• 산업공학
• /
• 제15권1호
• /
• pp.20-25
• /
• 2002

In this research, a nameplate engraving system for images and texts downloaded through Internet on nameplate is developed. The system consists of two subsystems: thinning algorithm and NC code generation module. In the thinning algorithm, the concept of connectivity is used and center lines of images and texts, which will be used as NC tool paths, can be obtained successfully. Because the center lines are composed of a lot of pixels, NC code would be too long. In the NC code generation module, many useless pixel data are removed and linear interpolation algorithm is applied to only the remaining pixels. By performing actual experiments, the thinning algorithm and the NC code generation module are verified.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2008년도 하계종합학술대회
• /
• pp.161-162
• /
• 2008

In this paper we design an irregular low-density parity-check (LDPC) code for a multi-input multi-output (MIMO) system. The considered MIMO system is minimum mean square error soft-interference cancellation (MMSE-SIC) detector. The MMSE-SIC detector and the LDPC decoder exchange soft information and consist a turbo iterative detection and decoding receiver. Extrinsic information transfer (EXIT) charts are used to obtain the edge degree distribution of the irregular LDPC code which is optimized for the input-output transfer chart of the MMSE-SIC detector. It is shown that the performance of the designed LDPC code is much better than that of conventional LDPC code optimized for the AWGN channel.

• Journal of Positioning, Navigation, and Timing
• /
• 제7권3호
• /
• pp.139-146
• /
• 2018

In recent years, a satellite navigation signal authentication technique has been introduced to determine the spoofing of commercial C/A code using the cross-correlation mode of GPS P(Y) code received at two receivers. This paper discusses the technical considerations in the implementation and application of authentication system simulator hardware to achieve the above technique. The configuration of the simulator consists of authentication system and user receiver. The synchronization of GPS signals received at two devices, data transmission and reception, and codeless correlation of P(Y) code were implemented. The simulation test result verified that spoofing detection using P(Y) codeless correlation could be achieved.

• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 1999년도 춘계학술발표회요약집
• /
• pp.22-22
• /
• 1999

The HELlOS-MASTER code system is verified through the benchmark of the critical experiments that were performed by RRC "Kurchatov Institute" with water-moderated hexagonally pitched lattices of highly enriched Uranium fuel rods (8Ow/o). We also used the same input by using the MCNP code that was described in the evaluation report, and compared our results with those of the evaluation report. HELlOS, developed by Scandpower A/S, is a two-dimensional transport program for the generation of group cross-sections, and MASTER, developed by KAERI, is a three-dimensional nuclear design and analysis code based on the two-group diffusion theory. It solves neutronics model with the AFEN (Analytic Function Expansion Nodal) method for hexagonal geometry. The results show that the HELIOSMASTER code system is fast and accurate enough to be used as nuclear core analysis tool for hexagonal geometry.ometry.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 학술대회 논문집 전문대학교육위원
• /
• pp.176-179
• /
• 2005

In this paper, we propose the new method that separate the existing common VQ code book into two parts, one is the common VQ code book which is the half of existing common VQ code book, another is the personal speaker VQ code book which accommodate the personal speaker characteristic, variation to improve the performance of the text-dependent speaker verification system using discrete HMM. We apply the propose method m this paper to the text-dependent speaker verification system using discrete HMM and have the improvement performance of about 0.24% compared to existing method

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2002년도 추계학술대회 논문집(I)
• /
• pp.471-477
• /
• 2002

In this paper, it is proposed instruction code satisfied algorithm that is able to prevent data collision when transponder access in the area of recognition system that is operated to single channel. Differ from absolute collision is used to in the time domain procedure, instruction code satisfied algorithm, transmits data which don't generate collision and must satisfy instruction code. So, to prevent data collision, transponder is of great if it read the entire instruction code. Consequently, it is applied to algorithm that made the system of wireless recognition13.56 Mhz. As a result, for the time of one bit data transmission had 14${\mu}$s difference, it is proved the prevention of data loss in experiment.

