• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.1
• /
• pp.114-123
• /
• 2000

The flow structure around a rotating axial-fan was experimentally investigated using a phase averaging velocity field measurement technique. The fan blades were divided into 4 different phases, for which 500 velocity fields were acquired for each phase angle with a 2-frame PTV system. Velocity field measurements were also carried out at two planes parallel to the axis of rotation, with offsets toward the radial direction of the fan. For accurate synchronization of the PTV system with the phase of the axial fan, two synchronization circuits were employed with a photo-detector attached to the rotating shaft. The phase averaged velocity fields show periodic variations with respect to the blade phase. The periodic formation of vortices at the blade tip is also observed in vorticity contour plots. Locations of local maximum turbulence intensities in the axial and radial directions are found to be located in an alternating pattern. These experimental results can be used to validate numerical calculations and to understand the flow characteristics of an axial fan.

• Journal of the Korean Society of Safety
• /
• v.27 no.5
• /
• pp.35-41
• /
• 2012

The Numerical simulation was performed on the flow field around the two-dimensional rectangular bluff body in order to complement the previous experimental results of the bluff body stabilized flames [1]. For both fuel ejection configurations against an oxidizer stream, the flame stability was affected mainly by vortex structure and mixing field near bluff body. FDS(Fire Dynamic Simulator) based on the LES(Large Eddy Simulation) was employed to clarify the isothermal mixing characteristic and wake flow pattern around bluff body. The air used atmosphere and the fuel used methane. The result of counter flow configuration shows that the flow field depends on air velocity but the mixing field is influenced on the fuel velocity. At low fuel velocity the fuel mole fraction is below the flammable limit and hence the mixing is insufficient to react. Therefore, as the result, the flame formed at low fuel velocity is characterized by non-premixed flames. For the flow field of co-flow configuration, flame stability was affected by fuel velocity as well as air velocity. the vortex generated by fuel stream has counter rotating direction against the air stream. Therefore, the momentum ratio between air and fuel stream was important to decide the flame blow out limit, which is result in the characteristic of the partially premixed reacting wake near extinction.

• 유체기계공업학회:학술대회논문집
• /
• 2006.08a
• /
• pp.407-408
• /
• 2006

Passenger safety is one of the most important considerations in the purchase of an automobile. A curtain-type air bag is increasingly adapted in deluxe cars for protecting passengers from the danger of side clash. Inflator housing is a main part of the curtain-type air bag system for supplying high-pressure gases to pump up the air bag-curtain. Although the inflator housing is fundamental in designing a curtain-type air bag system, flow information on the inflator housing is very limited. In this study, we measured instantaneous velocity fields of a high-speed flow ejecting from the inflator housing using a dynamic PIV system. From the velocity field data measured at a high frame-rate, we evaluated the variation of the mass flow rate with time. From the instantaneous velocity fields of flow ejecting from the airbag inflator housing in the initial stage, we can see a flow pattern of broken shock wave front and its downward propagation. The flow ejecting from the inflator housing was found to have large velocity fluctuations and the maximum velocity was about 700m/s. The velocity of high-speed flow was decreased rapidly and the duration of high-speed flow over 400m/s was maintained only to 30ms. After 100ms, there was no perceptible flow.

• Journal of Power System Engineering
• /
• v.10 no.4
• /
• pp.25-30
• /
• 2006

This paper represents the numerical analysis in unsteady state on the variation of diameter and environmental velocity of carbon heating source. In general heating system, the oil and sheath heater is widely used, but these systems have many problems. So, the heating source with carbon ingredient has been researched in many country about manufacture, thermal and electrical properties. In this research, the carbon heating source was studied through numerical analysis on several conditions of unsteady state, heat generation, diameter and environmental velocity. The temperature distributions at steady state are appeared as a non-proportional linear pattern with variations of environmental velocity due to the Nesselt number with convective heat flux is proportioned to 0.805 of Reynolds number. As the radius is increasing, the temperature distributions is appeared the minus tilt because of the environmental condition is cooling by constant temperature. So, the correlation equation between temperature at steady state and environmental velocity was obtained.

• Journal of the Korean earth science society
• /
• v.37 no.7
• /
• pp.408-419
• /
• 2016

To investigate the in-situ sound velocity of sediment in the southwestern part of the East Sea, the laboratory sound velocity was measured using the pulse transmission technique. The sediment sound velocity measured in laboratory was corrected to in-situ sound velocity based on the seafloor temperature, seawater sound velocity, Kim et al. (2004) model, and Hamilton (1980) model. The distribution of the corrected in-situ sound velocity applying Kim et al. (2004) and Hamilton (1980) models reflects the characteristics of sediments of the study area and shows a similar distribution pattern. The correction for in-situ sound velocity was mostly influenced by seafloor temperature. Then, correction of sound velocity using seafloor sediment temperature data should be accomplished for conversion of laboratory data to in-situ sound velocity.

