• 한국분말재료학회지
• /
• 제10권4호
• /
• pp.255-261
• /
• 2003

Ultrafine TaC-5%Co composite powders were synthesized by spray conversion process using tantalum oxalate solution and cobalt nitrate hexahydrate(Co($(NO_3)_2$ . 6$H_2O$). The phase of Ta-Co oxide powders had amorphous structures after calcination below 50$0^{\circ}C$ and changed $Ta_2O_5$, $TaO_2$ and $CoTa_2O_6$ phase by heating above $600^{\circ}C$. The calcined Ta-Co oxide powders were spherical agglomerates consisted of ultrafine primary particles <50 nm in size. By carbothermal reaction, the TaC phase began to form from 90$0^{\circ}C$. The complete formation of TaC could be achieved at 105$0^{\circ}C$ for 6 hours. The observed size of TaC-Co composite powders by TEM was smaller than 200 nm.

• 한국기계가공학회지
• /
• 제21권5호
• /
• pp.40-45
• /
• 2022

In recent years, indoor air pollution has become a crucial environmental problem. Hence, the purification of indoor air is an important issue. Typical physical filters show relatively high dust collection efficiency at a dust particle size of more than 5.0 ㎛ but extremely low efficiency at an ultrafine size of less than 2.5 ㎛. In this study, an electric field filter was proposed to capture ultrafine dust with a size of less than 5.0 ㎛. Simulation results showed that the electric field filter effectively removed ultrafine dust. In addition, sufficient dust collection efficiency was obtained even with a simple plate-shaped filter without bending the Chevron filter.

• 한국세라믹학회:학술대회논문집
• /
• 한국세라믹학회 2003년도 춘계총회 및 연구발표회 초록집
• /
• pp.70.1-70
• /
• 2003

• 한국세라믹학회:학술대회논문집
• /
• 한국세라믹학회 2003년도 춘계총회 및 연구발표회 초록집
• /
• pp.150.2-150
• /
• 2003

• 한국입자에어로졸학회지
• /
• 제6권2호
• /
• pp.91-103
• /
• 2010

Size-segregated number concentration and scattering coefficient of urban aerosols were measured using an SMPS (scanning mobility particle sizer) and a nephelometer, respectively in Seoul, Korea, during the winter season of 2003. The average number concentrations of ultrafine particles (20~100 nm) and accumulation mode particles (100~600 nm) were $2,170\;particles\;cm^{-3}$ and $1,521\;particles\;cm^{-3}$, respectively. The scattering coefficient at the wavelength of 550 nm ranged from $62.6Mm^{-1}$ to $330.1Mm^{-1}$ and average value was $163.4Mm^{-1}$. The peak concentrations of ultrafine particles and accumulation mode particles were simultaneously recorded between 6:00 and 9:00 A.M., indicating the effect of vehicle emissions which are major air pollution sources in the urban atmosphere. On average, the number concentration of ultrafine particles was 1.4 times higher than that of accumulation mode particles, although it was a little higher during the morning peak time. The variation of aerosol scattering coefficient was in good agreement with that of accumulation mode particle number concentration rather than that of ultrafine particle number concentration.g coefficient was in good agreement with that of accumulation mode particle number concentration rather than that of ultrafine particle number concentration.

• Environmental Engineering Research
• /
• 제24권4호
• /
• pp.680-689
• /
• 2019

Temperature effects on the generation of brake wear particles from railway vehicles were generated, with a particular focus on the generation of ultrafine particles. A real scale brake dynamometer test was repeated five times under low and high initial temperatures of brake discs, respectively, to obtain generalized results. Size distributions and temporal patterns of wear particles were analyzed through visualization using clustered heatmaps. Our results indicate that high initial temperature conditions promote the generation of ultrafine particles. While particle concentration peaked within the range of fine sized particles under both low and high initial temperature, an additional peak occurred within the range of ultrafine sized particles only under high initial temperature. The timing of peak occurrence also differed between low and high initial temperature conditions. Under low initial temperature fine sized particles were generated intensively at the latter end of braking, whereas under high initial temperature both fine and ultrafine particles were generated more dispersedly along the braking period. The clustered correlation heatmap divided particle sizes into two groups, within which generation timing and concentration of particles were similar. The cut-off point between the two groups was approximately 100 nm, confirming that the governing mechanisms for the generation of fine particles and ultrafine particles are different.

