• Journal of Korea Society of Industrial Information Systems
• /
• v.17 no.3
• /
• pp.27-34
• /
• 2012

This paper presents the impact of time dependent dielectric breakdown (TDDB, also called as gate oxide breakdown) failure on nanoscale digital CMOS Circuits. Recently, TDDB for ultra-thin gate oxides has been considered as one of the critical reliability issues which can lead to performance degradation or logic failures in nanoscale CMOS devices. Also, leakage power in the standby mode can be increased significantly. In this paper, TDDB aging effects on large CMOS digital circuits in the 45nm technology are analyzed. Simulation results show that TDDB effect on MOSFET circuits can result in more significant increase of power consumption compared to delay increase.

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1526-1528
• /
• 1996

The dielectric reliability of a polycrystalline and a multilayered $BaTiO_3$ thin films was evaluated using a time-zero dielectric breakdown (TZDB) and a time-dependent dielectric breakdown (TDDB) techniques. The $BaTiO_3$ thin films were prepared by rf-magnetron sputtering technique on ITO-coated glass substrates. In case of the multilayered $BaTiO_3$ thin film, the dielectric breakdown histogram, which was obtained from the TZDB measurements, showed a typical Weibull distribution. While in case of polycrystalIine $BaTiO_3$ thin film, a randomly distributed dielectric breakdown histogram was observed. The TDDB results of the multilayered $BaTiO_3$ thin film guaranteed about $10^5$ hours-operation under the stress field of 1 MV/cm.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.16 no.4
• /
• pp.173-179
• /
• 2023

This paper analyzes the time-dependent dielectric breakdown(TDDB) degradation mechanism for each stress region of Peri devices manufactured by 4th generation VNAND process, and presents a complementary lifetime prediction model that improves speed and accuracy in a wider reliability evaluation region compared to the conventional model presented. SiON dielectric nMOSFETs were measured 10 times each under 5 constant voltage stress(CVS) conditions. The analysis of stress-induced leakage current(SILC) confirmed the significance of the field-based degradation mechanism in the low electric field region and the current-based degradation mechanism in the high field region. Time-to-failure(TF) was extracted from Weibull distribution to ascertain the lifetime prediction limitations of the conventional E-model and 1/E-model, and a parallel complementary model including both electric field and current based degradation mechanisms was proposed by extracting and combining the thermal bond breakage rate constant(k) of each model. Finally, when predicting the lifetime of the measured TDDB data, the proposed complementary model predicts lifetime faster and more accurately, even in the wider electric field region, compared to the conventional E-model and 1/E-model.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.30A no.11
• /
• pp.105-112
• /
• 1993

Oxide and reoxidized-nitrided-oxide were formed by furnace oxidation and rapid thermal processing (RTP). MOS capacitor and n-MOSFET's with those films as gate insulators were fabricated. The electrical characteristics of insulators were evaluated by current-voltage, high-frequency capacitance-voltage (C-V), and time-dependent dielectrical breakdown (TDDB) measurements. The hot carrier effects of MOSFET's were also investigated. Time-dependent dielectrical breakdown (TDDB) characteristics show that the life time of reoxidized-nitrided-oxide films is about 3 times longer than that of oxides. Hot carrier effects reveal that the life time of MOSFET's with reoxidized-nitrided-oxides is about 3 times longer than that of MOSFET's with oxides. Therefore, it is found that the reliability of dielectric films estimated by the hot carrier effects of MOSFET's is consistent with that of dielectric films from TDDB method.

• Proceedings of the KIEE Conference
• /
• 1988.11a
• /
• pp.147-150
• /
• 1988

Since the integration level of VLSI circuits progresses very quickly, a highly reliable thin $SiO_2$ film is required to fabricate a small-geometry MOS device. In the present study we have attempted to eliminate the failure-causing defects that develop in thin oxide films during the oxidation step by performing a long-time preoxidation and postoxidation annealing. The TDDB test and the copper decoration method were used to calculate the oxide defects density of MOS device. The dielectric reliability of high-quality thin oxides have been studied by using the time-zero-dielectric-breakdown (ramp-voltage-stressed I-V) and time-dependent-dielectric -breakdown (Constant-stressed I-V) tests. Failure times against temperature and electric field are examined and acceleration factors are abtained for each parameter. Based on the data obtained, breakdown wearout limitation for thin oxide films is estimated.

