• Journal of Mechanical Science and Technology
• /
• v.18 no.9
• /
• pp.1668-1679
• /
• 2004

The design of an axial piston pump for electro-hydrostatic transmission systems requires accurate information where and how much the internal friction and flow losses are produced. This study is particularly focused on the friction losses of a bent-axis type hydraulic piston pump, aiming at finding out which design factors influence its torque efficiency most significantly. To this end, the friction coefficients of the pump parts such as piston heads, spherical joints, shaft bearings, and valve plate were experimentally identified by a specially constructed tribometer. Applying the experimental data to the equations of motion for pistons as well as to the theoretical friction models for the pump parts, the friction torques produced by them were computed. The accuracy of the computed results was confirmed by the comparison with the practical input torque of the pump. In this paper, it is shown that the viscous friction forces on the valve plate and input shaft bearing are the primary source of the friction losses of the bent-axis type pump, while the friction forces and moments on the piston are of little significance.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.12
• /
• pp.1269-1274
• /
• 2014

Since power and control cables have narrow bandwidth due to their loss at high frequencies, it is difficult to detect the weak fault using conventional reflectometry. It is because the reflected wave caused by the weak fault is overlapped and hidden by the ripple of the strong reflected wave from the end of the cable. This paper proves that the reflected wave from the weak fault can be considered to be linearly superposed on the strong reflected wave from the end of the cable based on the transmission line theory. Then, the weak fault point is experimentally diagnosed using the difference between reflection coefficients before and after the fault generation.

• Wind and Structures
• /
• v.11 no.4
• /
• pp.303-321
• /
• 2008

When first commissioned, the 1.6 km span 275kV Severn Crossing Conductor experienced large amplitude vibrations in certain wind conditions, but without ice or rain, leading to flashover between the conductor phases. Wind tunnel tests undertaken at the time identified a major factor was the lift generated in the critical Reynolds number range in skew winds. Despite this insight, and although a practical solution was found by wrapping the cable to change the aerodynamic profile, there remained some uncertainty as to the detailed excitation mechanism. Recent work to address the problem of dry inclined cable galloping on cable-stayed bridges has led to a generalised quasi-steady galloping formulation, including effects of the 3D geometry and changes in the static force coefficients in the critical Reynolds number range. This generalised formulation has been applied to the case of the Severn Crossing Conductor, using data of the static drag and lift coefficients on a section of the stranded cable, from the original wind tunnel tests. Time history analysis has then been used to calculate the amplitudes of steady state vibrations for comparison with the full scale observations. Good agreement has been obtained between the analysis and the site observations, giving increased confidence in the applicability of the generalised galloping formulation and providing insight into the mechanism of galloping of yawed and stranded cables. Application to other cable geometries is also discussed.

• Journal of the Korea Computer Industry Society
• /
• v.3 no.9
• /
• pp.1287-1294
• /
• 2002

The algorithm method for progressive image coding based on discrete wavelet transform presented in a paper. After discrete wavelet transform and extract edge information through edge detection, and then designed efficient coding method more then established embedded coding algorithm using expanded EZW algorithm. Generally, edges have a relatively higher influence on image reconstruction. Occurred DWT on image, and can classify significant coefficients and non-significant coefficients. Using property that edge part has appeared significant coefficient in the paper. Especially, we confirmed that higher frequency sub region on DWT image present homogenous direction property. And on embedded coding, which are effective and well-directed information have higher priority to image reconstruction on transmission. Therefore, our technique algorithm system perform better than that of the conventional method such as progressive image coding application.

• Proceedings of the KIEE Conference
• /
• summer
• /
• pp.607-609
• /
• 2004

A breakdown occurred in power transformer causes interruption of power transmission. Protective relay should be installed in transformer to detect such a fault. Protective relaying algorithm for transformer must be included a function to discriminate between winding fault and inrushing state. Recently, current differential relay is widely used to protect power transformer. However if inrush occurs in transformer, relay can be tripped by judging as internal fault. New algorithms are required in order to such problem. This study proposes a new protective relaying algorithm using Neuro-Fuzzy inference and wavelet. A variety of transformer transient states are simulated by BCTRAN and HYSDT in EMTP. D1 coefficients of differential current are obtained by wavelet transform. D1 coefficients and RMS of 3-phase primary voltage are used to make a target data and are trained by Nwo-Fuzzy algorithm which distinguishes correctly whether internal fault occurs or not within 1/2 after fault detection. It is evaluated that the results obtained by simulations can effectively protect a transformer by contact discriminating between winding fault and inrushing state.

