• Journal of Information Technology Applications and Management
• /
• v.26 no.6
• /
• pp.103-117
• /
• 2019

Demand for high power motors is rapidly increasing as the 4th industry and convergence technology has recently emerged. In order to produce high-strength permanent magnets, the magnets used for magnetization have been increased from DC 300V in the 1970s to DC 2.5kV in the 2010s, Up to DC 10kV in the 2030s, It is expected that higher voltage will be used to magnetize. However, in the case of a magnetizer using an existing electric signal control device, it is necessary to use a control device with a high-voltage insulation function in case a high voltage used for magnetization is leaked to the control device. If a short circuit accident occurs, the controller must be shut down and serious problems such as excessive repair costs arise. In this study, a control system adopting optical communication method instead of electric signal control method is proposed to prevent leakage currents in high-voltage magnetizer. We design a transmitter(Tx) and a receiver(Rx) device for the optical communication control device and implemented a prototype connecting the optical cable. In order to demonstrate the utility of high-voltage magnetizer using the optical communication control device, we analyzed the initial cost and the yearly cost for the years to analyze the net present value. As a result, In the case of the low-voltage magnetizer, the electric signal control method cost less, As the operating voltage of the magnetizer becomes higher. It is confirmed that it takes less cost when the optical communication control device is used.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.8
• /
• pp.79-85
• /
• 2004

In this paper, the RF-ID system for ubiquitous tagging applications has been designed, fabricated and analysed. The RF-ID System consists of passive RF-ID Tag and Reader. The passive RF-ID tag consists of rectifier using zero-bias schottky diode which converts RF power into DC power, ID chip, ASK modulator using bipolar transistor and slot loop antenna. We suggest an ASK undulation method using a bipolar transistor to compensate the disadvantage of the conventional PIN diode, which needs large current Also, the slot loop antenna with wider bandwidth than that of the conventional patch antenna is suggested The RF-ID reader consist of patch array antenna, Tx/Rx part and ASK demodulator. We have designed the RF-ID System using EM and circuit simulation tools. According to the measured results, The power level of modulation signal at 1 m from passive RF-ID Tag is -46.76 dBm and frequency of it is 57.2 KHz. The transmitting power of RF-ID reader was 500 mW

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.10
• /
• pp.31-39
• /
• 2009

This paper presents the single supply power line communication(PLC) SoC ASIC with built-in analog frond-end circuit. To achieve the low power consumption along with low chip cost, this PLC SoC ASIC employs fully CMOS analog front-end(AFE) and several built-in Regulators(LDOs) powering for Core logic, ADC, DAC and IP Pad driver. The AFE includes RX of pre-amplifier, Programmable gain amplifier and 10 bit ADC and TX of 10bit Digital Analog Converter and Line driver. This PLC Soc was implemented with 0.18um 1 Poly 5 Metal CMOS process. The single power supply of 3.3V is required for the internal LDOs. The total power consumption is below 30mA at standby and 300mA at active which meets the eco-design requirement. The chips size is $3.686\;{\times}\;2.633\;mm^2$.

• Investigative Magnetic Resonance Imaging
• /
• v.24 no.3
• /
• pp.95-122
• /
• 2020

In this article, we evaluated the performance of radiofrequency (RF) coils in terms of the signal-to-noise ratio (S/N) and homogeneity of magnetic resonance images when used for ultrahigh-frequency (UHF) 7T magnetic resonance imaging (MRI). High-quality MRI can be obtained when these two basic requirements are met. However, because of the dielectric effect, 7T magnetic resonance imaging still produces essentially a non-uniform magnetic flux (|B₁|) density distribution. In general, heterogeneous and homogeneous RF coils may be designed using electromagnetic (EM) modeling. Heterogeneous coils, which are surface coils, are used in consideration of scalability in the |B₁| region with a high S/N as multichannel loop coils rather than selecting a single loop. Loop coils are considered state of the art for their simplicity yet effective |B₁|-field distribution and intensity. In addition, combining multiple loop coils allows phase arrays (PA). PA coils have gained great interest for use in receiving signals because of parallel imaging (PI) techniques, such as sensitivity encoding (SENSE) and generalized autocalibrating partial parallel acquisition (GRAPPA), which drastically reduce the acquisition time. With the introduction of a parallel transmit coil (pTx) system, a form of transceiver loop arrays has also been proposed. In this article, we discussed the applications and proposed designs of loop coils. RF homogeneous coils for volume imaging include Alderman-Grant resonators, birdcage coils, saddle coils, traveling wave coils, transmission line arrays, composite right-/left-handed arrays, and fusion coils. In this article, we also discussed the basic operation, design, and applications of these coils.

