• The Journal of the Korea institute of electronic communication sciences
• /
• v.9 no.2
• /
• pp.249-254
• /
• 2014

We have studied on the possibility of railway stability system using RFID tag. UHF RFID tag was desinged, manufactured and tested. Proposed UHF tag antenna has PIFA type structure and inset feed multi matching technique was attempted for impedance matching of antenna. The impedance bandwidth (VSWR < 3) of the proposed tag antenna covers 917~923 MHz. Measured peak gain is 3.225 dBi and UHF band with an omni-directional radiation pattern. RFID reader and tag installed in motor car and track, respectively. Then, tag recognition rate according to velocity of car (under 45 km/h) represented 100 %.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.14 no.5
• /
• pp.385-393
• /
• 2004

This paper proposes a swing-arm type dual-stage actuator, which consists of a PZT actuator for fine motion and a VCM(voice coil motor) for coarse motion, for an SFF ODD(small form factor optical disk drive), in order to achieve fast access speed and precise track-following control. Over the past few decades there have been a lot of researches related to the VCM and dual-stage actuator. In this paper, we focus our attention on the design and control of the PZT actuator. Due to the dual cantilever structure. the PZT actuator can generate precise translational tracking motion at its tip to which an optical pickup is attached. and the effect of hysteric behavior of the PZT element is reduced. The dynamic model of the PZT actuator is derived by using the Hamilton's principle, and verified by comparing it with the experimental frequency response. The sliding mode control is designed in order to be robust against modeling uncertainties. Simulations and experimental results confirm the effectiveness of the suggested control scheme.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.9
• /
• pp.1628-1635
• /
• 2008

In this paper, the motion coordination algorithm of mobile agents in active sensor network is proposed to track the dynamic boundary for environmental monitoring. While most of dynamic boundary tracking algorithms in the literature were studied under the assumption that the boundary and/or its evolving rate is known a priori, the proposed algorithm is assumed that the individual active agent can measure the state of environment locally without any information of the boundary. When the boundary is evolving dynamically, the formation of active agents is designed to achieve two objectives. One is to track boundary layer based on the measured information and a small deviation. The other is to maintain a uniform distance between adjacent agents. The algorithm structure based on a state diagram is proposed to achieve these two objectives. Finally, it will be shown in the simulations that all given agents converge to a desired boundary layer and maintain a formation along the boundary. (e.g., a circle, an ellipse, a triangle and a rectangle)

• Journal of the Korean Society for Railway
• /
• v.11 no.3
• /
• pp.272-279
• /
• 2008

The importance of maintenance of rail surface defects is increasing more according to the KTX operation. That is because during high speed operation of rolling stock, rail surface defects may cause shortened fatigue life of rail, acceleration of track degradation and reduced ride comfort. The paper was intended to study the establishment of rail grinding criteria of high-speed railway lines considering the KTX operation circumstances. For this, the specimens of UIC 60 rail on Kyeong-Bu high-speed operation lines were collected and they were tested for metallographic structure and measured for the hardness. As the factors affecting RCF causing the defects of rail surface, passing tonnage, running speed and track condition are considered.

• Journal of the Korean Society for Railway
• /
• v.12 no.4
• /
• pp.574-581
• /
• 2009

Displacement of the bridge and additional rail stress due to interaction between track and bridge should be limited to the design criteria. Interaction analysis was conducted to investigate the displacement and additional rail stress on CWR in railway bridge of conventional line. Particularly, various parameters affecting interaction phenomena were taken into account in the analysis to enhance an applicability. These parameters included configuration of structure, stiffness of deck and support, steel/concrete bridge, ballast/concrete track and FM/MFM type etc. The results were presented in the form of the design chart which could be useful in preliminary design of the bridge.

• Journal of the Korean Society for Railway
• /
• v.12 no.4
• /
• pp.565-573
• /
• 2009

Displacement of the bridge and additional rail stress due to interaction between track and bridge should be limited to the design criteria. Interaction analysis was conducted to investigate the displacement and additional rail stress on CWR in high speed railway bridge. Particularly, various parameters affecting interaction phenomena were taken into account in the analysis to enhance an applicability. These parameters included configuration of structure, stiffness of deck and support, steel/concrete bridge, ballast/concrete track and FM/MFM type etc. The results were presented in the form of the design chart which could be useful in preliminary design of the bridge.

