• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.3C
• /
• pp.271-280
• /
• 2008

M channel near-perfect-reconstruction(NPR) pseudo-QMF banks are a hybrid of conventional pseudo-QMF design and spectral factorization approach where the analysis and synthesis filters are cosine-modulated versions of the prototype-lowpass filter(p-LPF). However, p-LPF H(z) does not have linear-phase symmetry as well as magnitude-distortion optimization since it is obtained by spectral factorization of $2M^{-th}$ band filter $G(z)=z^{-(N-1)}H(z^{-1})H(z)$. A fair amount of attention, therefore, has been focused on the design of filter banks for reducing only alias-cancellation distortion without reconstructed-amplitude distortion. In this paper, we propose a new method for designing linear-phase p-LPF in NPR pseudo-QMF banks, which is based on Maxflat(maximally flat) FIR filters with closed-form transfer function. In addition, p-LPF H(z) is optimized in this approach so that the 2M-channel overall distortion response represented with $G(z)=H^2(z)$ approximately becomes an unit magnitude response. Through several examples of NPR pseudo-QMF banks, it is shown that the peek ripple of the overall magnitude distortion is less than $3.5{\times}10^{-4}\;({\simeq}-70dB)$ and analysis/synthesis filters have the sharp monotone-stopband attenuation exceeding 100 dB.

• Journal of Energy Engineering
• /
• v.8 no.2
• /
• pp.298-308
• /
• 1999

Experimental study on characteristics of direct contact condensation of steam discharged into a sub-cooled water pool has been performed using five different sizes of horizontal nozzle over a wide range of steam mass fluxes and pool temperatures. Steam condensation phenomena have been observed visually and by taking pictures of steam jets using a high speed video camera. Two different steam jet shapes such as ellipsoidal shape and conical shape were typically observed for a stable steam jet, depending on the steam mass flux and pool temperature. The steam jet expansion ratio and the steam jet length as well as the condensation heat transfer coefficients were determined. The effect of steam mass flux, pool temperature, and nozzle diameter on these parameters were also discussed. Empirical correlations for the steam jet lengths and the condensation heat transfer coefficients as a function of steam mass flux and condensation driving potential were established. The axial and radial temperature distributions in steam jet and in surrounding water were measured. The effect of steam mass flux, pool temperature, and nozzle diameter were also discussed. The condensation regime map, which consists of six regimes such as chugging, transient chugging, condensation oscillation, stable condensation, bubble condensation oscillation, and intermittent oscillation condensation, were established. In addition, the dynamic pressures at the pool wall were measured. The close relation of dynamic pressure and steam condensation mode, which is also dependent on steam mass flux and pool temperature, was found.

• Journal of the Korean Society of Radiology
• /
• v.5 no.5
• /
• pp.283-287
• /
• 2011

In this study, fine $Gd_2O_2S$:Tb powder was synthesized by using a low temperature solution-combustion method for a high-resolution digital x-ray imaging detector. From the fabricated phosphor power, the fine scintillator films was fabricated by particle sedimentation method and was investigated the luminescent property. From the experimental results of relative light output as a function of terbium concentration, the highest luminescent efficiency has at 5 wt% Tb concentration, and luminescent intensity decreased rapidly according to quenching effect about higher Tb concentration. Also, the relative light output of $270{\mu}m$-$Gd_2O_2S$:Tb film has 2945 pC/$cm^2$/mR. And light intensity was saturated at higher film thickness. Finally, to evaluate an image acquisition performance of fabricated phosphor, images were obtained by using commercial CMOS sensor and measured the MTF, NPS, and DQE. DQE(0 lp/mm) of fine phosphor film has 37%. But, DQE improvement of fine phosphor film is possible by resolving problem of film fabrication process and has a significant potential in the application of digital radiation imaging system later.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.21 no.6
• /
• pp.323-330
• /
• 1988

