• Journal of Soil and Groundwater Environment
• /
• v.18 no.1
• /
• pp.85-93
• /
• 2013

This study is conducted to evaluate the leaching of contaminants from mine tailing by natural water and finally to estimate the leaching and transportation of heavy metal contaminants by rainfall. In order to identify contaminated heavy metal of soil, 17 soil, 2 tailing and 2 waste dump and 2 control samples were taken at mine area and analyzed total metal contents. The leaching experiments were conducted using distilled water. Cu, Pb, Zn was extracted from the reddish mine tailing in a short period time, especially the extraction rate of Cu (45.0%) was highest. The contaminants were leached from the yellowish mine tailing within an hour and the leaching rate of Cd (42.0%) and Zn (17.2%) were relatively high. The reddish soil from the waste dump showed leaching of Cu (5.1%), Pb (4.0%) and Zn (3.3%), however the leaching rate was low except Mi (14.2%). From the yellowish soil sampled from the dumping site, the leaching of Cu (8.2%) and Ni (9.7%) was high while the leaching of Zn (0.2%) were relatively low.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.12
• /
• pp.4327-4331
• /
• 2011

A new method in thermal ionization mass spectrometry (TIMS) was developed to correct peak tailing backgrounds in the isotope ratio measurements of uranium in ultra trace levels for higher accuracy. Two different uranium standard reference materials (U005 and U030) were used to construct databases of signal intensities at mass 234 u and mass 236 u, which correspond to the two uranium minor isotopes, and signal intensity of $^{238}U$. Correlations between peak tailing backgrounds and $^{238}U$ were obtained by least-squares regression on calculated backgrounds at mass 234 u and mass 236 u with respect to the signal intensity of $^{238}U$ followed by separation of the peak tails of the two major isotopes of uranium ($^{235}U$ and $^{238}U$), which enables us to obtain a master equation for peak tailing background correction on all kinds of samples. Verification of the correction method was carried out using U010 and IRMM-040a.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.09a
• /
• pp.40-43
• /
• 2002

Electrokinetic remediation was studied for the removal of toxic heavy metals from tailing soils. This study emphasized the dependency of removal efficiency upon heavy metal speciation, as demonstrated by different extraction methods (sequential extraction, total digestion, and 0.1 N HC1 extraction). The tailing soils examined showed different physicochemical characteristics, in view of initial pH, particle size distribution, and major mineral constituents, and contained high concentrations of target metal contaminants in various forms. The electrokinetic removal efficiency of heavy metals was significantly influenced by their partitioning prior to treatment, and by the pHs of the tailing soils. The mobile and weakly bound fractions of heavy metals, such as exchangeable fraction, were easily removed by electrokinetic treatment (more than 90% in removal efficiency), whereas immobile and strongly bound fractions, such as organically bound and residual fractions, were not effectively removed (less than 20% in removal efficiency).

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.04a
• /
• pp.279-282
• /
• 2002

In this study, mine tailing buffer zone in cathode was used to overcome precipitation of heavy metals that reducing remediation efficiency during electrokinetic remediation. Test results showed that heavy metal transportation affected by initial soil pH which was verified through traditional test and enhanced test with two type of soils. With mine tailing enhanced method 39% of extraction rate was achieved in surface soil and significant transportation trend was observed in deep soil.

• Proceedings of the Korean Operations and Management Science Society Conference
• /
• 2001.10a
• /
• pp.83-86
• /
• 2001

There have been several attempts to describe the recent phonemona of e-tailing and the competition of e-tailers with traditional retailers. However, it appears that the previous models exhibit some shortcomings. With an extension of the well-known circular city model, this paper attempts to relax those limiting assumptions and addresses various issues around electronic commerce: whether e-tailing will eventually drive out traditional retailing, whether e-tailing will necessarily increase competition and lead to lower prices, and whether all the consumers will be better off with more alternatives to choose from.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2004.11a
• /
• pp.297-300
• /
• 2004

The purpose of this study reutilization of waste fine tailing as admixture for cement. We observe tailing's basic properties such as shape, physical and chemical basic features. Also, various admixtures were made of 2 Types of tailings, OPC, fly-ash and blast furnace slag. The basic properties of the cement mortars incorporation with these admixtures were examined and analyzed under a verity of experimental conditions. This work showed that the tailing separated coarse materials could be effectively utilized as replacement materials of cement without any decrease in the strength if we can control the blaine of materials like OPC, slag and fly ash.

