• Korean Journal of Adult Nursing
• /
• v.19 no.5
• /
• pp.138-149
• /
• 2007

Purpose: This study was to identify the level of quality of life in patients with woman cancer across treatment phases. Methods: The research method was a cross-sectional descriptive study. Data was collected by questionnaires from 226 female, who were in- and out-patients. They were diagnosed with breast and uterine cancer from three university hospitals and two general hospitals. The instruments used for this study included, "the Quality Of Life Scale(QOL)". The collected data were analyzed using Frequency, Percentage, ANOVA, Two-Way ANOVA. Results: Quality of life of women cancer patients was significantly different according to three treatment phases. Quality of life of women cancer patients was not significantly different according to areas of disease in the three treatment phases. Quality of life of women cancer patients was significantly different according to level of fatigue in the three treatment phases. Quality of life of women cancer patients was significantly different according to level of perceived health status in the three treatment phases(F=60.14, p=0.000). Quality of life of women cancer patients was significantly different according to education level(F=3.70, p=0.027) & occupation(F=5.67, p=0.018) in three treatment phases. Conclusion: Strategies for intervention are needed to improve the quality of life in women cancer patients across the treatment phases. The significant several characteristics of affecting on quality of life across treatment phases should be considered in sociopsychological nursing intervention.

• Journal of Powder Materials
• /
• v.17 no.1
• /
• pp.1-6
• /
• 2010

In this study, a convergent heat treatment was performed in certain temperature regions in order to control the microstructures of Nd-rich phases and to reduce thermal stress on grain boundaries which could be caused during expansion and shrinkage of Nd-rich and $Nd_2Fe_{14}B$ phases. The difference of thermal expansion coefficient between $Nd_2Fe_{14}B$ and Nd-rich phases is the mechanism for convergent heat treatment. The Nd-rich phases which were located in junctions could penetrate into the grain boundaries between $Nd_2Fe_{14}B$ phases due to the difference of thermal expansion coefficient. Through the convergent heat treatment, the microcracks that were observed in cyclic heat treatment were not observed and coercivity was increased to 34.05 kOe at 8 cycles.

• Journal of the Korean Society for Heat Treatment
• /
• v.18 no.6
• /
• pp.362-368
• /
• 2005

Formation and thermal stability of a quasicrystalline phases in Al-Fe-Mo alloys were investigated by means of melt-spinning process and subsequent heat treatment test. Thermal decomposition and phase transformation process of the as-spun alloys were studied using X-ray diffraction and electron microscopy. The melt-spun Al-Fe-Mo alloys contained an icosahedral quasicrystalline phase with a quasilattice constant of 0.457 nm. Icosahedral phase formed at a composition of $Al_{82.5}Fe_{14}Mo_{3.5}$ as a metastable phase during rapid solidification was transformed into the stable crystalline phases, cubic 1/0 approximant and monoclinic ${\lambda}$-phase, upon heating. A metastable icosahedral and cubic(a = 0.93 nm) phases in as-spun $Al_{65}Fe_{20}Mo_{15}$ alloy were decomposed into two cubic(a = 0.62, 0.31 nm) phases by heat treatment.

• Progress in Superconductivity
• /
• v.4 no.1
• /
• pp.90-93
• /
• 2002

The sintering process of BSCCO 2223 tapes is a complex process that is very sensitive to parameters, such as temperature, oxygen partial pressure, heating and cooling rate and holding time. During the first heat treatment, 2212 phase of precursor powder is partially transformed into 2223 phase and some residual secondary phases, such as $(Bi,Pb)_2$$Sr_2$CuO／sub y／(2201), $(Ca,Sr)_2$CuO／sub y／(2/1AEC), (Ca,Sr)／sub 14／Cu／sub 24／O／sub 41／(14／24 AEC) etc. The secondary phases are difficult to be removed from the BSCCO 2223 matrix on the heat treatment. These secondary phases degrade the critical current density. In order to minimize the amount and size of alkaline earth cuprate(AEC) particles step heat treatment is applied during the first heat treatment under the varying atmosphere. Experimental results showed that by adapting the step heat treatment process, the amount and particle size of the secondary phases in the final tapes are decreased. Consequently, the BSCCO 2223grain texture and Jc properties are improved.

