• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.3A
• /
• pp.214-220
• /
• 2006

In this paper, we propose the transmit power controlled adaptive modulated OFDM with frequency symbol spreading and equalization(TPC-AMS/FSS-OFDM) system. In the transmitter of the TPC-AMS/FSS-OFDM, each SP transformed signal is spread by orthogonal spreading codes and combined, so the detected signals obtain the same SINR(signal interference to noise ration) for each frequency symbol spreading block. In this case, we can assign the same modulation level and transmit power for each frequency symbol spreading block. Thus, the proposed system provides the increased throughput performance with reducing the total transmit power, FBI and MLI.

• Journal of Korea Society of Industrial Information Systems
• /
• v.25 no.4
• /
• pp.39-47
• /
• 2020

We propose a multi-access points transmit power control algorithm in consideration of the channel estimation error and the multi-rate service. In the real communication systems, the channel estimation at the receiver side is imperfect due to limited number of pilot symbol usage. Furthermore, the multi-rate service is supported. We theoretically prove the uniqueness and the convergence of the proposed algorithm in multi-rate service environment. The proposed algorithm composes of one inner loop part and one outer loop part. Simulation results show that 1) the inner loop algorithm guarantees convergence of the transmit power level and the multi-rate service, 2) the outer loop algorithm compensates for the channel estimation error.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.7
• /
• pp.1271-1277
• /
• 2008

This paper proposes the code acquisition scheme on a MIMO channel for preamble search in a CDMA-MIMO uplink system. The multiple transmit/receive antennas are used for beamforming. The performance of a ML code acquisition technique based on transmit and receive beamforming is analyzed by considering rho detection probability. The acquisition performance and MAT for a MIMO code acquisition system are numerically evaluated. It is shown that multiple transmit antennas can give the code acquisition system a transmit beamforming gain and result in much better performance than a SIMO case.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.15 no.4
• /
• pp.1568-1589
• /
• 2021

Deployment of access point (AP) is a problem that must be considered in network planning. However, this problem is usually a NP-hard problem which is difficult to directly reach optimal solution. Thus, improved AP deployment optimization scheme based on swarm intelligence algorithm is proposed to research on this problem. First, the scheme estimates the number of APs. Second, the multi-objective particle swarm optimization (MOPSO) algorithm is used to optimize the location and transmit power of APs. Finally, the greedy algorithm is used to remove the redundant APs. Comparing with multi-objective whale swarm optimization algorithm (MOWOA), particle swarm optimization (PSO) and grey wolf optimization (GWO), the proposed deployment scheme can reduce AP's transmit power and improves energy efficiency under different numbers of users. From the experimental results, the proposed deployment scheme can reduce transmit power about 2%-7% and increase energy efficiency about 2%-25%, comparing with MOWOA. In addition, the proposed deployment scheme can reduce transmit power at most 50% and increase energy efficiency at most 200%, comparing with PSO and GWO.

• Korean Journal of Acupuncture
• /
• v.34 no.3
• /
• pp.109-115
• /
• 2017

Objectives : Many researches have studied warm needling technique to standardize its treatment by temperature measurement and material differences in the effectiveness. The purpose of this study is to compare the temperature changes of the acupuncture needle shaft during the combustion process of the moxa stick to determine the heat transfer pattern of the warn needling. Methods : A moxa stick($7{\times}8mm$) was connected to one side of the needle shaft using a stainless steel needle(ø 0.3 mm, ø 0.5 mm, ø 0.8 mm, shaft length 40 mm) with the needle handle removed. During the warm needling, temperature changes of the needle shaft were observed with an infrared camera(Flir E30) and an infrared thermometer(TESTO 845). Results : In the normal condition, heat transmit of needle shaft increased at spots 10 mm and 25 mm below the moxa stick. The amount of heat transmit increased with the diameter of needle shaft. However, when the heat shield was installed to exclude radiant heat from the moxa stick, heat transfer was less at 10 mm below the moxa stick and no temperature change was observed at 25 mm below the moxa stick. Heat transfer by warm needling does not reach the end of needle shaft even in ø 0.8 mm needle. Conclusions : It is suggested that the radiant heat of moxa stick results in the heat transmit of acupuncture needle shaft. Thus, radiant heat transmit must be considered as one of the heat transfer characteristics of the warm needling.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.12
• /
• pp.2417-2424
• /
• 2016

