• Journal of Korean Society of Transportation
• /
• v.14 no.3
• /
• pp.45-59
• /
• 1996

The shortest path algorithm for route guidance is implicitly required not only to support geometrical variations of transportation network such as U-TURN or P-TURN but to efficiency search reasonable routes in searching mechanism. The purpose of this paper is to integrate such two requirements ; that is, to allow U-TURN and P-TURN possibilities and to cut down searching time in locating routes between two points (origin and destination) in networks. We also propose a new type of link searching algorithm which can solve the limitation of vine building algorithm at consecutively left-turn prohibited intersections. The test site is a block of Gangnam road network that has some left-turn prohibited and allowed U-TURN intersections. Four models have been identified to be comparatively analyzed in terms of searching efficiency. The Models are as follows : (i) Model 1 - Link Searching Dijkstra Algorithm without Searching Area Extraction (SAE) ; (ii) Model 2 - Link Searching Dijkstra Algorithm with SAE ; (iii) Model 3 - Link Searching Bidirectional Dijkstra Algorithm without SAE ; and (iv) Model 4 - Link Searching Bidirectional Dijkstra Algorithm with SAE. The results of comparative evaluation show that Model 4 can effectively find optimum path faster than any other models as expected. Some discussions and future research agenda have been presented in the light of dynamic route guidance application of the urban ATIS.

• Journal of Korean Society of Transportation
• /
• v.8 no.1
• /
• pp.25-40
• /
• 1990

This study was undertaken to develop a traffic signal timing method for interconnected and semi-protected-left-turn intersections(the intersections which have left-turn signal but not exclusive left-turn lanes) on four-lane streets for energy saving and to computerize the method for the practical use. For this study, a probability model which could estimate the utilized time of the shared left-turn lane by through traffic during green period was developed based on field studies. The two left-turn treatments, leading and lagging left-turns, were tested for the intersections, and it can be concluded that the leading left-turn was more efficient for the normal urban streets on which through traffic is major traffic. Adopting the leading left-turn macro-models to estimate vehicular average delay and proportions of vehicles stopped at the intersections were developed. Using the two models as well as the idling fuel consumpution rate and the excess fuel consumption per stop-go speed change, a traffic signal timing method for the intersections for energy saving was developed and computerized. The method can be used for more than four-lane streets and for other measures of effectiveness such as minimum delay, minimum stop rates, etc.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.20 no.4
• /
• pp.305-312
• /
• 2015

In this study, inter-turn short fault models of interior permanent magnet synchronous motors (IPMSM) are developed by adding saliency modeling to surface-mounted permanent magnet motor models. The saliency model is obtained using the deformed flux models based on both fault-winding flux information and inductance variations caused by cross-flux linkages that depend on the distribution of the same phase windings. By assuming the balanced three-phase current injection, we obtain the positive and negative sequence voltages and the fault current in the positive and the negative synchronous reference frames. The output torque model is developed by adding the magnet and the reluctance torque, which are derived from the developed models. To verify the proposed IPMSM model with an inter-turn short fault, finite element method-based simulation and experimental measurement results are presented.

• Journal of Korean Society of Transportation
• /
• v.14 no.4
• /
• pp.91-106
• /
• 1996

This paper deals with on the efficiency questions of the left-turn prohibit at an isolated intersection and a corridor with 5-phase signal system. Its objectives are three-fold ; (1) to analyze the efficiency of the left-turn prohibit with the use of an imaginary network, (2) to evaluate various factors under consideration in decision making on the left-turn prohibit, (3) to provide a framework for estimating and evaluating overall impacts of the left-turn prohibit in traffic network. the major findings using an imaginary network and computer packages such as MINUTP, TRANSYT-7F and STATGRAPH are followings. First, left-turn prohibit reduces cycle length by 33 seconds and delay time per vehicle by 36 seconds at an isolated intersection, and cycle length by 31 seconds and delay time per veicle by 43 seconds along a corridor. Second, total vehicle mile of travel and total travel time at an isolated intersection seem up to increase 38.85 miles(57.36km), 14.4 hour on the average, Regarding to a corridor, total vehicle mile of travel is increased by 50.14 miles(80.22km), but total travel time is decreased by129.9 hours. Third, the efficiency of left-turn prohibit are affected the following eight factors including left-turn volume(veh/hr) and ratio(%), average delay time per vehicle(sec/veh) and others. Finally, several simple and multiple regression models to evaluate the impacts on the left-turn prohibit are formulated from the above eight factors. It can be expected that these models will take an important role in decision-making of left-turn prohibit.

• International Journal of Highway Engineering
• /
• v.16 no.2
• /
• pp.119-129
• /
• 2014

PURPOSES : The purpose of this study is to develop the U-turn accident model at 4-legged signalized intersections in urban areas. METHODS : In order to analyze the characteristics of the accidents which are associated with U-turn operation at 4-legged signalized intersections in urban areas and develop an U-turn accident model by regression analysis, the tests of overdispersion and zero-inflation are conducted about the dependent variables of number of accidents and EPDO (Equivalent Property Damage Only). RESULTS : As their results, the Poisson model fits best for number of accident and the ZIP (Zero Inflated Poisson) fits best for EPOD, the variables of conflict traffic, width of opposing road, traffic passing speed are adopted as independent variable for both models. The variables of number of bus berths and rate of U-turn signal time at which the U-turn is permitted are adopted as independent variable only for EPDO. CONCLUSIONS : These study results suggest that U-turn would be permitted at the intersection where the width of opposing road is wider than 11.9 meters, the passing vehicle speed is not high and U-turn operation is not hindered by the buses stopping at bus stops.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.05a
• /
• pp.65-68
• /
• 2003