• 산업식품공학
• /
• 제13권1호
• /
• pp.44-49
• /
• 2009

Angelicae gigantis Radix (dried root of Angelica gigas) including major bioactives such as decursin and decursinol angelate provides rich flavors and several healthy benefits. Recent studies have shown that ultrafine powders of herbal medicines provide better physical properties and biological activities. Thus, ultrafine Angelica powder was added into the oligosaccharide syrup to provide flavors and healthy benefits in this study. Angelicae gigantis Radix was pulverized into d(0.1) = 3.220, d(0.5) = 7.822, and d(0.9) = 7.817 $\mu$m respectively using an air-flow mill. The ultrafine Angelica powder was added into the oligosaccharide syrup process with different ratios of water to oligosaccharide syrup at 1:5, 1:8, 1:11, and 1:14. The physicochemical properties such as viscosity and bulk density were measured. The Stokes' law was applied to predict the sedimentation velocity of the added Angelica powder in the syrup. The Angelica syrup prepared in this experiment showed good stability since the Angelica particles precipitated down slowly. The ratio of water to oligosaccharide syrup at 1:11 showed the optimal preparation in terms of the stability and the viscosity. The ultrafine-sized herbal powders such as Angelicae gigantis Radix have potentials for various food and pharmaceutical applications.

• 한국산학기술학회논문지
• /
• 제19권12호
• /
• pp.279-286
• /
• 2018

그라우팅공법은 지반강화와 차수를 위한 공법으로 약액을 주입하여 지반을 고화시키는 것이다. 시멘트계 그라우트 주입재는 수세기 전부터 보통 포틀랜드 시멘트를 사용하였으나 시멘트 입경이 커 주입효과에 한계가 있다. 이에 본 연구는 초미립자 시멘트가 사용된 암반지반에서의 그라우팅 주입효과를 분석하기 위함이다. 이를 위해 초미립자 시멘트로 3S-1호가 사용되었고, OPC와 3S-1호를 각각 적용하여 암반그라우팅 현장시험시공을 실시하였으며 수압시험 공내재하시험 주입시험을 통해 그 결과를 비교분석 하였다. 시험 결과, 암반지반에서는 OPC보다 초미립자 시멘트(3S-1호)를 사용하는 것이 차수효과(K, $10^{-6}cm/sec$)가 더 높으며 보강효과도 확인할 수 있었다. 또한 초미립자 시멘트(3S-1호)가 OPC보다 약 4~9배 주입성이 더 높은 것으로 나타났다. 따라서 본 연구는 암반그라우팅 시공시 OPC대신 초미립자 시멘트를 적용하는 것이 더 유리한 것으로 판단이 된다.

• 한국대기환경학회지
• /
• 제29권1호
• /
• pp.10-26
• /
• 2013

To understand the traffic emissions with high temporal and spatial resolutions on road, a mobile laboratory was developed. The objective of this study is to characterize on-road air pollution on Naebu express way surrounding the northern area of Seoul, Korea. We measured the number concentration of ultrafine particles larger than 5 nm and particle size distribution using a condensation particle counter and a fast mobility particle sizer, respectively on 3, 7, and 8 December 2009. The average ultrafine particle number concentration on the Naebu express way excluding tunnels was 126,000 particles/$cm^3$ and 4.2 times higher than that on internal road at Korea Institute of Science and Technology in Seoul, and more than twice higher than that measured on and at the arterial roads of Seoul in previous studies. The maximum ultrafine particle number concentration was observed at the tunnel sections. It was 232,000 particles/$cm^3$ and 1.8 times higher than average ultrafine particle number concentration for the other sections on Naebu express way. The ultrafine particle number concentration on the wider roads with higher traffic volume along the Han River was similar to that in the residential section, probably because of enhanced dilution effect in widely open environment. The size distribution of particles on the Naebu express way was highly fluctuated for a short duration. Ultrafine particles measured at the tunnel showed a bimodal size distribution with mode diameters of ~10 nm and ~50 nm. At the Han riverside section, ~10 nm particles appeared significantly compared with size distribution at the tunnel. This on-road measurement approach can be utilized to manage vehicle-related air pollution in urban area.

• 한국환경보건학회지
• /
• 제38권5호
• /
• pp.393-397
• /
• 2012

Objectives: The objectives of this study were to measure passengers' exposure to ultrafine particles (UFP) and to determine effects of fuel, operating condition and position of seat. Method: UFP exposures in front and back seats of the Elephant vehicle in Seoul Grand Park were simultaneously measured by a condensation particle counter (P-Trak model 8525, TSI). The measurements were conducted 7 times with diesel-powered vehicle and 3 times with electricity vehicle in one day. The vehicle stopped at 3 locations along with 2.2 km of driving route. Results: UFP concentration in diesel-powered vehicle was significantly higher than electricity vehicle. At front seat of diesel-powered vehicle, average UFP exposure during stopping was significantly higher than during moving. When diesel-powered vehicle moved, UFP exposure in back seat was significantly higher than in front seat. Conclusions: Passengers in the diesel-powered Elephant vehicle could be exposed to high level of UFP. The UFP exposure was associated with operation condition and position of seat.