• JSTS:Journal of Semiconductor Technology and Science
• /
• v.10 no.2
• /
• pp.134-142
• /
• 2010

A comparative study on the trade-off between the drive current and the total gate capacitance in double-gate (DG) and triple-gate (TG) FinFETs is performed by using 3-D device simulation. As the first result, we found that the optimum ratio of the hardmask oxide thickness ($T_{mask}$) to the sidewall oxide thickness ($T_{ox}$) is $T_{mask}/T_{ox}$=10/2 nm for the minimum logic delay ($\tau$) while $T_{mask}/T_{ox}$=5/1~2 nm for the maximum intrinsic gate capacitance coupling ratio (ICR) with the fixed channel length ($L_G$) and the fin width ($W_{fin}$) under the short channel effect criterion. It means that the TG FinFET is not under the optimal condition in terms of the circuit performance. Second, under optimized $T_{mask}/T_{ox}$, the propagation delay ($\tau$) decreases with the increasing fin height $H_{fin}$. It means that the FinFET-based logic circuit operation goes into the drive current-dominant regime rather than the input gate load capacitance-dominant regime as $H_{fin}$ increases. In the end, the sensitivity of $\Delta\tau/{\Delta}H_{fin}$ or ${{\Delta}I_{ON}}'/{\Delta}H_{fin}$ decreases as $L_G/W_{fin}$ is scaled-down. However, $W_{fin}$ should be carefully designed especially in circuits that are strongly influenced by the self-capacitance or a physical layout because the scaling of $W_{fin}$ is followed by the increase of the self-capacitance portion in the total load capacitance.

• Geomechanics and Engineering
• /
• v.34 no.2
• /
• pp.115-124
• /
• 2023

By conducting three-dimensional simulation with consideration of small-strain characteristics of soil stiffness, the effects of excavation geometry and tunnel cover to diameter ratio on deformation mechanisms of an existing tunnel located either at a side of basement or directly underneath the basement were systematically studied. Field measurements were used to verify the numerical model and model parameters. For basement excavated at a side of an existing tunnel, the maximum settlement and horizontal displacement of the tunnel are always observed at the tunnel springline closer to basement and tunnel crown, respectively, regardless of basement geometry. By increasing basement length and width by five times, the maximum movements of tunnel located at the side of basement and directly underneath the basement increase by 450% and 186%, respectively. Obviously, tunnel movements are more sensitive to basement length rather than basement width. For basement excavated at a side of an existing tunnel, tunnel movements at basement centerline become stable when basement length reaches 10 H_e (i.e., final excavation depth). Moreover, tunnel heaves due to overlying basement excavation become stable when the normalized basement length (L/H_e) is larger than 8.0. As tunnel cover to diameter ratio varies from 2.5 to 3.0, the maximum heave and tensile strain of tunnel due to overlying basement excavation decrease by up to 41.0% and 44.5%, respectively. If basement length is less than 8 H_e, the assumption of plane strain condition of basement-tunnel interaction grossly overestimates tunnel movements, and ignores tensile strain of tunnel along its longitudinal direction. Thus, three-dimensional numerical analyses are required to obtain a reasonable estimation of tunnel responses due to adjacent and overlying basement excavations in clay.

• Korean journal of food and cookery science
• /
• v.14 no.4
• /
• pp.327-332
• /
• 1998

In the fermentation of Yulmoo Mulkimchi, various ratios of Yulmoo to water (l/l.14, l/l.5, 1/2, l/2.75, 1/4) were prepared and fermented at 4$^{\circ}C$, 15$^{\circ}C$, 25$^{\circ}C$ for up to 10 days. According to the fermentation time, the pH, acidity, total vitamin C content and microbial growth in Mulkimchi samples were determined together with sensory evaluation. Fermentation temperature on water addition ratio didn't show any difference in pH and microbial growth of Mulkimchi. However, low ratio of water resulted in high acidity and vitamin C content in Mulkimchi. In terms of acid odor and acid taste, the least water addition (l/l.4) sample was significantly strong than those of other samples. The ratio of Yulmoo to water, l/2 showed the highest overall sensorial acceptability and followed by l/l.5, l/l.4, l/2.75 and 1/4 samples. It was found that the content of vitamin C and acid taste of Mulkimchi have correlation with its acceptability.

• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.8
• /
• pp.549-556
• /
• 2012

T-P removal efficiency was analyzed according to the metal to initial T-P ratio (mole basis) with respect to the samples from different WWTPs having various initial T-P and SS conditions. Also, operating costs were calculated based on the injected coagulant amount and the amount of sludge production. Most experiments were conducted by the standard jar-test protocol. Molar ratio of coagulant dose was varied considerably according to the initial SS concentration range in secondary clarifier effluent samples which had above 0.5 mg/L of initial T-P. Based on 90% T-P removal efficiency, results were: At the initial SS range of below 10 mg/L, Alum (8%) = 11 mol Al/mol P needed and PAC (17%) = 9.6 mol Al/mol P needed; At the initial SS range of above 10 mg/L, Alum (8%) = 3.9 mol Al/mol P needed and PAC (17%) = 3.2 mol Al/mol P needed.

• Tuberculosis and Respiratory Diseases
• /
• v.43 no.1
• /
• pp.22-29
• /
• 1996

Background: Abnormalities of the peripheral blood are frequent and varied in patients with miliary tuberculosis. Anemia, leukopenia, thrombocytopenia, pancytopenia, monocytosis, basophilia, eosinophilia and leukemoid reactions have been reported. These abnormalities are more frequent in patients with positive bone marrow study. In this report, we evaluated clinical, hematological and immunological features in patients with miliary tuberculosis in order to know whether difference is existed between "bone marrow biopsy positive group(pathologically proven to miliary tuberculosis)" and "negative group". Method: Clinical evaluation, serum ADA, sIL-2R, and T-lymphocyte subsets were measured in 40 patients with miliary tuberculosis who received bone marrow biopsy. Results: 1) The average age of patients was 39 year-old. There were 23 male and 17 female patients. Associated extrapulmonary tuberculosis are 9 CNS tuberculosis, 6 joint tuberculosis, and 2 tuberculous pleurisy. 2) Sixteen of the 40 patients were positive bone marrow biopsy(60%). 3) Sixteen of the 40 patients(60%) had anemia(11 positive patients: 13 negative patients). Leukopenia occurred in 12 per cent(4:1). Thrombocytopenia was noted in 10%(3:1). 4) The mean value of serum ADA was 83 U/L(90 U/L: 70.6 U/L, p=0.23). 5) The mean activity of Soluble IL-2 receptor was 4,643 pmol/L($6840{\pm}7446\;pmol/L$: $1,897{\pm}1,663\;pmol/L$, p=0.06). 6) In the T lymphocyte subsets, the percent of T-lymphocytes was 64%(62%:73%, p=0.2). In some patients(9), $T_4$ and $T_8$ ratio in BAL fluid($1.97{\pm}1.2$) was higher than that in the peripheral blood($1.16{\pm}0.5$). Conclusion: Bone marrow examination are diagnostic in 60% of cases of miliary tuberculosis. Percents of the total T lymphocyte and helper T cell in BAL are more elevated than in peripheral blood. There was no significant difference in peripheral blood abnormalities and marker of T lymphocyte activation between the bone marrow biopsy positive and negative group.

• Korean Management Science Review
• /
• v.16 no.1
• /
• pp.63-74
• /
• 1999

This paper presents a R&D investment model for the Information and telecommunications(l&T) technology using multiple objective linear programming(MOLP). The MOLP model involves the simultaneous maximization of three linear objective functions associated with three criteria, which are social, technological, and economic criterion. This model is different from the traditional one which only involves the maximization of economic criterion. It yields a suitable R&D investment ratio to each technology field. Its application to the National R&D Project in l&t Industry is also presented. In this application, the Analytic Hierarchy Process(AHP) is proposed to estimate the weights, which used as the coefficients in each objective function of the MOLP model. Then the problem is solved using the interactive method STEM. It is showed that with the aid of STEM, the MOLP model can be useful decision aid in formulation R&D investment plan in l&t industry. It is expected that the MOLP model works as the basis for planning R&D investment strategy in l&T industry.

• Journal of Korean Society of Forest Science
• /
• v.76 no.3
• /
• pp.218-229
• /
• 1987

This study was carried out to investigate all the parts' weight growth under the different light intensity and root-cutting. As results : ${\cdot}$ Fresh and dry weight of leaf, shoot, root and seedling treated under 63% R.L.I showed the largest growth. ${\cdot}$ The largest growth in fresh and dry weight of shoot arid seedling appeared at 1/4 root cutting plot. ${\cdot}$ The value of T/R ratio was increased in low light intensity and high root-cutting. ${\cdot}$ The simple nonlinear relationship between light intensity, root-cutting and T/R ratio was recognized, respectively.

