• Journal of the Society of Naval Architects of Korea
• /
• v.44 no.4
• /
• pp.389-397
• /
• 2007

This research describes a framework to compare and analyze the icebreaker(Terry Fox) resistance in pack ice condition between with a refrigerated ice and a synthetic ice. Model tests with a refrigerated ice have been conducted at Institute for Ocean Technology (IOT/NRC) and the tests with a synthetic ice were conducted at Pusan National University towing tank. For the validation of further tests of measurement and accuracy, the open water tests were first carried out with same model ship to compare the test results of both Institutes. Two different size of the wax-type synthetic ice were used and tests were conducted in pack ice of three different concentration ice conditions. The test results show that the difference of resistance between with synthetic and with refrigerated ice becomes larger according to the increase of ship speed. Although the quantity of resistance difference is not so small in high speed range, the present study is predicted to be used as a useful correlation between synthetic and refrigerated ice.

• Special Issue of the Society of Naval Architects of Korea
• /
• 2008.09a
• /
• pp.46-53
• /
• 2008

Recently, the synthetic material stern tube bush has been applied by ship owner's requirement because the synthetic material has a merit. That is to say, when stern tube seal is damaged and sea water comes into stern tube, it can work without problem because of water lubricating property. However, the material also has a demerit of temperature rise problem when some factors meets on synthetic material, for example, not sufficient lubrication oil supply and not proper shaft alignment and so on. As known in the world, the RAILKO bush is rampant for synthetic material by some ship owner because of the above mentioned reason. However, the bush has several accidents on large container vessel. Unfortunately or fortunately our yard has a chance to apply the RAILKO bush owing to requirement of specific ship owner. Therefore, it is much more required to approach the accurate shaft alignment analysis. In line with this reason, we had a shaft alignment calculation considering hull deformation and hull flexibility (hull stiffness). Also, in the calculation, we had considered dynamic condition which is reflected he propeller thrust forces and moments and oil film stiffness on the shaft alignment calculation. According to he shaft alignment calculation, bearing slope was applied on the tern tube bush and was measured. The RAILKO bush should be applied the running in procedure according to maker's recommendation for performing the oil film on the bush surface. Finally, the vessels were delivered successfully without any problem with AILKO bush as shown on his paper.

• Korean Journal of Remote Sensing
• /
• v.33 no.4
• /
• pp.437-444
• /
• 2017

Since land pixels often generate false alarms in ship detection using Synthetic Aperture Radar (SAR), land masking is a necessary step which can be processed by a land area map or water database. However, due to the continuous coastline changes caused by newport, bridge, etc., an updated data should be considered to mask either the land or the oceanic part of SAR. Furthermore, coastal concrete facilities make noise signals, mainly caused by side lobe effect. In this paper, we propose two methods. One is a semi-automatic water body data generation method that consists of terrain correction, thresholding, and median filter. Another is a dynamic land masking method based on water database. Based on water database, it uses a breadth-first search algorithm to find and mask noise signals from coastal concrete facilities. We verified our methods using Sentinel-1 SAR data. The result shows that proposed methods remove maximum 84.42% of false alarms.

• Journal of Integrative Natural Science
• /
• v.6 no.3
• /
• pp.151-157
• /
• 2013

The ion exchange resins were synthesized from 1-aza-18-crown-6 macrocyclic ligand attached to styrene (2th petroleum in 4th class hazardous material) divinylbenzene (DVB) copolymer with crosslinks of 1%, 6%, and 15% by substitution reaction. These synthetic resins were confirmed by chlorine content, elementary analysis, surface area, and IR-spectrum. The object of this study was to seperate the metal ion absorbed in reinforcement water fire extinguishing agent. As the results of the effects of pH, equilibrium arrival time, and crosslink of synthetic resin on metal ion adsorption for resin adsorbent, the metal ions were showed high adsorption at pH 3 or over and adsorption equilibrium of metal ions was about 2 hours. In addition, adsorption selectivity for the resin in water was the order of Al (III) > Ni (II) > Sm (III) ions, adsorbability of the metal ions was in the crosslinks order of 1%, 6%, and 15%.

• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09a
• /
• pp.449-450
• /
• 2006

This paper described the preparation method for composing high-grade synthetic diamond by water atomizing using FeNi30 powder catalyst. The objective of this article is about powder making process using super high water atomizing in the atmosphere of inert gas, and then corroded the powder with a corrosion inhibitor. Finally, FeNi30 catalyst powder with lower oxygen content and good sphericity is produced. The experiment of making diamonds by using cubic press and the performance of the diamonds are also discussed.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.29 no.3
• /
• pp.17-25
• /
• 1997

Natural water-soluble polymers such as starch, casein and carboxy methyl cellulose(CMC) have been limited in their uses. However, the proper water retention of coating colors can not be obtained without addition of these polymers. Furthermore, the coating runnability and the physical properties of coated paper were not also satisfied. Therefore, the objective of this study was to synthesize the water retention and flow modifiers which can improve the water retention and flow properties of coating colors. We have measured physical properties of flow modifiers and coating colors which included flow modifiers. The viscosity of flow modifiers was very low at acid pH, and rapidly increased at about pH 7, and gradually reached to equilibrium at alkali pH. Such an increase comes from the molecular weight of flow modifiers and the amount of acrylic and methacrylic acids. The viscosity of coating color containing the flow modifiers was lower than that containing CMC. However, both of them had little difference in water retention. The water-phase viscosity of synthetic modifier containing coating color was either higher or similar compared to that of CMC containing coating color. The high shear viscosity of coating colors was low. Therefore, it can be concluded that the synthetic flow modifiers are very useful for improvement of flow properties and water retentions.

