• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.64 no.8
• /
• pp.1145-1153
• /
• 2015

The paper analyzes reactive power flow characteristic in power system by reactive power tracing. In addition, virtual buses are inserted in the algorithm to consider losses of transmission lines, and shunt capacitor treated as a reactive power generator. The results of simulation are analyzed by two points of view. The one is load’s point of view and another is generator’s point of view. Classic purpose of the reactive power tracing consists in the reactive power pricing. However, it is significantly used to select vulnerable area about line outage in this paper. To find the vulnerable area, reactive power tracing variations between pre-contingency and post-contingency are calculated at all load buses. In heavily load area, buses which has highest variation become the most vulnerable bus. This method is applied to the IEEE 39-bus system. It is compared with voltage variation result and VQ-margin to verify its effect.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.5B
• /
• pp.357-364
• /
• 2012

In Visible Light Communication (VLC) system, with the limitation of transmission range and Field Of View (FOV), LOS (Line of Sight) link between two transceivers should be guaranteed due to the straightness of the visible-light signal. Especially for indoor applications, link recovery is an advantage method to remain the link connection because of the link failure in which caused by movement obstacle. Link recovery schemes try to keep link dynamically without re-initialing connection. This article proposes a new link recover scheme for VLC system by using cooperative communication. Our propose scheme focuses on the QoS reservation resource by GTS in IEEE 802.15.7 specification in which the requested QoS resource from client should be guarantee during the application time. With the link recovery scheme, we will try to continue the link connection as long as possible when unexpected disconnect link. The mathematical analysis and simulation results show that proposed scheme increases the overall reliability of the VLC system.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.51 no.8
• /
• pp.354-360
• /
• 2002

The partial discharge detecting method using the ultrasonic technique has been investigated to monitor the insulation ageing of a transformer. However, the result of the studies on the ultrasonic technique for detecting of partial discharge in the operating transformer is not enough yet to utilize. This paper presents the analysis of the ultrasonic signals due to the partial discharge in a model transformer and the corona in air at a shielded high voltage room. In addition, the ultrasonic signals due to the vibration from the core, operation of the cooling pump, the fan and the OLTC at the 345㎸ power transformer, were analyzed and corona noise from overhead transmission line in 345㎸ substation were measured to remove the electrical and mechanical noises from the transformer. Furthermore, ultrasonic signal due to the partial discharge in the 154㎸ power transformer with in $C_2$$H_2$ gas warning condition was measured. The inside of the transformer was examined with care. which confirms the existence of the partial discharge source.

• Proceedings of the KIEE Conference
• /
• 1998.07c
• /
• pp.1082-1084
• /
• 1998

In this paper, we developed a diagnosis device for ZnO arrester to detect on-line leakage current and acquire data from the power distribution system. The arrester is important power equipment used in power transmission and distribution systems to protect the generator and the main transformer from surge and overvoltage. First of all we developed a diagnosis device for ZnO arrester leakage current. And then we detect the total leakage current by the developed device without disconnecting the arrester ground wire and analysis the 3rd order harmonic by Fast Fourier Transform(FFT) to diagnose the ZnO arrester deterioration. With measuring the total current and the resistive current of power distribution system in operation, we analysis the trend of resistive current component in the total leakage current. We expect the result will be promote the method to protect electrical utility and customer from accident.

• ETRI Journal
• /
• v.38 no.1
• /
• pp.1-8
• /
• 2016

A large incoherent crosstalk (IC) caused by amplified spontaneous emission (ASE) noise power from Tx-disabled optical network units and a differential path loss has been shown to degrade upstream transmission performance in time-division multiplexing passive optical networks. This paper considers the IC-induced power penalty of an upstream signal both in an XG-PON and in a TWDM-PON. We investigate the degradation of the extinction ratio and relative intensity noise through a simulation and experiments. For the XG-PON case, we observe a 9.6 dB difference in the level of ASE noise power from Tx-disabled ONUs (hereafter known simply as ASE noise) between our result and the ITU-T XG-PON PMD recommendation. We propose an optical filtering method to mitigate an IC-induced power penalty. In the TWDM-PON case, the IC-induced power penalty is naturally negligible because the ASE noise is filtered by a wavelength multiplexer at the optical line terminal. The results provide design guidelines for the level of ASE noise in both XG-PONs and TWDM-PONs.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.9B
• /
• pp.1635-1640
• /
• 2000

