• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2015년도 춘계 학술논문 발표대회
• /
• pp.100-101
• /
• 2015

This study was carried out to investigate and analyse the influence of brain and unit weight of cement on the properties of shotcrete through the laboratory and field test. From the results of the test, the shotcrete with high blaine cement showed the rebound ratio lower and the strength properties higher than the shotcrete with normal blaine cement. Such as this was produced also in the mix with low unit weight of high blaine cement.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2014년도 추계 학술논문 발표대회
• /
• pp.53-54
• /
• 2014

This study evaluates engineering properties of mortar using lightweight fine aggregate made by bottom ash discharged air cooling process according to grading. Then we confirm possibility of use as lightweight fine aggregate. Consequently, Mix using bottom ash need additional examination for a change with the passage of time of flow. Also, mix of S indicates similar compressive strength with mix of Plain and 16% decrease of unit weight compared to mix of Plain; while mix of B indicates 10% decrease of compressive strength and 16% decrease of unit weight. Therefore, this study shows that mix of S and B is superior compared with other mix.

• Geomechanics and Engineering
• /
• 제5권4호
• /
• pp.299-312
• /
• 2013

The horizontal pullout capacity of a group of two vertical strip plate anchors, placed along the same vertical plane, in a fully cohesive soil has been computed by using the lower bound finite element limit analysis. The effect of spacing between the plate anchors on the magnitude of total group failure load ($P_{uT}$) has been evaluated. An increase of soil cohesion with depth has also been incorporated in the analysis. For a weightless medium, the total pullout resistance of the group becomes maximum corresponding to a certain optimum spacing between the anchor plates which has been found to vary generally between 0.5B and B; where B is the width of the anchor plate. As compared to a single plate anchor, the increase in the pullout resistance for a group of two anchors becomes greater at a higher embedment ratio. The effect of soil unit weight has also been analyzed. It is noted that the interference effect on the pullout resistance increases further with an increase in the unit weight of soil mass.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1991년도 가을 학술발표회 논문집
• /
• pp.15-20
• /
• 1991

High-strength concrete were produced with super-plasticizer, silica fume, fly ash and blast furnace slag powder. Topics investigated inclued mix proportion, and effects of unit weight of binder, W/C ratio, additive type on the physical properties of high-strength concrete. As the result, at 20% of silica fume, unit weight of binder 700kg/$\textrm{m}^3$ and W/C=0.24, 28days compressive strength of concrete was over 1,000kgf/$\textrm{cm}^2$. And in cases of blending with silica fume 10% and fly ash or slag 10%, it was able to produce economical high-strength concrete with 28 days strength similar to silica fume 20% only, and higher strength after 90days.

• Advances in concrete construction
• /
• 제5권1호
• /
• pp.1-15
• /
• 2017

This research project aimed at evaluating experimentally the effect of natural perlite powder as an alternative supplementary cementing material (SCM) on the performance of fiber reinforced self-consolidating repair mortars (FR-SCRMs). For this purpose, four FR-SCRMs mixes incorporating 0%, 10%, 20%, and 30% of natural perlite powder as cement replacements were prepared. The evaluation was based on fresh (slump flow, flow time, and unit weight), hardened (air-dry unit weight, compressive and flexural strengths, dynamic modulus of elasticity), and durability (water absorption test) performances. The results reveal that structural repair mortars confronting the performance requirements of class R4 materials (European Standard EN 1504-3) could be designed using 10%, 20%, and 30% of perlite powder as cement substitutions. Bonding results between repair mortars containing perlite powder and old concrete substrate investigated by the slant shear test showed good interlocking justifying the effectiveness of these produced mortars.

• Journal of Ceramic Processing Research
• /
• 제20권4호
• /
• pp.363-371
• /
• 2019

In this study, physical properties of normal concrete, magnetite concrete, EAF concrete, and EAF concrete with added iron powder were evaluated and a feasibility of radiation shielding is also evaluated through irradiation tests against X-rays and gamma-rays. While the unit weight of EAF concrete (3.21 t/㎥) appeared lower than that of magnetite concrete (3.50 t/㎥), the results in compressive strength of EAF concrete were greater than those in magnetite and normal concrete. While the radiation transmission rate of normal concrete reaches 26.0% in the X-ray irradiation test, only 6.0% and 9.0% of transmission rate were observed in magnetite concrete and linear relationship with unit volume weight and radiation shielding. In the gamma-ray irradiation test, the performance of EAF and magnetite concretes appeared to be similar. Through the results on the excellent physical properties and radiation shielding performance a potential applicability of EAF concrete to radiation shielding was verified.

