• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2000.11a
• /
• pp.40-43
• /
• 2000

Groundwater qualities in Nakdong river region were investigated during 1999 and 2000. Groundwater samples were collected twice from about 150 sites over the region. The EC and TDS obtained in first survey (October, 1999) show rather high values than those in second survey(April, 2000) and this seems to be caused by groundwater temperature. There is obvious positive correlation between EC and TDS. For the study area, the following equation can be written : TDS(mg/l) = <0.64~0.70> x EC($mutextrm{s}$/cm). As the concentration of major ions increases in natural condition, there is a tendency that the ratio of TDS and EC has consistent value. This observation suggests that TDS measurement can be replaced by EC measurement in the some ranges.

• Journal of environmental and Sanitary engineering
• /
• v.11 no.3
• /
• pp.29-35
• /
• 1996

Numerical solutions were obtained to the model equations for various parameters characterizing the pore structure, effective internal diffusion and the chemical reaction constant. The conversion was decreased with the cause of pore closure at the surface of reacting particles, reduction of porosity, surface area of reaction and effective diffusion coefficient in the solid with the progress of reaction. Total conversion was strongly depend on the local conversion at surface. According to the decreasing of impregnated concentration of the copper oxide and the increase of the flue gases concentration, total conversion was increased. And the conversion were affected by gas flow rate and pore size distribution of the reacting solid.

• Journal of the Optical Society of Korea
• /
• v.12 no.3
• /
• pp.210-214
• /
• 2008

A critical angle method was used to measure the index of refraction of a solid medium when an air gap between the prism and the medium is present. The gap effect was analyzed both numerically and experimentally. Since the total internal reflection is severely disturbed by the large gap, determination of the critical angle and the resulting refractive index becomes ambiguous and inaccurate. By using an index matching fluid, we could determine the index of refraction with an uncertainty of ${\pm}2{\times}1^{-3}$ even when the gap is as large as 1 ${\mu}m$.

• Proceedings of the Korean Institute of Resources Recycling Conference
• /
• 2006.09a
• /
• pp.3-12
• /
• 2006

The main feature of these total technologies is that we can constitute the optimum treatment scheme fitting to the property of wastes, amount of wastes and energy requirement. For high moisture content wastes or biomass resources, high pressure steam process (MMCS) for crush, dry and deodorize wastes to produce high quality fertilizer of fuel is most appropriate. For dry or semi-dry solid wastes, the STAR-MEET system can be applied to produce low-BTU gases for power generation using duel fueled diesel engines of Stirling engines, and the REPRES and HyPR-MEET systems can be applied to produce hydrogen rich medium-BTU gas. For waste plastics and oils, liquefaction technology is best fit to produce light oil or kerosene equivalent fuel oils. These total technologies are completely different from the existent waste treatment technologies based on land-filling or incineration, and are expected to disseminate all over the world in the near future.

• Journal of the Korean Professional Engineers Association
• /
• v.33 no.1
• /
• pp.106-115
• /
• 2000

The effect of puffing treatments on the sensory qualities improving of Ginseng Extract were investigated in the good products for rejecting soil flavor as Ginseng foreign bad taste, through chemical analysis and actual manufacturing practice, the following results were obtained. Puffing treated<15kg / ㎠psi> ginseng has produced a marked increase in soluble solid, crude saponin yield to the extent of 10% and without soil taste as compared with control Ginseng. Optimum Ginseng ethanol extraction condition were 90$\^{C}$ for 8 hours, which was cheap operating cost and color, apperance, total solid yield of Ginseng extracted products. For 70% ethanol extraction in temperature range of 60∼90$\^{C}$ for 8 hours, the higher temperature resulted higher yields in solids and Ginsenoside Especially, GinsenosideRgl as most effective physiological function component yield was increased in 18% by puffed Ginseng than control Cinseng products. The Hunter's color, L. a and b values of Ginseng extract were 31.09, 21.9 and 49.5 and increase brown and red color value and total Δ Evalue.

