• Nuclear Engineering and Technology
• /
• v.48 no.5
• /
• pp.1273-1279
• /
• 2016

Production of iodine-131 by neutron activation of tellurium in tellurium dioxide ($TeO_2$) material requires a target that meets the safety requirements. In a radiopharmaceutical production unit, a new lid for a can was designed, which permits tight sealing of the target by using tungsten inert gaswelding. The leakage rate of all prepared targets was assessed using a helium mass spectrometer. The accepted leakage rate is ${\leq}10^{-4}mbr.L/s$, according to the approved safety report related to iodine-131 production in the TRIGA Mark II research reactor (TRIGA: Training, Research, Isotopes, General Atomics). To confirm the resistance of the new design to the irradiation conditions in the TRIGA Mark II research reactor's central thimble, a study of heat effect on the sealed targets for 7 hours in an oven was conducted and the leakage rates were evaluated. The results show that the tightness of the targets is ensured up to $600^{\circ}C$ with the appearance of deformations on lids beyond $450^{\circ}C$. The study of heat transfer through the target was conducted by adopting a one-dimensional approximation, under consideration of the three transfer modes-convection, conduction, and radiation. The quantities of heat generated by gamma and neutron heating were calculated by a validated computational model for the neutronic simulation of the TRIGA Mark II research reactor using the Monte Carlo N-Particle transport code. Using the heat transfer equations according to the three modes of heat transfer, the thermal study of I-131 production by irradiation of the target in the central thimble showed that the temperatures of materials do not exceed the corresponding melting points. To validate this new design, several targets have been irradiated in the central thimble according to a preplanned irradiation program, going from4 hours of irradiation at a power level of 0.5MWup to 35 hours (7 h/d for 5 days a week) at 1.5MW. The results showthat the irradiated targets are tight because no iodine-131 was released in the atmosphere of the reactor building and in the reactor cooling water of the primary circuit.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.141-141
• /
• 2013

We have generated the needle-typed nonthermal plasma jet by using an Ar gas flow at atmospheric pressure. Diagnostics of electron temperature anddensity is critical factors in optimization of the atmospheric plasma jet source in accordance with the gas flow rate. We have investigated the electron temperature and density of plasma jet by selecting the four metastable Ar emission lines based on the atmospheric collisional radiative model and radial profile characteristics of current density, respectively. The averaged electron temperature and electron density for this plasma jet are found to be ~1.6 eV and ~$3.2{\times}10^{12}cm^{-3}$, respectively, in this experiment. The densities of OH radical species inside the various bio-solutions are found to be higher by about 4~9 times than those on the surface when the argon bioplasma jet has been bombarded onto the bio-solution surface. The densities of the OH radicalspecies inside the DI water, DMEM, and PBS are measured to be about $4.3{\times}10^{16}cm^{-3}$, $2.2{\times}10^{16}cm^{-3}$, and $2.1{\times}10^{16}cm^{-3}$, respectively, at 2 mm downstream from the surface under optimized Ar gas flow 250 sccm.

• Journal of Biomedical Engineering Research
• /
• v.32 no.3
• /
• pp.245-250
• /
• 2011

Parallel imaging technique can provide several advantages for a multitude of MRI applications. Especially, in SENSE technique, sensitivity maps were always required in order to determine the reconstruction matrix, therefore, a number of difference approaches using sensitivity information from coils have been demonstrated to improve of image quality. Moreover, many filtering methods were proposed such as adaptive matched filter and nonlinear diffusion technique to optimize the suppression of background noise and to improve of image quality. In this study, we performed SENSE reconstruction using computer simulations to confirm the most suitable method for the feasibility of filtering effect and according to changing order of polynomial fit that were applied on variation of spatial resolution of sensitivity map. The image was obtained at 0.32T(Magfinder II, Genpia, Korea) MRI system using spin-echo pulse sequence(TR/TE = 500/20 ms, FOV = 300 mm, matrix = $128{\times}128$, thickness = 8 mm). For the simulation, obtained image was multiplied with four linear-array coil sensitivities which were formed of 2D-gaussian distribution and the image was complex white gaussian noise was added. Image processing was separated to apply two methods which were polynomial fitting and filtering according to spatial resolution of sensitivity map and each coil image was subsampled corresponding to reduction factor(r-factor) of 2 and 4. The results were compared to mean value of geomety factor(g-factor) and artifact power(AP) according to r-factor 2 and 4. Our results were represented while changing of spatial resolution of sensitivity map and r-factor, polynomial fit methods were represented the better results compared with general filtering methods. Although our result had limitation of computer simulation study instead of applying to experiment and coil geometric array such as linear, our method may be useful for determination of optimal sensitivity map in a linear coil array.

