 2001

This paper describes implementation of an embedded 32-Bit RISC core for portable communication/information equipment, such as cellular phones, PDA(Personal Digital Assistants), notebook, etc. The RISC core implements the ARM$\circled$V 4 instruction set, operates with typical 5-stage pipeline. It supports Thumb code to improve the code density, and uses the dynamic power management method of pipeline registers. It was modeled and simulated in RTL level using VHDL, and verified with ARMulator of ADS (Arm Developer Suite) and had average CPI of 1.44. The core is synthesized automatically using the cell library based on $0.6{\mu}m$ CMOS 1-poly 3-metal CMOS technology. It consists of about 41,000 gates and the clock frequency is expected to be above 45 MHz.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.9A
• /
• pp.1368-1376
• /
• 2000

This paper describes the codesign method for IS-95 based CDMA(Code Division Multiple Access). By codesign we mean to design hardware and software simultaneously. Codesign lead to reduction in design time, cost and power consumption. When we partition a system into hardware and software, some modules with longer processing time and larger power consumption are implemented using hardware and the remaining part is implemented using software. In proposed design, we design the synchronous accumulator of CDMA searcher in hardware and the other part in software, The hardware part is designed using VHDL, while software part is designed using GC(Generic C). We simulated and verified the system using COSSAP in SYNOPSYSTM. Experimentation showed the maximum 48.5% speed reduction compared with the design using software only.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.8 no.5
• /
• pp.83-97
• /
• 1998

This paper developes an integrated environment CAD system that can design and implement an accurate and cost-effective FLC automatically. For doing this, an integrated development environment (IDE) (called FADIS; FLC Automatic Design and Implementation Station) is built by the seemless coupling of many existing. CAD tools in an attempt to the FADIS performs various functions such that (1) i~utomatically generate the VHDL components appropriate for the proposed FLC architecture from the various design parameters (2) simulate the generated VHDL code on the Synopsys's VHDL Simulator, (3) automatically compiler, (4) generate the optimized, placed, and routed rawbit files from the synthesized modules by Xilinx's XactStep 6.0, (5) translate the rawbit files into the downloadable ex- [:cution reconfigurable FPGA board (VCC's EVCI), and (7) continuously monitor the control status graphically by communicating the FLC with the controlled target via S-bus. The developed FADIS is tested for its validity by carrying out the overall procedures of designing and implementing the FLC required for the truck-backer upper control, the reduction of control execution time due to the controller's FPGA implementation is verified by comparing with other implementations.

• Journal of the Institute of Convergence Signal Processing
• /
• v.8 no.4
• /
• pp.285-292
• /
• 2007

SoC which deploys software modules as well as hardware IPs on a single chip is a major revolution taking place in the implementation of a system design, and high-level synthesis is an important process of SoC design methodology. Recently, SPARK parallelizing high-level synthesis software tool has been developed. It takes a behavioral ANSI-C code as an input, schedules it using code motion and various code transformations, and then finally generates synthesizable RTL VHDL code. Although SPARK employs various loop transformation algorithms, the synthesis results generated by SPARK are not acceptable for basic signal and image processing algorithms with nested loop. In this paper we propose a SoC platform with an application-specific PLD targeting local operations which are feature of many loop algorithms used in signal and image processing, and demonstrate design process which maps behavioral specification with nested loops written in a high-level language (ANSI-C) onto 2D systolic array. Finally the derived systolic array is implemented on the proposed application-specific PLD of SoC platform.