• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.12B
• /
• pp.1066-1074
• /
• 2008

In this paper, we proposed an efficient algorithm using pulse signal based on group-node-contention in LR-WPAN. The purpose of IEEE 802.15.4 is low speed, low cost and low power consumption. Recently, as applications of LR-WPAN have been extended, there is a strong probability of collision as well and almost collision occurs because of hidden node problem. Moreover, if the collision continuously occurs due to hidden node collision, network performance could be decreased. Nowadays, although several papers focus on the hidden node collision, algorithms waste the channel resource if continuous collisions frequently occur. In this paper, we assume that PAN has been already formed groups, and by using pulse signal, coordinator allocates channel and orders, and then, nodes in the allocated group can compete each other. Hence, contention nodes are reduced significantly, channel wastage caused by collision is decreased, and data transmission rate is improving. Finally, this algorithm can protect the network from disruption caused by frequent collisions. Simulation shows that this algorithm can improve the performance.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.10 no.2
• /
• pp.184-191
• /
• 2017

This paper presents cluster based hybrid spectrum sensing system for M2M services. For each cluster, secondary nodes within the transmission radius of the primary node use hard decision method through local spectrum sensing to determine whether the primary node exists. And the other secondary nodes and the secondary nodes having poor radio channel conditions judge the existence of the primary node through the soft decision method of the values obtained by performing the cooperative spectrum sensing. In the proposed hybrid spectrum sensing system, the performance according to the number of secondary nodes is analyzed with the conventional system over Rayleigh fading channel. As the number of cooperative sensing users increased to 2, 3 and 4, the cluster error probability decreased to 0.5608, 0.5252 and 0.4001 at SNR of -10[dB] respectively. Since the proposed system uses less overhead traffic, it is found that it is more effective in terms of frequency usage than the conventional system using soft decision-soft decision and soft decision-hard decision methods.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.2
• /
• pp.269-276
• /
• 2016

Internet of Things (IoT) is based on wireless networks being able to connect things and people on a large scale. In the IoT environment, reliable broadcast plays an important role to distribute data to a large number of devices. Energy harvesting from a surrounding environment is a key technique to achieve a sustainable IoT network. In IoT networks, a problem of transmission errors and energy shortage should be mitigated for reliable broadcast. In this paper, we propose an energy-efficient and reliable broadcast method to consider packet errors and energy consumption in the environment where a large number of nodes are connected. The proposed scheme can improve data restoration probability by up to 15% and reduce energy consumption by up to 17%.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.10
• /
• pp.965-976
• /
• 2012

Multi-Platform Image and Intelligence Common data link(MPI-CDL) systems are designed to transmit the imaginary and signal intelligence data at an aeronautical to ground line of sight(LOS) link. This paper proposes a method to predict a link availability and analyzes the required link margin to satisfy a given link availability for MPI-CDL systems. To estimate a link availability the proposed method applies the conditional probability so that both a rain attenuation and a multipath fading are considered simultaneously. Link margins to meet the link availability for MPI-CDL systems are calculated according to an operating environment including frequencies, flight altitudes and transmission ranges. The required link margins for actual unmanned air vehicle systems are also given by simulation results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37A no.12
• /
• pp.1013-1022
• /
• 2012

Tag collection is one of the major concerns in radio frequency identification(RFID) system. All tags in RFID reader's transmission range send response message back to the reader in response to collection request message on the given rf channel. When multiple tags respond simultaneously, tag-collision may occur. Tag-collision problem is one of the most important issues in active RFID performance. To mitigate this problem, frame slotted ALOHA(FSA) anti-collision protocol is widely used in active RFID system. Several studies show that the maximum system efficiency of FSA anti-collision protocol is 36.8%. In this paper, we propose an efficient slotted CSMA/CA protocol to improve tag collection performance. We compare our protocol to the FSA anti-collision protocol. For the experiment, an 433MHz active RFID system is implemented, which is composed of an RFID reader and multiple tags. We evaluated the tag collection performance using one RFID reader and 40 tags in the real test bed. The experimental result shows that proposed protocol improves the tag collection time, round and collision probability by 18%, 37.4% and 77.8%, respectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.8A
• /
• pp.787-793
• /
• 2008