• Journal of Soil and Groundwater Environment
• /
• v.8 no.3
• /
• pp.45-55
• /
• 2003

This study investigates the fractional composition and the leaching characteristics of heavy metals in polluted soils due to mining activities. The fractionated composition of heavy metals is classified into five fractions; adsorbed, carbonate, reducible, organic and residual fraction. The status of humic substances in mine wastes of most sites are polyhumic except tailing from Sangdong mine. According to the sequential extraction procedures (SEPs), leaching probabilities of Cd in coal wastes and tailing are relatively low due to high percentage of residual fraction. 46.4% of Ni in tailings from Sangdong mine is probably leached under oxidized environment, and 39.4% of Cu in these tailings is readily extracted under strongly oxidized environment by organic fraction. According to leaching condition of pH 3.0 and pH 5.6, the amount of heavy metals leached out of coal wastes and tailing increases to 1/2 hours. At pH 3.0 and pH 5.6, concentration of Ni in tailing increases up three times of the initial value. Heavy metals released from coal wastes and tailing were not influenced significantly by leaching time.

• Resources Recycling
• /
• v.13 no.3
• /
• pp.19-26
• /
• 2004

In order to use the mine tailing which was generated in the flotation process of scheelite ore into the raw material of ordinary portland cement, the characteristics of the prepared cement clinker was investigated. Scheelite mine tailing is composed of 68.8% of $SiO_2$, 8.6% of $Al_2$$O_3$, 10.8% of $Fe_2$$O_3$, 5.0% of CaO, respectively. It exists as $\alpha$-quartz, muscovite, clinochlore and has 8.0% of 88 $\mu\textrm{m}$ residue. When LSF, SM, and IM of the raw materials (such as limestone, convertor slag, fly ash, and mine tailing) are 91.0, 2.60, and 1.60, respectively, the burnability index of the raw materials is 50.7, the crystal size of $C_3$S and $\beta$-C$_2$S in the prepared clinker is 15∼35$\mu\textrm{m}$, and about 3.8% of scheelite mine tailing can be used as raw material.

• Korean Journal of Soil Science and Fertilizer
• /
• v.34 no.1
• /
• pp.33-41
• /
• 2001

Enormous volumes of mining wastes from the abandoned and closed mines are disposed without a proper treatment in the upper Okdong River basin at Southeastern part of Kangwon Province. Erosion of these wastes contaminates soil, surface water, and sediments with heavy metals. Objectives of this research were to fractionate heavy metals in the mine tailing stored in the Sangdong Tungsten tailing dams and to assess the potential pollution index of each metal fraction. Tailing samples were collected from tailing dams at different depth and analyzed for physical and chemical properties. pH of tailings ranged from 7.3 to 7.9. Contents of total N and organic matter were in the ranges of 3.2~5.5%, and 1.3~9.1%, respectively. Heavy metals in the tailings were higher in the newly constructed tailing dam than those in the old dam. Total concentrations of metals in the tailings were in the orders of Zn > Cu > Pb > Ni > Cd, exceeded the corrective action level of the Soil Environment Conservation Law and higher than the natural abundance levels reported from uncontaminated soils. Relative distribution of heavy metal fractions was residual > organic > reducible > carbonate > adsorbed, reversing the degree of metal bioavailability. Mobile fractions of metals were relatively small compared to the total concentrations. Distribution of metals in the tailing dam profiles was metal specific. Concentrations of Cu at the surface of tailing dams were higher than those at the bottom. Pollution index (PI) values of each fraction of metals were ranged from 4.27 to 8.51 based on total concentrations. PI values of mobile fractions were lower than those of immobile fractions. Results on metal fractions and PI values of the tailing samples indicate that tailing samples were contaminated with heavy metals and had potential to cause a detrimental effects on soil and water environment in the lower part of the stream. A prompt countermeasure to prevent surface of tailings in the dams from water and wind erosions is urgently needed.

• Korean Journal of Environmental Agriculture
• /
• v.25 no.4
• /
• pp.316-322
• /
• 2006

Objective of this research was to assess the release characteristics of metals from the mine tailing to base the prediction of metal load potential from tailing to soils. Water-soluble concentrations of Cd, Cu, Pb and Zn released from mine tailing after 2 hrs were 2.31, 129.38, 17.17, and 287.53 mg/kg, respectively, as compared to 1.6, 128, 108, and 142 mg/kg that were extractable by 0.1 M HCl. Kinetics of metal releases followed the power function model significantly indicating that more of water soluble fractions of those metals released at the initial short time, followed by a slow increase. Concentrations of metals released from tailing by water and 0.1 M HCl were in the orders of Zn > Cu > Pb > Cd. The breakthrough curve from the column experiment showed that concentrations of Cd, Cu, and Zn reached at highest after one pore volume, but that of Pb reached highest after five pore volumes when 0.1 M HCl was used as eluent. The release rate of Cd from mine tailing was the fastest but Pb was the slowest. The cumulative mass of metal released by 0.1 M HCl was in the order of Zn > Cu > Pb > Cd after nine pore volume elution.