• Journal of Agricultural Extension & Community Development
• /
• v.11 no.1
• /
• pp.53-65
• /
• 2004

The purposes for this study was to provide information for developing educational programs for U-turn farmers' based on their needs on rural settlement. Special objectives of the study were; 1) to survey the general characteristics of U-turn farmers including motives. preparation, and education, 2) to investigate problems and difficulties of the U-turn farmers in rural settlement 3) to identify the reasons for success and failure in U-turn filming, and 4) to provide information in developing programs for U-turn farmers. Data for the study were collected from 526 U-turn farmers throughout the country, and after data cleaning, 494 questionnaires were used for data analysis. Based on the results of this study, the following were recommended for further development of U-turn farming programs; 1) to facilitate and expand continuous surveys on the motives. preparation, education and information for U-turn farmers will be neceassary to update the important and current information on U-turn farming. 2) Further examination of the problems and difficulties of U-turn farmers would be necessary to develop appropriate policies and educational programs for U-turn farming. 3) continuous investigations on the reasons for success and failure of U-turn farming would be necessary to develop appropriate apicultural policies. 4) for more effective educational programs for U-turn farmers. selection of educators, institution, curricular and timing etc. Should be carefully designed to meet the practical needs of the U-turn farmers. 5) more research activities should be encouraged to improve program development and implementation of U-turn farming.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.12A
• /
• pp.1174-1182
• /
• 2005

This paper, we propose a new channel Estimation method for MB-OFDM(Multi-Band OFDM) system that is suggested as one of standards in IEEE 802.15 TG3a for high data rate(110Mbps${\~}$480Mbps) WPAN system. The proposed method uses correlation characteristic of the PS(Packet Synchronization) sequence for timing synchronization. It can reduce the influence of noise compared with the conventional algorithm which based on LS(Least square) algorithm is redundancy without using the CE(Channel Estimation) Sequence for channel Estimation. We simulate both conventional method and proposed method for performance analysis in S-V channel environment which proposed by IEEE 802.15.3a. Simulation results show the proposed algorithm outperforms conventional algorithm about 1${\~}$1.5dB of Eb/NO.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.5
• /
• pp.108-116
• /
• 1989

The simulator described here-LOSIM(LOgic SIMulator)-was developed to verify the logic design for VLSI(Very Large Scale Integrated) circuits at mixed level. In this paper, we present a modeling approach to obtain more accurate results than conventional logic simulators [5-6,9] for general elements, functional elements, transmission gates and tri-state gates using eight signal values and two gignal strengths. LOSIM has the capability which can perform timing and hazard analysis by using assignable rise and fall delays. We also prosent an efficient algorithm to accurately detectdynamic and static hazards which may be caused by the circuit delays. Our approach is based on five logic values and the scheduled time. LOSIM has been implemented on a UN-3/160 workstation running Berkeley 4.2 UNIX, and the program is written in C language. Static RAM cell and asynchronous circuit are illustrated as an example.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.36C no.12
• /
• pp.59-68
• /
• 1999

The timing characteristics of an ASIC are analyzed based on the propagation delays of each gate and interconnect wire. The gate delay can be modeled using the two-dimensional delay table whose index variables are the input transition time and the output load capacitance. The AWE technique can be adopted as an algorithm to compute the interconnect delay. Since these delays are affected by the interaction to the two-dimensional delay table and the AWE technique. A method to model this effect has been proposed through the effective capacitance and the gate driver model under the assumption of single driving gate. This paper presents a new technique to handle the multiple CMOS gates driving interconnect wire by extending previous approach. This technique has been implemented in C language and applied to several interconnect circuits driven by multiple CMOS gates. In most cases, we found a few tens of speed-up and only a few percents of errors in computing both of gate and interconnect delays, compared to SPICE.

