• Journal of Korean Society of Transportation
• /
• v.24 no.7 s.93
• /
• pp.65-79
• /
• 2006

The ATIS(Advance Traveler Information System), as one part of ITS, is a system aiming to disperse traffic volume on transportation networks by providing traffic information to transportation users on pre-trip and en-route trips. One of tools in ATIS is usage of VMS(Variable Message Signs). It provides to the drivers with direct information about state of processing direction. which is considered as the most effective method in ATIS. The purposes of providing VMS information are classified two categories. One is to provide simple information to drivers for their convenience. The other is to manage traffic demand to improve transportation network performance. However, for more effective and reliable VMS information, several strategies should be taken into account. The main VMS management strategy is "Traffic Diversion Strategy for minimum delay" when traffic congestion or incident are occurred. For effective operation. firstly. reasonable diversion traffic volume is determined by network traffic condition Secondly, it is necessary to make providing information strategy which reflects driver response behavior for controling diversion traffic volume. This paper focuses on the providing real-time route guidance information by VMS when congestion is occurred by the incidents. This sturdy estimates time-dependent system optimal diversion rate that inflects travel time and queue lengths using traffic flow simulation model on base Cellular Automata. In addition, route choice behavior models are developed using binary logit model for traffic information variable by traffic system controller. Finally, this study provides time-dependent VMS massage contents and degree of providing information in order to optimize the traffic flow.

• Journal of the Korean institute of surface engineering
• /
• v.51 no.6
• /
• pp.393-399
• /
• 2018

Formation behavior of aluminum anodic oxide (AAO) films on Al6061 alloy was studied in view of thickness, morphology and defects in the anodic films in 20 vol.% sulfuric acid solution at a constant current density of $40mA/cm^2$, using voltage-time curve, observation of anodized specimen colors and surface and cross-sectional morphologies of anodic films with anodization time. With increasing anodizing time, voltage for film formation increased exponentially after about 12 min and its increasing rate decreased after 25 min, followed by a rapid decrease of the voltage after about 28 min. Surface color of anodized specimen became darker with increasing anodizing time up to about 20 min, while it appeared to be brighter with increasing anodizing time after 20 min. The darkened and brightened surfaces with anodizing time are attributed to an increase in thickness of porous anodic oxide film and a chemical damage of the films due to heat generated by increased resistance of the film, respectively. Cross-sectional observation of AAO films revealed the formation of defects of crack shape at the metal/oxide interface after 15 min which prevents the growth of AAO films. Width and length of the crack-like defect increased with anodizing time up to 25 min of anodizing, and finally the outer part of AAO films was partly dissolved or detached after 30 min of anodizing, resulting in non-uniform surface structures of the AAO films.

• Journal of the Korea Concrete Institute
• /
• v.24 no.6
• /
• pp.633-641
• /
• 2012

In this study, the effects of the inelastic shear behavior of beam-column joint on the response of RC OMRF are evaluated in the inelastic time history analysis. For an example, a 5-story structure for site class SB and seismic design category C was designed in accordance with KBC2009. Bending moment-curvature relationship for beam and column was evaluated using fiber model and bending moment-rotation relationship for beam-column joint was calculated using simple and unified joint shear behavior model and moment equilibrium relationship. The hysteretic behavior was simulated using three-parameter model suggested in IDARC program. The inelastic time history analysis with PGA for return period of 2400 years showed that the model with inelastic beam-column joint yielded smaller maximum base shear force but nearly equivalent maximum roof displacement and maximum story drift as those obtained from analysis using rigid joint. The maximum story drift satisfied the criteria of KBC2009. Therefore, the inelastic shear behavior of beam-column joint could be neglected in the structural design.

• Korean Journal of Health Education and Promotion
• /
• v.13 no.2
• /
• pp.35-53
• /
• 1996

