• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.124-128
• /
• 2004

A Poly-Si and a ITO films with surface roughness 1.8 nm and 0.5 nm of root mean square ($R_{rms}$ vakue) values were developed, respectively. A 3 inch UXGA LTPS TFT-LCD with 667 ppi resolution and a 10 inch VGA LTPS OLED have been developed and demonstrated using PMOS technology.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.1339-1342
• /
• 2006

We focused on improving of the optical efficiency in the direct BLU. We could achieve the optical efficiency by reducing the thickness of BLU and processing the prism shapes on a reflection sheet. And we were able to reduce the Lamps.

• The Safety technology
• /
• no.143
• /
• pp.16-19
• /
• 2009

경기도 파주시 문산읍 당동리에 위치한 파주전기초자 주식회사는 일본의 NEG와 국내 LG Display가 손잡고 설립한 기업이다. TFT-LCD Glass를 주로 가공하고 있는 이곳은 일본과 한국의 안전문화를 결합하여 독특하면서도 철저한 안전관리 활동을 펼쳐 나가고 있다. 2005년 설립 이후 무재해 행진을 지속하고 있으며 철저한 분리수거와 소각실명제의 도입으로 안전은 물론 친환경 기업으로서의 역할에도 최선을 다하고 있다.

• Journal of Information Display
• /
• v.1 no.1
• /
• pp.3-8
• /
• 2000

We have developed a high performance vertical alignment TFT-LCD (Thin Film Transistor Liquid Crystal Display), that shows a high light transmittance, and wide viewing angle characteristics with an unusually high contrast ratio. In order to optimize the electro-optical properties we have studied the effect of cell parameters, multi-domain structure and retardation film compensation. With the optimized cell parameters and process conditions, we have achieved a 24" wide UXGA TFTLCD monitor (16:10 aspect ratio 1920X1200) showing a contrast ratio of over 500:1, panel transmittance near 4.5%, response time near 25 ms, and viewing angle higher than 80 degree in all directions.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.1473-1475
• /
• 2006

The electro-optic properties of an active-matrix polymer network liquid crystal display (AM-PNLCD) with crossed polarizer films to improve its contrast ratio were evaluated. By using crossed polarizer films, it shows good contrast ratio as well as wide viewing angle and adequate response time at normal TFT-twisted nematic (TN) LCD driving voltage (2.8V).

• 한국정보디스플레이학회:학술대회논문집
• /
• 2003.07a
• /
• pp.266-269
• /
• 2003

TFT LCD mode has some well-documented performance limitations, namely limited viewing angle, inversion of the gray scale levels and poor luminance efficiency because of the necessity of using crossed polarisers attached to the display cell. During the last few years many initiatives have been undertaken to solve these problems by incorporation birefringent films of various designs into the LCD module. Controlling the optical performance of LCDs often requires combination of liquid crystal material properties, cell parameters and optical films. Such optical films have traditionally been made with stretched polymer materials such as polycarbonate, but recently coated liquid crystalline materials have been used to give improved optical films which can greatly enhance the performance of LCDs. We have now developed reactive mesogen materials to add ultra-thin optical layers into the display structure, and these allow the potential for many new applications.

• 전자공학회논문지 IE
• /
• v.46 no.4
• /
• pp.57-65
• /
• 2009

This paper presents the image contrast enhancement technique suitable for local dimming backlight of small-sized mobile display while achieving the reduction of the power consumption. In addition to the large-sized TFT-LCD, small-sized one has adopted LED for backlight. Since, conventionally, LED was mounted on the side edge of a display panel, global dimming method has been widely used. However, recently, new advanced method of local dimming by placing the LED to the backside of the display panel and it raised the necessity of sub-blocked processing after partitioning the target image. When the sub-blocked image has low brightness, the supply current of a backlight LED is reduced, which gives both enhancement of contrast ratio and power consumption reduction. In this paper, we propose simple and improved image enhancement algorithm suitable for the small-sized mobile display. After partitioning the input image by equal sized blocks and analyzing the pixel information in each block, we realize the primary contrast enhancement by independently processing the sub-blocks using the information such as histogram, mean, and standard deviation values of luminance(Y) component. And then resulting information is transferred to each backlight control unit for local dimming to realize the secondary contrast enhancement as well as reduction of power consumption.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2003.07a
• /
• pp.241-244
• /
• 2003

The world largest 21.3" LTPS LCD has been successfully developed using SLS crystallization technology. Successful integration of gate circuit, transmission gate and level shifter was performed in a large area uniformly. Uniformity and high performance from high quality grains of SLS technology make it possible to come true a uniform large size LTPS TFT-LCD with half number of data driver IC's used in typical a-Si LCD. High aperture ratio of 65% was obtained using an organic inter insulating method, which lead a high brightness of 500cd/cm2.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.826-829
• /
• 2006

In order to increase the transmittance of panel, in process of FFS TFT-LCD, fine patterning process which is adopted to the optimum passivation(PVX) hole was applied fine metal line patterning process and was made with optimum efficiency of liquid crystal by using space/bar size control of pixel electrode. We fabricated 2.03" mobile FFS devices with fine patterning process. Further, this technology will be applied to the basis of other process for higher PPI or higher aperture ratio technology.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.409-412
• /
• 2006

A high data accuracy and low power consumption driving method and output stage of the source driver are proposed for the LTPS TFT-LCD in mobile applications. The proposed driving method is insensitive to the variations of the electrical characteristics of TFTs, which enables the output errors of the source driver are under 1/2 LSB in all gray levels. In addition, the power consumption of the driver with the method is decreased to 9.9mW which is 55.9% of that of the conventional source driver by reducing unnecessary charge waste.