• Nuclear Engineering and Technology
• /
• v.48 no.5
• /
• pp.1230-1236
• /
• 2016

This study aims to determine the effect of fly ash with a high replacing ratio of clay on the radiation shielding properties of bricks. Some interaction parameters (mass attenuation coefficients, half value layer, effective atomic number, effective electron density, and absorption efficiency) of clay fly ash bricks were measured with a NaI(Tl) detector at 661.6 keV, 1,173.2 keV, and 1,332.5 keV. For the investigation of their shielding behavior, fly ash bricks were molded using an admixture to clay. A narrow beam transmission geometry condition was used for the measurements. The measured values of these parameters were found in good agreement with the theoretical calculations. The elemental compositions of the clay fly ash bricks were analyzed by using an energy dispersive X-ray fluorescence spectrometer. At selected energies the values of the effective atomic numbers and effective electron densities showed a very modest variation with the composition of the fly ash. This seems to be due to the similarity of their elemental compositions. The obtained results were also compared with concrete, in order to study the effect of fly ash content on the radiation shielding properties of clay fly ash bricks. The clay fly ash bricks showed good shielding properties for moderate energy gamma rays. Therefore, these bricks are feasible and eco-friendly compared with traditional clay bricks used for construction.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.8
• /
• pp.19-26
• /
• 1999

umerical simulations are performed to estimate how strongly the manufacturing error of an open-ended coaxial probe affects its measured complex permittivity of a contacted medium. The reflection coefficients of several dielectric materials contacted with an open-ended coaxial probe are calculated by employing the FDTD method. And then those complex permittivities are reconstructed by applying the calculated reflection coefficients into a new imaginary transmission-line model, which reveals more physically meaningful than the conventional model. It is found that the reconstructed complex permittivities suffer from significant error in spite of a slight imperfection of open-ended coaxial probe.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.1
• /
• pp.105-113
• /
• 2000

This paper proposes the optimal design method of PSF(pulse shaping filter) with fixed-point coefficients, often used in digital communication system. Though RCF (Raised Cosine Filter) and Root-Squared RCF have less attenuation in stopband and are designed with floating point coefficients, those are selected by the reason that the design is simple. In this paper, 1 introduce the optimal design method for fixed point PSF including Root Squared type by using mixed integer linear programming. Through some design examples, it is shown that the proposed method better performs in ISI and requires less complexity. The complexity of the proposed filter is reduced to 20% as compared to conventional RCF and Root Squared RCF. For IS-95, that is the standard of CDMA system, the proposed filter reduces ISI up to 75% compared to the standard transmission filter.

• Nuclear Engineering and Technology
• /
• v.54 no.2
• /
• pp.701-708
• /
• 2022

The mass attenuation coefficients (μ_m) of polyethylene glycol (PEG) of different molecular weights (1000-200,000) were measured using single-beam photon transmission. The X-ray fluorescent (XRF) photons from Zinc (Zn), Zirconium (Zr), Molybdenum (Mo), Silver (Ag) and Cadmium (Cd) targets were used to determine the attenuation of gamma radiation of energy range between 8.67 and 23.19 keV in PEG samples. The results were compared to theoretical values using XCOM and Monte Carlo simulation using Geant4 toolkit which was developed to validate the experiment at those certain energies. The mass attenuation coefficients were then used to compute the effective atomic numbers, electron density and half value layers for the studied samples. The outcomes showed good agreement between experimental and simulated results with those calculated theoretically by XCOM within 5% deviation. The PEG 1000 sample showed slightly higher μ_m value compared with the other samples. The dependence of the photon energy and PEG composition on the values of μ_m and HVL were investigated and discussed. In addition, the values of Z_eff and N_eff for all PEG samples behaved similarly in the given photon energy range, and they decreased as the photon energy increased.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.23 no.1
• /
• pp.37-43
• /
• 2023

Compressed still image or video bitstreams require protection from channel errors in a wireless channel. Embedded Zerotree Coding(EZW), SPIHT could have provided unprecedented high performance in image compression with low complexity. If bit error is generated by dint of wireless channel transmission problem, the loss of synchronization on between encoder and decoder causes serious performance degradation. But wavelet zerotree coding algorithms are producing variable-length codewords, extremely sensitive to bit errors. The idea is to partition the lifting coefficients. A many partition of lifting transform coefficients distributes channel error from wireless channel to each partition. Therefore synchronization problem that caused quality deterioration in still image and video stream was improved.