• Nuclear Engineering and Technology
• /
• v.54 no.11
• /
• pp.4030-4048
• /
• 2022

In this study, road transportation tests were conducted with surrogate fuel assemblies under normal conditions of transport to evaluate the vibration and shock load characteristics of spent nuclear fuel (SNF). The overall test data analysis was conducted based on the measured acceleration and strain data obtained from the speed bump, lane-change, deceleration, obstacle avoidance, and circular tests. Furthermore, representative shock response spectrums and power spectral densities of each test mode were acquired. Amplification or attenuation characteristics were investigated according to the load transfer path. The load attenuated significantly as it transferred from the trailer to the cask. By contrast, the load amplified as it transferred from the cask to the surrogate SNF assembly. The fuel loading location on the cask disk assembly did not exhibit a significant influence on the strain measured from the fuel rods. The principal strain was in the vertical direction, and relatively large strain values were obtained in spans with large spacing between spacer grids. The influence of the lateral location of fuel rods was also investigated. The fuel rods located at the side exhibited relatively large strain values than those located at the center. Based on the strain data obtained from the test results, a hypothetical road transportation scenario was established. A fatigue evaluation of the SNF rod was performed based on this scenario. The evaluation results indicate that no fatigue damage occurred on the fuel rods.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.46 no.4
• /
• pp.160-172
• /
• 2023

In contemporary global warfare, the significance and imperative of air transportation have been steadily growing. The Republic of Korea Air Force currently operates only light and medium-sized military cargo planes, but does not have a heavy one. The current air transportation capability is limited to meet various present and future air transport needs due to lack of performance such as payload, range, cruise speed and altitude. The problem of population cliffs and lack of airplane parking space must also be addressed. These problems can be solved through the introduction of heavy cargo planes. Until now, most studies on the need of heavy cargo plane and increasing air transport capability have focused on the necessity. Some of them suggested specific quantity and model but have not provided scientific evidence. In this study, the appropriate ratio of heavy cargo plane suitable for the Korea's national power was calculated using principal component analysis and cluster analysis. In addition, an optimization model was established to maximize air transport capability considering realistic constraints. Finally we analyze the results of optimization model and compare two alternatives for force structure.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.11 no.5
• /
• pp.136-146
• /
• 2012

As information technology used for simulation and virtual reality developed, there is a growing interest in animation technologies which will effectively deliver simulation results to users. Various efforts have been made to improve animation performance, like playback quality and speed, input-output speed and storage space reduction. However, earlier studies generally focused on image compression frame by frame. To significantly improve storage space and playback speed, animation data should be vectorized. Also, spatial and temporal duplication have to be removed. In this study, animation data structure was improved fundamentally through establishment of hierarchy and vectorization. Also Spatial and temporal duplication of animation data was removed through vectorization based on train route. As a result, storage space was reduced, input-output speed and playback speed were considerably improved. According to the test, additional Patternization which followed vectorization brought reduction of over 80% in storage space and input-output speed was quadrupled. Patternization technology can be used as a proper storage method of animation data, and can provide user-specific animation by small data transmission.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.12 no.6
• /
• pp.116-126
• /
• 2013

Weather factor to affect driver's driving environment are due to changes in weather conditions is caused rainfall, snowfall, fog etc and the reducing of road capacity and because deteriorating weather could be affect the headway and vehicle speed and the decrease in lane caused by an accident occurs that was analyzed that bad weather occur congestion greater than on the clear day. Bad weather to reduce of the driver's visibility was analysed the sensitive to changes in travel speed and traffic accident to appears high characteristics according to weather conditions on the expressway(higher speed) than general road. As a result, visibility have been determined to be important factor in changes of the highway traffic flow characteristics. Therefore, in this study, we selected traffic volume and travle speed that have a major impact on high-speed expressway basic segments as importance effect factor and we selected to subject of analysis among the Metropolitan Expressway that it could be obtained certain level of traffic volume data and we studied the changing of expressway traffic flow due to change visibility after the collecting of meteorological and traffic data. In order to perform this study, data collection and analysis methods were established through the existing literature and we had selected level of visibility of the expressway and we had performed the statistical verification. Finally, we had calculated the rate of change of expressway traffic flow characteristics due to visibility and we had come up with a way to apply at capacity and service level analysis.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.15 no.3
• /
• pp.34-44
• /
• 2016

This study was initiated to evaluate the performance of methodologies to estimate the space mean speed(SMS) using the time mean speed(TMS) which was collected from the vehicle detection system(VDS) in expressways. To this end, the methodologies presented in prior studies were firstly summarized. It is very hard to achieve exact SMSs and TMSs due to mechanical and communication errors in the field. Thus, a microscopic traffic simulation model was utilized to evaluated the performance. As a result, the harmonic mean and volume-distance weighted harmonic mean were close to the SMS in the case in which the TMSs of individual vehicles were used. However, when the 30-second-interval aggregated TMS were used, the volume-distance weighted harmonic mean was outstanding. In this study, a radar detector was installed in the Joongbu expressway to collect the SMS. The trajectory of individual vehicles collected from the detector were used to calculate the SMS, which was compared with the estimates using other methodologies selected in this study. As a result, the volume-distance weighted mean was turned out to be close to the SMS. However, as the congestion becomes severe. the deviation between the two speed becomes bigger.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.16 no.5
• /
• pp.121-133
• /
• 2017