• Journal of Environmental Policy
• /
• v.12 no.2
• /
• pp.17-32
• /
• 2013

The potential impact of water temperature on air temperature in response to recent anthropogenic global warming has been noticed. To predict climate, induced change in river aquatic environment, it is necessary to understand the thermal constrains of fish species and the timing of the projected river temperature. As a preliminary study, air-water temperature relationship was analyzed on the basis of the observed data during the time period of 2009-2011 and the number of data corresponds to 873-1083. As a result of analyzing the auto-and cross-correlation coefficient between air-water temperature, high correlation is shown (~0.9). It is also found that the correlation coefficient of air temperature is higher than that of water temperature at the lag time less than approximately 10 days. Observed data was divided into two groups to investigate hysteresis: rising limb and falling limb. For some stations there is strong evidence that hysteresis exist between air-water temperature relationships. Consequently it is recommended that seasonal hysteresis needs to be included in determining an airwater relationship.

• Physical Therapy Korea
• /
• v.8 no.3
• /
• pp.11-26
• /
• 2001

In rehabilitation programs involving muscle re-education and endurance exercise, it is necessary to confirm when fatigue occurs. It is also necessary to quantify fatigue, to confirm whether the muscle has been exercised sufficiently. In general, as fatigue occurs, the force-generating ability of the muscle is reduced. If the median frequency (MDF) obtained from electromyogram (EMG) power spectrum is correlated highly with work, then the timing and degree of fatigue may be confirmed. This study examined the relationship between work and MDF obtained from the EMG power spectrum during repetitive isokinetic exercise. Surface EMG signals were collected from biceps brachii and vastus lateralis of 52 normal subjects (26 males, 26 females) at $120^{\circ}/sec$ and $60^{\circ}/sec$ while performing an isokinetic exercise. The exercise was finished at 25% of peak work. MDF data was obtained using a moving fast Fourier transformation (FFT), and random noise was removed using the inverse FFT, then a new MDF data was obtained from the main signal. There was a high correlation between work and MDF during repetitiv isokinetic exercise in the biceps brachii and vastus lateralis of males and the biceps brachii of females (r=.50~.77). However, there was a low correlation between work and MDF in the vastus lateralis of females (r=.06~.19).

• Journal of the Korean Society of Radiology
• /
• v.6 no.2
• /
• pp.107-114
• /
• 2012

The study was conducted in patients who had undergone angiography and arterial embolization after being diagnosed with arterial bleeding among those registered with severe trauma at the admission to the department of emergency due to accidents. In the study, comparison was done between the survived group and the nonsurvived group to investigate the usefulness and the optimal performance timing of angiography and embolization as the survival-affecting factors and treatment methods for patients. The study was performed as a retrospective analysis in 45 patients who had undergone angiography and arterial embolization among those categorized as severe trauma patients from the emergency department of H hospital located in Gyeonggi-do from July, 2006 until December, 2010. The Injury Severity Score (ISS), the Revised Trauma Score (RTS), the hematocrit were the main outcome measurements. Arterial embolization was technically successful in all cases, transcatheter arterial embolization of arterial bleeding is a useful procedure in lowering the mortality and complication in severe trauma patients. and RTS, ISS, Hematocrit were the predictable early mortality factors. So bad vital sign patients must be progressed rapidly.

• Journal of the Korean Society for Precision Engineering
• /
• v.29 no.2
• /
• pp.178-184
• /
• 2012

This paper presents a transformable track mechanism for wall climbing robots. The proposed mechanism allows a wall climbing robot to go over obstacles by transforming the track shape, and also increases contact area between track and wall surface for safe attachment. The track mechanism is realized using a timing belt track with one driving actuator. The inner frame of the track consists of serially connected 5R-joints and 1P-joint, and all joints of the inner frame are passively operated by springs, so the mechanism does not require any actuators and complex control algorithms to change its shape. Static analysis is carried out to determine design parameters which enable $90^{\circ}$ wall-to-wall transition and driving over projected obstacles on wall surfaces. A Prototype is manufactured using the transformable track on which polymer magnets are installed for adhesion force. The size of the prototype is $628mm{\times}200mm{\times}150mm$ ($Length{\times}Width{\times}Height$) and weight is 4kgf. Experiments are performed to verify its climbing capability focusing on $90^{\circ}$ wall to wall transition and driving over projected obstacle.

