• Journal of Korea Water Resources Association
• /
• v.49 no.4
• /
• pp.283-291
• /
• 2016

As the infrastructures and populations are the condensed in the mega city, urban flood management becomes very important due to the severe loss of lives and properties. For the more accurate calculation of runoff from the urban catchment, hourly or even minute rainfall data have been utilized. However, the time steps of the measured or forecasted data under climate change scenarios are longer than hourly, which causes the difficulty on the application. In this study, daily rainfall data was disaggregated into hourly using the stochastic method. Based on the historical hourly precipitation data, Gram Schmidt orthonormalization process and K-Nearest Neighbor Resampling (KNNR) method were applied to disaggregate daily precipitation into hourly. This method was originally developed to disaggregate yearly runoff data into monthly. Precipitation data has smaller probability density than runoff data, therefore, rainfall patterns considering the previous and next days were proposed as 7 different types. Disaggregated rainfall was resampled from the only same rainfall patterns to improve applicability. The proposed method was applied rainfall data observed at Seoul weather station where has 52 years hourly rainfall data and the disaggregated hourly data were compared to the measured data. The proposed method might be applied to disaggregate the climate change scenarios.

• Journal of Korea Water Resources Association
• /
• v.51 no.8
• /
• pp.655-664
• /
• 2018

The riverbed material survey is to investigate the particle size distribution, specific gravity, porosity, etc. as basic data necessary for river channel plan such as calculation of sediment transport and change of river bed. In principle, the survey spots are 1 km interval in the longitudinal direction of the river and 3 points or more in the 1 cross section. Therefore, depending on longitudinal length of the river to be investigated, the number of surveyed sites is very large, and the time and cost for the investigation are correspondingly required. This study is to compare the particle size analysis method with the volumetric method and the image analysis method in work efficiency and cost and to examine the applicability of the image analysis method. It was confirmed that the diameter of the equivalent circle converted by the image analysis method can be applied to the analysis of bed material particle size. In the gravel stream with a particle size of less than 10 cm and a large shape factor, the analytical result of the bed material by the image analysis method is accurate. However, when the shape factor decreases as the particle size increases, the error increases. In addition, analysis results of the work efficiency and cost of the volume method and the image analysis method showed a reduction of about 80%.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.9 no.3
• /
• pp.146-155
• /
• 2006

A handful of previous studies have attempted to integrate socioeconomic data and remotely sensed data for urban quality of life assessment with their spatial dimension in a zonal unit. However, such a zone-based approach not only has the unrealistic assumption that all attributes of a zone are uniformly spatially distributed throughout the zone, but also has resulted in serious methodological difficulties such as the modifiable areal unit problem and the incompatibility problem with environmental data. An alternative to the zone-based approach can be a pixel-based approach which gets its spatial dimension through a pixel. This paper proposes a pixel-based approach to linking remotely sensed data with socioeconomic data in GIS for urban quality of life assessment. The pixel-based approach uses dasymetric mapping and spatial interpolation to spatially disaggregate socioeconomic data and integrates remotely sensed data with spatially disaggregated socioeconomic data for the quality of life assessment. This approach was implemented and compared with a zone-based approach using a case study of Fulton County, Georgia. Results indicate that the pixel-based approach allows for the calculation of a microscale indicator in the urban quality of life assessment and facilitates efficient data integration and visualization in the assessment although it costs an intermediate step with more processing time such as the disaggregation of zonal data. The results also demonstrate that the pixel-based approach opens up the potential for the development of new database and increased analytical capabilities in urban analysis.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.48 no.3
• /
• pp.50-61
• /
• 2011

The Infrared touch method is generally used for a mid and large-size touch screen. But this method has several problems, such as difficulty with installation of a touch-object recognition device, limited application and coordinate error in multi-point touch system. Since we can take advantages of both color and local information when we use general cameras for a touch screen, a touch screen using general camera is more efficient than infrared one. It also has an advantage of easy installation of a touch-object device. However, it did not much appeal in a market because of several problems, such as color sensitivity, illumination and reflected light. In this paper, we study a method for a touch screen using a general camera and image processing method to recognize touch objects and coordinate calculation method to single and multi-point touch screen. It has the same recognition performance as an infrared touch screen for single-point method. And it does not have ghost point problem by using distance information of touch object and camera in multi-point touch system. But recognition performances of multi-point touch screen are less than single-point. If we improve execution time, this method can replace an infrared method for a single point touch screen, according to result of experience.

