• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2008년도 추계학술대회B
• /
• pp.2798-2803
• /
• 2008

The confined slot air jet impinging normally on a moving flat surface has been investigated numerically by using commercial CFD code Ansys CFX-V11. Turbulent flows are modeled using k-w turbulence model. Two-dimensional turbulent flow is considered. Calculations were conducted for a nozzle-to-plate spacing of eight slot nozzle width, at three Reynolds number(Re=4500, 6700 and 10,000) and four surface-to-velocity ratios i.e. 0, 0.25, 0.5 and 1. Results are compared against corresponding cases for heat transfer from a stationary plate. Local Nusselt number is calculated under constant wall temperature condition. The analysis reveals that the average Nusselt number increases considerably with the jet exit Reynolds number, but decrease with the plate velocity.

• 설비공학논문집
• /
• 제12권4호
• /
• pp.371-380
• /
• 2000

The turbulent heat transfer from a round oblique impinging jet on a concave surface were experimentally investigated. The transient measurement method using liquid crystal was used in this study. In this measurement, a preheated wall was suddenly exposed to an impinging jet while recording the response of liquid crystals to measure surface temperature. The Reynolds numbers were 11000, 23000 and 50000, nozzle-to-surface distance ratio was from 2 to 10 and the surface angles were a =$0^{\circ}\;15^{\circ},\;30^{\circ}and\;40^{\circ}$. Correlations of the stagnation point Nusselt numbers with Reynolds number, jet-to-surface distance ratio and dimensionless surface angle, which account for the surface inclined angle, are presented. The maximum Nusselt numbers, in this experiment, occurred in the direction of upstream. The displacement of the maximum Nusselt number from the stagnation point increases with increasing surface angle or decreasing nozzle-to-surface distance. In this experiment, the maximum displacement is about 0.7 times of the jet nozzle diameter when surface curvature, D/d is 10.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2006년도 제32회 KOSCO SYMPOSIUM 논문집
• /
• pp.105-110
• /
• 2006

Many previous works have been performed to provide correlations of flame length, theoretically and experimentally. Most of these results studied were conducted in vertical turbulent flame with no coaxial air condition. The present study analyzes the flame length scaling with coaxial air. In turbulent hydrogen non-premixed jet flames with coaxial air, flame length scaling theoretically proposed so far has been related with the concept of a far-field equivalent source. At high coaxial air to fuel velocity ratio, $U_A/U_F$, however, this scaling theory has some difference with experimental flame length data. This difference is understood to be due to the fact that the theory is based on far-field notion, while the effect of coaxial air on jet flame occurs in the region near the nozzle exit. Therefore, we define effective jet density $P_{eff}$ involving the concept of near-field so that effective jet diameter can be extended to the near-field region. In this condition, we modify the correlation and compare with experimental data.

• 대한기계학회논문집
• /
• 제16권12호
• /
• pp.2368-2375
• /
• 1992

본 연구에서는 축대칭 유동장치를 구성하여 열선 풍속계를 이용, 중심축에 따 른 난류쇠퇴양식을 살펴보고 동시에 난류에너지천이에 대한 세밀한 분석을 통하여 각 각 상류유동전개부, 수축부 및 자유분사류로 연속되는 3개의 유동 구조속에서 어떻게 천이해 갈 것인가를 측정하여 축대칭 유동의 난류구조 변천에 대한 기초 실험자료로 제시하고저 한다.

• 대한기계학회논문집B
• /
• 제20권3호
• /
• pp.1028-1039
• /
• 1996

This study was focused on the examination of the flame structure and the combustion characteristics of diffusion flame which was formed the turbulent shear flow of a double coaxial air jet system. The shear flow was formed by the difference velocity of surrounding air jet(U$\_$s/) and center air jet (U$\_$c/). So experimental condition was divided S-type flame (.lambda. > 1) and C-type flame (.lambda. < 1) by velocity ratio .lambda. (=U$\_$s//U$\_$c/). For examination of the flame structure and the combustion characteristics in diffusion flame, coherent structure was observed in flame by schlieren photograph method. We measured fluctuating temperature and ion current simultaneously and accomplished the statistical analysis of its. According to schlieren photograph, the flame was stabilized in the rim of the direction of lower velocity air jet, coherent eddy was produced and developed by higher velocity air jet. The statistical data of fluctuating temperature and ion current was indicated that reaction was dominated by higher velocity air jet. The mixing state of burnt gas and non-burnt gas was distributed the wide area at Z = 100 mm of C-type flame.