• 대한방사선치료학회:학술대회논문집
• /
• 2005.06a
• /
• pp.13-17
• /
• 2005

Introduction : For stereotactic radiosurgery (SRS) of a tumor in the region whose movement due to respiration is significant, like Lung lower lobe, the gated therapy, which delivers radiation dose to the selected respiratory phases when tumor motion is small, was peformed using the Respiratory gating system and its clinical effectiveness was evaluated. Methode and Materials : For two SRS patients with a tumor in Lung lower lobe, a marker block (infrared reflector) was attached on the abdomen. While patient' respiratory cycle was monitored with Real-time Position Management (RPM, Varian, USA), 4D CT was performed (10 phases per a cycle). Phases in which tumor motion did not change rapidly were decided as treatment phases. The treatment volume was contoured on the CT images for selected treatment phases using maximum intensity projection (MIP) method. In order to verify setup reproducibility and positional variation, 4D CT was repeated. Result : Gross tumor volume (GTV) showed maximum movement in superior-inferior direction. For patient $\#$1, motion of GTV was reduced to 2.6 mm in treatment phases ($30\%\~60\%$), while that was 9.4 mm in full phases ($0\%\~90\%$) and for patient $\#$2, it was reduced to 2.3 mm in treatment phases ($30\%\~70\%$), while it was 11.7 mm in full phases ($0\%\~90\%$). When comparing two sets of CT images, setup errors in all the directions were within 3 mm. Conclusion : Since tumor motion was reduced less than 5 mm, the Respiratory gating system for SRS of Lung lower lobe is useful.

• Journal of the Korean Society for Heat Treatment
• /
• v.11 no.3
• /
• pp.192-199
• /
• 1998

This study was carried out to investigate the influence of variations in the temperature and time of isothermal heat treatment, applied stresses and prestrain on the isothermal transformation behavior of ${\gamma}$ and ${\sigma}$ phases and mechanical properties of 25Cr-7Ni-3Mo duplex stainless steel. The precipitation of ${\gamma}$ and ${\sigma}$ phases through isothermal heat treatment showed the type curves with a certain incubation period, the curve migrated to in a short period of time and the amount of precipitation increased with decreasing isothermal heat treatment temperature. Under the state of isothermal transformation, the precipitation of ${\gamma}$ and ${\sigma}$ phases was stimulated by applied stress, with increasing applied stress, the curves migrated to in a short period of time and also observed that the application of stress has a greater influence on the amount of ${\sigma}$ precipitation than that of ${\gamma}$ precipitation. The precipitation of ${\gamma}$ and ${\sigma}$ phases was stimulated by cold and warm rolling before isothermal heat treatment and precipitation of ${\gamma}$ and ${\sigma}$ phases has a greater influence on the warm rolling than cold rolling. The tensile strength and hardness increased with increasing cold and warm rooling reduction ratio.

• Journal of the Korean Society for Heat Treatment
• /
• v.19 no.5
• /
• pp.257-261
• /
• 2006

Scandium(Sc) in Al-Zn-Mg-Cu based Al alloy on precipitation phenomenon was compared to a 7001(Al-7.2%Zn-3.2%Mg-1.8%Cu) Al alloy. GP zone and ${\eta}^{\prime}$ phases were the main strengthening phases at low aging temperature under $100^{\circ}C$, but ${\eta}^{\prime}$ and $Al_3Sc$ phases were the main strengthening phases at high aging temperature above $1600^{\circ}C$ in Sc added 7000(Al-7.7%Zn-2.0%Mg-1.9%Cu-0.1%Zr) Al alloy. With the addition of 0.1%Sc in 7000 Al alloy, the activation energy for the GP zone, ${\eta}^{\prime}$ and ${\eta}$ phase decreased compared to the 7001 Al alloy. This result indicates that the Sc accelerated the precipitation for the GP zone, ${\eta}^{\prime}$ and ${\eta}$ phases in 7000 Al alloy. Al-7.7%Zn-2.0%Mg-1.9%Cu-0.1%Zr-0.1 Sc alloy has higher strength than 7001 Al alloy, which has high strength.