The objective of the health promotion program was to strengthen the ability and willingness of individuals in the course of each stage of their lives to take action in support of their health and that of their families and communities in the home, the place of work and the school, and during recreation. The purpose of this study was to assess the need of school health promotion through health care behavior survey about diet, accident prevention, cigarette smoking experience, personal hygiene, visual impairment prevention, exercise, and environment protection. The subjects of this study were 914 students composed of Samrye, Bongdong, Samrye-Dong, Iseo, and Songkwang elementary school in Wanju area. The data were collected by questionaire corrected for the purpose of this study which had been developed by WHO, ‘Health behavior in school children’. These were carried out from March 20 to April 20, 1996. The data was analyzed by frequency, percentage, χ²-test with SPSS-PC+ program. The results were as follows. 1. Diet related behavior 1) Girl students eat less breakfast than male students. 2) Girl students eat less 3 times a day than male students. 3) The rate of eating nutritious medicine was high in order of 4th, 6th, and 5th graders. 4) Girl students drink less milk than male students. 5) The intake frequency of eating between meals was high in order of 6th, 5th, and 4th grader. 2. Cigarette smoking behavior 1) The rate of cigarette smoking rarely was high in 5th grader. 2) Male students smoke cigarette more than girl students. 3. Personal hygiene related behavior 1) The rate of washing hands after using toilet room was low in order of 4th, 5th, and 6th graders. 2) The rate of washing hands after using toilet room was low in male students. 3) The rate of washing hands when entering home from outdoor was low in male students. 4) The tooth brushing frequency before going to bed was low in male students. 5) The tooth brushing frequency was low in male students. 6) The rate of bathing was most low in 4th grader. 7) The rate of bathing was low in male students. 4. Visual impairment preventive behavior 1) The distance between eyes and book was near in order of 6th, 5th, and 4th graders. 5. Exercise 1) The exercise time in school was less in 4th grader. 2) The exercise time in school was less in girl students. 3) The exercise time out of school was less in 4th grader. 4) The exercise time out of school was less in girl students. 5) The self evaluation score about exercise ability was low in girl students. 6. Environment related behavior D The rate of collecting waste separately in school was most low in 4th grader.

• Journal of Animal Science and Technology
• /
• v.63 no.4
• /
• pp.790-798
• /
• 2021

The objective of this study was evaluation of pig behavior changes related to temperature, relative humidity, volatile organic compounds (VOCs), and illuminance. A total of 24 growing pigs ([Yorkshire × Landrace] × Duroc) were used in the experiment. A sensor was installed at a height of 0.5 m in the center of the pig house. In experiment 1, temperature was changed every four days to 18℃ (T1), 22℃ (T2), 26℃ (T3), and then 30℃ (T4). In experiment 2, relative humidity was adjusted to 45% (low humidity [LH]), 60% (middle humidity [MH]), and then 75% (high humidity [HH]) for four days. In experiment 3, after cleaning the pig house just before experiment, only minimal ventilation was provided. VOCs and pig behaviors were observed for 7 days without cleaning the pig house. In experiment 4, three light bulbs of 40 W (470 lumens / 45 lx; low illuminance [LI]), 75 W (1,055 lumens / 103 lx; middle illuminance [MI]), and 100 W (1,521 lumens / 146 lx; high illuminance [HI]) were used for four days each. Pig behavior analysis was performed for following criteria : Feed intake, Standing, Lying, Sitting, Drink water, Rooting, Posture transition (lying-standing), Posture transition (standing-lying), Wallowing, and Biting. In experiment 1, feed intake time was lower (p < 0.05) for the T3 than other treatment groups. Standing time was highest (p < 0.05) for the T1 and lowest (p < 0.05) for the T3. Lying time was shorter (p < 0.05) in T1 and T2 compared to T3 and T4. Drinking frequency was higher (p < 0.05) for the T4 than other treatment groups. In experiment 2, the frequency of rooting and wallowing increased (p < 0.05) with increasing humidity. LH showed the lowest (p < 0.05) rooting frequency and HH showed the highest (p < 0.05) rooting frequency. In experiment 3, VOCs concentration did not (p > 0.05) change pig behavior. In experiment 4, lying time was the longest (p < 0.05) at LI and shortest (p < 0.05) at HI. Therefore, pig behavior is heavily influenced by the environment, especially temperature and humidity. However, correlation between pig behavior to VOCs and illuminance seems to be needed more research.

• Journal of Families and Better Life
• /
• v.22 no.5
• /
• pp.29-45
• /
• 2004

This ethnographic case-study explores the interpretation and behavior in job considering among full-time housewives. The participants of this study are eleven middle class full-time housewives in their thirties and forties. In-depth interviews based on an unstructured Questionnaire were conducted for this study. Findings are as follows: Six full-time housewives tend to think their full-time housewife-lives more convenient, something unable to substitute and more profitable compared to the counter partner's lives. But they are classified into two groups according to the satisfaction for full-time housewife life. One group has found out more positive meaning in their life but the other group has not yet and they are doubtful about real life and other opportunity. In Contrast, other five full-time housewives tend to interpret employment as a more productive source to secure family resource for their children's education and repay the loan used to buy larger apartment. And the job is considered to confirm her own individuality and the feeling for the social entity as a competent social entity. But two of them who have never been employed do not try to get a job as a new identity alternative. And the various elements like household income, job experience, health, children's age and husband's attitude to his wife's employment etc. are defined to influence the interpretation and the job considering behavior among full-time housewives.