• Journal of Korean Public Health Nursing
• /
• v.3 no.1
• /
• pp.101-119
• /
• 1989

In the present, since a five-year plan for economic development which was started in the early 60's has been successfully promoted for a quarter century, with consolidation in a department of social welfare in our country the participation. in economic society for women is more required than any other times. As a professional occupation for women is incereaing through a high-standard specialization, I think the upbringing for productive woman expert who has a strong motive of accomplishment as a developed person as well as a technical and skilful capacity which can be contributed to the growth of organization is very important. So in this study, I am evaluating the technical disposition of character of professional nurses working with hospital and also trying to supply the basic data being served to th extension of a skillful ability as a nurse, understanding the important factor related to it. The research method applied here is that we used 527 of formed questionnaires which were distributed to 7 University and General Hospitals, somewhat large in a scale, located in Seoul as an analytical material. It was performed between October 11, 1988 and October 18, 1988. An implement which was invented by Cho Moo-Sung is used after being amended and supplemented, which can measure the disposition of professional character. The formation of questionnaires of the disposition of character is 26 totally, 10 for Open-disposition, 11 for Active-disposition, 5 for wise-disposition, and it was measured. 'Ye', or 'No' through an one-half-standard and the environment of hospital organization is composed 12 questions from one point of 'Very Good' to 5 points of 'Very Bad.' Collected materials were analysed through an electronic calculation into the average value, the standard deflection, percentage, person correlative number, $X^2-test, m$ stepwise multiple regression. Summarizing the result from this research is as follows; 1. The average age of the subjective person of this investigation is 28.6 and the average career as a nurse is 6.0 years. 2. The Open-disposition that technical nurses showed is mostly half and half. 3. The Active-disposition of professional nurses was discovered affirmative largely and what they said in their questionnaires describes that they are very active answering $88.2\%$ for the disposition of self-control, $87.3\%$ for the people who think the training more seriously. 4. It was found out that the wise·disposition of technical nurse showed $90.7\%$ of 'Yes' about a new alternative of inquisitive question and we can see a progressive and profound aspect here. 5. As technical character of nurses, mutual relations between Active-disposition, Active-disposition, and wise­disposition were very profitably revealed as 0.42 in justice relations and also suggested that relations between Open-disposition, Active-disposition, and wise-disposition are 0.27 and 0.20 respectively. 6. What nurses recognize about the environment of hospital organization is reasonably acceptable while they feel very bad about rewards and punishments showing average 3.1 comparing to average 2.2 about time­control each other. Considering the prosperity of Active-disposition upon the result what I mentioned above, th possibility which is contributed to the productive improvement of hospital organization is very great and I think it can be more developed as a professional woman who has a strong motive of accomplishment, in advance.

• Korean Chemical Engineering Research
• /
• v.50 no.6
• /
• pp.1021-1026
• /
• 2012

The transient mass transfer in a single droplet system consisting of 1-octanol (continuous phase)/aqueous succinic acid solution (dispersed phase) was investigated in the presence of chemical reaction, which is acid/anion exchange reaction of succinic acid and tri-n-octylamine (TOA). This succinic acid extraction by TOA can be considered to occur at the interface between organic and aqueous phase, that is, heterogeneous reaction system. The basic properties of the system such as viscosity, density, distribution coefficient, terminal velocity of droplet, and diffusion coefficient were measured experimentally or calculated theoretically, and used for theoretical calculation of characteristic parameters of mass transfer later. The effects of succinic acid concentration on the terminal velocity was negligible in the existence of TOA, although the terminal velocity increases with succinic acid concentration in the absence of TOA. On the contrary, the terminal velocity decreases with TOA concentration. While droplets falls through organic phase, the trajectory of droplets is observed to oscillate around its vertical path. A mass trnasfer cell was prepared to monitor the mass transfer behavior in a single droplet and used to measure the mean concentration of succinic acid inside droplet. The results are expressed with dimensionless parameters. Under 50 g/L succinic acid condition, the system with 0.1 mol/kg TOA showed that the molar flux decreases in proportion to the decrease of concentration gradient, while in the case of 0.5 mol/kg TOA Sh increases rapidly with time indicating the molar flux of succinic acid decreases relatively slowly compared to the decrease in concentration gradient.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.3
• /
• pp.51-61
• /
• 2012

