• Electronics and Telecommunications Trends
• /
• v.34 no.6
• /
• pp.1-16
• /
• 2019

The paper presents five strategic opinions for promoting the fourth industry revolution through the supply of 5G additional frequency. The assessments are on the basis of 5G frequency utilization technologies and services, with reference to 3GPP 5G New Radio standards, after investigating the domestic 1G, 2G, 3G, 4G, and 5G mobile communication services as well as the use of mobile radio frequency and spectrum. The presented opinions contain the frequency supply of contiguous-wide bandwidth channels, harmonized frequency supply between licensed and unlicensed spectrum, the existing 4G frequency recycle for increasing 5G coverage and capacity, balance frequency supply in the multi-band for 5G services, and the development of 5G vertical frequency for industry. The aim is that the presented five strategic opinions can offer guidance for the upcoming plan of domestic 5G additional frequency supply.

• Journal of Internet Computing and Services
• /
• v.20 no.5
• /
• pp.95-104
• /
• 2019

Various kinds of devices are used for the Internet of Things (IoT) service, and IoT devices mainly use communication technology that uses the frequency of the unlicensed band. There are several types of communication technology in the unlicensed band, but WiFi is most commonly used. Devices used for IoT services vary in computing resources from devices with limited capabilities to smartphones and provide services over wireless networks such as WiFi. Most IoT devices can't perform complex operations for network control, thus they choose a WiFi access point (AP) based on signal strength. This causes a decrease in IoT service efficiency. In this paper, an intelligent AP system that can efficiently control the WiFi connection of the IoT devices is implemented. Based on the network information measured by the IoT device, the access point learns using a feed forward neural network algorithm, and predicts a network connection state to control the WiFi connection. By controlling the WiFi connection at the AP, the service efficiency of the IoT device can be improved.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.2
• /
• pp.113-119
• /
• 2017

In this paper, we have shown the performance analysis results of the LoRa low power wide area network under duty cycle local regulation in Korean RFID/USN frequency band. Especially, we analyzed uplink throughput and data transmission time of a single LoRa end device. From the analysis results, duty cycle regulation, in which a data transmission should be ended within 0.4 second, limits the performance of LoRa network. Therefore, it is necessary to revise Korea's duty cycle regulation referencing EU regulation in order to assess LoRa network in Korea.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.6
• /
• pp.110-120
• /
• 2008

Cognitive Radio (CR) technology is proposed for using the unused spectrum band efficiently because of the spectrum scarcity problems. Spectrum sensing technology is one of the key challenge issues in cognitive radio technologies, which enables unlicensed users to identify and utilize vacant spectrum resource allocated to primary users. In this paper, the cooperative spectrum sensing technologies apply the ITS(Intelligent Transport System) and performance of signal detection analyzes. Then, we utilize the OR-rule and AND-rule for the cooperative signal detection. These data fusion rules improve the performance and reliability of the signal detection.

• 제어로봇시스템학회:학술대회논문집
• /
• 2004.08a
• /
• pp.922-925
• /
• 2004

Bluetooth technology is essentially a method for wireless connection of a diverse set of devices ranging from PDAs, mobile phone, notebook computers, to another equipments. The bluetooth system supports both point-to-point connection and point-to-multipoint connections. In point-to-multipoint connection, the channel is shared among several bluetooth devices. Two or more devices sharing the same channel form a piconet. There is one master device and up to seven active slave devices in a piconet. The radio operates in the unlicensed 2.45GHz ISM band. This allows users who travel world-wide to use bluetooth equipments anywhere. Since the link is based on frequency-hop spread spectrum, multiple channels can exist at the same time. The Bluetooth standard has been suggested that Bluetooth equipments can be used in the short-range, maximum 100 meters . It has been defined that the time takes to setup and establish a bluetooth connection among devices is 10 seconds. It is a long time and may be a cause to lose a chance of finding other non-fixed devices. We propose a routing protocols for scatternets which can be used to control a mobile units(MUs) in this network. The proposed routing protocol is composed of two kinds of bluetooth information, access point(AP) and MU.