In this paper, a 18 GHz oscillator is designed with the push-push method an fabricated by semi-MMIC process, in which the second harmonic is the main output signal with the suppressed fundamental mode. In semi-MMIC process, passive components with microstrip transmission line are implemented using MMIC process on semi-insulating GaAs substrate. Then, chip types of P-HEMT, resistors, and capacitors are connected through Au wire-bonding. Also, the ground plane is inserted around the circuit and connected each other with the back-side of substrate through Au wire-bonding instead of via-hole. The semi-MMIC push-push oscillator shows the output powder of -10.5 dBm, the fundamental frequency suppression of -17.3 dBc/Hz, and the phase noise of -97.9 dBc/Hz at the offset frequency of 100 kHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.1
• /
• pp.8-15
• /
• 1998

In this paper, to improve the bandwidth of microstrip antenna, we discussed parasitic patch structure coupled capacitively at radiating slot. To reduce the overal size of antenna,$\lambda$/4 short structure is accepted instead of $\lambda$/2 patch. Since ground plane is reduced, backward radiation is occurred. The characteristics of the designed antenna is evaluated, based on the transmission line model and the aperture analysis method. And by computer program the radiation pattern and return loss are evaluated. As simulation results, backward radiation is -15 dB. Bandwidth of constructed antenna is 167 MHz at the resonant frequency of 2.45 GHz, which is very broad, compared to conventional microstrip antennas. Therefore the proposed antenna will be suitable for very wide bandwidth communications.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.2
• /
• pp.257-265
• /
• 2011

As the competitive market system has been introduced to the electrical power trade, the priority concern would be that the price of electrical power should be reasonable. It is because, when this rule is solid, we can avoid the distortion of competition and assure the greater efficiency in management. LMP(Locational Marginal Price) means marginal price at each bus. This components consist of energy, loss and congestion cost. At this point, the LMP result that is calculated by traditional model is changeable by the location of the slack and can not be used in bilateral Transaction. This paper proposed algorithm is proved its rationality and credibility by comparing the result of the simulation of virtual 6_bus system that is calculated by traditional method, and showed that the LMP components are changed according to the Transaction Strategy. Furthermore, It shows the effect of additional congestion cost on the transmission line that has bottle neck frequently by simulation.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.5
• /
• pp.1769-1777
• /
• 2018

This paper proposes a method for optimal placement of Phasor Measurement Units (PMUs) considering system configuration and its attributes during the planning phase of PMU deployment. Each bus of the system is assessed on four diverse attributes; namely, redundancy of measurements, rotor angle and frequency monitoring of generator buses, reactive power deficiency, and maximum loading limit under transmission line outage contingency, and a consolidated 'degree of criticality' is determined using Technique for Order of Preference by Similarity to Ideal Solution (TOPSIS). The major contribution of the proposed work is the development of modified objective function which incorporates values of the degree of criticality of buses. The problem is formulated as maximization of the aggregate degree of criticality of the system. The resultant PMU configuration extends complete observability of the system and majority of the PMUs are located on critical buses. As budgetary restrictions on utilities may not allow installation PMUs even at optimal locations in a single phase, multi-horizon deployment of PMUs is also addressed. The proposed approach is tested on IEEE 14-bus, IEEE 30-bus, New England (NE) 39-bus, IEEE 57-bus and IEEE 118-bus systems and compared with some existing methods.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.5
• /
• pp.1085-1092
• /
• 2010

This paper describes the development of estimating equation for under 16 aged children's exposure to habitat's magnetic field for 24 hours by using particle swarm optimization(PSO) algorithm, which was carried out by using the measured database collected from the exposure survey to Korean habitat's magnetic field as to under 16 aged Korean students such as preschooler, children in elementary school, and children in middle school. Sex, age, residence type, size of habitation site, distance from power line, and power transmission voltage are used as the input data of estimating 24 hour's personal exposure to magnetic field. And distribution of 24 hour's personal exposure to magnetic field, exposure characteristic to magnetic field, and exposure characteristic to magnetic field according to special conditions, are analyzed for under 16 aged children.