Interconnected power system operation has given rise to the problem of increased fault levels and leads to over stressing of all the components. Use have been made of recently developed high Tc superconductor in devising a superconducting fault current limiter (SFCL) that promises optimum performance in terms of capital cost, size, auto sensing, operational losses, response time and reliability. Recently, research about the application of the SFCL is actively progressing in Korea. To be applied for SFCL practically, the electrical insulation design of SFCL must be developed. Therefore, this paper presents the result of an investigation of the dielectric characteristics of turn-to-turn insulation for SFCL in liquid nitrogen. The dielectric characteristics of turn-to-turn insulation models of SFCL were investigated. We obtained following results. The breakdown voltages increased as the spacer thickness and length increased. And the breakdown voltages of turn-to-turn model without spacer were higher than the breakdown voltages of turn-to-turn model with spacer under impulse as well as AC voltages. The information gathered in this test series should be helpful in the design of liquid nitrogen filled SFCL.

• Journal of Korean Society of Transportation
• /
• v.27 no.1
• /
• pp.157-167
• /
• 2009

This study deals with the turn penalty functions in the urban transportation demand forecasting. The objectives are to develop the penalty functions of left-turn traffic in the case of signalized intersections, and to analyze the applicability of the functions to the traffic assignment models. This is based on the background that the existing models can not effectively account for the delays of left-turn traffic which is bigger than that of through traffic. In pursuing the above, this study gives particular attention to developing the penalty functions based on the degrees of saturation by simulation results of Transyt-7F, and analyzing the applicability of the functions by the case study of Cheongju. The major findings are the followings. First, two penalty functions developed according to the degrees of saturation, are evaluated to be all statistically significant. Second, the results that the above functions apply to the Cheongju network, are analyzed to be converging, though the iteration numbers increase. Third, the link volumes forecasted by turn penalty functions are evaluated to be better fitted to the observed data than those by the existing models. Finally, the differences of traffic volumes assigned by two functions, which are exponential and divided forms, are analyzed to be very small.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.11a
• /
• pp.356-362
• /
• 2004

Using multi wrapped copper by polyimide film for HTS transformer, the breakdown and V-t characteristics of two type models for turn-to-turn, one is point contact model, the other is surface contact model, were investigated under ac and impulse voltage at 77 K. A material that is Polyimide film (Kapton) 0.025 mm thickness is used for multi wrapping of the electrode. Statistical analysis of the results using Weibull distribution to examine the wrapping number effects on V-t characteristics under at voltage as well as breakdown voltage under ac and impulse voltage in $LN_2$ was carried. Also, survival analysis was performed according to the Kaplan-Meier method. The breakdown voltages for surface contact model are lower than that of the point contact model, because the contact area of surface contact model is wider than that of point contact model. At the same time, the shape parameter of the point contact model is a little bit larger than the of the surface contact model. The time to breakdown tn is decreased as the applied voltage is increased, and the lifetime indices slightly are increased as the number of layers is increased. According to the increasing applied voltage and decreasing wrapping number, the survival probability is increased.

• Journal of Korean Society of Transportation
• /
• v.5 no.2
• /
• pp.19-35
• /
• 1987

Transportation energy saving is a national concern because all national petroleum energy is imported. A number of intersections are operating as semi-protected intersections, which have left-turn signal but not exclusive left-turn lanes, because of limited roadways in urban areas. Since the traffic signal methods for the intersections having left-turn signal/lanes cannot be applied to the semi-protected intersection, it is needed to develop a new technique. The purpose of this study was to develop a traffic signal timing method at semi-protected intersections for energy saving and to computerize the method for the practical use. A probability model which could estimate left-turn utilization factors of through traffic during green signal was developed based on field studies. Employing the factors, macro-models to estimate vehicular average delay and proportions of vehicles stopped at the semiprotected intersections were developed. The calculated values of the delay model agreed well with the simulated values of a simulation model using SLAM Ⅱ, a simulation language. Using the two models and the idling fuel consumption rate and the excess fuel consumption per stop-go speed change of vehicles. a traffic signal timing method at semi-protected intersections for energy saving was developed and computerized. The method can be used for other measures of effectiveness such as minimum delay, minimum stop ratio, etc.

• International Journal of Highway Engineering
• /
• v.18 no.5
• /
• pp.95-103
• /
• 2016

PURPOSES : Permitted left turn is a turning maneuver in which a vehicle turns left using a gap between oncoming vehicles, called gap acceptance, and it enables for more efficient traffic operation at intersections. In Korea, the permitted left turn has not been a common maneuver at signalized or un-signalized intersections. However, many experts and the Police Agency tried to apply this effective turning maneuver at intersections in Korea since 2010. Though the investigation of gap acceptance is significantly important in understanding a driver's behavior at intersections, there have not been many studies about this topic, specifically a study to develop probability models of gap acceptance behavior. METHODS : In this study, the probability model of gap acceptance behavior for a permitted left turn was developed based on observational field studies. To develop the model, seven variables were analyzed including gap, waiting time, traffic volume, conflict-flow vehicle type, left-turning vehicle type, the number of lane, and time. RESULTS : In the final model, gap and left-turning vehicle type were found to be significant influencing factors. CONCLUSIONS : Through this model development, it was concluded that as the gap size increased, the probability of gap acceptance was higher. Moreover, when a left-turning vehicle was a passenger car, the probability of gap acceptance was higher than compared to large size buses or freight cars.