The spatial distribution of sea water temperature variation pattern in the South-eastern coastal region of Korea was studied by empirical orthogonal function (E. O. F) analysis in several depths from surface to 300m using the monthly mean water temperature averaged for 23 years, water mass analysis by T. S diagram and sectional diagram of water temperature. Typical type of water temperature variation in this area can be divided into surface (0m-50m), subsurface (100m-150m) and intermediate (200m-300m) layer. The first mode value of water temperature change on the surface layer showed $99\%$ of total variation, and decreased with the increase of the depth. It is deduced to be in the range of $60-70\%$ on the 300m layer. The representative type of water temperature fluctuation by the first mode in each layer is as follows. Water temperature change in the surface layer showed a seasonal variation. In the subsurface layer, it is governed by the interaction of the Tsushima Warm Current water with the cold water and by the heat transfer process from the upper layer. In the intermediate layer, water temperature variation seems to be governed by the advection of the bottom cold water.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.22 no.1
• /
• pp.103-113
• /
• 2019

Spatial resolution is still one of the most important parameters for evaluating image quality. In this study, we propose an approach to evaluate spatial resolution and MTF(Modulation Transfer Function) using bar target and Siemens star chart as a part of quality evaluation for UAV images. To this end, images were taken with a fixed-wing eBee(Canon IXUS) at the flight height of 130m and 260m, and with a rotary-wing GD-800(SONY NEX-5N) at flight height of 130m, with a Phantom 4 pro(FC 6310) at flight height of 90m, respectively. Spatial resolution was measured on orthoimages produced from this data. Results show that the resolution measured on the Siemens star and bar target was accurately degraded in proportion to the flight height regardless of the cameras. In the words, the spatial resolution of images taken at the same altitude of 130m with the eBee(Canon IXUS) and the GD-800(SONY NEX-5N) equipped with different cameras was the same as 4.1cm, and that of the eBee(Canon IXUS) at 260m was 8.0cm. In addition, the resolution measured on the Siemens star was about 1~2cm lower than that of the bar target at every flight height. The general tendency was also found to be proportional to the flight height in the measurement of the ${\sigma}_{MTF}$ from MTF, which simultaneously represents the resolution and contrast information of the image. However, at the same altitude of 130m, the ${\sigma}_{MTF}$ of the GD-800(SONY NEX-5N) is 0.36 and the eBee(Canon IXUS) is 0.59, which shows that the GD-800(SONY NEX-5N) has better camera performance. It is expected that study results will contribute to the analysis of spatial resolution of UAV images and to improve the reliability of quality.

• Journal of Bio-Environment Control
• /
• v.30 no.4
• /
• pp.401-409
• /
• 2021

This study aimed to estimate the photosynthetic capacity of tomato plants grown in a semi-closed greenhouse using temperature response models of plant photosynthesis by calculating the ribulose 1,5-bisphosphate carboxylase/oxygenase maximum carboxylation rate (V_cmax), maximum electron transport rate (J_max), thermal breakdown (high-temperature inhibition), and leaf respiration to predict the optimal conditions of the CO₂-controlled greenhouse, for maximizing the photosynthetic rate. Gas exchange measurements for the A-C_i curve response to CO₂ level with different light intensities {PAR (Photosynthetically Active Radiation) 200µmol·m^-2·s^-1 to 1500µmol·m^-2·s^-1} and leaf temperatures (20℃ to 35℃) were conducted with a portable infrared gas analyzer system. Arrhenius function, net CO₂ assimilation (A_n), thermal breakdown, and daylight leaf respiration (R_d) were also calculated using the modeling equation. Estimated J_max, A_n, Arrhenius function value, and thermal breakdown decreased in response to increased leaf temperature (> 30℃), and the optimum leaf temperature for the estimated J_max was 30℃. The CO₂ saturation point of the fifth leaf from the apical region was reached at 600ppm for 200 and 400µmol·m^-2·s^-1 of PAR, at 800ppm for 600 and 800µmol·m^-2·s^-1 of PAR, at 1000ppm for 1000µmol of PAR, and at 1500ppm for 1200 and 1500µmol·m^-2·s^-1 of PAR levels. The results suggest that the optimal conditions of CO₂ concentration can be determined, using the photosynthetic model equation, to improve the photosynthetic rates of fruit vegetables grown in greenhouses.

