• Journal of Conservation Science
• /
• v.29 no.1
• /
• pp.35-45
• /
• 2013

The Clay Statues of Donggwanwangmyo Shrine (Treasure No. 142) are highly damaged physical weathering which are crack, exfoliation. Pigment of surface are discolored by chemical weathering like dust. The result of ultrasonic velocity measurement, low velocity zone was measured the lowest part of Woojanggun Statue. Deficiency condition of pigment layer was evaluated quantitatively through infrared Thermography. As a result, exfoliation part was detected at high temperature. Making techniques of the Clay statues were identified by gamma rays, infrared TV, SEM. All Clay Statues were founded on wood base and joints of wood were fixed using thin iron wires. After wood base was twisted a straw rope, it was made by clay. Clay was blended with rice straw to prevention of crack and exfoliation. The upper side of clay layer was coated with Hanji(Korean handmade paper) and cotton in order to isolate the pigment layer.

• Fibers and Polymers
• /
• v.7 no.3
• /
• pp.317-322
• /
• 2006

Reduction of yam hairiness by nozzles in ring spinning and winding is a new approach. Simulation of the airflow pattern inside the nozzles provides useful information about actual mechanism of hairiness reduction. The swirling air current inside the nozzles is capable of wrapping the protruding hairs around the yam body, thereby reducing yam hairiness. Since production rate of winding is very high and the process itself increases yarn hairiness any method to reduce the hairiness of yarns at this stage is a novel approach. A CFD (computational fluid dynamics) model has been developed to simulate the airflow pattern inside the nozzles using Fluent 6.1 software. In this study, both S- and Z-type nozzles having an axial angle of 500 and diameter of 2.2 mm were used for simulation studies. To create a swirling effect, four air holes of 0.4 mm diameter are made tangential to the inner walls of the nozzles. S- and Z-twisted yams of 30 tex were spun with and without nozzles and were tested for hairiness, tensile and evenness properties. The total number of hairs equal to or exceeding 3 mm (i.e. the S3 values) for yam spun with nozzle is nearly 49-51 % less than that of ring yams in case of nozzle-ring spinning, and 15 % less in case of nozzle-winding, while both the yarn types show little difference in evenness and tensile properties. Upward airflow gives best results in terms of hairiness reduction for nozzle-ring and nozzle wound yams compared to ring yarns. Yarn passing through the centre of the nozzle shows maximum reduction in S3 values.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.11a
• /
• pp.124-127
• /
• 2002

LC aligning capabilities and the variation of pretilt angles with ion beam irradiation on the a-C:H thin films, and electro-optical (EO) performances of the ion beam aligned twisted nematic (TN)-liquid crystal display (LCD) with oblique ion beam exposure on the a-C:H thin film were studied. A high pretilt angle of $3.5{^{\circ}}$ via ion beam irradiation on the a-C:H thin film was measured. Also, the LC pretilt angle decreased due to the increase in surface roughness at over 2 min of IB exposure time. It is considered that this roughness increase due to increasing IB exposure time that generated destroy of oriented rings of atoms related to LC alignment. An excellent voltage-transmittance (V-T) curve of the ion beam aligned TN-LCD was observed with oblique ion beam exposure on the a-C:H thin film for 1 min. Also, a faster response time for the ion beam aligned TN-LCD with oblique ion beam exposure on the a-C:H thin film for 1 min can be achieved. Finally, the residual DC property of the ion beam aligned TN-LCD with ion beam exposure of 1 min on the a-C:H thin film is almost same as that of the rubbing aligned TN-LCD on a PI surface.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.8
• /
• pp.1249-1255
• /
• 2007

