• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.11 no.6
• /
• pp.1-8
• /
• 2011

Power Line Communication (PLC: Power Line Communication) to propagate the current power lines are in every household of the existing infrastructure is the most extensive network configuration. In addition, the cost required for network configuration, the advantage of almost zero for the investors and is sufficient to attract the attention of operators. The PLC is supply power to power lines used the voice and data communication technologies put it on KHz ~ tens of hundreds of high-frequency signal MHz. But because uses power lines as existing wireless communications systems will occurs interference. The notch filters of a common way to eliminate the interference are used. In this paper, a dynamic high-performance notch filter applying CIC filter performance was verified through MATLAB and was implemented using a TI's TMS320C6416T DSP board.

• Korean Journal of Optics and Photonics
• /
• v.17 no.1
• /
• pp.1-6
• /
• 2006

We investigated the characteristics of the nonlinear magneto-optic effect (NMOE) depend on the transitions, the laser intensity and the temperature of the vapor cell, in the $D_1$ transition of $^{87}Rb$ atoms by using the Rb vapor cell contained with buffer gas of Ne 6.7 kPa. The size and the width of NMOE signal were increased according to the light intensity and temperature in the transition of F=2$\to$F'=2. However, In the case of using the F=2$\to$F'=1 transition, the size of the signal could be increased according to the light intensity without additional broadening of the width. We confirmed that the sensitivity of detecting small magnetic flux improved in this transition, and explained these effects by the different of the CPT configuration between Zeeman sublevels. At the optimal condition in experiment, the sensitivity of this system was evaluated less then $70pT/\sqrt{Hz}$.

• Nuclear Engineering and Technology
• /
• v.5 no.4
• /
• pp.291-309
• /
• 1973

Exposure rates due to leakage gamma-rays from operating reactors TRIGA Mark II and III were measured in a horizontal plane by means of scintillation spectrometry using a 3"$\times$3" cylindrical Nal(T1) detector associated with a 400 channel pulse height analyzer under varied conditions of reactor operation. In determining exposure rate due to the leakage gamma-rays at each point of measurement, Moriuchi's spectrum-exposure rate conversion theory was applied instead of using conventional responce matrix method which necessitates very complicated procedures to convert a spectrum into exposure rate. The results show that a basic pattern of "typical" spectrum of the reactor leakage gamma-rays is neither affected by thermal output of the reactor, nor influenced by overall attenuation in radiation intensity. It was indicated that he attenuation of the leakage gamma-rays in air in terms of exposure rate as a whole follows an exponential law, and the total exposure rate due to the leakage gamma-rays at a certain point is nearly proportional to thermal output of the reactor. The complexity in spectrum measured for a movable core reactor, TRIGA Mark III, was analyzed through spectrum resolution, and proper judgement of the leakage gamma-rays in a complex spectrum was discussed.ctrum was discussed.

• Journal of Industrial Technology
• /
• v.28 no.A
• /
• pp.11-17
• /
• 2008

Applicability of hyperbolic settlement prediction method to consolidation settlement in the dredged and reclaimed ground was assessed by analyzing results of centrifuge tests modelling self-weight consolidation of soft marine clay. From literature review about self-weight consolidation of soft marine clays located in southern coast in Korea, constitutive relationships of void ratio - effective stress - permeability and typical self-weight consolidation curves with time were obtained by analyzing centrifuge model experiments. For the condition of surcharge loading, exact solution of consolidation settlement curve obtained by using Terzaghi's consolidation theory was compared with results predicted by the hyperbolic method. It was found to have its own inherent error to predict final consolidation settlement. From results of analyzing thc self-weight consolidation with time by using this method, it predicted relatively well in error range of 0.04~18% for the case of showing the linearity in the relationship between T vs T/S in the stage of consolidation degree of 60~90 %. However, it overestimated the final settlement with large errors if those relation curves were nonlinear.

• Proceedings of the KIEE Conference
• /
• 1995.07c
• /
• pp.1193-1195
• /
• 1995

The superconducting properties of YBaCuO thin films prepared by pulsed laser deposition(PLD) have been investigated. The x-ray diffraction patterns of the films are substantially different from one another. The YBaCuO thin films manufactured at the 20% of Argon mixture ratio were indicated $T_c$(zero)=88.2 K, $T_c$(onset)=92.1 K, and $J_c=9.0{\times}10^4A/cm^2$(at 77.3K).

• Publications of The Korean Astronomical Society
• /
• v.11 no.1
• /
• pp.91-107
• /
• 1996

We determine analytically the onset of thin-shell formation time of fast wind bubble with power-law energy injection $E_{in}=E_0t^s$, and power-law ambient density structure, ${\rho}_0(r)={\bar{\rho}}(r/{\bar{r}})^{-{\omega}}$. Thin-shell formation time, $t_{sf}$ can be estimated by minimizing the total time elapsed before the complete cooling of shocked gas. For uniform medium (${\omega}=0$) and constant energy injection (s = 1), the onset of shell formation is found to be at $t_{sf}=5.2{\times}10^3yr$, which agrees Quite well with the results of FCT 1D numerical calculation. We solve the line transfer problem with previous result derived by numerical calculation in order to calculate line profile of [OIII] (${\lambda}=5007{\AA}$) forbidden line. In general, radiative outer shell causes the formation of double peaked line profile. Each peak corresponds to approaching and receeding shells with large velocities. Our line profiles show good agreements with observation of expanding shell structure.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.3
• /
• pp.254-258
• /
• 2000

Current leads of high $T_{c}$ superconductor were fabricated with Bi excess B $i_{2.2}$/S $r_{1.8}$/C $a_{1}$/C $u_{2}$/ $O_{x}$ composition by rapid cooling method. The dimensions of final samples were fixed 3 mm and 8 mm diameter with 50 mm length each To control uniform density the samples were preformed by CIP(Cold Isostatic Press) process and followed by partial or full melting process after raising up to 90$0^{\circ}C$ for 30min. Plate shaped microstructure was clearly observed adjacent to the Ag tube wall and the size of plate was about 100$\mu$m. However the severe destruction of growth orientation was shown in the inner growth part. critical temperature ( $T_{c}$) was about 53~71K after directional growth while Tc was decreased about 77~80 K before directional growth. After directional growth critical current( $I_{c}$) and critical current density( $J_{c}$) in the specimen of 8 mm diameter at 50 K were about 110 A and 280 A/c $m^2$ respectively.pectively.ely.

• Journal of Korean Academy of Nursing Administration
• /
• v.10 no.4
• /
• pp.401-415
• /
• 2004

Purpose: The purpose of this study was to examine the effects of preceptor preparation education on the preceptor's role recognition and job satisfaction. Method: This study was designed as a pre-experimental, one group pre-test and post-test design. The subjects of this study were 44 preceptors who had the preceptor preparation education at a university hospital in Suwon, Korea. Data were collected from May 26th to June 15th, 2003. The collected data were analyzed using SPSS WIN 10.0 with paired t-test and Pearson's correlation. Result: The results were as follows; (a) After the preceptor preparation education, preceptor's role recognition increased significantly compared to before the preceptor preparation education (t=-4.910, p=.000), (b) After the preceptor preparation education, job satisfaction increased significantly compared to before the preceptor preparation education(t=-4.470, p=.000), (c) Preceptor's role recognition was significantly positive correlation with job satisfaction(r=.422, p=.004). Conclusion: The results of this study shows that preceptor preparation education was effective in increasing preceptor's role recognition and job satisfaction.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2012.10a
• /
• pp.951-952
• /
• 2012

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2012.10a
• /
• pp.939-940
• /
• 2012