• The Korean Journal of Physiology
• /
• 제21권1호
• /
• pp.59-66
• /
• 1987

This study was aimed to investigate whether the conduction velocity of nerve impulses through the ventral afferent fibers is constant along their entire courses in dorsal as well as in ventral roots. Cats were anesthetized with ${\alpha}-chloralose$ (60 mg/kg, i.p.) and artificially ventilated. Laminectomies were done on L4-S1 spinal vertebrae to expose the lumbosacral spiral cord. Both ventral and dorsal roots of L7 or S1 spinal segments were isolated and cut near the spinal cord. Ventral roots were placed on 6-lead stimulating electrodes and stimulated with supra C-threshold intensity. Divided dorsal root fascicles were placed on bipolar recording electrodes and single fiber units activated by the stimulation of the ventral roots were identified. Followings are the results obtained: 1) A total of 27 VRA units were identified. 10 units of them conducted impulses slower than 2 m/sec. Conduction velocities of the remaining units were in the range of 3.11-20.91 m/sec. 2) In 12 Units conduction velocities Of the VRA units through dorsal$(CV_{DR})$ and venral root$(CV_{DR})$ were determined respectively. There was a tendency to conduct impulses faster through dorsal roots$(CV_{DR}=8.19{\pm}3.26\;m/sec)$ than ventral roots$(CV_{DR}=3.46{\pm}1.02\;m/sec)$. From the above results we confirmed that there exist nerve fibers in continuity between the spinal ventral and dorsal roots but we could not ascertain whether there is a change in conduction velocity through the entire course of ventral afferent unit.

• Journal of Periodontal and Implant Science
• /
• 제23권3호
• /
• pp.564-576
• /
• 1993

The purpose of this study was to evaluate the effects of Nd:YAG laser treatment on removal of smear layer and exposure of dentinal tubules. The experimental specimens were obtained from root planed surface of 30 human teeth which were extracted due to severe periodontal disease. The specimens were assigned randomly of three groups: root planed group, Tetracycline HCl(100mg/ml, 5min) group, and Nd:YAG laser ($Laser-35^{TM}$, U.S.A. 5 seconds )group. Nd:YAG laser group was divided into 4 subgroups according to 3.0W, 3.5W, 4.0W, 4.5W of power. The surface change of specimens were evaluated by scanning electron microscopy. The number of exposed dentinal tubules and percentage of area occupied by dentinal tubule orifices per unit area between each group was statistically analyzed by paired Student t-test. The results were as follows: 1. By root planing only, dentinal tubule was not exposed, but scale-like smear layer and parallel instrument tracks were resulted. 2. Tetracycline HCl treated surfaces exhibited the small number of partially exposed dentinal tubules with long orifices. The number($3.80{\pm}0.79$) of exposed dentinal tubules on Tetracycline HCl group was significantly less than that in laser groups above 3.5W of power(P<0.001), and the percentage ($0.68{\pm}0.19$) of area occufied by dentinal tubule orifices per unit area($192\;{\mu}m^2$) was significantly lower than that of any laser group(P<0.001). 3. The laser group irradiated with 4.5W of power showed both the most number($10.60{\pm}0.97$) of exposed dentinal tubules among the experimental groups, and the highest percentage($3.75{\pm}0.55\;%$) of area occupied by dentinal tubule orifices. 4. Energy Surge during laser pulsing and overlapping passes of the fiber resulted in melted and resolidified surface textures with lava-like appearance.

