• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.7
• /
• pp.627-633
• /
• 2002

Many isolated featureless domains were explicitly observed even at the air-water interface. We measured the surface pressure shift originating from the photo-isomerization of azobenzene units on the periphery of dendrimers. The maximum surface pressure was gradual1y increased and saturated by cyclic compression and decompression. By irradiation of 365 [nm] light, the surface pressure was increased, which was originated by the photo-isomerization process of the azobenzene group on the periphery from trans to cia form. The increase of the dipole moment ($\mu$), which may increase the interaction among Azo dendrimer molecules, made an important role on surface pressure shift. From the absorbance spectrum by UV irradiation and heat treatment, we can see that the absorbance in the UV region decreases with the increase of the UV irradiation time, but the peak at 350 m, characteristic of dendrimers in the LB monolayers, was not shifted until four irradiation cycles. This suggests that optical behavior and morphological change are affected by the functional group and the symmetric chain.

• Publications of The Korean Astronomical Society
• /
• v.20 no.1 s.24
• /
• pp.7-10
• /
• 2005

We have calculated 2448 interstellar cloud models to investigate the formation and destruction of high rotational level $H_2$ according to the combinations of five physical conditions: the input UV intensity, the $H_2$ column density, cloud temperature, total density, and the $H_2$ formation rate efficiency. The models include the populations of all the accessible states of $H_2$ with the rotational quantum number J < 16 as a function of depth through the model clouds, and assume that the abundance of $H_2$ is in a steady state governed primarily by the rate of formation on the grain surfaces and the rates of destruction by spontaneous fluorescent dissociation following absorption in the Lyman and Werner band systems. The high rotational levels J = 4 and J = 5 are both populated by direct formation into these levels of newly created molecules, and by pumping from J = 0 and J = 1, respectively The model results show that the high rotational level ratio N(4)/N(0) is proportional to the incident UV intensity, and is inversely proportional to the $H_2$ molecular fraction, as predicted in theory.

• BMB Reports
• /
• v.29 no.5
• /
• pp.423-428
• /
• 1996

A superoxide anion radical scavenger isolated from Capsella bursa-pastoris was characterized by infrared (IR) spectroscopy, sugar analysis, ultraviolet (UV) spectroscopy, $^{1}H$ and $^{13}C$ nuclear magnetic resonance (NMR) spectroscopies, and fast atom bombardment (FAB) mass analysis. The compound was assumed to be a flavonoid-O-glycoside from IR spectrum and UV absorption maxima. When the sugar composition of the compound was examined by thin layer chromatography (TLC) and gas chromatography (GC) of the acid hydrolysate, only glucose was detected. According to the results of UV spectrotroscopy by using shift reagents, the compound was supposed to be luteolin (5,7,3',4'-tetrahydroxy flavone) or chrysoeriol (5,7,4'-trihydroxy-3'-methoxy flavone) with glucose. Based on $^{1}H$- and $^{13}C-NMR$ spectroscopies, the compound was deduced as 7,4'-dihydroxy-5,3'-dimethoxy-${\alpha}$-6-c-glucosyl-${\beta}$-2"-o-glucosyl flavone. In FAB mass analysis the compound was finally characterized as 7,4'-dihydroxy-5,3'-dimethoxy-${\alpha}$-6-c-glucosyl-${\beta}$-2"-o-glucosyl flavone ($C_{29}H_{34}O_{16}$, M.W.=638).

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.20 no.2
• /
• pp.41-49
• /
• 2014

This study illustrates the synthesis of gelatin based zinc oxide nanoparticle (ZnONPs) incorporated nanocomposite films using different concentrations of ZnONPs. The ZnONPs were oval in shape and the size ranged from 100- 200 nm. The nanocomposite films were characterized by UV-visible, FE-SEM, FT-IR, and XRD. The concentrations of ZnONPs greatly influenced the properties of nanocomposite films. The absorption peaks around 360 nm increased with the increasing concentrations of ZnONPs. The surface color of film did not change while transmittance at 280 nm was greatly reduced with increase in the concentration of ZnONPs. FTIR spectra showed the interaction of ZnONPs with gelatin. XRD data demonstrated the crystalline nature of ZnONPs. The thermostability, char content, water contact angle, water vapor permeability, moisture content, and elongation at break of nanocomposite films increased, whereas, tensile strength and modulus decreased with increase in the concentrations of ZnONPs. The gelatin/ZnONPs nanocomposite films showed profound antibacterial activity against both Gram-positive and Gram-negative food-borne pathogenic bacteria. The gelatin/$ZnONP^{1.5}$ nanocomposite film showed the best UV barrier and antimicrobial properties among the tested-films, which indicated a high potential for use as an active food packaging films with environmentally-friendly nature.

• Korean Journal of Materials Research
• /
• v.27 no.9
• /
• pp.459-465
• /
• 2017

Nano-sized Zinc selenide (ZnSe) powder was successfully synthesized using Zn and Se precursors in a hydrothermal process. Temperature for the synthesis was varied from $95^{\circ}C$ to $180^{\circ}C$ to evaluate its influence on the microstructural properties of the synthetic particles. ZnSe powder thus fabricated was characterized using various analytical tools such as SEM, XRD, TEM and UV-Vis methods. Two types of ZnSe particles, that is, the precipitated particle and the colloidal particles, were identified in the analysis. The precipitated particles were around 100 nm in average size, whereas the average size of the colloidal particles was around 20 nm. The precipitated particles made at $150^{\circ}C$ and $180^{\circ}C$ were found to be a single phase of ZnSe; however, an inhomogeneous phase was obtained at the lower synthesis temperature of $95^{\circ}C$, suggesting that the temperature for the synthesis should be over $100^{\circ}C$. The precipitated particles were inactive in the UV-Vis absorption investigation, whereas the colloidal particles showed that absorptions occurred at 380 nm in the UV-Vis spectrum.