• Progress in Medical Physics
• /
• v.26 no.1
• /
• pp.28-35
• /
• 2015

In this study, we investigated the effects of an iterative reconstruction algorithm and an automatic exposure control (AEC) technique on image quality and radiation dose through phantom experiments with coronary computed tomography (CT) angiography protocols. We scanned the AAPM CT performance phantom using 320 multi-detector-row CT. At the tube voltages of 80, 100, and 120 kVp, the scanning was repeated with two settings of the AEC technique, i.e., with the target standard deviations (SD) values of 33 (the higher tube current) and 44 (the lower tube current). The scanned projection data were reconstructed also in two ways, with the filtered back projection (FBP) and with the iterative reconstruction technique (AIDR-3D). The image quality was evaluated quantitatively with the noise standard deviation, modulation transfer function, and the contrast to noise ratio (CNR). More specifically, we analyzed the influences of selection of a tube voltage and a reconstruction algorithm on tube current modulation and consequently on radiation dose. Reduction of image noise by the iterative reconstruction algorithm compared with the FBP was revealed eminently, especially with the lower tube current protocols, i.e., it was decreased by 46% and 38%, when the AEC was established with the lower dose (the target SD=44) and the higher dose (the target SD=33), respectively. As a side effect of iterative reconstruction, the spatial resolution was decreased by a degree that could not mar the remarkable gains in terms of noise reduction. Consequently, if coronary CT angiogprahy is scanned and reconstructed using both the automatic exposure control and iterative reconstruction techniques, it is anticipated that, in comparison with a conventional acquisition method, image noise can be reduced significantly with slight decrease in spatial resolution, implying clinical advantages of radiation dose reduction, still being faithful to the ALARA principle.

• Journal of Internet Computing and Services
• /
• v.1 no.2
• /
• pp.29-37
• /
• 2000

Asynchronous transfer mode is flexible to support multimedia communication services using asynchronous time-sharing and statistical multimedia techniques to the existing data communication area, ATM ABR service controls network traffic using feedback information on the network congestion situation in order to guarantee the demanded service qualities and the available cell rates, In this paper we apply the control method using queue length prediction to the formation of feedback information for more efficient ABR traffic control. If backward node receive the longer delayed feedback information on the impending congestion, the switch can be already congested from the uncontrolled arriving traffic and the fluctuation of queue length can be inefficiently high in the continuing time intervals, The feedback control method proposed in this paper predicts the queue length in the switch using the slope of queue length prediction function and queue length changes in time-series, The predicted congestion information is backward to the node, NLMS and neural network are used as the predictive control functions, and they are compared from performance on the queue length prediction. Simulation results show the efficiency of the proposed method compared to the feedback control method without the prediction, Therefore, we conclude that the efficient congestion and stability of the queue length controls are possible using the prediction scheme that can resolve the problems caused from the longer delays of the feedback information.

• Journal of the Korean Wood Science and Technology
• /
• v.40 no.4
• /
• pp.237-243
• /
• 2012

Sound absorption capability and anatomical features of the organosolv pretreated Japanese larch and yellow poplar wood were estimated by stereoscopic observation and two microphone transfer function method. Sound absorption capabilities of organosolv treated wood, in the entire estimated frequency range (50~6,400 Hz), were higher than those of control specimen. Especially, the treated wood's absorption capabilities measured in the frequency range of 2~4 kHz were about two times higher than those of control specimen. By the organosolv pretreatment (at $70{\sim}120^{\circ}C$), the weight loss of wood occurred in less than 1% of total weight of wood and the porosity of wood increased slightly. In addition, it was presupposed that microstructural changes of wood occurred during organosolv pretreatment and this structural changes cause the increasing of the sound absorption capability of wood.

• Progress in Medical Physics
• /
• v.21 no.3
• /
• pp.239-245
• /
• 2010

The purpose of this study is to comprehensively compare and evaluate the characteristics of image quality for digital mammography systems which use a direct and indirect conversion detector. Three key metrics of image quality were evaluated for the direct and indirect conversion detector, the modulation transfer function (MTF), normalized noise power spectrum (NNPS), and detective quantum efficiency (DQE), which describe the resolution, noise, and signal to noise performance, respectively. DQE was calculated by using a edge phantom for MTF determination according to IEC 62220-1-2 regulation. The contrast to noise ratio (CNR) was evaluated according to guidelines offered by the Korean Institute for Accreditation of Medical Image (KIAMI). As a result, the higher MTF and DQE was measured with direct conversion detector compared to indirect conversion detector all over spatial frequency. When the average glandular dose (AGD) was the same, direct conversion detector showed higher CNR value. The direct conversion detector which has higher DQE value all over spatial frequency would provide the potential benefits for both improved image quality and lower patient dose in digital mammography system.