• Journal of Korean Society of Transportation
• /
• v.27 no.2
• /
• pp.169-178
• /
• 2009

This study is aimed at identifying the association of commuting behavior with health for workers in the Korea Capital Region. The study surveyed a total of 1,285 commuters whose major work is deskwork-oriented; the authors obtained their health status on body form, blood pressure and cholesterol as well as their commuting behavior. The measures of the latter were comprised of a main commuting mode, a use term, out-of-vehicle time, total travel time, transit transfer, and alternative mode in order to identify the amount of physical activity obtained through commuting behavior. The results indicate that non-automobile commuters are positively associated to improve their health status, as compared to car commuters. Specifically, bus commuters and walkers had decreased weight, blood pressure, and cholesterol, while rail commuters are only correlated to relieving cholesterol. In addition, the measures for health are improved as out-of-vehicle time increases. For commuters who drive to work, their health status tends to be worse.

• Steel and Composite Structures
• /
• v.34 no.5
• /
• pp.625-641
• /
• 2020

The realistic modeling of the beam-column semi-rigid connection in steel frames attracted the attention of many researchers in the past for the seismic analysis of semi-rigid frames. Comparatively less studies have been made to investigate the behavior of steel frames with semi-rigid connections under different types of earthquake. Herein, the seismic behavior of semi-rigid steel frames is investigated under both far and near-field earthquakes. The semi-rigid connection is modeled by the multilinear plastic link element consisting of rotational springs. The kinematic hysteresis model is used to define the dynamic behavior of the rotational spring, describing the nonlinearity of the semi-rigid connection as defined in SAP2000. The nonlinear time history analysis (NTHA) is performed to obtain response time histories of the frame under scaled earthquakes at three PGA levels denoting the low, medium and high-level earthquakes. The other important parameters varied are the stiffness and strength parameters of the connections, defining the degree of semi-rigidity. For studying the behavior of the semi-rigid frame, a large number of seismic demand parameters are considered. The benchmark for comparison is taken as those of the corresponding rigid frame. Two different frames, namely, a five-story frame and a ten-story frame are considered as the numerical examples. It is shown that semi-rigid frames prove to be effective and beneficial in resisting the seismic forces for near-field earthquakes (PGA ≈ 0.2g), especially in reducing the base shear to a considerable extent for the moderate level of earthquake. Further, the semi-rigid frame with a relatively weaker beam and less connection stiffness may withstand a moderately strong earthquake without having much damage in the beams.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.32 no.7
• /
• pp.1046-1055
• /
• 2008

The purpose of this study is to investigate the effects of product variables(i.e., fashionability, brand fame) and situational variables(i.e., time constraint, usage occasion) on the internet browsing behavior (i.e., prepurchase search; ongoing search for products, stores, fashion trends, promotions, and post-purchasing information) for fashion products. This study developed hypothetical scenarios based on the factorial design of the two independent variables for the survey with a questionnaire. All items in the questionnaire were measured on a six-point scale. By convenience sampling and on-line survey, a total of 209 usable responses were used for further analyses. The results show as follows; firstly, respondents more intensively browse for information search on products, stores and fashion trends when the style of browsing products is trendy. Secondly, whether the fashion products have a famous brand name or not has a significant influence on browsing behavior for stores and fashion trends information search. Thirdly, time constraint is found to influence significantly on respondents' browsing for promotions information search. Lastly, occasion for product worn shows a significant influence on browsing behavior for stores and fashion trends information search. The managerial implications are provided based on findings.

• International Journal of Highway Engineering
• /
• v.10 no.4
• /
• pp.171-180
• /
• 2008

This study was conducted to analyze the curling behavior of concrete slabs on grade under temperature loading through the laboratory tests and to investigate the effects of the support conditions of underlying layers on the curling behavior of the slab on grade systems. For the laboratory tests, the concrete slabs were fabricated and the temperature measurement sensors were installed. The temperature loading was applied intentionally and the time histories of the vertical displacements of the slab at several different positions were measured. One-layered underlying layers were made using different materials and different thicknesses. Two-layered underlying layers were also made to have the same composite stiffness each other, but the material of the upper layer was designed to be different The experimental analysis results showed that the trend of the displacement time histories of the slab was basically the same as that of the temperature gradient time histories. The characteristics of the curling behavior of the slab were analyzed by separating the regions of curling up and curling down. The difference in the vertical displacements at the center and comer decreased as the stiffness of the underlying layer became larger, and the upper layer's material of the underlying layers affected the curling behavior of the slab.