3GPP evolved packet system (EPS) is an all-IP based system that supports various access networks such LTE, HSPA/HSPA+, and non-3GPP networks. Recently, the support of IP flows with packet level QoS profiles was added to the requirements of the EPS. This paper proposes an adaptive modulation and coding (AMC) scheme that supports the QoS of such IP flows in the 3G LTE access network of the EPS. Defining the retransmission as a critical factor for QoS, the proposed scheme applies different maximum packet error probability $P_{max}$ to each packet when selecting the AMC transmission mode. In determining $P_{max}$, the QoS constraints and NACK-to-ACK error as well as channel condition are considered, balancing two objectives: the satisfaction of the QoS and the maximization of spectral efficiency. The simulation results show that it is able to reduce both delay violation and status report by 10%, while improving the throughput 10% in comparison with an existing scheme.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.8
• /
• pp.1752-1758
• /
• 2010

A FM-CW radar is used for the various purposes as a remote sensing device since it has the advantages of the relatively simple implementation and the low probability of signal interception. A FM-CW radar uses the same frequency modulated continuous wave for both transmission and demodulation. Therefore, the received beat frequency represents the range and Doppler information of targets. However, using the conventional FFT method, the degree of accuracy and resolution in the spectrum estimation can be seriously degraded in the detection and tracking of fast moving targets because of the short dwell time. Therefore, in this paper, the model parameter estimation methods called as an autoregressive method is applied to overcome these problems and showed that the improved accuracy and resolution can be obtained for the target range and velocity estimation.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.10
• /
• pp.4661-4680
• /
• 2016

Cognitive radio (CR) technology is an effective solution to the spectrum scarcity issue. Collaborative spectrum sensing is known as a promising technique to improve the performance of spectrum sensing in cognitive radio networks (CRNs). However, collaborative spectrum sensing is vulnerable to spectrum data falsification (SSDF) attack, where malicious users (MUs) may send false sensing data to mislead other secondary users (SUs) to make an incorrect decision about primary user (PUs) activity, which is one of the key adversaries to the performance of CRNs. In this paper, we propose a coalition based malicious users detection (CMD) algorithm to detect the malicious user in CRNs. The proposed CMD algorithm can efficiently detect MUs base on the Geary'C theory and be modeled as a coalition formation game. Specifically, SSDF attack is one of the key issues to affect the resource allocation process. Focusing on the security issues, in this paper, we analyze the power allocation problem with MUs, and propose MUs detection based power allocation (MPA) algorithm. The MPA algorithm is divided into two steps: the MUs detection step and the optimal power allocation step. Firstly, in the MUs detection step, by the CMD algorithm we can obtain the MUs detection probability and the energy consumption of MUs detection. Secondly, in the optimal power allocation step, we use the Lagrange dual decomposition method to obtain the optimal transmission power of each SU and achieve the maximum utility of the whole CRN. Numerical simulation results show that the proposed CMD and MPA scheme can achieve a considerable performance improvement in MUs detection and power allocation.

• KIPS Transactions on Computer and Communication Systems
• /
• v.10 no.10
• /
• pp.269-276
• /
• 2021

Recently, smart sensors are used in various environments, and the implementation of ad-hoc sensor networks (ASNs) is a hot research topic. Unfortunately, traditional sensor network routing algorithms focus on specific control issues, and they can't be directly applied to the ASN operation. In this paper, we propose a new routing protocol by using the Q-learning technology, Main challenge of proposed approach is to extend the life of ASNs through efficient energy allocation while obtaining the balanced system performance. The proposed method enhances the Q-learning effect by considering various environmental factors. When a transmission fails, node penalty is accumulated to increase the successful communication probability. Especially, each node stores the Q value of the adjacent node in its own Q table. Every time a data transfer is executed, the Q values are updated and accumulated to learn to select the optimal routing route. Simulation results confirm that the proposed method can choose an energy-efficient routing path, and gets an excellent network performance compared with the existing ASN routing protocols.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.3
• /
• pp.215-222
• /
• 2019

A frequency hopping(FH) signal can change its carrier frequency during transmission and has spread-spectrum characteristics in these frequency bands. Therefore, FH signals are widely used in applications that require low-probability-of-intercept(LPI) and anti-jamming (AJ) abilities in wireless communication environments. In this study, the authors propose a method for generating hopping information (HI), which includes start time, dwell time, and hopping frequency for unknown FH signals. The proposed blind HI generation method produces signal detection information based on the spectrum data and then extracts HI using operational procedures for estimating the target FH signal's status, such as appearance, maintenance, and termination. Further, simulation results demonstrate that the proposed method provides accurate HI without detection omissions for various FH signals.