• Proceedings of the KSR Conference
• /
• 2004.10a
• /
• pp.127-132
• /
• 2004

The third double-track construction part of work, called Chung Ang Railroad line(Deok-So$\∼$Won-Ju) is in progress and the personal museum located 330m from the starting point of Pal-Dang Tunnel(length=4,470m) line in the canyon is to be effected by rock blasting during the tunnel excavation work, especially museum articles and building itself. This paper is the example of application suitable tunnel rock blasting pattern for excavation after the case study about the investigation and analysis of rock blasting noise pollution during tunnel excavation work. The museum is a three-story building, RC concrete structure and is located 17m from the top of the tunnel, in the center of the double-track line. Comparing estimate vibration frequency with site vibration one, it can be verified the reasonable rock blasting noise pollution as improving the application of tunnel excavation rock blasting pattern. The above pattern has been selected economically and effectively and applied to our construction field.

• Atmosphere
• /
• v.30 no.4
• /
• pp.347-360
• /
• 2020

The automatic algorithm optimized for the Korean Peninsula was developed to detect and track the center of typhoon based on a geometrical method using high-resolution retrieved WISSDOM (WInd Syntheses System using DOppler Measurements) wind and reflectivity data. This algorithm analyzes the center of typhoon by detecting the geometric circular structure of the typhoon's eye in radar reflectivity and vorticity 2D field data. For optimizing the algorithm, the main factors of the algorithm were selected and the optimal thresholds were determined through sensitivity experiments for each factor. The center of typhoon was detected for 5 typhoon cases that approached or landed on Korean Peninsula. The performance was verified by comparing and analyzing from the best track of Korea Meteorological Administration (KMA). The detection rate for vorticity use was 15% higher on average than that for reflectivity use. The detection rate for vorticity use was up to 90% for DIANMU case in 2010. The difference between the detected locations and best tracks of KMA was 0.2° on average when using reflectivity and vorticity. After the optimization, the detection rate was improved overall, especially the detection rate more increased when using reflectivity than using vorticity. And the difference of location was reduced to 0.18° on average, increasing the accuracy.

• Geomechanics and Engineering
• /
• v.30 no.3
• /
• pp.273-280
• /
• 2022

A certain amount of random vibration excitation to subway track is caused by subway operation. This excitation is transmitted through track foundation, tunnel, soil medium, and ground building to the ground and ground structure, causing vibration. The vibration affects ground building. In this study, the results of ANSYS numerical simulation was used to establish back-propagation (BP) neural network model. Moreover, a back-propagation neural network model consisting of five input neurons, one hidden layer, 11 hidden-layer neurons, and three output neurons was used to analyze and calculate the vertical Z-vibration level of New Capital's ground buildings of Qingdao Metro phase I Project (Line M3). The Z-vibration level under different working conditions was calculated from monolithic roadbed, steel-spring floating slab roadbed, and rubber-pad floating slab roadbed under the working condition of center point of 0-100 m. The steel-spring floating slab roadbed was used in the New Capital area to monitor the subway operation vibration in this area. Comparing the monitoring and prediction results, it was found that the prediction results have a good linear relationship with lower error. The research results have good reference and guiding significance for predicting vibration caused by subway operation.

• Proceedings of the KSR Conference
• /
• 2011.10a
• /
• pp.297-302
• /
• 2011

Railway construction in the random vibration natural phenomena, as well as a relatively regular train loads for dynamic loads, such as a usability and safety should be ensured. Vibration due to train loads and seismic vibrations caused by wind compared to the typically very small in size, rather than the safety of the structure affects the usability. Recently in the downtown area, ground and underground facilities, such as a permanent facility that may cause excessive vibration increases, associated with the construction of these transportation facilities on ground vibrations of structures has been increasing concern and complaint. More recently, high-speed train vibration and noise due to furnace is increasing. In order to solve this problem, such as soundproof considering several feet, but by applying the vibration and noise reduction measures insufficient for the study is Free. In this study, track structure, track, and the inside of the building to support the system, the different forms of neurological history and share about the history cheonanahsan high-speed rail, if passed by the bus stop on the train loads of noise, and the history of interior noise and vibration measurement / analysis of measurement results to assess the relative comparison with the relevant provisions were reviewed. Based on this history, future plans for the design of the bridge to reflect the results of a study is intended to provide information. Waiting for the analysis of vibration and noise reduction, cheonanahsan history passed quietly in the train, on average, appeared to 67.53dB and 65.41dB nervous week on average, were measured with the history. Nervous week waiting room of history and the history cheonanahsan radically different shapes and sizes, so a direct comparison is impossible, but the vibration caused by the disc on the base of the polyurethane elastomer disk is not supported by GERB SYSTEM Waiting more effective in reducing the noise level considered in The main materials for railway and for the localization will help to ensure affordability is considered.