• Journal of the Korean Society of Physical Medicine
• /
• v.8 no.1
• /
• pp.49-58
• /
• 2013

PURPOSE: The purpose of this study was to determine if auditory cues velocity has a greater effect on the gait pattern of patients with Parkinson's disease (PD) than the cues applied individually. METHODS: The subjects were 15 elderly patients diagnosed with PD, 15 healthy elderly persons. Patients were measured of three conditions performed in random order: slow, general, fast. The auditory cue velocity consisted of a metronome beat ${\pm}20%$ than the subject's general gait speed. Using a motion analysis and a force platform measurement system, changes in spatiotemporal variables, kinetic and kinematic variables were compared to gait analysis. RESULTS: Comparison between the auditory cues velocity, there was a significant difference in the spatiotemporal variables with regard to the cadence, stride length, support time, step length, double support time (p<.05). Comparison between the auditory cues velocity, there was a significant increase general and fast velocity gait than slow velocity gait in the maximum flexion in swing phase of knee joint (p<.05). There appears to be the aspect of an increasing ground reaction force (GRF) on the first peak in the vertical axis (p<.05). CONCLUSION: Auditory cues velocity improved of spatio-temporal factors, kinematic and kinetic factors depending on the velocity of the faster. Therefore at the rehabilitation training of PD patients auditory cues velocity would be used for recovery and gait reeducation, may arise through the patients functional ability.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.27 no.8
• /
• pp.1033-1041
• /
• 2003

Two-phase flow pattern data during horizontal in-tube flow boiling are presented for pure and mixed refrigerants of R134a and Rl23, The flow pattern is observed through tubular sight glasses located at inlet and outlet of the test section, which is made of a stainless steel tube, 2m long with 10mm I.D., 1.5mm wall thickness. The obtained results are compared with the available various correlations for flow pattern. The flow pattern map of Hashizume was in good agreement with the present data except the region of low mass velocity. Weisman flow pattern map was also known to satisfactorily predict data for refrigerants in the region of annular flow. In this study, the flow pattern are simply classified into two groups; stratified(including intermittent, stratified and stratified-wavy) flow and annular flow. The transition quality from stratified to annular flow was obtained by modifying the liquid Froude number.

• Korean Journal of Applied Biomechanics
• /
• v.13 no.2
• /
• pp.65-74
• /
• 2003

The purpose of this study was to analyze kinematic variables in the badminton smash motion through 3-dimensional image analysis. The kinematic variables were velocity of joints in upper limbs, the angle of wrist in the impact, and the angular velocity of the top of racket head. The smash motions of four male badminton players in H University and four male students at department of the physical education in K University who were not majoring in badminton were analyzed kinematically and the attained conclusions were as follow. 1. The velocity of segments in upper limbs of the unskilled group was faster than that of the skilled group. The movement pattern was fast back swing-slow impact moment-fast fellow through in the unskilled group, but slow back swing-fast impact moment-slow follow through in the sullied group. 2. As the BS phases, the velocity of segment in right shoulder was different significantly between groups. Right elbow and right wrist segments, velocity of racket head was different significantly between groups(p<.05) by IP phases. As the FT phases, there was no significant difference. 3. The angle of right wrist at the impact, the angle of palm flexion and the angle of palm flexion in aspect were shown that the skilled group was higher than unskilled group. There was no significant difference. 4. The velocity of racket head was shown that the unskilled group has fast velocity, but the angle velocity was shown the unskilled group has slow. 5. The angle velocity of racket head in aspect were no significant difference between groups, but maximal angle velocity was different significantly between groups(p<.05).

• Water for future
• /
• v.25 no.3
• /
• pp.87-96
• /
• 1992

Hydraulic characteristics such as velocity, surface level and flow pattern in the curved channel are analyzed by model experiment, where model is scaled down by 1:20 for prototype channel containing side branch and curved section. The withdrawal of channel flow from channel is analyzed to find the effect on the curve section. The numerical scheme for shallow water equation using ADI method is verified through the comparison of hydrauric characteristics by experiment with that by numerical analysis in the side section of model channel. The comparison of numerical results with experimental data shows that velocity, surface level and flow pattern agree well for overall channel. Because fo the relative contraction of cross section in the curved section caused by rectangular system, the velocity calculated by numerical analysis is faster in curved section than that from experiment, which can be improved using finer spatial grid in curved section. The characteristics of the curved section such that the surface level is higher in the outer zone of curved section and the velocity is faster in the inner zone are well simulated by both experiment and numerical analysis. The effect of side branch reaches within the zone of the curved section.

• Journal of Biomedical Engineering Research
• /
• v.35 no.3
• /
• pp.35-41
• /
• 2014

In this study, joint angles of the lower extremity and inertial sensor data such as accelerations and angular velocities were measured during a ski simulator exercise in order to evaluate the skill of skiers. Twenty experts and twenty unskilled skiers were recruited for the study. All expert skiers held the certificates issued by the Korea Ski Instructors Association. A three-dimensional motion capture system and two inertial sensors were used to acquire joint movements, heel acceleration and heel angular velocity during ski simulator exercises. Pattern variation values were calculated to assess the variations in ski simulator motion of expert and unskilled skiers. Integral ratio of roll angular velocity was calculated to determine the parallel alignment of the two feet. Results showed that ski experts showed greater range of motion of joint angle, peak-to-peak amplitude(PPA) of heel acceleration and PPA of heel angular velocity than unskilled skiers. Ski experts showed smaller pattern variations than unskilled skiers. In addition, the integral ratio of roll angular velocity in ski experts was closer to 1. Inertial sensor data measurements during the ski simulator exercises could be useful to evaluate the skill of the skier.