• Nuclear Engineering and Technology
• /
• 제50권6호
• /
• pp.981-988
• /
• 2018

An experiment was performed for the OECD/NEA ROSA-2 Project with the large-scale test facility (LSTF), which simulated a steam generator tube rupture (SGTR) accident due to a double-ended guillotine break of one of steam generator (SG) U-tubes with operator recovery actions in a pressurized water reactor. The relief valve of broken SG opened three times after the start of intact SG secondary-side depressurization as the recovery action. Multi-dimensional phenomena specific to the SGTR accident appeared such as significant thermal stratification in a cold leg in broken loop especially during the operation of high-pressure injection (HPI) system. The RELAP5/MOD3.3 code overpredicted the broken SG secondary-side pressure after the start of the intact SG secondary-side depressurization, and failed to calculate the cold leg fluid temperature in broken loop. The combination of the number of the ruptured SG tubes and the HPI system operation difference was found to significantly affect the primary and SG secondary-side pressures through sensitivity analyses with the RELAP5 code.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2009년도 춘계학술대회
• /
• pp.485-488
• /
• 2009

본 논문에서는 블록 채널 부호 계열에서 다중 오류정정 능력을 갖는 BCH Encoder를 FPGA로 구현한 논문이다. 또한 부호율의 변경이 가능하게 하여 다양화 부호 율에 따른 부호를 생성할 수 있게 하였다. 본 논문에서는 FPGA 구현을 위해 Matlab을 이용하여 시뮬레이션을 하였고, 이를 HDL로 설계하고, 동시에 Xilinx사의 System Generator를 사용하여 구현하였고, Timming Analysis와 Resource estimation도 하였다.

• Journal of information and communication convergence engineering
• /
• 제20권1호
• /
• pp.1-7
• /
• 2022

Herein, a new space-time block coding technique is proposed for a MIMO 2 × 2 multiple-input multiple output (MIMO) system to minimize the bit error rate (BER) in Rayleigh fading channels with reduced decoding complexity using ZF and MMSE linear detection techniques. The main objective is to improve the service quality of wireless communication systems and optimize the number of antennas used in base stations and terminals. The idea is to exploit the correlation product technique between both information symbols to transmit per space-time block code and their own orthogonal Walsh-Hadamard sequences to ensure orthogonality between both symbol vectors and create a full-rate orthogonal STBC code. Using 16 quadrature amplitude modulation and the quasi-static Rayleigh channel model in the MATLAB environment, the simulation results show that the proposed space-time block code performs better than the Alamouti code in terms of BER performance in the 2 × 2 MIMO system for both cases of linear decoding ZF and MMSE.

• 한국컴퓨터정보학회논문지
• /
• 제6권4호
• /
• pp.100-103
• /
• 2001

자바프로그램의 실행속도를 빠르게 하는데 있어서 가장 좋은 방법은 빠른 자바가상머신(JVM : Java Virtual Machine)을 사용하는 것이다. 자바가상머신의 성능은 구현 차이에 따라 성능차이가 많이 난다. 자바가상머신을 구현하는데 있어서 가장 중요한 성능 향상의 기술은 JIT(Just-in-Time) 코드 생성기(Code Generator)이다. JIT 코드 생성기는 자바 바이트 코드를 플랫폼에 맞는 native machine code로 변환해 준다. 이 native code들은 자바가상머신에서 각 바이트 코드를 분석하는데 걸리는 시간을 단축할 수 있기 때문에 기존의 방식보다 빠르게 동작한다. 그러나 JIT 코드 생성기는 많은 레지스터를 사용하기 때문에 스택과 레지스터간의 traffic이 가중되는 문제가 있다. 그러므로 본 논문에서는 자바가상머신의 성능 향상을 위한 방안으로 효율적인 stack allocation 정책을 JIT 코드 생성기에 적용하여 레지스터와의 traffic을 감소시킬 수 있는 방안을 제시하였다.