• Journal of Acupuncture Research
• /
• v.23 no.5
• /
• pp.177-185
• /
• 2006

Objectives : To observe the effect of acupuncture treatment and western medical treatment on frozen shoulder patients. Methods : 39 voluntary patients were randomly assigned to the Eastern treatment group(E group, n=22) and the Western treatment group(W group, n=17). The E group received acupuncture treatment on LI15, TE14, GB21 and Master Dong's acupuncture points, Shin-gwan and Gyun-joong, twice a week for 4 weeks. The W group received suprascapular nerve block, subacromial injection and trigger point injection, twice a week for 4 weeks. Both groups were instructed to practice self exercise during their daily lives. Evaluations were made before treatment and after treatment using Constant Shoulder Assessment(CSA), Shoulder Pain and Disability Index(SPADI) and the patient's satisfaction concerning the treatment was measured by Visual Analogue Scale(VAS). The obtained data were analyzed and compared. Results : The E group showed significant improvement(p<0.05) according to the CSA and SPADI. The patient's satisfaction scored 5.67 on a scale of 10. The W group showed significant improvement(p<0.05) according to the CSA and SPADI. The patient's satisfaction scored 7.73. But the difference between the two groups were insignificant according to CSA and SPADI. Conclusion : Both acupuncture and nerve block treatment significantly improved frozen shoulder. But the difference of the two treatments was insignificant.

• Journal of Acupuncture Research
• /
• v.29 no.3
• /
• pp.1-8
• /
• 2012

Objectives : The purpose of this study was to compare the skin temperature changes by the rechargeable and programmable electronic moxibustion device(EMD) with the traditional combustible moxibustion device(CMD). Methods : Skin temperature changes in six healthy volunteers induced by CMD and EMD were measured with digital infrared thermal imaging(DITI). Heat stimulation was applied on $LI_4$ and $TE_5$, and skin temperature changes on each point were measured at baseline and per minute for total 7 minutes, 2 minutes of heat stimulation and 5 minutes of observation. Results : There was no significant difference in the skin temperature changes between CMD and EMD. The temperature on $LI_4$ with EMD was $32.3{\pm}1.3^{\circ}C$ at baseline, $34.0{\pm}1.3^{\circ}C$ at 1 minute after heat stimulation start, $34.6{\pm}1.2^{\circ}C$ at 2 minutes after, and from 3 minutes after heat stimulation, it maintained $32.6{\sim}32.8^{\circ}C$. Conclusions : Methods for measuring skin temperature changes induced by heat stimulation of moxibustion were established, and the possibility of effectiveness of the newly developed electronic moxibustion device was raised with this preliminary study. This study can contribute to the development of clinical research methodology for traditional Korean medicine.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.25 no.3
• /
• pp.47-66
• /
• 1999

We have tried to measure the anti-dandruff effect of the several kinds of formulations by determining the MIC values of the P. ovale which was determined by resazurin(alarmar Blue$^{TM}$). To get high reproducibility, it was suggested that about 2.6$\times$10$^{5}$ cfu/$m\ell$ of P ovate should be incubated with alarmar Blue$^{TM}$, optimum dilution ratio between alarmar Blue$^{TM}$ and PBS buffer should be 1:1 -1:4, and optimum incubation time should be 16 ~ 24 hours. Even though 1:1 diluted alarmar Blue$^{TM}$ was incubated with P ovale, the metabolic activity of if ovule was not inhibited by alarmar BlueTM. The Minimum Inhibitory Concentration(MIC) values of several kinds of anti-dandruff formulation which were the mixture system between Zinc pyrithione and Climbazole make it possible to determine the optimal anti-dandruff formulation, which show similar results with that of microscopic MIC determination and that of SDDM(Skin-Disk Diffusion Method). It is expected that the anti-dandruff test method which uses alarmar Blue$^{TM}$ could be used as an effective in vitro test method because it was not so much affected by the turbidity of the broth and samples, and it can afford the MIC values of many samples within relatively short time by using microplate reader.te reader.