• 한국추진공학회지
• /
• 제9권2호
• /
• pp.97-104
• /
• 2005

많은 장점에도 불구하고 유동함수를 이용한 수치해석용 격자생성 좌표변환기법의 단점은 저속영역에서의 격자간격이 고속영역에 비해 상대적으로 큼에 따라 수치적 처리에 많은 오차를 내포하고 있다는 점이다. 본 연구에서는 이러한 저속영역에서의 단점을 보완하기 위하여 격자간격을 속도크기 및 영역에 따라 적절히 조절할 수 있도록 수학적으로 변형된 압축성 유동함수를 이용한 좌표변환기법을 제안하고 가스터빈엔진에 주로 적용되는 유동모델로서 동심원상 두개 이상의 난류제트혼합유동에 대해 적용하였으며 해당 실험치, 즉 축 방향 평균속도분포, 난류운동에너지, 그리고 난류전단응력분포와 비교하여 난류운동에너지가 약간 과소평가 된 대칭축을 제외한 혼합경계층 내에서 $3.5\%$ 이내의 신뢰성을 확보하였다. 본 기법은 특히 터보팬엔진에 대한 내부흐름들의 혼합유동을 규명하거나 또는 난류전단응력에 의한 제트소음발생 및 저감방법을 도모하는데 유용하게 활용될 것으로 기대된다.

• 대한기계학회논문집
• /
• 제12권5호
• /
• pp.1150-1157
• /
• 1988

본 연구에서는 수치계산을 통해 진행하는 방향에 수직으로 일정한 압력구배를 받는 2차원 난류 자유제트의 발달을 고려해 보고자 한다.속도장을 구한 후에는 제 트의 온도가 주위온도 보다 높을 경우와 또 제트를 사이에 둔 양쪽 유체에 온도차가 있을때의 열확산 특성도 함께 알아보려는 것이다. 수직 방향으로 압력구배가 있는 유동장은 최근 활발히 연구가 진행되는 분야인 제트축에 수직방향으로 주위유동이 있 는 경우와 흡사하며 제트를 통한 열확산현상은 air curtain등 실제 응용도가 큼에도 불구하고 문헌에 보고된 것이 별로 없는 것으로 보여진다.

• 한국전산유체공학회지
• /
• 제18권2호
• /
• pp.49-55
• /
• 2013

The goal of the research is to evaluate the open source code of OpenFOAM for the use of nuclear plant flow simulation objectively. Of the various incompressible flow solvers, simpleFoam, pimpelFoam are then tested under three validated cases (backward facing step, flow over circular cylinder and turbulent round jet flow). For the evaluation of steady state incompressible laminar flow simulation, low reynolds number of backward facing step flow was solved by simpleFoam. The resultant of the reattached lengths turned out to be similar with the other experimental and simulation results. For transient flow simulation, flow over circular cylinder and turbulent round jet flow were solved by pimpleFoam. The simulation accuracy was evaluated by comparing the resultant flow patterns with the description of the characteristics of the flow over the circular cylinder. The quantitative accuracy was evaluated for no more than 85% by comparing it to the decaying constants of the turbulent round jet velocity.

• Journal of Advanced Marine Engineering and Technology
• /
• 제18권1호
• /
• pp.81-91
• /
• 1994

Combustion noise involved with chemical heat release and turbulent process in turbopropulsion systems, gasturbine, industrial furnaces and internal engines is indeed noisy. The experimental study reported in this paper is made to identify a dominant combustion noise in jet flames. Gaseous propane and kerosene fuel have been used with air as the oxidizer in a different jet combustion systems. Combustion and aerodynamic noise are studied through far field sound pressure measurements in an anechoic chamber. And also mean temperature and velocities and turbulent intensities of both isothermal and reacting flow fields were measured. It is shown that axial mean velocity of reacting flow fields is higher about 1 to 3m/sec than that of cold flow in a gaseous combustor. As the gaseous fuel flow rate increases, the acoustic power increases. But the sound pressure level for the spray flame decreases with increasing equivalence ratio. The influence of temperature in the combustion fields due to chemical heat release has been observed to be a dominant noise source in the spray flame. The spectra of combustion noise in gaseous propane and kerosene jet flame show a predominantly low frequency and a broadband nature as compared with the noise characteristics in an isothermal air jet.

• 한국연소학회지
• /
• 제4권2호
• /
• pp.51-62
• /
• 1999

NOx formation in turbulent flames is strongly coupled with temperature, superequilibrium concentration of O radical, and residence time. This implies that in order to accurately predict NO level, it is necessary to develop sophisticated models able to account for the complex turbulent combustion processes including turbulence/chemistry interaction and radiative heat transfer. The present study numerically investigates the turbulent nonpremixed hydrogen jet flames using the laminar flamelet model. Flamelet library is constructed by solving the modified Peters equations and the turbulent combustion model is extended to nonadiabatic flame by introducing the enthalpy defect. The effects of turbulent fluctuation are taken into account by the presumed joint PDFs for mixture fraction, scalar dissipation rate, and enthalpy defect. The predictive capability of the present model has been validated against the detailed experimental data. Effects of nonequilibrium chemistry and radiative heat loss on the thermal NO formation are discussed in detail.