• Journal of Nutrition and Health
• /
• v.35 no.5
• /
• pp.505-511
• /
• 2002

The study was designed to compare the anti-carcinogenic effect of different level of conjugated linoleic acid (CLA) in 1,2-dimethylhydrazine (DMH)-treated rats by determining biomarkers (apoptosis, cell proliferation, eicosanoids, 1,2-diacylglycerol) and phospholipid fatty acid profile in colonic mucosa. Eighty male Sprague Dawley rats weighing 180-220g were randomly divided into 4 groups depending on the content of CLA, i.e. 0.0% CLA, 0.5% CLA, 1.0% CLA, 1.5% CLA. The experimental diet contained protein 21.6%, carbohydrate 54.6%, and fat 14.5% including CLA mixture at different level by weight. The experimental diet was fed for 14 weeks with the initiation of intramuscular injection of DMH, which was injected twice a week for 6 weeks to give total amount of 180 mg/kg body weight. Regardless of the amount of CLA supplemented to diet, CLA significantly increased the apoptotic index but did not have significant effect on cell proliferation in colonic mucosa. CLA was undetected in colonic mucosal phospholipid of rats fed the 0% CLA diet and increased to 5.9mg/g phospholipid in rats fed the 0.5% diet. The apoptotic index was increased by 251% and the 1,2-DAG content was decreased by 57% in rats fed 0.5% CLA. No further changes in these variables were observed when CLA in the diet was raised to 1.0% or 1.5%. However, dietary CLA decreased mucosal levels of prostaglandin (PG)E$_2$, thromboxane (TX)B$_2$, and arachidonic acid in dose-dependent manner. The present data indicate that dietary CLA can inhibit DMH-induced colon carcinogenesis by mechanism probably involving increased apoptosis.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.19 no.1
• /
• pp.15-24
• /
• 1997

The principle of guided tissue regeneration (GTR), as applied to bone healing, is based on the prevention of connective tissue from entering the bony defect during the healing phase. This allows the slower bone producing cells to migrate into and reproduce bone within the defect. GTR has demonstrated a level of success in regenerating bone defect. Several types of membrane barrier have been utilized to apply this principle in bone regeneration. The purpose of this study was to evaluate whether improved bone regeneration can be achieved with different membrane barriers ($Gore-Tex^{TM}$membrane, $COLLACOTE^{(R)}$). In the 10 NewZealand white rabbits, full-thickness bone defects on three sites of each rabbit calvaria were made. Experimental group 1 was covered with $COLLACOTE^{(R)}$, and group 2 was covered with $Gore-Tex^{TM}$membrane. Macroscopic, microscopic examinations were made serially on 1, 2, 3, 6, 12 weeks after operation. The results were as follows : 1. Macroscopically, both of experimental group 1, 2 were filled with bone-like mass but the defects of experimental group 1 disclosed markedly thinner than the original bone. 2. Microscopically, the defect of experimental group 1, 2 was filled with bony trabeculae without infection and adverse reaction. But multinucleated giant cell infiltration around $COLLACOTE^{(R)}$ was seen till 6th week. 3. Resorption of $COLLACOTE^{(R)}$ started from 3rd week and it was completely resorped on the 12th week.

• Journal of Advanced Navigation Technology
• /
• v.18 no.6
• /
• pp.541-545
• /
• 2014

Rec. ITU-R M.1842-1 is international recommendation for VHF band communication guideline in maritime mobile service RR Appendix 18 channels. In this paper, we simulate 28.8 kbps VHF ${\pi}$/4-DQPSK digital baseband modem compatible with the recommendation, then it is designed and implemented with FPGA. Cazac sequence is used as a preamble since packet format is not defined untill now in the recommendation. Baseband modem is designed by VHDL language and implemented on NEXYS4 development platform having Atrix7 FPGA chip from Xilinx. For wireless communication test of total prototype system, ADC/DAC board is implemented and EV9730 RF module is utilized. From the experimental results, implemented FPGA modem shows spectral bandwidth of 25 kHz and successful data exchanges between tx and rx communication platform.

