• Journal of Life Science
• /
• v.23 no.3
• /
• pp.333-340
• /
• 2013

This study was performed to determine whether stem bark extract containing saponin of Albizzia julibrissin in the diet influences gonadal maturation and spawning in medaka (Oryzias latipes). The crude extraction containing saponin (HaBC) was partially purified from n-BuOH extraction of A. julibrissin stem bark by Diaion HP-20, Silica gel and Sephadex LH-20 chromatographies. We fed diets supplemented with HaBC to medaka. We then studied the effects of the HaBC supplement on the suppression of gonadal maturation and spawning in female medaka that were reared in aquaria with recirculation systems. In the experiment with immature female medaka, the periods of initiation of gonadal maturation and spawning were delayed in the fish that were fed diets supplemented with at least HaBC 20 mg/g-feed. In the experiment with mature female medaka, the fish that were fed diets supplemented with at least HaBC 20 mg/g-feed had lower GSIs than the control diet group did. The results showed that the growth of the immature medaka was not correlated with the amount of supplementation of HaBC in the diet. However, the condition factors (CF) in the medaka that were fed diets supplemented with at least HaBC 20 mg/g-feed were higher than in the medaka fed on the control diet. We concluded that extracts containing saponin from the stem bark of A. julibrissin have the potential to inhibit gonadal maturation in female medaka, but they did not act as growth stimulation. Further studies are required to determine the mechanism of the action.

• KSBB Journal
• /
• v.9 no.2
• /
• pp.211-223
• /
• 1994

In fermentations with a 4-liter stirred tank bioreactor, a better than two-fold enhancement of the gas-liquid mass transfer coefficient$(k_La)$ in the celite-immobilized fungal cultures of Tolypocladium in flatum over the parallel conventional free-cell was observed at identical biomass concentrations, despite the higher specific oxygen uptake rate of the immobilized fungi during exponential growth. As a result oxygen sufficient conditions, i. e., dissolve oxygen(D.O.) concentrations exceeding 75% air saturation, could be maintained throughout exponential growth period of the immobilized culture, in contrast to the suspended fungal culture, whose D.O. levels fell below 50% air saturation. A linear monotonic dependence of $k_La$ upon impeller agitaion rate was found for both immobilized and conventional cultivation modes over a range of 250 to 550rpm, the slope being a function of biomass concentration for the free but not for the immobilized cell system In contrasts oxygen transfer rate was a much weaker function of aeration rate up to about 2.5 vvm for both culture configurations. Above this level, aeration rate had no further effect on the mass transfer. In addition, the immobilized cultures sustained good morphological and physiological states, leading to almost two times higher cyclosporln A (CyA) productivity overt the parallel free cell system. These experiments suggest that the celite-immobilized fungal system in a stirred tank reactor has considerable promise for scaling up cyclosporin A production in terms of high-density cultivation.

• KSBB Journal
• /
• v.24 no.4
• /
• pp.397-402
• /
• 2009

The Portulaca oleracea (P. oleracea) is a popular herbal medicine in East Asia that was known to possess detoxification, antifebrile and antifungal effects. In the present study, we examined the biological activities of ethanol extracts of P. oleracea under various conditions with NIH3T3, B16F10, and MCF-7 cell line model systems. Extracts of P. oleracea (0.5 mg/ml) showed inhibition of expression of tyrosinase, but does not suppress either of TYRP-1 or DCT expression on B16F10 cells. Extracts of P. oleracea (2 mg/ml) showed anti-inflammatory effects on TNF-$\alpha$-stimulated NIH3T3/$NF{\kappa}B$-Luc cells and increase of the synthesis of collagen on NIH3T3 (wild type) cells. These results suggest that extracts of P. oleracea could be used as a functional biomaterial in developing a skin whitening agent and having the anti-inflammatory, anti-wrinkle, and anti-aging activities.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.43 no.2
• /
• pp.72-78
• /
• 2020

