• Proceedings of the IEEK Conference
• /
• 2004.06b
• /
• pp.489-492
• /
• 2004

In this paper, we demonstrate polymer thin-film transistors (TFTs) on a paper-based flexible substrate. As a substrate, commercially available photo-paper is used with Parylene coating. The parylene layer enables conventionally used wet chemical process and vacuum deposition processes for electrodes and gate insulator. As an active channel layer, we used poly-3-hexylthiophene (P3HT) which is solution process. Field effect mobility up to $(0.06 {\pm} 0.02) cm^2/Vs$ and on/off ratio of $10^3 {\~}10^4$ are achieved on a photo-paper.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.05a
• /
• pp.11-14
• /
• 2001

We give pressure stimulation into organic thin films and then manufacture a device under the accumulation condition that the state surface pressure is 30[mN/m]. LB layers of Arac. acid deposited by LB method were deposited onto slide glass as Y-type film. The physicochemical properties of the LB films were examined by UV absorption spectrum, SEM and AFM. The structure of manufactured device is Au/arachidic acid/Al. the number of accumulated layers are 3~9. Also. we then examined of the MIM device by means of I-V. The I-V characteristic of the device is measured from -3 to +3[V]. The insulation property of a thin film is better as the distance between electrodes is larger.

• Proceedings of the KSME Conference
• /
• 2007.05a
• /
• pp.441-445
• /
• 2007

In this paper we demonstrated the applications of OTFTs (organic thin film transistors) to flexible displays such as AM-EPD (active matrix electrophoretic display) and AM-OLED (active matrix organic light emitting diode), and also to integrated circuits. The OTFTs using pentacene semiconductor layer and PVP gate dielectric and Au S/D electrodes exhibited good performance for AM-EPD with the mobility of $0.59\;cm^{2}/V.sec,$ and with also good uniformity over 2.5" diagonal area. However, it is nor enough for AM-OLED requiring the mobility larger than $1\;cm^{2}/V.sec$ for large area displays. The integrated circuits also worked, producing the operating frequency of 1MHz. We need to develop a fabrication process to reduce parasitic capacitance for high frequency operation.

• Proceedings of the KIEE Conference
• /
• 1988.11a
• /
• pp.172-174
• /
• 1988

Studies and measurements of open circuit voltage in a metal/insulator/metal structure where metal are electrodes, when the insulator molecules have dipole moments all oriented parallel to each other have been reported here. The measured voltage has been shown to be directed related to the dipole moment of the molecules in the films. The insulator ultra thin films was deposited on them by the Langmuir-Blodgett technique to obtain the structure referred to as z type and Hetero structure of LB films.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.1135-1138
• /
• 2006

By ink-jet printing method, organic thin-film transistors (OTFTs) having soluble 6,13-bis (triisopropylsilylethynyl) pentacene (TIPS pentacene) as an active material were fabricated. The TIPS pentacene solution was made with chlorobenzene and anisole. The solutions were printed on poly (4-vinylphenol) (PVP) dielectric layers and source/drain electrodes by piezo-type heads for bottom contact OTFTs. The dielectric layers had untreated or HMDS-treated conditions. The chlorobenzene device showed the highest field effect mobility of $0.016\;cm^2/Vs$ and the anisole HMDS-treated device shows the highest $I_{on}/I_{off}$ ratio of $10^5$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.04b
• /
• pp.63-64
• /
• 2009

The TFTs have been fabricated with 3 different geometry SID electrodes which have the same channel W/L ratio (W/L = 5) due to constant channel resistance, The 3 samples have different channel widths (350, 150, and $25\;{\mu}m$) and channel lengths (70, 30, and $5\;{\mu}m$) by fixed channel W/L ratio simultaneously on one chip for reliable comparisons. Resultant on-current and field effect mobility are proportional to the channel width, while the subthreshold swing is inversely proportional to the channel width mainly due to the change of contact resistance. These results show that the contact resistance strongly affects the device performances and should be considered in the applications.

• Proceedings of the KSME Conference
• /
• 2008.11a
• /
• pp.1733-1736
• /
• 2008

ZnO thin films with preferred orientation along the (0 0 2) plane were fabricated by a sol-gel method. The effects of the annealing temperature, time, and thickness were studied by investigating UV-visible spectra, FT-IR spectra, and XRD of ZnO films. The films were dried and annealed ed at $100^{\circ}C,\;200^{\circ}C$, and $300^{\circ}C$ for 1hr, 2hrs, and 3hrs, respectively. The film showed the preferred (0 0 2) orientation and high transmittance near 90% in the visible range. Also, SEM images of the films exhibited very smooth surfaces without holes and cracks. Schottky diodes were fabricated by using ZnO sol-gel material. Au and Al were used as electrodes to make Ohmic and Schottky contacts, respectively. The annealing temperature, time and the thickness dependent I-V characteristics were presented in this article.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.99-99
• /
• 2014

Transparent oxide semiconductors (TOSs) are. currently attracting attention for application to transparent electrodes in optoelectronic devices and active channel layers in thin-film transistors. One of the key issues for the realization of next generation transparent electronic devices such as transparent complementary metal-oxide-semiconductor thin-film transistors (CMOS TFTs), transparent wall light, sensors, and transparent solar cell is to develop p-type TOSs. In this talks, I will introduce issues and status related to p-type TOSs such as LnCuOQ (Ln=lanthanide, Q=S, Se), $SrCu_2O_2$, $CuMO_2$ (M=Al, Ga, Cr, In), ZnO, $Cu_2O$ and SnO. The growth and properties of SnO and Cu-based oxides and their application to electronic devices will be discussed.

• Applied Science and Convergence Technology
• /
• v.27 no.2
• /
• pp.23-25
• /
• 2018

With respect to the electrode structure and the discharge characteristics, the atmospheric pressure plasma sheet of a thin polyimide film is introduced in this study; here, the flexible plasma device of a dielectric-barrier discharge with the ground electrode and the high-voltage electrode formulated on each surface of a polyimide film whose thickness is approximately $100{\mu}m$, that is operated with a sinusoidal voltage at a frequency of 25 kHz and a low voltage from 1 kV to 2 kV is used. The streamer discharge is appeared along the cross-sectional boundary line between two electrodes at the ignition stage, and the plasma is diffused on the dielectric-layer surface over the high-voltage electrode. In the development of a plasma sheet with thin dielectric films, the avoidance of the insulation breakdown and the reduction of the leakage current have a direct influence on the low-voltage operation.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2018.06a
• /
• pp.142.1-142.1
• /
• 2018

This research presents a new field effect transistor (FET) by using liquid crystal gate dielectric with remote gate. The fabrication of thin-film transistors (TFTs) was used Indium tin oxide (ITO) for the source, drain, and gate electrodes, and indium gallium zinc oxide (IGZO) for the active semiconductor layer. 5CB liquid crystal was used for the gate dielectric material, and the remote gate and active layer were covered with the liquid crystal. The output and transfer characteristics of the LC-gated TFTs were investigated.