• Journal of Sensor Science and Technology
• /
• v.28 no.1
• /
• pp.17-22
• /
• 2019

As CMOS technology scales down, reliability is becoming an important concern for VLSI designers. This paper analyzes gate-oxide breakdowns (i.e., the time-dependent dielectric-breakdown (TDDB) aging effect) as a reliability issue for combinational circuits with 45-nm technology. This paper shows simulation results for the noise margin, delay, and power using a single inverter-chain circuit, as well as the International Symposium on Circuits and Systems (ISCAS)'85 benchmark circuits. The delay and power variations in the presence of TDDB are also discussed in the paper. Finally, we propose a novel method to compensate for the logic failure due to dielectric breakdowns: We used a higher supply voltage and a negative ground voltage for the circuit. The proposed method was verified using the ISCAS'85 benchmark circuits.

• Proceedings of the KIEE Conference
• /
• 1991.07a
• /
• pp.191-193
• /
• 1991

In this paper, we introduce silicon dioxide films deposited by Laser CVD, and evaluate the breakdown characteristics of these films by TZDB(Time Zero Dieiectric Breakdown) and TDDB(Time Dependent Dielectric Breakdown) test, failure times against eletric field are examined and accelation factors ${\beta}$ are obtained, and also, long term reliability is described by examining TDDB under positive voltage bias, all the above results are compared with PECVD(Plasma Enhanced CVD) $SiO_2$ breakdown, data, as a result, it is shown that the breakdown characteristics of Laser CVD $SiO_2$ films is improved.

• Proceedings of the KIEE Conference
• /
• 1997.07d
• /
• pp.1232-1235
• /
• 1997

서로 다른 두께를 가진 다층구조 $BaTiO_3$ 박막의 절연신뢰성을 time-zero dielectric breakdown (TZDB) 기법과 time-dependent dielectric breakdown (TDDB) 기법을 사용하여 평가하였으며 통계적 방법을 이용하여 그 결과를 분석하였다. 다층구조 $BaTiO_3$ 박막은 rf-magnetron sputtering 방법으로 ITO가 코팅된 유리기판 위에 형성되었다 TZDB 측정 결과, 박막의 두께가 증가 할수록 최고 빈도수를 보이는 항복전기장의 세기는 낮아지는 것으로 확인되었으며, 두께에 따라 다른 항전기장의 분포를 보였다. TDDB 결과로부터 박막의 두께 증가에 파라 안정적인 시간거동 특성이 확인되었으며 이것은 항전기장의 분포 특성과 관계가 있는 것으로 보인다.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.6
• /
• pp.43-49
• /
• 1997

Tungsten poycide has studied gate oxide reliability and dielectric strength charactristics as the composition of gate electrode which applied submicron on CMOS and MOS device for optimizing gate electrode resistivity. The gate oxide reliability has been tested using the TDDB(time dependent dielectric breakdwon) and SCTDDB (stepped current TDDB) and corelation between polysilicon and WSi$_{2}$ layer. iN the case of high intrinsic reliability and good breakdown chracteristics on polysilicon, confirmed that tungsten polycide layer is a better reliabilify properities than polysilicon layer. Also, hole trap is detected on the polysilicon structure meanwhile electron trap is detected on polycide structure. In the case of electron trap, the WSi$_{2}$ layer is larger interface trap genration than polysilicon on large POCL$_{3}$ doping time and high POCL$_{3}$ doping temperature condition. WSi$_{2}$ layer's leakage current is less than 1 order and dielectric strength is a larger than 2MV/cm.

• Proceedings of the IEEK Conference
• /
• 1998.06a
• /
• pp.343-346
• /
• 1998

Ultra-thin gate oxide in MOS devices are subjected to high-field stress during device operation, which degrades the oxide and exentually causes dielectric breakdown. In this paper, we investigate the electrical properties of ultra-thin nitrided oxide (NO) and reoxidized nitrided oxide(ONO) films that are considered to be promising candidates for replacing conventional silicon dioxide film in ULSI level integration. We study vriations of I-V characteristics due to F-N tunneling, and time-dependent dielectric breakdown (TDDB) of thin layer NO and ONO depending on nitridation and reoxidation condition, and compare with thermal $SiO_{2}$. From the measurement results, we find that these NO and ONO thin films are strongly depending on its condition and that optimized reoxided nitrided oxides (ONO) films show superior dielectric characteristics, and breakdown-to-change ( $Q_{bd}$ ) performance over the NO films, while maintaining a similar electric field dependence compared to NO layer.