• Journal of Institute of Control, Robotics and Systems
• /
• v.10 no.11
• /
• pp.1052-1057
• /
• 2004

Bluetooth technology is essentially a method for wireless connectivity of a diverse set of devices ranging from PDAs, mobile phone, notebook computers, to another equipments, The bluetooth system both point-to point connection and point-to multipoint connection. In point-to multipoint connection, the channel is shared among several bluetooth devices. Two or more devices sharing the same channel form a piconet. There one master device and up to seven active slave devices in a piconet. The radio operates in the unlicensed 2.45GHz ISM band. This allows users who travel world-wide to use bluetooth equipments anywhere. Since the link is based on frequency-hop spread spectrum, multiple channels can exist at the same time. The bluetooth standard ha s been suggested that bluetooth equipments can be used in the short-range, maximum 100 meters. It has been defined that the time takes to setup and establish a bluetooth connection among devices is 10 seconds. It is a long time and may be a cause to lose a chance of finding other non-fixed devices. We propose a routing protocols for scatternets which can be used to control a mobile units(MUs) in this network. The proposed routing protocol is composed of two kinds of bluetooth information, access point(AP) and MU.

• ETRI Journal
• /
• v.44 no.4
• /
• pp.543-559
• /
• 2022

To determine a suitable waveform for Internet of Things (IoT) transmission over low-Earth orbit (LEO) satellites, this paper reports the results of a performance comparison between chirp spread spectrum (CSS)-based LoRa and direct sequence spread spectrum (DSSS)-based Ingenu. The performance of both waveforms was measured in terms of the packet error rate, throughput, and packet loss rate, considering the Doppler effect caused by the high speed of LEO satellites and the interference among multiple terminals. Simulation results indicate that the DSSS scheme is more suitable than the CSS scheme for high-traffic IoT services because of its robustness against interference among multiple terminals. However, the CSS scheme is more suitable than the DSSS scheme for high-mobility IoT services because of its robustness against the Doppler effect. We discuss various solutions, such as the preprocessing of Doppler effect and avoidance of packet collision, to enhance the performance of the DSSS and CSS schemes. The simulation results of the proposed solution show that the enhanced DSSS scheme can be a proper waveform in IoT transmission over LEO satellites for both the high-traffic and high-mobility services.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.11B
• /
• pp.1357-1362
• /
• 2011

TV White Spaces (TVWS) are freed up after transition from analog television to Digital Television (DTV). Some wireless communications are allowable to operate in TVWSs, such unlicensed Wireless Fidelity (WiFi). Because TVWSs are located in the VHF and UHF bands, TVWSs can provide significantly better coverage and wall penetration inside buildings and other structures than the 2.4 GHz and 5 GHz WiFi frequencies currently in use. Therefore, this paper assumes that WiFi will be deployed in TVWSs. However, the interference impact of WiFi on DTV has to be taken into account. The interference probability in DTV receiver was evaluated by using Spectrum Engineering Advanced Monte-Carlo Analysis Tool (SEAMCAT). As a result, when 20 WiFi UEs are simultaneously operating at the maximum transmit power of 23 dBm and the guard band is 22 MHz, the protection distance should be at least 6 km to meet the interference probability of 5% in DTV receiver.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.26 no.5
• /
• pp.694-702
• /
• 2022

This paper shows a small and low-powered wireless communication system based on the ATSC broadcasting system using the ISM frequency band that can be used as a PBS(Personal Broadcasting System). It is designed to demonstrate a channel-adaptive CR(Cognitive Radio) system to provide a better service quality in the unlicensed band where co-channel interference exists. And it achieved very reliable communications by a closed-loop active phased array antenna. This ATSC-based personal broadcasting platform can be modified easily with given flexibility by using GNU Radio as an open-source signal processing platform based on USRP and implementing additional functions in FPGA. In addition, the chosen communication frequency resource can be managed and controlled by the return channel that transmits the channel status and communication parameters between transmission and reception in real-time.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.23 no.7
• /
• pp.164-171
• /
• 2019

Focusing on the bridge facilities, which occupy the largest proportion among SOC public facilities in Korea, it is possible to reduce the cost compared to existing wired measurement systems or wireless measurement systems developed by domestic telecommunications companies, and to increase the technical perfection to be applied to many bridges. We developed a wireless measurement system for bridges. Using LoRa, one of the unlicensed LPWAN technologies, we have developed an optimized MEMS-based LoRa smart sensor node considering the domestic ISM band and the existing wired sensor LoRa DAQ sensor node that can communicate with the LoRa network. Application server was developed for the test bed performance verification and efficient management of the developed sensor node.