• Proceedings of the KIEE Conference
• /
• 2002.07c
• /
• pp.1745-1747
• /
• 2002

This paper describes the effect of secondary surges entering low voltage side on the primary winding of pole transformers. After having connected the secondary winding by 4 different methods, surge voltages were applied to the low voltage side, and voltage waveforms were measured at a surge applied point and a high voltage bushing terminal. The measured voltages were compared by the waveform, magnitude and damping characteristics with each connection. As a result, the voltage waveforms induced by the secondary surges were different one another with each connection, especially, the conventional connecting method for 2 voltage sources was far different from the present method supplying only 1 voltage source in shape of the voltage waveform.

• Proceedings of the KIEE Conference
• /
• 1999.11b
• /
• pp.282-284
• /
• 1999

This paper presents an accurate algorithm for fault location of a single phase to earth fault on a two-parallel transmission line using only one-terminal data. It is impossible to calculate the accurate fault distance, because of the unknown fault resistance and fault current at the fault point. The faulted line circuit and the zero-sequence circuit of two-parallel line are used as a fault location model, which the source impedance of the remote end is not involved. The algorithm can eliminate the effect of load flow and the fault resistance in calculating the fault location.

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.126-129
• /
• 2007

Telematics, one of the so-called New Growth Engine of IT839, is a leading IT service where wireless internet service represented by information and mobility is extended to the area of transportations to provide Telematics service. The killer-application of Telematics is navigation system. Recently, due to the mass storage conversion, the performance of the terminal and mobile communications technology development, navigation system is also changed. It more and more develops into 3D in a preexistence 2D map. In the future, it is expected to include the remote sensing map. There is also the characteristic of all the information expressed in frequently a change partially happening. That is, POI(Point Of Interest) which is freshly registered or is deleted is many. In a preexistence, MCP(Map Contents Providers) offer the new version map by off-line monthly or quarterly. And a user wastes time and is inconvenient because of updating the total map by the off-line. Thus, in this paper, in order to resolve this, we describe MCP-MAUS(Maus Air Update Server) interface for updating only the partial map that was changed.

• Journal of Powder Materials
• /
• v.14 no.5
• /
• pp.327-332
• /
• 2007

In a view point of environment, the advanced electric contact material without environmental load element such as cadmium has to be developed. Extensive studies have been carried out on $Ag-SnO_2$ electric contact material as a substitute of Ag-CdO contact materials. In the present study, powder metallurgy including compaction and sintering is introduced to solve the incomplete oxidation problems in manufacturing process of $Ag-SnO_2$ electrical contact material. The $Ag-SnO_2$ contact material, fabricated in this study, was actually set in an electric switchgear of which working voltage is 462V and current is between 25 and 40A, for the purpose of testing its performance. As a result, it exceeded the existing Ag-CdO contact materials in terminal-temperature ascent and main contact resistance.

• Health Policy and Management
• /
• v.10 no.3
• /
• pp.68-87
• /
• 2000

This study aims at the operation of the hospice in the virtual space by the use of telecommunication technology. The hospice can be an efficient alternative for the elderly and terminal patients. It can achieve both the quality of life of patients and the conservations of medical resources. The virtualization creates new norms and values which are different from the conventional environments. The concepts and limitations which are crucial to the projection of the existing hospice into the virtual space are discussed. The items ranging from the hospice need to the design criteria of the modules are investigated. The most important point in constructing the virtual hospice center is the human factor, which characterizes the hospice. In addition, the real-world circumstances of the hospice should be considered in the realization of the VHC.

• Journal of Korea Society of Digital Industry and Information Management
• /
• v.7 no.2
• /
• pp.39-46
• /
• 2011

Privacy IP hacking problems such as invasion of privacy, password cracking, voice wiretapping and internet over charged occurred, because VoIP internet voice phone service gradually spread. This thesis attempted to attack the VoIP service network by application. First use application to spoof IP address then attempted wiretap the VoIP service and sends a lot of messages to disturb service movement. At this point, we connected VoIP soft terminal, so we can operate real-time filtering operator to block the SIP Flooding offence by monitor the traffic and detect the location where it got attacked. This thesis used experiment to prove it is possible to detect the offence and defend from SIP Flooding offence.

