• Journal of Powder Materials
• /
• v.15 no.2
• /
• pp.142-147
• /
• 2008

The hypereutectic Al-20 wt%Si powders including some amount of Cu, Fe, Mg, Mn were prepared by a gas atomization process. In order to get highly densified Al-Si bulk specimens, the as-atomized and sieved powders were extruded at $500^{\circ}C$, Microstructure and tensile properties of the extruded Al-Si alloys were investigated in this study. Relative density of the extruded samples was over 98%. Ultimate tensile strength (UTS) in stress-strain curves of the extruded powders increased after T6 heat treatments. Elongation of the samples was also increased from 1.4% to 3.2%. The fracture surfaces of the tested pieces showed a fine microstructure and the average grain size was about $1{\mu}m$.

• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09b
• /
• pp.1022-1022
• /
• 2006

• Proceedings of the Korean Vacuum Society Conference
• /
• 1994.06a
• /
• pp.109-109
• /
• 1994

• Proceedings of the KIEE Conference
• /
• 1997.07d
• /
• pp.1528-1530
• /
• 1997

As device size shrinks, contamination will increasingly affect the reliability and yield of device. Therefore, contaminants must be removed from the surfaces of Si wafers prior to each process. But it becomes out increasingly difficult to clean silicon surfaces with finer patterns by the conventional wet treatment because of the viscosity and surface tension of solutions. Hence, a damage less dry cleaning process is needed for the silicon surfaces. For the removal of Si native oxide by UV-enhanced dry cleaning. $F_2$ gas and $F_2/H_2$ mixed gas were applied. As a result of analysis, UV-enhnaced $F_2/H_2$ treatment is more suitable than UV-enhanced $F_2$ treatment for removal of native oxide on the surfaces of Si wafers.

• Korean Journal of Metals and Materials
• /
• v.50 no.8
• /
• pp.575-582
• /
• 2012

Medium carbon steel was aluminized by hot dipping into molten Al or Al-1 at% Si baths. After hot-dipping in these baths, a thin Al-rich topcoat and a thick alloy layer rich in $Al_5Fe_2$ formed on the surface. A small amount of FeAl and $Al_3Fe$ was incorporated in the alloy layer. Silicon from the Al-1 at% Si bath was uniformly distributed throughout the entire coating. The hot dipping increased the microhardness of the steel by about 8 times. Heating at $700-1000^{\circ}C$, however, decreased the microhardness through interdiffusion between the coating and the substrate. The oxidation at $700-1000^{\circ}C$ in air formed a thin protective ${\alpha}-Al_2O_3$ layer, which provided good oxidation resistance. Silicon was oxidized to amorphous silica, exhibiting a glassy oxide surface.

• Journal of Surface Science and Engineering
• /
• v.51 no.6
• /
• pp.337-343
• /
• 2018

The present study investigated the effect of heat treatment process on the surface wettability of an Al-Si-Mg alloy. After solution-treated at $525^{\circ}C$ and aged at $160^{\circ}C$, the alloy showed high hardness due to the formation of precipitates. In addition, surface wettability was improved in such a way that the contact angle of distilled water droplet on the flat surface decreased to $37.6{\sim}42.1^{\circ}$ after the heat treatment. The surface energy predicted by Owens-Wendt equation also confirmed the increase of surface energy after the heat-treatment. However, when the surface roughness increased, the positive effect of the heat treatment on wettability diminished due to the geometrical factors of the rough surface.

• Journal of the Korean Chemical Society
• /
• v.53 no.3
• /
• pp.233-243
• /
• 2009

We have investigated the infrared spectra for CO adsorbed on silica supported nickel(Ni-Si$O_2$), silica supported copper(Cu-Si$O_2$), silica supported nickel-copper alloys(Ni/Cu-Si$O_2$) of several compositions with varying CO pressures(0.2 $torr{\sim}$50 torr) at room temperature and on pumping to vacumn at room temperature within the frequency range of 1500 $cm^{-1}{\sim}2500\;cm^{-1}$. Four bands(2059.6 $cm^{-1},\;{\sim}$2036.5 $cm^{-1},\;{\sim}$ 1868.7 $cm^{-1},\;{\sim}$ 1697.1 $cm^{-1}$) were observed for Ni-Si$O_2$, two bands($\sim$2115.5 $cm^{-1},\;{\sim}$1743.0 $cm^{-1}$) were observed for Cu-Si$O_2$ and five bands(${\sim}2123.2\;cm^{-1}$, 2059.6 $cm^{-1},\;{\sim}$2036.4 $cm^{-1},\;{\sim}$1899.5 $cm^{-1},\;{\sim}$1697.1 $cm^{-1}$) were observed for Ni/Cu-Si$O_2$. These absorption bands correspond with those of the previous reports approximately. The bands below 1800 $cm^{-1}$ were only observed with Ni metal or Ni/Cu alloy crystal plane containing step at room temperature and the ${\sim}1697.1\;cm^{-1}$ bands observed with Ni-Si$O_2$ and Ni/Cu-Si$O_2$ may be ascribed to CO molecule adsorbed on the adsorption sites near step. The bands below 2000 $cm^{-1}$ were rarely observed with Cu metal crystal plane at room temperature and the 1743.0 $cm^{-1}$ bands may be ascribed to CO molecule adsorbed on the adsorption sites near step. The band shifts of adsorbed CO with varing Cu contents from 0 to 0.5 mole fraction at the same CO pressure or at the same pumping time to vacumn were below 21 $cm^{-1}$. and comparatively small than those with other ⅠB metal addition. It may means ligand effect of Cu d electron is small.