Demand for cosmetics with functionality and eco-friendliness has increased dramatically due to recent aging, well-being trends, and increased interest in beauty. Cosmetics production in 2014 was 8,970.4 billion won, an increase of about 50% compared to 6,014.6 billion won in 2010. In the midst of this, similar companies in intense competition are pursuing differentiated strategies and innovation activities to solve quality, price and delivery problems. In particular, cosmetics packaging work is getting more difficult due to the increasing bill of materials (BOM) and difficult assembly methods. Therefore, in this study, the following problems were identified and suggestions for the improvement of the packaging Many research laboratories such as biotechnology, chemistry, and pharmaceuticals, which are undergoing various studies, are equipped with ready-made laboratory safety equipments such as bio-safety workbenches, aseptic bases, and exhaust workbenches. However, most researchers are disadvantaged in using existing safety equipment. This is because existing safety equipment can not take into account all of the unique characteristics of the research. For this reason, researchers are demanding the development of customized safety equipment that is well suited to their research needs. process of Company C, which is facing difficult situation to respond to the customer 's delivery due to the 52 - hour work week. First, we used the stopwatch to find the difficulty process in the packaging process and show ways to improve it. Second, to improve the efficiency of line balancing in the packaging process, we integrate processes, improve work methods, and perform simple automation. As a result, the prepare loss for replacement was reduced by 1 minute from 5 minutes, resulting in a 23% increase in productivity from 112 ea./hour to 137ea./ hour per person. At this time, the LOB of the packaging process was improved from 70% to 82% by operating one more production line through one person per line, total 9 people saving.

• KSBB Journal
• /
• v.10 no.3
• /
• pp.283-291
• /
• 1995

The characteristics of aminopeptidase M(ApM) immobilized covalently on Cellufine Formyl and the continuous production of authentic human growth hormone(hGH) from methionyl human growth hormono(met-hGH) using the column reactor packed with immobilized ApM were investigated. Immobilized ApM with the proportion of 2.3mg ApM per 1g Cellufine Formyl gel had the highest met-hGH conversion activity. The optimum pH(7.0) and temperature($55^{\circ}C$) showed no appreciable difference between free and immobilized enzymes and the optimum temperature in continuous operation of the column reactor was also found to be $55^{\circ}C$. Under the conditions at which met-hGH was converted completely to hGH, the yield and productivity were about 77% and 0.8mg hGH/ml$.$h, respectively. In two column reactors of different sizes, met-hGH was converted to hGH with the same conversion rates and hGH yields at the same space velocities. The half-life of the reactor systems at $45^{\circ}C$ and $55^{\circ}C$ were projected from the continuous operations for 90 days to be 225 days and 81 days, respectively.

• The Korean Journal of Pesticide Science
• /
• v.9 no.4
• /
• pp.338-346
• /
• 2005

Serum alanine aminotransferase(ALT), aspartate aminotransferase (AST), hepatic glutathione, glutathione S-transferase(GST), cytochrome P450 and cytochrome P450 reductase activity were measured to investigate the effects of hepatic detoxication system and metabolic activities of carbendazim in Sprague Dawley(S.D.) male rat at dose levels of 375, 750 or 1,500 mg/kg body weight. Serum alanine aminotransferase(ALT) and aspartate aminotransferase(AST) activities were slightly increased in all test groups after 120 minutes of administration. Glutathione was increased about 20% at high and medium dose level within 120 minutes after administration, while activity of glutathione S-transferase was decreased $36{\sim}50%$. However, the enzyme activity was recovered from all test groups after 240 minutes of administration. Cytochrome P450 and activity of cytochrome P450 reductase were decreased $25{\sim}50%$ until 120 minutes after administration, but recovered after 240 minutes.

• Korean Journal of Environmental Biology
• /
• v.39 no.3
• /
• pp.311-318
• /
• 2021

In this experiment, we investigated the toxicity of tebuconazole (fungicide) using domestic frog embryos, along the FETAX (Frog Embryo Teratogenesis Assay-Xenopus) protocol. Bufo gargarizans, Hyla japonica, and Pelophylax nigromaculatus embryos were incubated, and investigation of the tebuconazole effect was performed by the probit analysis. As a result, depending on the concentrations of tebuconazole, the mortality and malformation rates were increased and larval body length was decreased. The teratogenic concentrations (EC₅₀) of tebuconazole were 34.4mg L^-1, 10.6mg L^-1, and 14.9mg L^-1, respectively, and the embryo lethal concentrations(LC₅₀) of tebuconazole were 74.7 mg L^-1, 38.5 mg L^-1, and 39.1 mg L^-1, respectively. The teratogenic index (TI) valuesof tebuconazole were 2.19, 3.58, and 2.65; thus, it showed teratogenicity in embryonic development of these three frogs. These results revealed that in this experiment, tebuconazole suppressed the development of embryos at a relatively low concentration. In addition, mortality, malformation ratios, malformation patterns, and growth rates were similar to the results from the other assay systems. Therefore, tebuconazole was thought to have an effect on the embryo development of domestic frogs. In future, it will be necessary to identify species specificity in order to the clarify the causes of differences in mortality, malformation rate, and malformation patterns depending on the species.

