• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.6
• /
• pp.1-14
• /
• 2011

The surrogate safety assessment model which was developed based on the conflict theory by FHWA in the US is software to analyze traffic conflicts using the individual vehicle trajectory data from a microscopic traffic simulation model. This study aims at assessing the safety of different signal control strategies, including pre-time and actuated signal control, using the SSAM. To this end, this study effort has developed a microscopic traffic simulation model using VISSIM through a field study, and then produced the surrogate measures, including TTC, PET, DR, MaxS and DeltaS, and the numbers of conflicts, including rear-end, right angle and lane-changing conflicts. The assessment results indicated that the actuated signal control may produce more conflicts in terms of rear-end conflicts. The use of SSAM in the safety assessments for diverse traffic alternatives in a safe and fast way may contribute to the improvement of safety in the roadway transportation.

• Journal of Korean Society of Transportation
• /
• v.27 no.3
• /
• pp.59-70
• /
• 2009

This study presents a novel traffic information system which is capable of detecting unsafe traffic events leading to accident occurrence and providing warning information to drivers for safer driving. Unsafe traffic events are captured by a vehicle image processing-based detection system in real time. Surrogate safety measures (SSM) representing quantitative accident potentials were derived, and further utilized to develop a data processing algorithm and analysis techniques in the proposed system. This study also defined 'emergency warning area' and 'general warning area' for more effective provision of warning information. In addition, methodologies for determining thresholds to trigger warning information were presented. Technical issues and further studies to fully exploit the benefits of the proposed system were discussed. It is expected that the proposed system would be effective for better management of traffic flow to prevent traffic accidents on freeways.

• International Journal of Highway Engineering
• /
• v.14 no.5
• /
• pp.145-155
• /
• 2012

PURPOSES: This study proposes a novel method based on microscopic simulation models to evaluate bicycle passing ways in mixed traffic flow conditions at signalized intersections. METHODS: Both operational efficiency and safety are taken into consideration in the evaluation. A widely used performance measure, delay, is used for evaluating the operational efficiency. Regarding the safety evaluation, surrogate safety measures (SSM) to represent traffic conflicts and the level of crash severity, DeltaS and Max.DeltaV, are applied in the proposed method. RESULTS: Extensive simulations and statistical tests show that an integrated bike-box way is identified as the best in terms of operational efficiency and safety. CONCLUSIONS: The proposed method and outcomes of this study will be valuable for bicycle traffic operations and facility design.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.22 no.3
• /
• pp.73-87
• /
• 2023

Furnishing traffic safety information can contribute to providing hazard warnings to drivers, thereby avoiding crashes. A smart road lighting platform that instantly recognizes road conditions using various sensors and provides appropriate traffic safety information has therefore been developed. This study analyzes the short-term traffic safety improvement effects of the smart road lighting's tunnel traffic safety information service using surrogate safety measures (SSM). Individual driving behavior was investigated by applying the vehicle trajectory data collected with RADAR in the Anin Avalanche 1 and 2 tunnel sections in Gangneung. Comparing accumulated speeding, speed variation, time-to-collision, and deceleration rate to avoid the crash before and after providing traffic safety information, all SSMs showed significant improvement, indicating that the tunnel traffic safety information service is beneficial in improving traffic safety. Analyzing potential crash risk in the subdivided tunnel and access road sections revealed that providing traffic safety information reduced the probability of traffic accidents in most segments. The results of this study will be valuable for analyzing the short-term quantitative effects of traffic safety information services.

• Nuclear Engineering and Technology
• /
• v.49 no.2
• /
• pp.434-441
• /
• 2017

Containment venting is one of several essential measures to protect the integrity of the final barrier of a nuclear reactor during severe accidents, by which the uncontrollable release of fission products can be avoided. The authors seek to develop an optimization approach to venting operations, from a simulation-based perspective, using an integrated severe accident code, THALES2/KICHE. The effectiveness of the containment-venting strategies needs to be verified via numerical simulations based on various settings of the venting conditions. The number of iterations, however, needs to be controlled to avoid cumbersome computational burden of integrated codes. Bayesian optimization is an efficient global optimization approach. By using a Gaussian process regression, a surrogate model of the "black-box" code is constructed. It can be updated simultaneously whenever new simulation results are acquired. With predictions via the surrogate model, upcoming locations of the most probable optimum can be revealed. The sampling procedure is adaptive. Compared with the case of pure random searches, the number of code queries is largely reduced for the optimum finding. One typical severe accident scenario of a boiling water reactor is chosen as an example. The research demonstrates the applicability of the Bayesian optimization approach to the design and establishment of containment-venting strategies during severe accidents.