• Economic and Environmental Geology
• /
• v.28 no.1
• /
• pp.53-67
• /
• 1995

Geochemical characteristics of iron-related Ulsan granite was studied in comparison with the Cretaceous granitoids from the metallogenic provinces of copper, lead-zinc and lead-zinc/molybdenum in the Gyeongsang Basin, and the variation of cheminal compositions at the Ulsan granite/serpentinite contact was investigated. Ulsan granite is plotted in the regions of granite and granodiorite of Streckeisen's diagram. It shows differentiation trend of calc-alkali magma, and the magmatic evolution from granodiorite to granite is consistant with the general crystallization path of the Cretaceous the granitoids in Gyeongsang Basin. Differentiation index(D.I.) of Ulsan granite is 86~95, which is higher than those of Jindong granites (D.I.=45~70) and Onjongri granites (D.I.=67~84), and there are differences in the content of some major and trace elements between Ulsan granite and other Cretaceous granitoids. At the Ulsan granite/serpentinite contact $SiO_2$, $K_2O$, $Na_2O$, $Al_2O_3$, Rb, Sr, Ba which are abundant in Ulsan granite decrease toward serpentinite, while T.Fe, MgO, Ni, Cr which are abundant in serpentinite decrease toward Ulsan granite. Therefore, the geochemical characteristics of Ulsan granite is applicable to distinguish iron province from different metallogenic provinces where other Cretaceous granitoids occur in the Gyeongsang Basin, and it is possible to find serpentinite which was intruded by granite on the basis of chemical variations.

• Journal of the Semiconductor & Display Technology
• /
• v.12 no.3
• /
• pp.41-46
• /
• 2013

Efficient and inexpensive solar cells are necessary for photo-voltaic to be widely adopted for mainstream electricity generation. For this to occur, the recombination losses of charge carriers (i.e. electrons or holes) must be minimized using a surface passivation technique suitable for manufacturing. Recently it has been shown that aluminum oxide thin films are negatively charged dielectrics that provide excellent surface passivation of silicon solar cells to attract positive-charged holes. Especially aluminum oxide thin film is a quite suitable passivation on the rear side of p-type silicon solar cells. This paper, it demonstrate the interfacial microstructure and electrical properties of mono-crystalline silicon surface passivated by $Al_2O_3$ films during firing process as applied for screen-printed solar cells. The first task is a comparison of the interfacial microstructure and chemical bonds of PECVD $Al_2O_3$ and of PEALD $Al_2O_3$ films for the surface passivation of silicon. The second is to study electrical properties of double-stacked layers of PEALD $Al_2O_3$/PECVD SiN films after firing process in the temperature range of $650{\sim}950^{\circ}C$.

• Journal of Korean Neurosurgical Society
• /
• v.30 no.7
• /
• pp.861-869
• /
• 2001

Objective : In this study, we investigated the relationship between the histologic grading of meningiomas and proliferative potentials determined by the Ki-67, proliferating cell nuclear antigen(PCNA) and flow cytometry (FCM) with the aim of determining whether these potentials can be used as a parameter to the proliferative activity, in particular of atypical and malignant meningiomas. Methods : This study consisted of 47 meningiomas(6 malignant, 14 atypical, and random sampled 27 benign meningiomas). By immunohistochemical staining of Ki-67 and PCNA on formalin-fixed, paraffin-embedded sections, the anti-human rabbit polyclonal antibody against Ki-67 antigen and anti-PCNA monoclonal antibody(PC10) scores were counted. FCM was also performed on paraffin-embedded tissue using a selective staining technique for DNA. DNA ploidy, S-phase fraction, and proliferative index(PI)) were determined. Results : The results are summarized as follows ; 1) Proliferation rates as assessed by Ki-67 and PCNA closely correlated with the degree of anaplastic histologic features. 2) Proliferative potentials determined by FCM(S-phase fraction and PI) were not able to distinguish between benign and atypical/malignant meningiomas. 3) DNA ploidy was not a useful indicator of histologic grade in these tumors. 4) Proliferative potentials such as Ki-67 staining index(SI) and PCNA SI did not correlate with the ploidy pattern. 5) There was a linear correlation between Ki-67 SI and PCNA SI, but we could not find a correlation between Ki-67 SI and S-phase fraction or PI. Our results also did not show a statistically signficant correlation between PCNA SI and S-phse fraction or PI. Conclusions : We conclude that evaluation of the proliferative potentials with Ki-67 and PCNA is important as an additional factor for the prediction of malignancy in meningiomas. A dual study of Ki-67 and PCNA SIs on the same tissue might improve the accuracy with which the proliferative potential of a tumor can be predicted. We demonstrated that FCM in meningiomas is not valuable in predicting the behavior of these neoplasms, but we did observe a trend toward more malignancy with higher percent S-phase fraction and higher PI. Analysis of the S-phase fraction and PI might therefore be a useful tool to discriminate among histologic grades of meningiomas.