• Journal of Korean Society of Transportation
• /
• v.31 no.5
• /
• pp.48-59
• /
• 2013

Normally the benefits concerned in the feasibility study for highway constructions are travel time saving, vehicle operation cost, etc. which can be calculated using the simulation tool(EMME3). However, there must be extra benefits of driving amenity improvement that drivers can perceive through decreasing driving fatigue and improving driving comfortability. In this study, the definition of driving amenity was established and a method of estimation for the benefit of driving amenity improvement was developed. Highway type (urban/rural highway) and highway density was considered to estimate the driving amenity. And Double-bounded Dichotomous Choice among Contingent Valuation Method(CVM) was applied to survey the willingness-to-pay of drivers when highway density decreases. Finally the value of driving amenity was estimated using the results of survey and logit medel. As the existing highway density is high, willingness-to-pay increases in both urban and rural highways. Even though the changing rates of highway density are same, willingness-to-pay is different based on the existing highway density.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.8 no.2
• /
• pp.128-136
• /
• 2009

As results of previous researches and literatures, it is known that the application of the highway-supply index including generally utilized coefficient is not adequate due to the considerable difference of its characteristics. Therefore, in this study, the efficient methodology for determination of optimal highway-supply index in urban-rural consolidated city is extensively suggested and evaluated.

• Journal of Korean Society of Transportation
• /
• v.13 no.3
• /
• pp.19-33
• /
• 1995

Conventional traffic assignment techniques usually do not consider traveler's route choice behavior affected by hierachicla strucfture in urban highway system. This study realizes the route choice behavior such that travelers tend to choose more higher level of highway rather than lower level of highway for longer trops. Otherwise, for shorter trips, travelers tend to choose lower level of highway unless they can get sufficient travel time saving by using mojor arterial street or freeway (higher level of highway). Therefore, this study suggests a traffic assignment technique incorrporating route choice behavior related to hierachical highway structure by introducing some perception costs to generalized cost function such as perceptional preference measureemnt for higher level higheay and perceptional penalty when changing to different level of highway. Through simulation analysis, it is shown that the simulation results with the new traffic assignment echnique can be different a lot from the results with the convential method.

• Wind and Structures
• /
• v.9 no.4
• /
• pp.297-313
• /
• 2006

The concentration of air pollution along roads is higher than the surrounding area because ventilation efficiency has decreased due to the high-density use of space along roads in recent years. In this study, ventilation efficiency around a heavily traffic road covered by an elevated highway and hemmed in along its side by buildings is evaluated using Visitation Frequency (VF, the frequency for pollutant to return to the objective domain) and Purging Flow Rate (PFR, the air flow rate for defining the local domain-averaged concentration). These are analyzed using Computational Fluid Dynamics (CFD) based on the standard $k-{\varepsilon}$ model. The VF and PFR characteristics of four objective domains are analyzed in terms of the changes in wind direction and arrangements of the fencing dividing up and down direction in the road center under the elevated highway. The resulting VFs are more than 1.0 for all cases, which means that pollutants return to the objective domain restricted by the elevated highway and side buildings. The influence of the arrangement of the buildings around the objective domain and the structure in the domain on the VF is substantial. In cases where there are no obstacles under the elevated highway, the local air exchange rate in the domain tends to be improved. Using these indices, the urban ventilation efficiencies between different urban areas can be compared easily.

• International Journal of Highway Engineering
• /
• v.15 no.4
• /
• pp.155-165
• /
• 2013

PURPOSES : Benefits for improvement of travel time reliability obtained from construction of new highways should be considered as a major factor in the feasibility study for highway constructions. The purpose of this study is to develop a method of estimation for the value of travel time reliability. METHODS : Highway type (urban/rural highway) and traffic flow type(interrupted/uninterrupted) was considered to estimate he value of travel time reliability. And Double-bounded Dichotomous Choice among Contingent Valuation Method(CVM) was applied to survey the willingness-to-pay of drivers when travel time reliability is improved. Finally the value of travel time reliability was estimated using the results of survey and logit model. The value of travel time reliability was estimated considering travel objectives, time constraint travel and non-time constraint travel. RESULTS: The value of travel time reliability of business trip is higher than that of non-business trip. The value of travel time reliability of time constraint travel is higher than that of non-time constraint travel. The value of travel time reliability in urban area is higher than that in rural area. CONCLUSIONS: It was concluded that the proposed method in this study is more realistic and proper to estimate the value of travel time reliability because it reflects the situations of time constraint travel and non-time constraint travel.

• Journal of Environmental Science International
• /
• v.19 no.6
• /
• pp.665-670
• /
• 2010

Pollutants from urban pavement consists various kinds of substances which are originated from dry deposition, a grind out tire, corrosive action of rain to pavement and facilities and raw materials of the road etc.. These are major pollutants of urban NPS (Non-point source) during rainfall period. However there is not enough information to control such pollutants for appropriate management of natural water quality. In this study of transportation areas, three monitoring stations were set up at trunk road, urban highway and national road in Gyeongnam province. Runoff flow rate was measured at every 15minutes by automatic flow meters installed at the end of storm sewer pipe within the road catchment area for water quality analysis. Data was collected every 15 minutes for initial two hours of rainfall. Additional samples were collected 1-4 hours interval till the end of rainfall. The monitoring parameters were $COD_{Mn}$, SS, T-N & T-P and heavy metals. The average EMCs of TSS and $COD_{Mn}$ were 62.0 mg/L and 24.2 mg/L on the city trunk road, which were higher than those of urban highway and national road, indicating higher pollutant loads due to activities in the city downtown area beside the vehicle. On the other hand, the average EMC of T-N and T-P were in the range of 2.67-3.23 mg/L and 0.19-3.21 mg/L for all the sampling sites. Heavy metals from the roads were mainly Fe, Zn, Cu and Mn, showing variable EMCs by the type of road. From the TSS wash-off analysis in terms of FF(first flush) index, first flush phenomenon was clearly observed in the trunk road(FF : 0.89-1.43). However, such mass delivery behavior was not apparently shown in urban highway(FF : 0.90-1.11) and national road(FF : 0.81-1.41).

