• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.4 no.1
• /
• pp.11-19
• /
• 2008

Groundwater flow in confined aquifer and heat transport in underground geologic media are using same governing equation(line source) like well fuction. Therefore the conventional slope method using only later data obtained from in-situ thermal response test to determine the thermal conductivity of vertical geothermal heat exchanger(GHEX) is basically identical with one of Theis straight line method of aquifer test under artesian condition. In case that the pumping rate(Q, $m^3$/d) and drawdown(s,m) which are used for input data of existing hydrogeologic computer programs for aquifer test are replaced and converted to supplying heat energy per unit length of bore hole(Q/L,w/m or Kcal/h.m) and temperatures (T,$^{\circ}C$)measured at in and out-let of GHEX as in put data respectively, thermal conductivity around geothermal heat exchanger can be easily estimated without any special modification of the existing hydrogeologic computer program. Two numbers of time series temperature variation data obtained from in situ geothermal response test are analized using Theismethods(standard curve and straight line method) by using existing aquifer test program and conventional Slope method proposed by ASHRAE. The results show that thermal conductivity values estimated by two straight methods are identical and the difference of estimated values between standard curve methods and Slope method are also within acceptable ranges. In general,the thermal conductivity estimated from Theis straight linemethod gives more accurate value than the one of Slope method due to that Slope method uses only visual matching otherwise Theis method uses automatic curve matching estimation with reducing RSS.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.16 no.1
• /
• pp.106-113
• /
• 2008

The starter motor noise is usually well identified by the customers since it is operated while the engine is quiet, and leaves distinct impressions of the vehicle. In this study the design of experiments(DOE) was applied to the identification of the noise sources of direct drive starter motor since this process usually requires lengthy analysis and elaborate experiments. In the first stage of the test, five controllable factors(alignment and dynamic unbalance of armature, tightening torques of T/bolt and center bracket bolt, and alignment of the center bracket-yoke-rear bracket), excluding static unbalance, are sorted out of all possible factors. Test results showed that the dynamic unbalance and misalignment of armature are the major factors. However, the error level of the first test was relatively high, indicating that there might be some missing major factors. In the second stage test the results showed that both static and dynamic unbalances are the dominant factors contributing to more than 80% of the overall noise, while the misalignment contributes around 12%. Error of the second test was about 4% that could be considered satisfactory. The noise level of the optimal product was predicted to be reduced by 19dBA, and verification test showed the average noise reduction of 16.8dBA with the standard deviation of 3.2dBA, and proved the usefulness of the whole DOE process.

• Journal of the Korea Society of Computer and Information
• /
• v.3 no.2
• /
• pp.105-112
• /
• 1998

In this paper, we propose a ESP(Extended Scan Path) architecture for multi-board testing. The conventional architectures for board testing are single scan path and multi-scan path. In the single scan path architecture, the scan path for test data is just one chain. If the scan path is faulty due to short or open, the test data is not valid. In the multi-scan path architecture, there are additional signals in multi-board testing. So conventional architectures are not adopted to multi-board testing. In the case of the ESP architecture, even though scan path is either short or open, it doesn't affect remaining other scan paths. As a result of executing parallel BIST and IEEE 1149.1 boundary scan test by using the proposed ESP architecture, we observed that the test time is short compared with the single scan path architecture. By comparing the ESP architecture with single scan path responding to independency of scan path, test time and with multi-scan path responding to signal, synchronization, we showed that the architecture has improved results.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.19 no.3
• /
• pp.29-37
• /
• 2011

The modal characteristics of a compressor wheel of an automotive turbocharger have been investigated using an experimental method based on an acoustic frequency response function, p/f(${\omega}$), where p is sound pressure radiated from a structure, and f is impact force. First, a well-defined annular disc with narrow radial slots was examined to check whether the vibro-acoustic test could precisely determine natural quencies and vibration modes of structures showing that the vibro-acoustic test proposed in this paper was comparable to the conventional modal test with an accelerometer and the numerical analysis. The conventional method has been found to be inappropriate for compressor wheel because of additional mass due to the accelerometer and additional damping from the accelerometer cable alter the dynamic responses of the wheel blades. odal characteristics of the wheel have been defined using vibro-acoustic test and verified with the results from another conventional method using a laser vibrometer. Natural quencies and mode shapes of a turbocharger wheel, which can't be precisely obtained with onventional method, could be defined accurately without the additional effects from sensor and cable. Proposed method can be applied to small structures where conventional sensors and cables could generate troubles.

• The Journal of Korean Physical Therapy
• /
• v.12 no.2
• /
• pp.95-105
• /
• 2000

Glenohumeral internal and external rotation with shoulder abducted in the frontal plane often causes impingement of the supraspinatus tendon. whereas similar activity in scapular plane does not cause impingement. The Purpose of this study was to determine if assessment among the three positions as 30 degrees, 60 degrees, 90 degrees abduction in the sitting position of the scapular plane could be affected the comparison between intemal and external peak torque, total work, average power. In this study, Isokinetic shoulder rotational strength was evaluated in twenty healthy male university students, using the Cybex NORMTM System (CYBEX Division of LUMEX, Inc., Ronkonkoma, New York). Test data was gathered in the plane of the scapular, 30 degrees of horizontal flexion anterior to coronal plane, and the subjects performed the test with the arm 30, 60, and 90degrees abducted in the sitting position. also, test speed was set at deg/sec. Statistical analysis was performed using SPSS 7.5 for Windows software and mean and standard deviations were calculated. ANOVA was used to analyze the difference of the values in the three test positions. A paired t-test was used of examining the difference in the means peak torque between external and internal rotation. Not any significant difference was found among three abduction positions in scapular plane, even though there was a consistent pattern of greater strength in the abducted position of 60 degrees. Internal relation strength peak torque and total work were greater than those of external rotation in every test positions.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.11
• /
• pp.4496-4502
• /
• 2010