• 콘크리트학회논문집
• /
• 제14권4호
• /
• pp.457-466
• /
• 2002

현대사회에서 건설전반에 보편화되어 있는 레미콘은 다양한 사용재료의 물리 화학적 성분이 생산지 및 조성광물에 따라 다르므로 구해지는 결과 값 또한 무수한 변수가 있기 마련이다. 또한 콘크리트의 배합설계는 배합요소의 다변화로 인해 정확한 검정은 그리 간단하지가 않다. 신경망의 학습에 소요되는 시간은 컴퓨터의 성능 및 학습횟수(epoch)에 따라 다르고, 학습시 학습횟수를 최고 백만번까지 반복하도록 하였으며 학습 종료조건으로 최소자승법에 의해 목표 오차량이 0.10~0.001 사이가 될 때까지로 하였다. 신경망의 적용에는 현재 경북지방에 위치한 레미콘 회사중 A, B사에서 사용하는 콘크리트 시방배합표를 가지고 신경망 이론에 따라 학습시킨 후에 물시멘트비, 잔골재율, 단위수량, 단위시멘트량, 강모래의 단위량(S1), 부순모래의 단위량(S2), 단위굵은골재량 혼화제량을 추정하였고, 다음으로 압축강도 및 슬럼프 값을 각각 추정하였다. 배합요소 추정의 검정에 사용된 규격으로는 호칭강도 180~300kgf/${cm}^2$, 목표슬럼프값 8cm, 15cm를 사용하였고, 압축강도 및 슬럼프 값 추정에 사용된 규격으로는 회사별 최근 생산량이 가장 많은 호칭강도 210~240kgf/${cm}^2$, 목표 슬럼프 값 12, 15cm를 각각 사용하였다. 본 논문에서는 컴퓨터에 의한 학습 및 시뮬레이션을 통해 콘크리트의 배합요소, 압축강도 및 슬럼프 값을 추정하여 직접 실험 값과 비교함으로써 실험을 통하지 않고도 콘크리트의 배합요소 및 강도를 추정하는데 목적이 있다. 결과적으로 압축강도 및 슬럼프의 추정은 회사에 관계없이 오차량에 만족하여 수렴하는 것으로 나타나 인공신경망이론이 압축강도 및 슬럼프를 예측하는데 효율적인 것으로 판명되었다.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2015년도 추계 학술논문 발표대회
• /
• pp.17-18
• /
• 2015

In the case of concrete recently manufactured with a concrete mixing truck, although aggregate and cement are used as the main ingredients, from a costs savings perspective, low quality aggregates are processed and used as concrete aggregate. In the case of these low quality aggregates, the unit volume and unit binder weights are increased for manufacturing, and due to this problems such as dry shrinking of the architecture and economic infeasibility have arisen. Therefore by changing the aggregate material and the unit binder weights that are currently being distributed, this research analyzes the influence on concrete.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2012년도 추계 학술논문 발표대회
• /
• pp.163-164
• /
• 2012

Recently new construction system, the Infill Modular Construction System, is being emphasized depending on the industrialized technology introduction and the needs of high-rise housing. In order to applicate the Infill Modular Construction System and activate the domestic market, development of insufficient element technologies against the advanced technologies should be preceded and mobile device development of Infill Unit Module which is differentiated from the existing modular construction systems should be needed urgently. As advanced research for the activation of the Infill Modular Construction System, this research aims to develop Infill Unit Module's mobile device. This is expected to improve the constructability of Infill Unit Module. In addition development of mobile device considering weight of Infill Unit Module and construction errors are being planned.

• 한국항공우주학회지
• /
• 제33권5호
• /
• pp.93-98
• /
• 2005

과학기술위성 2호 시스템 내의 각 전자 유닛(Unit)의 상태 정보를 원격검침(Telemetry)하고 원격명령(Telecommand) 내릴 수 있는 원격검침-명령 유닛(Telemetry-Command Unit, TCU)의 시험모델(Engineering Model, EM)의 개발을 완료하고 동작시험 결과를 제시하였다. TCU는 과학기술위성 1호와는 다르게 CPU가 없이 FPGA 만으로 구현하여 소형화, 경량화 및 저 전력화를 실현하고 기술 집약화를 이루었다. 본 논문에서는 TCU의 개념 설계를 소개하고 구현결과를 제시한다.