• 한국초전도학회:학술대회논문집
• /
• v.9
• /
• pp.388-391
• /
• 1999

Well oriented Bi2212 superconductor thick films were formed successfully on a copper substrate by liquid reaction between a Cu-free precursor and Cu tape method in which Cu-free BSCO powder mixture was' printed on copper plate and heat-treated. And we examined the effect of heat-treatment atmosphere for the superconducting properties and microstructure of Bi2212. The composition of Cu-free BSCO powder mixture was Bi$_2O_3$ : SrCO$_3$ : CaCO$_3$ = 1.2~2 : 1 : 1 and the heat-treatment for the superconducting formation reaction was performed in air, oxygen, nitrogen and low oxygen pressure. At heat-treatment temperature, the printing layer partially melt by reacting with CuO of the oxidizing copper plate, and the nonsuperconducting phases present in the melt are typically Bi-free phases and Cu-free phases. Among the nonsuperconducting phases, it is known that the (Sr,Ca)CuO$_3$ phase restrain the formation of the Bi2212 superconducting phase. Because a kind of the nonsuperconducting phases is controled by the oxygen partial pressure, the optimum condition in which the remnants of the second phases don't leave in the fully processed conductor was determined by XRD and the critical tempera to re (Tc) analysis.

• Korean Journal of Metals and Materials
• /
• v.50 no.10
• /
• pp.711-720
• /
• 2012

In this study, the effect of aging treatment on the microstructure and tensile properties of AZ61-xPd (x = 0, 1 and 2 wt%) alloys were investigated. The microstructure of as-cast AZ61-xPd alloys mainly consisted of ${\alpha}-Mg$, $Mg_{17}Al_{12}$ and $Al_4Pd$ phases. After solution treatment, most of the $Mg_{17}Al_{12}$ phases were dissolved into the Mg matrix. Thereafter, $Mg_{17}Al_{12}$ phases were finely formed and distributed near thermally stable $Al_4Pd$ phases and inside the grains through aging treatment at $220^{\circ}C$ during 88 hours. With the aging at $220^{\circ}C$, the peak aged AZ61-xPd alloys showed higher hardness than as-cast and solution treated AZ61-xPd alloys. In particular, the AZ61-1Pd alloy was optimized due to refined $Mg_{17}Al_{12}$ and $Al_4Pd$ phases. Further, the peak aging time was reduced with increasing Pd addition (>1 wt%). Tensile strength was increased by Pd addition at $25^{\circ}C$, $150^{\circ}C$, both as-cast and peak aged AZ61-xPd alloys. After aging treatment, room and high temperature tensile strength were increased more than the as-cast specimens. The AZ61-1Pd alloy especially showed the largest strength increase range. Elongation was decreased with addition Pd at $25^{\circ}C$ and $150^{\circ}C$.

• Research in Community and Public Health Nursing
• /
• v.32 no.2
• /
• pp.205-219
• /
• 2021

Purpose: This concept analysis was conducted to clarify 'parents' treatment adherence for an epileptic child or adolescent'. Methods: The analysis used a hybrid model comprising three phases: theoretical phase, fieldwork phase, and integration phase. In the theoretical phase, fifty studies were reviewed. Interviews with four parents of epileptic children or adolescents were conducted during the fieldwork phase. In the integration phase, the results derived from prior phases were synthesized and clarified. All phases were performed cyclically. Results: The concept, 'parents' treatment adherence for an epileptic child or adolescent' was defined as parents' voluntary and goal-directed behavior towards the epilepsy treatment for their children: a collaborative decision-making process with health-care providers, establishing a support system, adaptability to the treatment plans, and appraisals of the child's health condition. Conclusion: This achievement is thought to contribute to improving the accuracy and validity of the concept measurement. It has implications for additional research on how the concept 'treatment adherence' differs in diverse health problems and other population groups than parents of children and adolescents with epilepsy.