• Archives of Plastic Surgery
• /
• v.44 no.5
• /
• pp.370-377
• /
• 2017

Background Composite grafts are frequently used for facial reconstruction. However, the unpredictability of the results and difficulties with large defects are disadvantages. Adipose-derived stem cells (ADSCs) express several cytokines, and increase the survival of random flaps and fat grafts owing to their angiogenic potential. Methods This study investigated composite graft survival after ADSC injection. Circular chondrocutaneous composite tissues, 2 cm in diameter, from 15 New Zealand white rabbits were used. Thirty ears were randomly divided into 3 groups. In the experimental groups (1 and 2), ADSCs were subcutaneously injected 7 days and immediately before the operation, respectively. Similarly, phosphate-buffered saline was injected in the control group just before surgery in the same manner as in group 2. In all groups, chondrocutaneous composite tissue was elevated, rotated 90 degrees, and repaired in its original position. Skin flow was assessed using laser Doppler 1, 3, 6, 9, and 12 days after surgery. At 1 and 12 days after surgery, the viable area was assessed using digital photography; the rabbits were euthanized, and immunohistochemical staining for CD31 was performed to assess neovascularization. Results The survival of composite grafts increased significantly with the injection of ADSCs (P<0.05). ADSC injection significantly improved neovascularization based on anti-CD31 immunohistochemical analysis and vascular endothelial growth factor expression (P<0.05) in both group 1 and group 2 compared to the control group. No statistically significant differences in graft survival, anti-CD31 neovascularization, or microcirculation were found between groups 1 and 2. Conclusions Treatment with ADSCs improved the composite graft survival, as confirmed by the survival area and histological evaluation. The differences according to the injection timing were not significant.

• Journal of Trauma and Injury
• /
• v.30 no.4
• /
• pp.166-172
• /
• 2017

Purpose: Thoracic traumas represent 10-15% of all traumas and are responsible for 25% of all trauma mortalities. Traumatic cardiac injury (TCI) is one of the major causes of death in trauma patients, rarely present in living patients who are transferred to the hospital. TCI is a challenge for trauma surgeons as it provides a short therapeutic window and the management is often dictated by the underlying mechanism and hemodynamic status. This study is to describe our experiences about emergency cardiac surgery in TCI. Methods: This is a retrospective clinical analysis of patients who had undergone emergency cardiac surgery in our trauma center from January 2014 to December 2016. Demographics, physiologic data, mechanism of injuries, the timing of surgical interventions, surgical approaches and outcomes were reviewed. Results: The number of trauma patients who arrived at our hospital during the study period was 9,501. Among them, 884 had chest injuries, 434 patients were evaluated to have over 3 abbreviated injury scale (AIS) about the chest. Cardiac surgeries were performed in 18 patients, and 13 (72.2%) of them were male. The median age was 47.0 years (quartiles 35.0, 55.3). Eleven patients (61.1%) had penetrating traumas. Prehospital cardiopulmonary resuscitations (CPR) were performed in 4 patients (22.2%). All of them had undergone emergency department thoracotomy (EDT), and they were transferred to the operating room for definitive repair of the cardiac injury, but all of them expired in the intensive care unit. Most commonly performed surgical incision was median sternotomy (n=13, 72.2%). The majority site of injury was right ventricle (n=11, 61.1%). The mortality rate was 22.2% (n=4). Conclusions: This study suggests that penetrating cardiac injuries are more often than blunt cardiac injury in TCI, and the majority site of injury is right ventricle. Also, it suggests prehospital CPR and EDT are significantly responsible for high mortality in TCI.