This paper suggests an algorithm that obtains Directed Graph Minimum Spanning Tree (DMST), using Prim MST algorithm which is Minimum Spanning Tree (MST) of undirected graph. At first, I suggested the Prim DMST algorithm that chooses Minimum Weight Arc(MWA) from out-going nodes from each node, considering differences between undirected graph and directed graph. Next, I proved a disadvantage of Prim DMST algorithm and Chu-Liu/Edmonds DMST (typical representative DMST) of not being able to find DMST, applying them to 3 real graphs. Last, as an algorithm that can always find DMST, an advanced Prim DMST is suggested. The Prim DMST algorithm uses a method of choosing MWA among out-going arcs of each node. On the other hand, the advanced Prim DMST algorithm uses a method of choosing a coinciding arc from the out-going and in-going arcs of each node. And if there is no coinciding arc, it chooses MWA from the out-going arcs from each node. Applying the suggested algorithm to 17 different graphs, it succeeded in finding the same DMST as that found by Chu-Liu/Edmonds DMST algorithm. Also, it does not require such a complicated calculation as that of Chu-Liu/Edmonds DMST algorithm to delete the cycle, and it takes less time for process than Prim DMST algorithm.

• Journal of Navigation and Port Research
• /
• v.42 no.3
• /
• pp.201-206
• /
• 2018

The purpose of this study is to estimate a proper Domain Watch between anchored vessels in order to propose a method for the efficient management of VTS(Vessel Traffic Service) of the N-anchorage in Busan harbor, which is the largest port in Korea. For this purpose, we proposed the calculation method of Domain Watch and investigated the ship length(L), the distance between anchored vessels ($D_{ij}$), the domain radius(R), and the domain radius vs L(R/L) during the peak time of the vessels in the latest usage of anchorage. As a result of technical analysis for the surveyed data, the minimum R/L for securing the safety distance between anchored vessels was selected based on 2.85 corresponding to the 70th percentile of the total data. This result was applied to the N-anchorage of Busan and compared with the 'Guidelines of Port and Harbor Design(2014)', and we have confirmed that it is reasonable to set the Domain radius with the minimum 2.85L or more in VTS. This study considers the safety management of anchorage for VTS. This study could contribute to the safety of vessels using anchorage and the safety management plan of VTS when it is applied to other ports in operation such as it was in Busan.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.47 no.5
• /
• pp.153-164
• /
• 2010

A program consumes energy by executing its instructions. The amount of cosumed power is mainly proportional to algorithm complexity and it can be calculated by using complexity information. Generally, the complexity of a S/W is estimated by the microprocessor simulator. But, the simulation takes long time why the simulator is a software modeled the hardware and it only provides the information about computational complexity quantitatively. In this paper, we propose a complexity estimation method of analysis of S/W on source code level and produce the complexity metric mathematically. The function-wise complexity metrics give the detailed information about the calculation-concentrated location in function. The performance of the proposed method is compared with the result of the gate-level microprocessor simulator 'SimpleScalar'. The used softwares for performance test are $4{\times}4$ integer transform, intra-prediction and motion estimation in the latest video codec, H.264/AVC. The number of executed instructions are used to estimate quantitatively and it appears about 11.6%, 9.6% and 3.5% of error respectively in contradistinction to the result of SimpleScalar.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.7
• /
• pp.61-68
• /
• 2008

In this paper, we propose an efficient hardware architecture and algorithm to increase an encoding process rate and implement a hardware for CABAC (Context Adaptive Binary Arithmetic Coding) which is used with one of the entropy coding ways for the latest video compression technique, H.264/AVC (Advanced Video Coding). CABAC typically provides a better high compression performance maximum 15% compared with CAVLC. However, the complexity of operation of CABAC is significantly higher than the CAVLC. Because of complicated data dependency during the encoding process, the complexity of operation is higher. Therefore, various architectures were proposed to reduce an amount of operation. However, they have still latency on account of complicated data dependency. The proposed architecture has two techniques to implement efficient pipeline architecture. The one is quick calculation of 7, 8th bits used to calculate a probability is the first step in Binary arithmetic coding. The other is one step reduced pipeline arcbitecture when the type of the encoded symbols is MPS. By adopting these two techniques, the required processing time was reduced about 27-29% compared with previous architectures. It is designed in a hardware description language and total logic gate count is 19K using 0.18um standard cell library.