• 유체기계공업학회:학술대회논문집
• /
• 2004.12a
• /
• pp.665-672
• /
• 2004

Chemical cleaning of boiler pipelines is necessary before the commissioning of thermal power plant after many years of construction. Fluid-Dynamic study for the chemical cleaning of boiler piplelines in Young-Heung thermal power plant is carried out. First, flow velocity necessary to sustain and exhaust solid particles in the vertical pipelines is calculated. Second, the flowrate necessary to make the calculated velocities in each vertical pipelines is calculated. Third, all the pipelines are analyzed with the Piping Systems Fluid Flow software to calculated the pressure loss in the pipelines. Finally, the operating point of the applied pump is calculated with the help of the same software.

• Journal of Korea Port Economic Association
• /
• v.18 no.1
• /
• pp.135-157
• /
• 2002

The fact that Pyeongtaek Port is located ideally at the central point of the Yellow Sea's Economic Zone and it is very close to the metropolitan area of South Korea which occupies more than 50 percent of the total trade volume in terms of tonnage is providing a good prospect of development for the Port of Pyeongtaek. This study examines the perception of shippers in Kyonggi-do on the development of Pyeongtaek Port, giving some suggestions to the Pyeongtaek Port Authority. It begins with a description of the port such as current economic status, statistics on the economy, trade and investment regarding the Port of Pyeongtaek. According to a particular questionnaire survey conducted in December 2001, the major obstacles to the utilization of the port are as follows: a shortage of liner shipping routes, lack of container handling facilities including container terminal, crane etc., and port sales promotion activity. Therefore the port should make aggressive efforts to attract container cargoes to and from China by expanding port facilities, implementing effective marketing strategies, introducing a customs-free zone/free trade zone, and strengthening port sales etc.

• Journal of the Korea Safety Management & Science
• /
• v.19 no.3
• /
• pp.49-58
• /
• 2017

This paper suggests a specific model that could efficiently improve the interaction and the interface between MES(Manufacturing Execution System) server and POP(Point of Production) terminal through electronic document server and electronic pen, bluetooth receiver and form paper in disassembly and process inspection works. The proposed model shows that the new method by electronic document automation system can more efficiently perform to reduce processing time for maintenance work, compared with the current approach by handwritten processing system. It is noted in case of the method by electronic document automation system that the effects of proposed model are as follows; (a) While the processing time per equipment for maintenance by the current method was 300 minutes, the processing time by the new method was 50 minutes. (b) While the processing error ratio by the current method was 20%, the error ratio by the new method was 1%.

• Clinical and Experimental Pediatrics
• /
• v.53 no.9
• /
• pp.824-829
• /
• 2010

The safety and effectiveness of colonoscopy in the investigation of lower gastrointestinal tract pathology in children has been established for more than 2 decades in Korea. The skill and experience have since advanced to the point that both diagnostic and therapeutic colonoscopy are now routinely performed by most pediatric gastroenterologists. Pediatric colonoscopy differs significantly from its adult parallels in nearly every aspect including patient and parent management and preparation, selection criteria for sedation and general anesthetic, bowel preparation, expected diagnoses, instrument selection, imperative for terminal ileal intubation, and requirement for biopsies from macroscopically normal mucosa. Investigation of inflammatory bowel disease, whether for diagnosis or follow-up evaluation, and suspected colonic polyps are the most common indication for pediatric colonoscopy. The child who presents with signs and symptoms of lower gastrointestinal disorder should undergo colonoscopy with biopsy to make the diagnosis, as well as to help determine the appropriate therapy. This review introduces practical information on pediatric colonoscopy, the author's experiences, and the role of colonoscopic examination in the diagnosis and treatment of pediatric lower gastrointestinal disorders.