• Korean Journal of Clinical Laboratory Science
• /
• v.53 no.4
• /
• pp.326-332
• /
• 2021

Swabs are useful and common sampling tools in various research fields, such as medicine, ecology, biotechnology, forensic medicine, and pollutant monitoring systems. Collection reagents are one of the essential components in sampling. It is important to develop a sample collection kit and designate an appropriate storage temperature because samples need to be stored for a long time. The purpose of this study was to identify the effects of three collection reagents and three storage temperatures on the recovery of living bacteria without media. We selected Escherichia coli and Staphylococcus aureus as representative environmental bacteria. Distilled water (DW), phosphate buffered saline (PBS), and Tris-EDTA (TE) buffer were used as collection reagents and stored at 22℃, 4℃, and -70℃ after sampling. The results of using each collection reagent and storage temperature on the bacteria were compared using relative light units (RLU) and the number of colony forming units (CFU). When using -70℃ storage temperature and the TE buffer, the number of living bacteria and the RLU values remained constant. It is therefore recommended that the sample be stored at -70℃ immediately after collection and a TE buffer solution be used as the collection reagent.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.13 no.4
• /
• pp.2060-2077
• /
• 2019

Recently, mobile healthcare services have attracted significant attention because of the emerging development and supply of diverse wearable devices. Smartwatches and health bands are the most common type of mobile-based wearable devices and their market size is increasing considerably. However, simple value comparisons based on accumulated data have revealed certain problems, such as the standardized nature of health management and the lack of personalized health management service models. The convergence of information technology (IT) and biotechnology (BT) has shifted the medical paradigm from continuous health management and disease prevention to the development of a system that can be used to provide ground-based medical services regardless of the user's location. Moreover, the IT-BT convergence has necessitated the development of lifestyle improvement models and services that utilize big data analysis and machine learning to provide mobile healthcare-based personal health management and disease prevention information. Users' health data, which are specific as they change over time, are collected by different means according to the users' lifestyle and surrounding circumstances. In this paper, we propose a prediction model of user physical activity that uses data characteristics-based long short-term memory (DC-LSTM) recurrent neural networks (RNNs). To provide personalized services, the characteristics and surrounding circumstances of data collectable from mobile host devices were considered in the selection of variables for the model. The data characteristics considered were ease of collection, which represents whether or not variables are collectable, and frequency of occurrence, which represents whether or not changes made to input values constitute significant variables in terms of activity. The variables selected for providing personalized services were activity, weather, temperature, mean daily temperature, humidity, UV, fine dust, asthma and lung disease probability index, skin disease probability index, cadence, travel distance, mean heart rate, and sleep hours. The selected variables were classified according to the data characteristics. To predict activity, an LSTM RNN was built that uses the classified variables as input data and learns the dynamic characteristics of time series data. LSTM RNNs resolve the vanishing gradient problem that occurs in existing RNNs. They are classified into three different types according to data characteristics and constructed through connections among the LSTMs. The constructed neural network learns training data and predicts user activity. To evaluate the proposed model, the root mean square error (RMSE) was used in the performance evaluation of the user physical activity prediction method for which an autoregressive integrated moving average (ARIMA) model, a convolutional neural network (CNN), and an RNN were used. The results show that the proposed DC-LSTM RNN method yields an excellent mean RMSE value of 0.616. The proposed method is used for predicting significant activity considering the surrounding circumstances and user status utilizing the existing standardized activity prediction services. It can also be used to predict user physical activity and provide personalized healthcare based on the data collectable from mobile host devices.

• Food Science and Industry
• /
• v.50 no.2
• /
• pp.2-11
• /
• 2017

Packaging is the last defensive barrier that protects food products from insect infestation during storage. However, though packaging films are hermetically sealed, insects can still be attracted by strong olfactory cues and penetrate through packaging materials, resulting in contamination. Insect contamination may cause consumers to be repulsed by contaminated food products. Especially, it is well known that stored-product insects cause critical problems in the cereal industry by inducing quantitative and qualitative damages to the grain products. The contaminations are caused by insects' metabolic byproducts and body parts, consequentially caused customer repulsion. Therefore, it is necessary to repel and control insects. However, management systems for storage insects in food industry have been inadequate for many years. Synthetic pesticides has been widely used, but pesticides may accumulate in foods, causing acute and chronic symptoms in consumers. For this reason, there is a growing need for the development of natural insecticides that can replace synthetic pesticides. Thus, various reports about anti-insect packaging materials and strategies to repel insects were introduced in this study. Furthermore, we suggested new strategies to develop an insect-repelling active packaging materials which could be applied in the food packaging industry.