• Water for future
• /
• v.24 no.4
• /
• pp.59-66
• /
• 1991

Abstract The purpose of the synthetic of monthly river flows based on the short-term observed data by means of multivariate stochastic models is to provide abundunt input data to the water resources systems of which the system performance and operation policy are to be determined beforehand. In this study, multivariate Thomas-Fiering and Matalas models for synthetic generation based on stream flows in neihboring basin were employed to check if it can be applide in the modeling of monthly flows. Statistical parameters estimated by Method of Moment and Fourier Series Analysis respectively were reproduced for statistical features. For comparisons the statistical parameters of the generated monthly flow by each model were compared with those of the observed monthly flows. Results of this study suggest that the application of Matalas model for synthetic generation of monthly river flows can be adapted.

• Applied Chemistry for Engineering
• /
• v.4 no.2
• /
• pp.254-263
• /
• 1993

The industry of amino acids has developed for the synthetic methods, zymotechnics from the methods of extraction. In the present, part of amino acids (L-cystine, L-tyrosine, etc.) is manufactured by the methods of extraction, but most of amino acids is produced by synthetic methods, zymotechnics. Among the methods, the synthetic methods use of cyanic acid, which generate a large of waste water by acid or alkali in hydrolysis. In this point of view, improved new synthetic methods are demanded for being the influence of environment. This article Introduces new synthetic methods of phenyl alnine, further more, the recent of research results are introduced to prepare the derivative ${\alpha}-keto$ acids of precursor for preparing more than particular amino acids.

• Journal of Environmental Science International
• /
• v.22 no.7
• /
• pp.801-810
• /
• 2013

To improve the physical and chemical properties of the soil and increasing water-retaining property of the soil, Superabsorbent synthetic polymeric materials have been used. The experiment carried out from April to July 2012 after the influence evaluation of Superabsorbent synthetic polymeric materials to vines plant. The result shows that the study of Hedera japonica Tobler, the growth and the survival rates rank as media > hydroponic > superabsorbent synthetic polymers, and the growth and the survival rates are considerably pessimistic in the experiment of hydroponic and superabsorbent synthetic polymers. In the study of Trachelospermum asiaticum var. intermedium, the growth and the survival rates rank as hydroponic > media > superabsorbent synthetic polymers, the difference between the experiment of hydroponic and is very small and the survival rates are not very good in the experiment of superabsorbent synthetic polymers. In the study of Euonymus fortunei var. radicans Rehder,it is insignificantly difference among the different of planting based. Judging from these results, the differences are depending on the species of plants. The thesis holds that the characteristics of plant should be considered in plant cultivation and soil improvement in the future, and it is desirable to use the appropriate mixing ratio of soil in soil improvement as well.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2006.05a
• /
• pp.1191-1195
• /
• 2006

Now days, heavy storm occur to be continue. It is hard to use before frequency based on flood discharge for decision that design water pocket structure. We need to estimation of frequency based on flood discharge on the important basin likely city or basin that damage caused by flood recurrence. In this paper flood discharge calculated by Clark watershed method and SCS synthetic unit hydrograph method about upside during each minute of among time distribution method of rainfall, Huff method choosing Bocheong Stream basin that is representative basin of International Hydrologic Project (IHP) about time distribution of rainfall that exert big effect at flood discharge estimate to research target basin because of and the result is as following. Relation between probability flood discharge that is calculated through frequency analysis about flood discharge data and rainfall - runoff that is calculated through outward flow model was assumed about $48.1{\sim}95.9%$ in the case of $55.8{\sim}104.0%$, SCS synthetic unit hydrograph method in case of Clark watershed method, and Clark watershed method has big value overly in case of than SCS synthetic unit hydrograph method in case of basin that see, but branch of except appeared little more similarly with frequency flood discharge that calculate using survey data. In the case of Critical duration, could know that change is big area of basin is decrescent. When decide time distribution type of rainfall, apply upside during most Huff 1-ST because heavy rain phenomenon of upsides appears by the most things during result 1-ST about observation recording of target area about Huff method to be method to use most in business, but maximum value of peak flood discharge appeared on Huff 3-RD too in the case of upside, SCS synthetic unit hydrograph method during Huff 3-RD incidental of this research and case of Clark watershed method. That is, in the case of Huff method, latitude is decide that it is decision method of reasonable design floods that calculate applying during all $1-ST{\sim}4-TH$.