Small size and light weight is very important for components used in radar mounted platform such as airborne radar. Recently, the active phased array radar is developed as an array of antennas for thousands of transmit/receive modules to be used as a multi-function radar that can detect and track targets. In this case, the size and weight of the transmit/receive modules are critical factor for developing the radar. In this paper, we developed a compact transmit/receive module using the 10W RF MEMS switch domestically localizing and reduced the circuit area to about 86.5% compared to using a circulator. The developed module satisfies not only electrical requirements but also MIL-STD's environmental specifications. So it can be used in a military device. It can be used at adaptive tunable receivers, reconfigurable smart active antennas and wide band beam electrical steering antennas.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.9A
• /
• pp.749-754
• /
• 2005

It is well-known that mobile communication systems are usually limited in their performance and capacity by three major impairments, which are multipath fading, delay spread and co-channel interference (CCI). OFDMA (OFDM-FDMA) system can cope with the multipath fading and delay spread easily due to the beneficial properties of OmM technology. Though OFDMA scheme avoids intra-cell interference using the orthogonality among subcarriers, the scheme contains difficulty of reducing co-channel interference. Therefore, in this paper, adaptive antenna techniques are deployed into OFDMA/TDD system to minimize the co-channel interference induced by adjacent cells and to enhance the uplink performance. For the improvement of downlink performance, we apply TxAA (Transmit Adaptive Array), a kind of transmit diversity technique, utilizing preamble symbols for training antenna may into OFDMA/TDD transmitter side. Simulation results show that the uplink and downlink performance under multipath Rayleigh fading channel improved 9dB and 7dB each compared with the case of single antenna system at target BER $10^{-3}$ .

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.8C
• /
• pp.762-768
• /
• 2005

This paper proposes new space-time block codes achieving full rate and full diversity for QAM and quasi-static Rayleigh fading channels when using any number of transmit antennas larger than 3 transmit antennas. These codes are constructed by serially concatenating the constellation rotating $precoders^{[4,5]}$ with the Alamouti scheme$3^{[3]}$ Bike the conventional A-ST-CR code$^{[6,7]}$. Computer simulations show that the proposed codes achieve approximately 1.3dB, 1.4dB and 1.5dB larger coding gains than the ST-CR $codes^{[4,5]}$ for QPSK with 3, 4 and 5 transmit antennas, respectively, and about 3dB for 16QAM with 3 transmit antennas.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.1B
• /
• pp.56-65
• /
• 2002

This paper proposes a novel transmit diversity technique, namely symbol split orthogonal transmit diversity (SS-OTD). In this technique, full path diversity and temporal diversity are achieved by combining orthogonal transmit diversity technique (OTD) technique with the symbol splitting method proposed by Meyer. Its performances is simulated for fundamental channels associated with the forward link of the IS-2000 system, and then compared with those of OTD and space-time spreading (STS). Our proposed method offers a 0.5-7.7dB performance improvement over OTD under various simulation environments and its performance is similar to STS. Moreover, compares with that of STS, the peak-to-average power ratio (PAR) of transmitted signals in SS-OTD is reduced by a maximal 1.35dB, which decreases the complexity of base station RF devices, such as power amplifiers. Thus, SS-OTD is comparable to STS in performance and superior to STS in the cost and efficiency of base station RF devices.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.9
• /
• pp.685-697
• /
• 2017

In this paper, it is presented the result of design and fabrication for C-band solid state high power amplifier unit and components using in search radar. The solid state power amplifier(SSPA) assembly was fabricated using GaN(Gallium Nitride), which is semiconductor device, and the transmit signal output power of the solid state high power amplifier unit is generated by combining the transmit signal power of the solid state power amplifier configured in parallel through a design and fabricated waveguide type transmit signal combine assembler. Designed solid state high power amplifier unit demonstrated C-band 500 MHz bandwidth, maximum 10.5% duty cycle, transmit pulse width from $0.0{\mu}s{\sim}000{\mu}s$, and transmit signal power is 44.98 kW(76.53 dBm).