• The Plant Pathology Journal
• /
• 제38권1호
• /
• pp.1-11
• /
• 2022

Fusarium culmorum is one of the most important causal agents of root rot of wheat. In this study, 10 F. culmorum isolates were collected from farms located in five agro-ecological regions of Morocco. These were used to challenge 20 durum wheat genotypes via artificial inoculation of plant roots under controlled conditions. The isolate virulence was determined by three traits (roots browning index, stem browning index, and severity of root rot). An alpha-lattice design with three replicates was used, and the resulting ANOVA revealed a significant (P < 0.01) effect of isolate (I), genotype (G), and G × I interaction. A total of four response types were observed (R, MR, MS, and S) revealing that different genes in both the pathogen and the host were activated in 53% of interactions. Most genotypes were susceptible to eight or more isolates, while the Moroccan cultivar Marouan was reported resistant to three isolates and moderately resistant to three others. Similarly, the Australian breeding line SSD1479-117 was reported resistant to two isolates and moderately resistant to four others. The ICARDA elites Icaverve, Berghisyr, Berghisyr2, Amina, and Icaverve2 were identified as moderately resistant. Principal component analysis based on the genotypes responses defined two major clusters and two sub-clusters for the 10 F. culmorum isolates. Isolate Fc9 collected in Khemis Zemamra was the most virulent while isolate Fc3 collected in Haj-Kaddour was the least virulent. This work provides initial results for the discovery of differential reactions between the durum lines and isolates and the identification of novel sources of resistance.

• Journal of Ginseng Research
• /
• 제8권2호
• /
• pp.124-134
• /
• 1984

Ginseng root starch, prepared by conventional method, contained crude lipid of 0.5%, crude protein of 0.4%, crude mineral of 0.17% and phosphorous of 12.5mg% as noncarbohydrate constituents. The amylose content of ginseng root starch picked in Summer (May to August) and Winter (November to March) was 32-35% and 15-20%, respectively, and it was decreased with a growing preiod of ginseng. The blue value, alkali number and ferricyanide number of the starch were 0.14-0.17, 8.50 and 0.781, respectively. The molecular weight of amylose in the starch was estimated to be 1.27-7.95${\times}$105 by means of periodate oxidation, and the degree of branching and glucose unit per segment of amylopectin were 3.50-3.53% and 28.3-28.5, respectively, The starch content of ginseng root was decreased when dried under sunlight and stored at 5$^{\circ}C$ for twenty days. In contrast, sucrose content in the root was increased from 3.8% in fresh state to 11.5% during storage at the above condition. In the other hand, starch was converted to maltose by heating at temperature above 70$^{\circ}C$.

• Nuclear Engineering and Technology
• /
• 제29권5호
• /
• pp.375-384
• /
• 1997

Relative power density distributions of the Kori Unit 1 pressurized water reactor are calculated by Monte Carlo modeling with the MCNP code. The Kori Unit 1 core is modeled on a three-dimensional representation of the one-eighth of the reactor in-vessel component with reflective boundaries at 0 and 45 degrees. The axial core model is based on half core symmetry and is divided into four axial segments. Fission reaction density in each rod is calculated by following 100 cycles with 5,000 test neutrons in each cycle after starling with a localized neutron source and ten noncontributing settle cycles. Relative assembly power distributions are calculated from fission reaction densities of rods in assembly. After 100 cycle calculations, the system converges to a k value of 1.00039 $\geq$ 0.00084. Relative assembly power distribution is nearly the same with that of the Kori Unit 1 FSAR. Applicability of the full-scope Monte Carlo simulation in the power distribution calculation is examined by the relative root moan square error of 2.159%.

• International journal of advanced smart convergence
• /
• 제12권3호
• /
• pp.211-220
• /
• 2023

Surface electromyography (sEMG) is a noninvasive method used to capture electrically muscle activity, which can be easily measured even during exercise. The basic unit of muscle activity is the motor unit, and because an sEMG signal is a superposition of motor unit action potentials, analysis of muscle activity using sEMG should ideally be done from the perspective of motor unit activity. However, conventional techniques can only evaluate sEMG signals based on abstract signal features, such as root-mean-square (RMS) and mean-power-frequency (MPF), and cannot detect individual motor unit activities from an sEMG signal. On the other hand, needle EMG can only capture the activity of a few local motor units, making it extremely difficult to grasp the activity of the entire muscle. Therefore, in this study, a method to visualize the activities of motor units in a single-channel sEMG signal by relocating wavelet coefficients obtained by redundant discrete wavelet analysis is proposed. The information obtained through this method resides in between the information obtained through needle EMG and the information obtained through sEMG using conventional techniques.