• Journal of the Korean Ceramic Society
• /
• v.45 no.11
• /
• pp.651-657
• /
• 2008

In this study, CNT/$TiO_2$ composites were prepared using surface modified Multiwall carbon nanotube (MWCNT) and titanium n-butoxide (TNB) with benzene. The composites were characterized by nitrogen adsorption isotherms, scanning electron microscopy (SEM), X-ray diffraction (XRD), energy dispersive X-ray analysis (EDX), FT-IR spectra, and UV-vis absorption spectroscopy. The UV radiation induced photoactivity of the CNT/$TiO_2$ composites was tested using a fixed concentration of methylene blue (MB, $C_{16}H_{18}N_3S{\cdot}Cl{\cdot}3H_2O$) in an aqueous solution. Finally, it can be considered that the MB removal effect of the CNT/$TiO_2$ composites is not only due to the adsorption effect of MWCNT and photocatalytic degradation of $TiO_2$, but also to electron transfer between MWCNT and $TiO_2$.

• Journal of the Korean Ceramic Society
• /
• v.41 no.11
• /
• pp.826-833
• /
• 2004

In this study, photosensitivity dynamics in SiO$_2$ glass with the composition similar to that of silica Planar Lightwave Circuit (PLC) devices was investigated as a fundamental study prior to the device fabrication. Silica bulk glasses with similar composition to the core layer of PLC devices were prepared with variable composition of B$_2$O$_3$. The photosensitivity in boron and germanium co-doped SiO$_2$ glass yields refractive index change $\Delta$n as high as 10$\^$-3/. However such index modulation disappeared after annealing. From the result of annealing experiment and W absorption / Raman spectra, we conclude the compaction model is applicable to our glass system.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.11
• /
• pp.3133-3138
• /
• 2010

The electrochemical properties of the liposoluble vitamin $K_1$ adsorbed on bare and lipid coated glassy carbon electrodes (GCEs) were studied in unbuffered and well buffered aqueous media. The reduction products of vitamin $K_1$ were characterized by employing cyclic voltammetry and the in situ UV-visible spectroelectrochemical technique. The radical species of vitamin $K_1$ cannot be observed at the bare GCEs in well buffered media. The formation of the anion radical of vitamin $K_1$ was observed in unbuffered solutions above pH 5.9 or at the lipid coated GCE in a well-buffered solution. UV-visible absorption bands of neutral vitamin $K_1$ were observed at 260 nm and 330 nm, and a band corresponding to the anion radical species was observed at 450 nm. The derivative cyclic voltabsorptometric (DCVA) curves obtained for electrochemical reduction of vitamin $K_1$ confirmed the presence of both neutral and anion radical species. The anion radical of vitamin $K_1$ formed at the hydrophobic conditions with phosphatidylcholine (PC) lipid coated electrode was stable enough to be observed in the spectroelectrochemical experiments.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.1
• /
• pp.95-99
• /
• 2011

$CaTi_{1-x}Fe_xO_3(0{\leq}x{\leq}0.4)$ solid solution photocatalysts were synthesized by iron doping during the conventional solid state reaction at $1100^{\circ}C$ for 5 h and characterized by ultraviolet-visible (UV-vis) absorption spectroscopy, X-ray diffraction, morphological analysis. We found that $CaTi_{1-x}Fe_xO_3$ samples not only absorb UV but also the visible light photons. This is because the Fe substitution at Ti-site in $CaTi_{1-x}Fe_xO_3$ lattice induces the band transition from Fe3d to the Fe3d + Ti3d hybrid orbital. The photocatalytic activity of Fe doped $CaTiO_3$ samples for hydrogen production under UV light irradiation decreased with the increase in the Fe concentration. There exists an optimized concentration of iron in $CaTiO_3$, which yields a maximum photocatalytic activity under visible light ($\lambda\geq420nm$) photons.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.8
• /
• pp.1798-1804
• /
• 2009

In this study, we have studied on improved performance of carbon nanotubes/titanium (CNT/TiO2) structure electrode for methylene blue (MB). The composite electrodes consisting of CNTs and a titanium oxide matrix with phenol resin binder was fabricated with a mixture method. The chemical and morphological structure of CNT/Ti$O_2$ composites were characterized by means of BET surface area, X-ray diffraction (XRD), scanning electron microscopy (SEM), UV-Vis absorption technique, Raman spectroscopy and energy dispersive X-ray (EDX). The electrode showed a remarkably enhanced performance for MB oxidation under UV illumination with or without electro-chemical reaction (ECR). Such a remarkably improved performance of the CNT/Ti$O_2$ structure electrode might be due to the enhanced MB oxidation by electro- and photo-generated electrons and holes in the CNTs and Ti$O_2$ under UV illumination with or without ECR.