• Journal of Korean Society of Transportation
• /
• v.33 no.4
• /
• pp.323-336
• /
• 2015

Estimating the risks on the roadway using surrogate safety measures (SSM) has an advantage in that it focuses on the vehicle trajectory directly involved in conflicts. On the other hand, there is a restriction on estimating the risks of continuous segments due to the limited data collected from a location. To overcome the restriction, this study presents the scheme of acquiring the vehicular trajectory using real time kinematics-differential global positioning system (RTK-DGPS) and develops a methodology which contains the considerations of the problems to calculate the SSM such as time-to-collision (TTC), deceleration rate to avoid collision (DRAC) and acceleration noise (AN). By using the methodology, this study shows a result from an experiment executed in a section where the variation of vehicular movement can be observed from several continuous flow roadway sections near Seoul and Gyeonggi Province in Korea. The result illustrated the risks on the roadway by the SSM metrics in certain situations like merging and diverging, stop-and-go, and weaving. This study would be applied to relate the dangers with characteristics of drivers and roadway sections, and prevenst accidents or conflicts by detecting dangerous roadway sections and drivers' behaviors. This study contributes to improving roadway safety and reducing car-accidents.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.20 no.5
• /
• pp.18-34
• /
• 2021

Pedestrian deaths in Korea due to traffic accidents are 40 percent of the fatalities in traffic accidents, which is about twice the average of OECD member countries. To reduce severe pedestrian accidents, it is necessary to apply the accident reduction measures to high-risk drivers (novice, elderly, and commercial vehicle drivers) who are more likely to cause traffic accidents than general drivers. Therefore, this study analyzed the effect of safe driving education on high-risk drivers' behavior. Here, the safe driving education is chosen as the measure to reduce traffic accidents. As part of the study, sudden pedestrian crossing situations were implemented in the driving simulator, and the vehicle trajectory data were collected to compare the driving behavior before and after the education. Most surrogate safety measures showed no improvement in the driving behavior of novice and elderly drivers, and the effect of safe driving education was found to be significant only in the group of commercial vehicle drivers. The results implied that additional measures such as pedestrian safety infrastructure and driver assistance systems, apart from the safe driving education, may be needed for novice and elderly drivers to reduce pedestrian accidents caused by them. With the findings mentioned above, this study is expected to provide a foundation to establish a plan to reduce pedestrian accidents caused by high-risk drivers.

• International Journal of Highway Engineering
• /
• v.17 no.4
• /
• pp.89-98
• /
• 2015

PURPOSES : This study evaluated the feasibility of implementing protected-permissive left-turn (PPLT) signals at three-leg signalized intersections. METHODS: A three-leg signalized intersection with permissive left-turn was first selected. A VISSIM simulation model was constructed using data collected from the test site. The VISSIM network was calibrated by adjusting related parameter values in order to minimize the difference between the simulated and surveyed critical gap. The calibrated network was validated by the number of waiting left-turning vehicles per cycle. Finally, the mobility and safety measures were extracted from simulation runs in which permissive, protected left turns as well as PPLTs were realized based on diverse traffic volume scenarios. RESULTS : The mobility-related measures of effectiveness (MOEs) of the case with PPLT outperformed the other two left-turn treatment scenarios. In particular, the average waiting time per cycle for the left-turn vehicles in the case with PPLT was reduced by 30 s. The safety-related MOEs of the case with PPLT were somewhat higher than those in the case with protected left-turns and much higher than those in the case with permissive left-turns. CONCLUSIONS : Based on the mobility- and safety-related MOEs generated from the VISSIM simulation runs, the use of PPLT seems to be feasible at three-leg signalized intersections where the left-turn is permissive and a pedestrian signal exists at the conflicting approach. However, in order to use the PPLT in earnest, it is necessary to revise the road traffic act, traffic signs, and related manuals.

• Journal of Korean Society of Transportation
• /
• v.34 no.1
• /
• pp.68-80
• /
• 2016

Interest in freeway truck traffic has increased largely due to greater safety concerns regarding truck-related crashes. The negative interactions between slow-moving trucks and other vehicles are a primary cause of hazardous conditions, which lead to crashes with larger speed variations. To improve operational efficiency and safety, providing a climbing lane that separates slow-moving trucks from higher performance vehicles is frequently considered when upgrading geometrics. This study developed an operations strategy for freeway climbing lanes based on traffic conditions in real time. To consider traffic safety when designing a dynamic strategy to determine whether a climbing lane is closed or open, various factors, including the level of service (LOS) and the percentage of trucks, are investigated through microscopic simulations. A microscopic traffic simulator, VISSIM, was used to simulate freeway traffic streams and collect vehicle-maneuvering data. Additionally, an external application program interface, VISSIM's COM-interface, was used to implement the proposed climbing lane operations strategies. Surrogate safety measures (SSM), including the frequency of rear-end conflicts and, were used to quantitatively evaluate the traffic safety using an analysis of individual vehicle trajectories obtained from VISSIM simulations with various operations scenarios. It is expected that the proposed algorithm can be the backbone for operating the climbing lane in real time for safer traffic management.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.17 no.2
• /
• pp.152-167
• /
• 2018

The high-speed weigh-in-motion system can collect the traveling speed and load information of individual vehicles, which can be used in a variety of ways for the traffic surveillance. However, it has a limit to apply the high-speed weigh-in-motion data directly to a safety analysis because high-speed weigh-in-motion's raw data are point measured data. In order to overcome this problem, this paper proposes a method to calculate the conflict rate and the Impulse severity based on surrogate safety measures derived from the detection time, detection speed, vehicle length, vehicle type, vehicle weight. It will be possible to analyze and evaluate the risk of rear-end collision on freeway traffic. In addition, this study is expected to be used as a fundamental for identifying crash risks and developing policies to enhance traffic safety on freeways.