• Proceedings of the Korean Society of Postharvest Science and Technology of Agricultural Products Conference
• /
• 2005.09a
• /
• pp.124-132
• /
• 2005

• Journal of Korean Society for Atmospheric Environment
• /
• v.16 no.4
• /
• pp.299-308
• /
• 2000

This study analyzed solid wastes generated from a school. The emission potential of hazardous pollutants generated from incineration of the school solid wastes (SSWs) was analyzed. Components of the SSWs were identified and the SSWs were classified into combustible and non-combustible wasts. The combustible wastes consisted of papers of 56.5^ plastics of 30.2% woods of 7.1% and fibers of 6.1% based on weight of the wastes. The moisture content and the ash content of the combustible wastes were 18~20% and 11~13% respectively. The combustible wastes of the SSWs were incinerated by using a small-scale incinerator. Fly and bottom ashes and volatile organic compounds (VOCs) were collected from the incineration. Also the metal leaching experiments on the fly and bottom ashes were performed, In analysis of metals leached from the ashes the total amounts of metals leached in the acid solution (pH=3) were much greater than those in the neutral solution (pH=5.8~6.2) For the same amounts of the fly and bottom ashes the total amounts of metals leached from the fly ashes were much greater than those from the bottom ashes. The VOCs produced from incineration of the SSWs consisted of aromatics of 42.1% aliphatic alkenes of 26.3% oxidized forms of 17.3% and aliphatic alkanes of 14.3% In addition the considerable amounts of hazardous air pollutants (e.g benzene chloro-benzene and chloro-alkanes) and compounds (e. g, aliphatic alkenes) with high potential of ozone or photochemical smog formation were identified from the incineration experiment of the SSWs.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.16 no.5
• /
• pp.210-215
• /
• 2006

Mechanical alloying (MA) by high energy ball mill of pure copper and niobium powders was carried out under the Ar gas atmosphere. The supersaturated solid solution can be produced in the range up to $Cu_xNb_{100-x}$(x=5-30) by MA for 120 hrs, as demonstrated by X-ray diffraction, DSC analysis and the electronic studies through a change in the superconducting transition in the low-temperature specific heat. The $Cu_{30}Nb_{70}$ samples ball-milled for 120 hrs exhibit only a broad exothermic heat release. The total energy, ${\Delta}H_t$ accumulated during MA far the mixture of $Cu_{30}Nb_{70}$ powders increased with milling time and approached the saturation value of 7.5 kJ/mol after 120 h of milling. It can be seen that the free energy difference between the supersaturated solid solution and the mixture of $Cu_{30}Nb_{70}$ powders is estimated to be 7 kJ/mol by Miedema et al. Hence it is thermodynamically possible to assume the formation of a supersaturated solid solution phase in this system.

• Transactions of the Korean hydrogen and new energy society
• /
• v.33 no.3
• /
• pp.247-254
• /
• 2022

Slush hydrogen containing liquid and solid hydrogen is expected to achieve zero boil-off by suppressing boil-off gas because heat of fusion for solid absorbe the heat ingress from atmosphere. In this paper, quantitative analysis on storage cost considering specific energy consumption between 1,000 m³ class liquid hydrogen storage system with re-liquefaction and slush hydrogen storage system during equivalent zero boil off period. Even though approximately 50% of total storage capacity should be converted into solid phase during the initial cargo bunkering, total energy consumption to convert into slush hydrogen is relatively 25% less than re-liquefaction energy for boil off hydrogen during zero boil off period. That's because energy consumption of slush phase change take up only 1.8% of liquefaction energy. moreover, annual revenue requirement including CAPEX, OPEX and electric cost for slush hydrogen storage could be more reduced approximately 32.5% than those of liquid hydrogen storage and specific energy storage cost ($/kg-H₂) could also be lowered by about 41.7% compared with liquid hydrogen storage.

• Food Science of Animal Resources
• /
• v.43 no.4
• /
• pp.674-684
• /
• 2023

Xinjiang province is the main camel feeding area in China with a large square, and camel milk from different areas have different qualities. By now, there are few reports about the quality of camel milk from different areas of Xinjiang province in China. In this study, seven batches of camel milk and one batch of cow milk were collected, and the contents of fat, protein, lactose, total solid, and nonfat milk solid of these milk samples were determined, as well as the contents of lysozyme and vitamin C. All samples were scored and compared by principal component analysis score and comprehensive weighted multi-index score. As the results, camel milk from different areas showed different contents of fat (4.62%-7.02%), protein (3.34%-3.95%), lactose (3.85%-4.79%), total solid (13.59%-17.00%), nonfat milk solid (8.55%-9.73%), vitamin C (12.10-41.25 ㎍/mL), and lysozyme (8.70-22.80 ㎍/mL), as well as different qualities. This variation would help people to know more about quanlity of camel milk in Xinjiang province. Camel milk from Jeminay showed the best quality, and then followed by camel milk from Fukang, Changji, and Fuhai, while cow milk showed the lowest score. Therefore, Jeminay is the most suitable place for grazing camels. Our findings show the different qualities of camel milk in different distribution areas of Xinjiang province, and provide an insight for the evaluation of camel milk. In the present study, only seven components in camel milk were determined, many other factors, such as cfu, mineral, and other vitamins, have not been considered.