• The Transactions of the Korean Institute of Power Electronics
• /
• v.23 no.1
• /
• pp.40-46
• /
• 2018

In this study, the output voltage balancing characteristics of parallel-input series-output (PISO) boost converter is analyzed. The PISO boost converter is derived by combining two basic boost converters. In comparison with the conventional three-level boost converter, the PISO boost converter can balance the output voltages under an unbalanced load condition without requiring additional circuit components and control strategy. A 2 kW prototype converter is built and tested to verify the output voltage balancing characteristics of the PISO boost converter.

• Proceedings of the KIPE Conference
• /
• 2018.07a
• /
• pp.316-317
• /
• 2018

This paper propse the DC link capacitor voltage balancing control for three level neutral point clamped converter with harmonic component injection method. The injcetion voltage consists of harmonic component and DC link capacitor voltage difference. Theoretical analysis is provided to balance the DC link voltage, and it shows that harmonic component compensates the unbalanced condition between the capacitors. Both simulations and experiments are carried out to show that the voltage unbalance have been decreased by the proposed method.

• Proceedings of the KIPE Conference
• /
• 2018.07a
• /
• pp.444-445
• /
• 2018

신 재생에너지원을 바탕으로 하는 분산 발전이 증가함에 따라 이에 사용되는 PCS 또한 계통연계 및 독립 모드 운전을 해야 한다. PCS는 두 운전 모드 전환 시 발생하는 과도 상태를 최소화하기 위해 무순단 절체 기능이 필요하다. 이 기능은 평형 부하 뿐만 아니라 불평형 부하 상황에서도 이루어 져야 한다. 따라서, 본 논문에서는 불평형 부하 조건에서 무순단 절체 기능이 동작하는 것을 보이며, 시뮬레이션을 통해 제어 알고리즘의 타당성을 검증한다.

• Proceedings of the KIEE Conference
• /
• 2000.07b
• /
• pp.837-839
• /
• 2000

Capacitor-run single induction motors have the unbalanced elliptic rotating magnetic field so that it is difficult to analyze the characteristic and calculate the accurate slot leakage reactance of the rotor with the closed slot by using the lumped parameter. In this paper, the characteristic is analyzed by the symmetrical coordinate method in terms of the lumped parameter coupled with the numerical analysis. The secondary parameters are calculated by the one slot pitch boundary condition applying to Finite Element Method (FEM). The analysis results are compared with experimental ones.

• Proceedings of the KIPE Conference
• /
• 2005.07a
• /
• pp.504-506
• /
• 2005

This paper proposes a new neutral current reduction method using PQR instantaneous power theory on the active power filter, unbalanced nonlinear load condition in three-phase four-wire systems. For reduction of neutral line current, the single phase active power filter is used and its performance is same with the three-phase four-wire active power filter. For fully-digital implementation, ramp comparison PWM method was adopted. Simulation results verify good performance of the proposed current control strategy on the shunt APFs.

• Proceedings of the KIPE Conference
• /
• 2005.07a
• /
• pp.283-285
• /
• 2005

Three control strategies that can be applied to a three-phase AC-DC converter under unbalanced input voltage condition are discussed. Analytic solutions are given on the a-b-c frame, and are very simple, direct and Intuitive. All of the strategies guarantee sinusoidal input currents. All the control functions, including decoupled current control and PWM, are implemented on the a-b-c frame. Accordingly, the controller is very simple and robust. The proposal is verified by simulation and experiments on a prototype operating at 15 kHz

• The Transactions of the Korean Institute of Power Electronics
• /
• v.17 no.1
• /
• pp.41-47
• /
• 2012

This paper proposes a calculation of compensation current using phase shift to eliminate ripple components of instantaneous active power under unbalanced or non-linear loads condition. The proposed phase shift method instead of existing method(LPF; Low Pass Filter) to remove ripple components and this proposed method improves performances of transient and steady state response. To compare proposed method with existing method, experiments have been done for calculating an average active power at load side. Their results show that transient response and steady state response of proposed method is improved.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.43 no.3
• /
• pp.397-408
• /
• 1994

In this paper, a novel concept for a static three-phase to three-phase power converter for an AC drive with a unity power factor and reduced harmonics on the utility line is presented. The power circuit consists of two back-to-back connected six-pulse bridges having only a $\mu$F ceramic capacitor in the DC link. By controlling the active kpower balance between two bridges, the DC link voltage can be maintained within 20V deviation from the nominal value with the small ceramic capacitors regardless of the load variation even in the unbalanced source condition.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.52 no.1
• /
• pp.1-8
• /
• 2003

Generally, thrust force of double-sided LPM is more powerful than that of single-sided LPM. Also, double-sided LMP can be effectively applied to the high-precision position system with its simple control scheme. However, An equality between two airgap lengths Is a necessary condition for its high performance. If a little difference between two airgaps is existed, unbalanced normal force and undesirable vibration will be generated. Additionally, even though two airgap lengths are absolutely same, undesirable vibration can be generated because the direction of instantaneous normal force on mover is changed according to excitation methods. An effect of inequality of two airgap lengths is presented in this paper. Distribution of airgap permeance vs. relative displacement is analyzed by two dimensional finite element method. Excitation From this results, current waveforms to reduce the undesirable vibration is proposed.

• Proceedings of the KIPE Conference
• /
• 2001.07a
• /
• pp.97-100
• /
• 2001

본 연구에서는 3상이 불평형된 전원 조건하에서 비선형 부하전류를 유효성분, 기본파 무효성분 그리고 왜 형성분으로 분해한 후, 능동전력필터를 제어할 수 있는 새로운 평균전력 알고리즘을 제시하였다. 제안된 방법의 타당성을 입증하기 위해, $15\%$ 불평형된 3상 전원 전압하에서 실험을 수행하였으며, 종전의 평균전력 알고리즘에 비하여 새로운 평균전력 알고리즘의 유용성을 입증할 수 있었다.