• International Journal of Highway Engineering
• /
• v.7 no.3 s.25
• /
• pp.43-52
• /
• 2005

Highway classification is an essential part of defining design criteria of roads. This study is to classify highways by factor analysis. To accomplish the objectives, factor analysis is performed for classifying highways using the traffic data observed at the permanent traffic count points in 2004. A total off variables are applied : AADT, K factor, D factor, heavy vehicle proportion, day time traffic volume proportion, peak hour volume proportion, sunday factor, vacation factor and COV(Coefficient of Variation). The results of factor analysis show that variables are divided into two factors, which are the factor related to the fluctuational characteristics of traffic volume and the factor related to heavy vehicle and directional volume characteristics. According to the results of cluster analysis, 353 permanent traffic count points are categorized into such three groups as type I for urban highway, type II for rural highway, type III for recreational highway, respectively.

• International Journal of Highway Engineering
• /
• v.17 no.2
• /
• pp.123-134
• /
• 2015

PURPOSES : The key point of a multimodal LOS (level-of-service) evaluation system is that all of the modes are mutually associated to determine each mode's LOS. For example, the LOS of the bicycle mode is measured based on not only bicycle volumes, but also automobile volumes. However, the Korea Highway Capacity Manual (KHCM) still focuses on the automobile mode in evaluating the LOS of the roads. Additionally, the KHCM's LOS of the other modes, except for the automobile, is not consistent with actual road conditions. The KHCM, therefore, needs to develop and introduce a multimodal LOS system in order to evaluate the service conditions more accurately. METHODS: As a preliminary step to the introduction of multimodal LOS research, in this study the current problem of the KHCM's LOS system through a close review and comparison with other HCMs (highway capacity manuals) was identified. Secondly, a field survey and investigation of the urban streets to apply the HCM's multimodal LOS system was conducted. Finally, a comparison analysis of the results of the HCM and KHCM LOS was performed. RESULTS: In the study, it was found that the results of the LOS for the automobile mode did not show a significant difference between the HCM and KHCM. However, the LOS of the bicycle and pedestrian mode tended to be worse in the multimodal LOS system, which results from considering the effects of the automobile mode. Moreover, it was found that many cases have the potential to improve the overall LOS conditions, while reducing the automobile capacity. CONCLUSIONS: With the introduction of the multimodal LOS system, road diet and complete streets can be easily applied to ans actual road improvement project. Ultimately, the multimodal LOS system should be introduced into the KHCM, which can then be applied to traffic impact studies and other road improvement projects for more accurate evaluations.

• Journal of the Society of Disaster Information
• /
• v.13 no.4
• /
• pp.570-576
• /
• 2017

Trucks take up more portions than cars on highways. Due to this, road use relatively diminish and it serves locally as a threatening factor to nearby drivers. Baggage car accident has distinct characteristics so that it needs the application of different analysis opposed to ordinary accidents. Accident prediction model, one of accident analyses, is used to predict the numbers of accident in certain parts, establish traffic plans as well as accident prevention methods, and diagnose the danger of roads. Thus, this study aims to apply the accident rate of baggage car on highways and calculate the correction factor to be put in the accident prediction models. Accident data based on highway was collected and traffic amounts and accident documents between 2014 and 2016 were utilized. The author developed an accident prediction model based on numbers of annual accidents and set mean annual and daily traffic amounts. This study intends to identify the practical accident prediction model on highway and present an appropriate solution by comparing the prediction model in accords with the accident rate between baggage cars.

• Journal of Korean Society for Atmospheric Environment
• /
• v.18 no.6
• /
• pp.539-546
• /
• 2002

The physicochemical properties of solid wastes generated from seven highway service areas, four branch offices, and one construction site were analyzed in concert with air pollutants including heavy metals emitted from near-by small-scale incinerators. The amount of solid wastes generated from highway areas has been increasing with recent increases in the number of highways and passengers. Twelve incinerators examined in this study generally had capacity smaller than 100 kg/hr, most of which were equipped with cyclone for dust removal. It was seen that the concentrations of the gas-phase air pollutants (e.g., SO$_2$, NO$_{x}$, HCl and H$_2$S) were above the acceptable emission standards except one or two sites. CO concentrations at all incinerators were also higher due to incomplete combustion. In addition, particulate matters showed concentration six times higher at their maximum. The results of heavy metal analysis showed that the concentrations of Cu, Cd, and Ni satisfied the emission standards. whereas Pb at one site and Zn at five sites exceeded the standards. Cr measurement results indicated that 9 of 12 incinerators had higher values than the standard; especially one branch office showed nine times higher than normal concentration. In order to satisfy more stringent emission standards in the near future, it is necessary to install air pollution control system and to develop an intensified management plan.n.