• 한국자원식물학회지
• /
• 제9권3호
• /
• pp.203-210
• /
• 1996

더덕 뿌리 내에 함유되어 있는 항산화효소를 생육환경에 따라 조사하기 위하여 경북 서벽지역의 1 2년생 밭더덕, 야생더덕 및 논에서 재배되는 1 2년생 더덕을 채취하여 사용하였고, 부위별 비교는 각 더덕 뿌리를 upper, middle, low로 나누어서 사용하였다. 이들을 O radical caseade인 SOD, POD, CAT activity를 조사하여 다음과 같은 결과를 얻었다. 1. SOD 활성은 밭재배조건의 경우 1년생보다는 2년생이, 논재배시는 1년생이 2년생보다는 높은 활성을 나타내었으며, 야생종의 비활성이 96069u/mg protein으로 가장 높은 활성을 나타내었다. 부위별로 비교해보면 재배종은 upper>middle>lower 순으로 논재배시는 low>upper>middle 순으로 야생종은 middle>lower, upper 순으로 생육환경에 따라 차이를 나타내었다. 2. POD 비활성(u/mg protein)은 년근수가 높을수록 활성은 증가하며, 야생지역이 68 u/mg protein로 가장 높은 활성을 나타내었다. 부위별로는 middle>lower>upper 순으로 활성이 나타났으며, 서벽야생의 middle 부분이 85 u/mg protein를 나타내었다. 3. CAT 활성은 POD 활성과는 달리 년근수가 낮을수록 높게 나타났으며 밭재배지와 야생지의 활성은 비슷하며 논재배지는 상대적으로 그 활성이 낮았다. 부위별로는 upper>low>middle 순으로 upper 부위가 상당히 높은 활성을 나타내며, 서벽재배 1년생의 upper가 53.59 u/mg protein으로 가장 높게 나타났다. 4. MS1D(MS+2.4-D 1ppm)에 배양한 배양세포의 항산화효소의 활성은 CAT는 1564, POD는 30, SOD는 22200 u/mg protein로 생체에 비해 낮은 활성을 나타내었다.

• 한국공작기계학회논문집
• /
• 제10권5호
• /
• pp.85-95
• /
• 2001

This study proposed a technique for inverse problem, linear approximation of contact position and loading in single and double meshing of spiral bevel gear , using 2-dimension model considered near the tooth by root stress. Determine root stress is carried out far the gear tooth by finite element method and boundary element method. Boundary element discretization near contact point is carefully performed to keep high computational accuracy. And from those estimated results, the comparing estimate value with boundary element method value was discussed.

• 한국농공학회논문집
• /
• 제64권5호
• /
• pp.27-39
• /
• 2022

The smart farm is recognized as a solution for future farmers having positive effects on the sustainability of the poultry industry. Intelligent microclimate control can be a key technology for broiler production which is extremely vulnerable to abnormal indoor air temperatures. Furthermore, better control of indoor microclimate can be achieved by accurate prediction of indoor air temperature. This study developed predictive models for internal air temperature in a mechanically-ventilated broiler house based on the data measured during three rearing periods, which were different in seasonal climate and ventilation operation. Three machine learning models and a mechanistic model based on thermal energy balance were used for the prediction. The results indicated that the all models gave good predictions for 1-minute future air temperature showing the coefficient of determination greater than 0.99 and the root-mean-square-error smaller than 0.306℃. However, for 1-hour future air temperature, only the mechanistic model showed good accuracy with the coefficient of determination of 0.934 and the root-mean-square-error of 0.841℃. Since the mechanistic model was based on the mathematical descriptions of the heat transfer processes that occurred in the broiler house, it showed better prediction performances compared to the black-box machine learning models. Therefore, it was proven to be useful for intelligent microclimate control which would be developed in future studies.

• Journal of the Korean Data and Information Science Society
• /
• 제15권2호
• /
• pp.485-493
• /
• 2004

This paper considers the test of money and income causality. Jeong (1991, 2003) developed a nonparametric causality test based on the kernel estimation method. We apply the nonparametric test to USA data of money and income. We also compare the test results with ones of the conventional parametric test.