We have investigated the photophysical properties of dansyl-N-methylaminobenzoic acid (DABAH) as a ligand and its lanthanide (Ln3+)-cored complexes (Ln3+-(DABA)3(terpy)) in order to determine the main energy transfer pathway for sensitized near infrared emission of Ln3+ ions (Ln3+ = Nd3+ and Er3+) in Ln3+- (DABA)3(terpy). The fluorescence spectrum of DABAH shows a large Stokes shift with increasing solvent polarity. This large Stokes shift might be due to the formation of a twisted intramolecular charge transfer (TICT) state, as demonstrated by the large dipole moment in the excited state. It is in good agreement with the result that the phosphorescence even in the Gd3+-cored complex based on the DABAH ligand was not observed, maybe due to the highly forbidden character of the S1 → T1 transition in the DABAH ligand. A short decay component (ca. 1 ns) was observed in Er3+-(DABA)3(terpy) whereas the fluorescence lifetimes of DABAH and its Gd3+-(DABA)3(terpy) are observed about ~10 ns. The short component could be originated from the energy transfer process between the ligand and the Ln3+ ion. Based on the fluorescence of DABAH its Ln3+- (DABA)3(terpy), the sensitization of Ln3+ luminescence in the Ln3+-(DABA)3(terpy) takes place by the energy transfer via the TICT state of DABAH in the excited singlet state rather than via the excited triplet state.

• Korean Journal of Optics and Photonics
• /
• v.12 no.4
• /
• pp.339-344
• /
• 2001

We propose a method to represent binary data by modulating both the intensity and the phase of uniform plane waves with a twisted-nematic liquid crystal display for holographic digital data storage especially in a disk-shaped recording medium. As far as intensity modulation is concerned, our method is not different from the conventional method, because binary bit values 0 and 1 are represented by the dark (off) and lit (on) states of the liquid crystal display pixels, respectively (or vice versa). With our method, however, the on pixels are also controlled so that the beams passing through them can have one of two different phase delays. If the difference of the two phase delays is close to 180 degrees, we can reduce the dc component of the data image and thus improve the beam intensity uniformity at the holographic recording plane when Fourier plane holograms are recorded. The feasibility of our method is experimentally demonstrated. rated.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.18 no.5
• /
• pp.1235-1244
• /
• 1994

In this study, experimental results of the nucleate boling of wire-wrapped tubes are provided. Both water and R-113 were boiled. Solid stainless steel wires, stranded copper wires and stranded nylon wires were tested. Solid stainless wire is effective to enhance the boiling of water. The performance is approximately the same(or slightly better at certain conditions) as that of GEWA-T tubes. For the test range of wire diameter 0.6 $mm{\le}d{\le}2.6 mm$, the optimum gap width increases as the wire diameter increases. The maximum heat transfer coefficient was obtained for the 1.0 mm diameter wire, and it is 1.6 times larger than that of the GEWA-T at the heat flux of 20 $kW/m^{2}.$ Solid stainless wire is also effective to enhance the boling of R-113 at low heat fluxes. The performance of the wire-wrapped tube approaches that of GEWA-T. At high heat fluxes, however, the enhancement decreases. The reason may be attributed to the cavity shape and the high wettability of the refrigerants. Stranded copper or nylon wire is effective to enhance the boiling of R-113. The performance is approximately the same(or slightly better) as that of GEWA-T tubes. Maximum heat transfer was obtained for the stranded nylon wire, and it is approximately 1.4 times larger than that for the GEWA-T at the heat flux of 20 $kW/m^{2}.$ The reason may be atrributed to the favorable thermal environment in the restricted regions formed by twisted wires.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.36 no.8
• /
• pp.1010-1014
• /
• 2007

This study was designed to determine the trans fatty acid (tF A) contents of 41 take-out food items in Daejeon and Chungcheong Province. Total fatty acid composition and tFA contents of samples were determined by gas chromatography (GC) after fat extraction (Folch method). Maximum fat content among the observed samples was obtained from theater popcorn (13.74${/cdot}$38.09%) while minimum content was observed from the glutinous rice doughnut. 31${/cdot}$5.44%). The contents of tFA (g/100 g food) in toasts, glutinous rice doughnut and ggwabaegi (twisted doughnut sold in streets) ranged from 0.02 to 0.56 g while those in fried sweet potatostick (from highway resting place), fried squid and theater popcorn ranged from 0.05 to 3.08 g/100 g. As a result, most samples showed the tFA content as less than 1 g (g/100 g food) except one sample from theater popcorn which contained 3.08 g (g/100 g food) as tFA content.