• Journal of Nutrition and Health
• /
• v.37 no.8
• /
• pp.623-632
• /
• 2004

This study was performed to investigate effect of dried powder or ethanol extracts of onion flesh and peel intakes on lipid metabolism, antioxidative and antithrombogenic capacities in l6-month -old rats. Total of 40 Sprague-Dawley male rats of l6-month-old and weighing 816$\pm$6g were blocked into 5 groups according to body weight and raised for three months with control and experimental diets containing 5% (w/w) of dried powders of onion flesh or peel or ethanol extracts from equal amount of each dried powder. Contents of total flavonoids and total dietary fibers in peel powder were highest among onion preparations. Body weight gain and epididymal pad fat weight were lower in peel powder group than other groups. Plasma total lipid, triglyceride and total cholesterol concentrations of onion-containing groups were lower than control group. Above all, peel ethanol extract intake decreased them most remarkably. Plasma HDL-cholesterol concentrations in onion-containing groups were higher than control group, especially that of flesh powder group was the highest among groups. Liver total lipid, triglyceride and total cholesterol concentrations were not significantly different among all experimental groups. However, liver total lipid and triglyceride concentrations were tended to be lower in onion-containing groups than control group. Thiobarbituric acid reactive substances (TBARS) concentrations in LDL + VLDL fraction was not significantly affected by onion intakes, However peel powder group showed the lowest concentration, Plasma TX $B_2$ concentrations in onion flesh powder, peel powder and peel ethanol extract groups were lower than control group, while plasma 6-keto-PG $F_{1a}$ concentrations in these same groups were higher than control group. Clotting time was tended to be increased in peel ethanol extract group. In conclusion onion diets seemed to improve lipid metabolism and antithrombogenic capacity while effect on antioxidative was not significant.t.

• Journal of Korean Neurosurgical Society
• /
• v.47 no.6
• /
• pp.446-453
• /
• 2010

Objective : The purpose of this study was to analyze the biomechanical effects of three different constrained types of an artificial disc on the implanted and adjacent segments in the lumbar spine using a finite element model (FEM). Methods : The created intact model was validated by comparing the flexion-extension response without pre-load with the corresponding results obtained from the published experimental studies. The validated intact lumbar model was tested after implantation of three artificial discs at L4-5. Each implanted model was subjected to a combination of 400 N follower load and 5 Nm of flexion/extension moments. ABAQUS$^{TM}$ version 6.5 (ABAQUS Inc., Providence, RI, USA) and FEMAP version 8.20 (Electronic Data Systems Corp., Plano, TX, USA) were used for meshing and analysis of geometry of the intact and implanted models. Results : Under the flexion load, the intersegmental rotation angles of all the implanted models were similar to that of the intact model, but under the extension load, the values were greater than that of the intact model. The facet contact loads of three implanted models were greater than the loads observed with the intact model. Conclusion : Under the flexion load, three types of the implanted model at the L4-5 level showed the intersegmental rotation angle similar to the one measured with the intact model. Under the extension load, all of the artificial disc implanted models demonstrated an increased extension rotational angle at the operated level (L4-5), resulting in an increase under the facet contact load when compared with the adjacent segments. The increased facet load may lead to facet degeneration.

• Journal of Broadcast Engineering
• /
• v.13 no.4
• /
• pp.463-478
• /
• 2008

A Distributed Translator Network(DTxR) is a cost-effective and frequency-effective method which can use existing transmission utilities and can be constructed in a shorter time as compared with Multiple Frequency Network(MFN) or Single Frequency Network(SFN) using On Channel Repeater(OCR). In order to verify the feasibility of DTxR, this field test was done in 30 points of north-west area in Seoul using 3rd, 5th, and 6th generation DIV receivers. Electric field strength, noise margin and ease of reception were measured and subjective evaluation of video quality was done in these points during the field test. With the test result, an improvement of receiving quality was obtained and an ease of reception was increased in case of the 5th. and 6th. receiver. From the results, we conclude that DTxR is a feasible method in DIV networks.