• Nutrition Research and Practice
• /
• v.18 no.4
• /
• pp.511-522
• /
• 2024

BACKGROUND/OBJECTIVES: The study examined the association between homocysteine and diabetes mellitus in patients with H-type hypertension and assessed the possible effect modifiers. SUBJECTS/METHODS: This cross-sectional study included 1,255 eligible participants in the 'H-type Hypertension Management and Stroke Prevention Strategic International Science and Technology Innovation Cooperation Project' among rural Chinese people with H-type hypertension. A multivariate logistic regression model was used to evaluate the relationship between homocysteine and diabetes mellitus. RESULTS: The mean level of total homocysteine (tHcy) in the diabetes mellitus population was 19.37 μmol/L, which was significantly higher than the non-diabetic patients (18.18 μmol/L). When tHcy was analyzed as a continuous variable, the odds ratio (OR) of diabetes was 1.17 (95% confidence interval [CI], 1.01-1.35; per interquartile range). When tHcy was stratified according to the quintile, the ORs for diabetes were 2.86 (95% CI, 1.22-6.69) in the highest quintile (tHcy ≥ 20.60 μmol/L) compared to the reference group (tHcy < 12.04 μmol/L). When tHcy was grouped by 15 μmol/L and 20 μmol/L, patients with tHcy ≥ 20 μmol/L had a significantly (P = 0.037) higher risk of diabetes (OR, 2.03; 95% CI, 1.04-3.96) than in those with tHcy < 15 μmol/L. Subgroup analysis showed that the tHcy-diabetes association was unaffected by other variables. CONCLUSION: In this study of rural Chinese people with H-type hypertension, the tHcy levels showed a positive association with diabetes mellitus. This independent association is unaffected by other potential risk factors.

• Journal of Korean Society of Steel Construction
• /
• v.19 no.1
• /
• pp.129-137
• /
• 2007

In this study, the elastic out-of-plane buckling load and the effective length factor of X-bracing systems were studied. Points of the intersection of diagonals were modeled as a rigid connection or a pinned connection depending on the connection method of diagonals. The boundary condition of the intersection influences the buckling load of X-bracing systems. For each boundary condition of the intersection, effective out-of-plane length factors of X-bracing systems were derived as a function of the length ratio of tension and compression diagonals $L_P$/$L_T$, the applied force ratio of tension and compression diagonals T/P, and the Euler buckling load ratio of tension and compression diagonals $P_{ET}$/$P_{EP}$. The proposed effective out-of-plane length factors of X-bracing systems were compared with the results of previous researchers and those of the finite element analysis and their properties were verified. Finally, the effects of the boundary condition of the intersection on the out-of-plane buckling load of X-bracing systems were investigated.

• Korean Journal of Environmental Agriculture
• /
• v.24 no.2
• /
• pp.91-97
• /
• 2005

This study was conducted to evaluate the influence of pollutant loads on the water quality in the Dongjin River area from January 2003 to December 2004. The average value of BOD and T-N showed the highest peak in Yongho, Dukcheon watershed among Dongjin River. Concentrations of BOD, T-N and T-P in Jeongeup watershed were 2.29 mg $L^{-1}$, 4.40 mg $L^{-1}$ and 0.27 mg $L^{-1}$, respectively. Concentration of BOD in Chilbo was 1.19 mg $L^{-1}$ which would be in the grade I according to water quality criteria by Ministry of Environment. The BOD level in Wonpeung and Sinpeung watershed ranged from 4.06 to 7.35 mg $L^{-1}$. The T-N effluent loads of non-point pollutants were high in Wonpeung, Gobu, Yongho Dukcheon, Jeongeup and Sinpeung watershed in order. The major sources of BOD, T-N and T-P effluent loads were Livestock. The T-P effluent load of non-point pollutant was 68 kg $day^{-1}$ in Wonpeung, 58 kg $day^{-1}$ in Yongho Dukcheon and 45 kg $day^{-1}$ Jeongeup watershed. The delivered loads of BOD was high in Gobucheon, while both T-N and T-P were high in Yongho Dukcheon. The delivery ratio of BOD and T-N at dry season was below 100% in all watershed of Dongjin River. The delivery ratio of T-N at raining season was high in Yongho Dukcheon and Chilbo watershed