In this paper, for the purpose of improving the future domestic train control systems and securing interoperability according to the global development trends of train control systems, we present the test results of communication interfaces to verify the interoperability between CBTC wayside units tentatively installed in Bundang line that is one of the metropolitan area rail transit systems, and the CBTC onboard units developed through the national R/D project. The CBTC onboard equipment developed, has finished its installation and trial tests in the Bundang shunting yard. For the interoperability test, we should make an interface test with wayside equipment tentatively installed in Bundang line. Due to the safety-critical characteristics of train systems, the site test in the section where the wayside equipment is installed, leads to a danger against safety. Therefore, by way of constructing a simulation environment of train control systems, we confirm the T/R data systems of the equipment for interoperability and test the interoperability by applying these systems to developed CBTC onboard equipment.

• Research in Community and Public Health Nursing
• /
• v.32 no.2
• /
• pp.220-231
• /
• 2021

Purpose: This study is a pseudo-experimental study of design before and after the non-equivalent control group, which was attempted to verify that the application of the ukulele to the elderly has the effects of reducing depression, improving self-efficacy, strengthening social bonding, and improving cognitive function. Methods: 46 (23 in the experimental group and 23 in the control group) participants were selected. The experimental group was provided with three sessions of a music program using eight Ukuleles for the elderly, while the control group was provided with three sessions for the elderly. IBM SPSS 25.0 was used for data analysis, and the independent t-test, 𝑥²-test, and Fisher's exact probability test were performed to verify the homogeneity of the subject's general characteristics. The effect verification after the experimental treatment was analyzed by Fisher's exact probability test, Friedman test, and Mann-Whitney U test. Results: Depression showed a statistically significant difference between the two groups (F=39.88, p<.001), self-efficacy showed a statistically significant difference between the two groups (z=-4.96, p<.001), social bonding showed a statistically significant difference between the two groups (z=-5.19, p<.001), and cognitive function showed a statistically significant difference between the two groups (z=-3.98, p<.001). Conclusion: It was found that the 'Music Program using the Ukulele' was effective in reducing depression of the elderly, improving self-efficacy, reinforcing social bonding, and improving cognitive function. We hope that the Music Program using the Ukulele can be used in the elderly nursing curriculum in the future, and we suggest it should be applied as a nursing intervention to those who are experiencing cognitive decline.

• Journal of Korean Academy of Nursing
• /
• v.51 no.3
• /
• pp.265-279
• /
• 2021

Purpose: This study examined the impact of a drinking reduction program on drinking motivation, drinking refusal self-efficacy, and problematic drinking behaviors in college students with problematic drinking habits. Methods: This study incorporated a non-equivalent control group prepost-test design. Study participants included 58 college students who scored 12 or more in the AUDIT-K test (Alcohol Use Disorders Identification Test-Korean version) (experimental group: 30; control group: 28). The intervention consisted of eight sessions and was conducted once a week. It was designed to promote autonomy, competence, and relatedness-the three elements of basic psychological needs in self-determination theory. The participants were assessed before the intervention, immediately after, and four weeks post intervention. Data were collected from October 12 to December 31, 2017. The analysis employed the chi-square test, Fisher's exact test, independent t-test, and repeated measures ANOVA using SPSS/WIN 22.0. Results: The mean age of participants was 21.8 years. There were 30 men (51.7%) and 28 women (48.3%). The differences in drinking motivation, drinking refusal self-efficacy, and problematic drinking behaviors were statistically significant for the group by time interaction (F = 42.56, p < .001; F = 54.96, p < .001; F = 39.90, p < .001, respectively). Conclusion: The findings indicate that the intervention effectively decreases drinking motivation, increases drinking refusal self-efficacy, and decreases problematic drinking behaviors. It can be an efficient strategy for college students with problematic drinking habits to enhance their self-determination ability.

• The Journal of the Korea Contents Association
• /
• v.12 no.8
• /
• pp.240-247
• /
• 2012

Marginal and internal fit is an important part of the longevity of dental restorations. The purpose of this study was to analysis the marginal and internal fit of zirconia core by dental CAD/CAM system using innovative and non-destructive methods such as optical coherence tomography(OCT) and compare with conventional method such as silicone replica technique(SRT). Ten dental stone models of abutment of maxillary right central incisal were manufactured and scanned. Ten zirconia cores were fabricated with commercial CAD/CAM system. To measure the marginal and internal fit of each sample, five point of fitness were measured using 2 different methods(OCT and SRT). Statistical analysis was performed using independent sample t-test(${\alpha}$=0.05). OCT and SRT groups were not significantly different(P>0.05). By this results, analysis the fitness of dental restorations using OCT were acceptable measuring method.

• Journal of The Korean Association of Information Education
• /
• v.20 no.6
• /
• pp.597-606
• /
• 2016

By utilizing the TPCK model, this research analyzed the present state of pre-service elementary teachers' competencies related to the use of technology. It also conducted the Importance-Performance Analysis to prioritize remedial issues to improve curriculum related to the use of technology. A survey was conducted to 165 pre-service teachers who are senior students at a University. A questionnaire was used to investigate pre-service teachers' perception on the importance and performance related to Technology Knowledge, Technological Pedagogical Knowledge, Technological Content Knowledge and Technological Pedagogical Content Knowledge. As the result of the t-test, significant differences between importance scores and performance scores were found in all the competencies and 17 sub-competencies. In addition, as the results of the importance-performance analysis, 5 sub-competencies were found to be concentrated for the improvement, and 4 sub-competencies were found to be kept up because of their good work. Also 5 sub-competencies were turned out to have low priority, and 3 sub-competencies were turned out to be possible overkill.