• Reproductive and Developmental Biology
• /
• v.30 no.3
• /
• pp.181-187
• /
• 2006

In recent years the number of patients waiting for organ transplantation has greatly outpaced the supply of human organs available, which leads to a renewed interest in pig-to-human xenotransplantation as an alternative. However, one of the biggest barriers in the xenotransplantation is presence of porcine endogenous retroviruses(PERV) that can infect human cells. In this study, to present a possible solution for this problem we tried to inhibit expression of PERVs using shRNAs(short hairpin RNA) at the level of RNA synthesis and virus release. The shRNA targeting the sequence of PERV A, B type was cloned into pSIREN-RetroQ vector under the control of polymerase-III U6-RNA gene promoter. Quantitative real-time PCR was performed to detect my alterations in mRNA production of PERV A, B targeted by the shRNA in each done. Depending on the target sequence of the shRNA, the transcription of PERV was decreased to as much as 4% and the number of progeny viruses was reduced to less than 1/200,000. Transgenic pigs producing such shRNAs may result in a highly reduced PERV expression in cells and organs, which is a prerequisite for safe xenotransplantations.

• Reproductive and Developmental Biology
• /
• v.30 no.3
• /
• pp.157-162
• /
• 2006

Endogenous 84 amino acid parathyroid hormone(PTH) is synthesized as a pre-pro hormone by the chief cells of the parathyroid glands. Physiological actions of PTH include regulation of bone metabolism, renal tubular reabsorption of calcium and phosphate, and intestinal calcium absorption. In addition, PTH stimulates new bone formation by extraordinary stimulation of osteoblastic activity and decreasing calcium excretion by the kidney. In this study, we constructed and tested retrovirus vectors designed to express the human parathyroid hormone(hPTH) gene under the control of the tetracycline-inducible promoters. To increase the hPTH gene expression at turn-on state, woodchuck hepatitis virus posttranscriptional regulatory element(WPRE) sequence was also introduced into retrovirus vector at downstream region of either the hPTH gene or the sequence encoding reverse tetracycline-controlled transactivator(rtTA). Transformed primary culture cells(porcine fetal fibroblast, PFF, chicken embryonic fibroblast, CEF) were cultured in the medium supplemented with or without doxycycline(tetracycline derivative) for 48 hours, and induction efficiency was measured by comparing the hPTH gene expression level using two step RT-PCR and ELISA Higher hPTH expression($3{\tims}10^4\;pg/ml,\;5.3{\times}10^4\;pg/ml$) and tighter expression control(up to 8 fold) were observed from the vector in which the WPRE sequence was placed at downstream of the hPTH gene. The resulting tetracycline inducible vector system may be helpful in solving serious physiological disturbance problems which have been a major obstacle in successful production of transgenic animals.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.9 no.4
• /
• pp.483-491
• /
• 2021

The purpose of this study is to analyze the economic effect of the use of recycled aggregate on the construction industry and the effect of increasing the value of the recycled aggregate production industry on the premise of supporting quality assurance technology to promote the high-quality use of recycled aggregate. Accordingly, the production cost of ready-mixed concrete that can be obtained through the use of high-quality recycled aggregate is analyzed according to the recycled aggregate application rate recommended in the recycled aggregate quality standard, The economic effect of general ready-mixed concrete and recycled aggregate-applied rea dy-mixed concrete industry wa s a na lyzed by identifying the domestic rea dy-mixed concrete industry sca le a nd the ra te of satisfaction of recycled aggregate volume, and a cost-benefit analysis method was used to examine the benefits of high-quality recycled aggregate production and sales. As a result, the production cost of ready-mixed concrete is reduced by 2.3~16.2% depending on the application rate, the economic effect of the use of recycled aggregate on the construction industry is about 106.8~142.6 billion KRW, and the effect of increasing the value of the recycled aggregate production industry generated about 1.22 times the benefit.

• Journal of the Korean Society of Radiology
• /
• v.13 no.4
• /
• pp.523-530
• /
• 2019

The purpose of this study was to obtain the K-edge images using a spectral CT system based on a photon-counting detector and implement the 3D fusion imaging using the conventional and spectral CT images. Also, we evaluated the clinical feasibility of the 3D fusion images though the quantitative analysis of image quality. A spectral CT system based on a CdTe photon-counting detector was used to obtain K-edge images. A pork phantom was manufactured with the six tubes including diluted iodine and gadolinium solutions. The K-edge images were obtained by the low-energy thresholds of 35 and 52 keV for iodine and gadolinium imaging with the X-ray spectrum, which was generated at a tube voltage of 100 kVp with a tube current of $500{\mu}A$. We implemented 3D fusion imaging by combining the iodine and gadolinium K-edge images with the conventional CT images. The results showed that the CNRs of the 3D fusion images were 6.76-14.9 times higher than those of the conventional CT images. Also, the 3D fusion images was able to provide the maps of target materials. Therefore, the technique proposed in this study can improve the quality of CT images and the diagnostic efficiency through the additional information of target materials.