Since the mid 1990s, policies have been actively promoted to improve safety and pedestrian environment around the school such as the improvement of School zone. However, the prevention of accidents was not effective because it did not extend to the school road where the main transportation route for children's commuting takes place. In addition, due to the rapid increase of automobiles, trunk road traffic in the peak time bypasses the back roads, which threatens children's safety and the environment by invading the school area, which is the main living space of children. In this study, the characteristics of domestic children's traffic accidents were investigated and the problems were analyzed by conducting a field survey on Yeouido Secondary School in Seoul and Unjung Elementary School in Gyeonggi Province. In addition, Variable speed limit signs and Beacons were installed in the pedestrian road of comunity including School zone, and the effects of facilities on the speed of vehicles were analyzed. As a result of the analysis, the Variable speed limit sign showed a deceleration effect of about 8.3km/h, and the Beacon showed a phenomenon in which the traveling speed of 0.8km/h increased only slightly. In addition, the traffic violation rate of passenger cars, buses, and lorries decreased by about 3% as a result of investigating the number of traffic violation vehicles before and after installation.

• Journal of Korean Society of Transportation
• /
• v.33 no.5
• /
• pp.461-469
• /
• 2015

The next generation high-speed train, HEMU-430X, was developed and is now being tested. However, the existing mode choice models based on the guidelines for feasibility studies do not consider a high-speed train with a higher speed than KTX. This limitation might result in inaccurate demand forecasting. In this research, a stated preference survey was conducted in order to supplement the problem by considering the characteristics of HEMU-430X. Based on the survey results, this research developed two mode choice models, including a multinomial logit model and a nested logit model. For this purpose, the utility functions of travel time and travel costs were estimated using a Limdep 8.0 NLOGIT 3.0 package. After comparing the two models, it was concluded that the nested logit model is appropriate. The paper suggested a plan to implement the nested logit model and presented a policy implication.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.19 no.2
• /
• pp.62-73
• /
• 2020

Access management is aimed at preserving the road's high intercity mobility. In urbanized areas, immoderate acceleration lane-length requirements restrict the accessibility of land. Therefore, there are many opinions to revise the minimum acceleration lane-length requirement. For this purpose, it is important to diagnose the effects of slow vehicles on the mainline. This study analyzed a single merging vehicle's total delay occurrence depending on the mainline traffic flow rate and merging speed. A linear relationship was observed between the mainline traffic flow rate and total delay. As a merging speed increases gradually from 40km/h to 100km/h in 20km/h intervals, the total delay decreases by 5.0, 1.6, and 5.1 times, respectively. This shows that the ideal condition with the total delay is less than 0.5 vehicle·sec when there is no speed difference between the mainline and merging vehicle. On the other hand, given the one-second response time of drivers, the total delay occurrence was slightly low when the speed difference between the mainline and merging vehicle was less than 20km/h.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.22 no.5
• /
• pp.74-91
• /
• 2023

Several that analyzed the effectiveness of traffic safety facilities a method of comparing changes in the number of accidents, accident severity, speed through traffic accident data before and after installation or speed data collected from vehicle detection systems (VDS). , when traffic accident data is used, it takes a long time to collect because must be collected for at least one year before and after installation. , the road environment may change during this period, such as the addition of other traffic safety facilities in addition to the facilities to be analyzed. , the location of the VDSs for speed data is often different from the location where analysis is required, and there is a problem in that the investigators are exposed to the risk of traffic accident during on-site investigation. Therefore, this study a case study by establishing a methodology to determine effectiveness video images with a drone, extracting data using a program, and comparing vehicle driving speeds before and after speed reduction facilities. Vehicle speed surveys using drones are much safer than observational surveys conducted on highways and have the advantage of tracking speed changes along the vehicle, it is expected that they will be used for various traffic surveys in the future.

• Proceedings of the KOR-KST Conference
• /
• 1996.06a
• /
• pp.131-137
• /
• 1996

This paper discusses the necessity, strategy and objectives of the rail transportation recently developed in Shanghai. The objective should not be regarded just as a term project, but should be taken as an urgent mission with the 21st century, Shanghai should possess a network of about 100km of rail transport lines. To this end, the following measures are suggested : grade separation of all lines on elevated structures ; developing the rail car industries ; full utilization of all available transportation facilities ; optimizing the use of the space resources of highways ; bringing into play the initiatives of all parties concerned. Recently, it has become a popular consensus that the development of high-speed, safe, punctual, comfortable, non-pollution rail transport with large capacity is the best and only solution to Shanghai urban transportation. In this respect, this dissertation deals with the development strategy for current Shanghai rail construction, together with the infractructure in Shanghai, positioning the developing target; meanwhile, some proposals and solutions to hit this target will be put forward for the reference of leaders and experts.