• Bulletin of the Korean Chemical Society
• /
• v.27 no.12
• /
• pp.2002-2010
• /
• 2006

This study examined the quenching of ofloxacin (OFL) and flumequine (FLU) fluorescence by $Cuj^{2+}$, $Ni^{2+}$, $Co^{2+}$ and $Mn^{2+}$ in an aqueous solution. The change in the fluorescence intensity and lifetime was measured at various temperatures as a function of the quencher concentration. According to the Stern-Volmer plots, the fluorescence emission was quenched by both collisions (dynamic quenching) and complex formation (static quenching) with the same quencher but the effect of static quenching was larger than that of dynamic quenching. Large static and dynamic quenching constants for both OFL and FLU support significant ion-dipole and orbital-orbital interactions between fluorophore and quencher. For both molecules, the static and dynamic quenching constants by $Cu^{2+}$ were the largest among all the metal quenchers examined in this study. In addition, both the static and dynamic quenching mechanisms by $Cu^{2+}$ were somewhat different from the quenching caused by other metals. Between $Ni^{2+}$ and FLU, a different form of chemical interaction was observed compared with the interaction by other metals. The change in the absorption spectra as a result of the addition of a quencher provided information on static quenching. With all these metals, the static quenching constant of FLU was larger than those of OFL. The fluorescence of OFL was quite insensitive to both the dynamic and static quenching compared with FLU. This property of OFL can be explained by the twisted intramolecular charge transfer in the excited state.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.1079-1082
• /
• 2015

In Article 23 of Technical regulations for Telecommunication Line and Facilities, we have criteria of separation distance between telecommunication lines and power lines, and its related exceptional conditions. However, this is a conflicts condition with Article 32 that provides the type of indoor telecommunication cables such as twisted-pair cables and optical fiber cables. Also, it is frequently raised that exceptional condition related the PoE cables with up to 15.4W is improved to accept PoE cables with up to 30W. In this paper, we have proposed improvement plans of Technical regulations for separation distance between telecommunication lines and power lines by analyzing the variety of standard specifications at home and abroad.

• Fashion & Textile Research Journal
• /
• v.5 no.3
• /
• pp.299-303
• /
• 2003

Some of historical textiles were analyzed to identify the imprinted textures on the metal remains of Haengyeup(a horse strap pendant) and Doja (a knife), which were excavated in the ruins of Hwangsung-dong, Kyungju city in the fifth century and textiles imprinted on the human bones that were excavated in the Pungnae 4th Area, Namyangju county in the sixteenth century. The results analyzed arc as follows ; It was confirmed that the imprinted textures of Haengyeup and Doja are white ramie since the structural characteristics of cellulosic bast fibers, partially projected long oval cross sections with large lumens and the imprinted textures of human bones are silk fabrics since the triangular cross sections of fibroin is showed. All of the textiles were designed in plain weaves. In the case of weaving yarns, the warp threads were thicker than the weft threads, that is, the imprinted textures of Haengyeup were measured by 1.35 mm for warp and 1.21 mm for weft, and the Doja by 1.16mm for warp and 1.11 mm for weft. In connection with the direction of the yarn twist, the Z-twist were observed in the imprinted textures of human bones, whereas it presented the S-twist in the case of Haengyeup and Doja. The warp yarns were mostly harder twisted than the weft yarns on the amounts of twist, that is, it was observed that the case of Haengyeup were amounted to 0.33 twists per centimeter for warp yarns and 0.25 twists per centimeter for weft yarns. Also it was showed 0.32 twists per centimeter for warp yarns and 0.26 twists per centimeter in the case of the textures of human bones. On the fabric counts, it was showed that the finer the yarns the higher the densities since it were $4.3{\times}5.1$ threads per sqaure centimeters and $7.6{\times}7.1$ threads per sqaure centimeters each in the case of Haengyeup and Doja, whereas it was $18.2{\times}33.7$ threads per sqaure centimeters in the case of the textures of human bones.