• Journal of Power Electronics
• /
• 제3권1호
• /
• pp.33-39
• /
• 2003

This paper presents the self-commissioning for surface-mounted permanent magnet synchronous motor. The proposed strategy executes three tests with a vector controlled inverter drive system. To do this, synchronous d-q axes currents are appropriately controlled for each test. From the three tests, armature resistance, armature inductance, equivalent iron loss resistance, and emf coefficient are identified automatically. The validity of the proposed strategy is confirmed by experimental results.

• 전력전자학회논문지
• /
• 제14권3호
• /
• pp.204-210
• /
• 2009

본 논문에서는 저분해능 위치센서를 갖는 표면부착형 영구자석 동기전동기의 새로운 전류센서 없는 단위 전류당 최대 토크 제어를 제안한다. 영구자석 동기전동기의 수학적 모델로부터 d축 전류를 추정하고, 추정된 d축 전류가 영(零)이 되도록 d축과 q축 전압지령 사이의 위상 각을 제어하여 단위 전류 당 최대 토크 제어를 구현한다. 제안된 방식은 동적 응답 특성이 느린 저가 응용 분야에 적합하다.

• 전력전자학회논문지
• /
• 제22권6호
• /
• pp.543-546
• /
• 2017

This paper presents a simple approach for improving the performance of back-electromotive force (back-EMF)-estimation-based sensorless drives for surface-mounted permanent magnet synchronous motors (SPMSM). Similar to conventional approaches, a hypothetical d-q synchronous reference frame model of SPMSM is employed in the proposed approach to estimate the back-EMFs. This approach also employs a dual phase locked loop structure to compensate for the effect of the dead time and parameter uncertainty of the inverter on the estimated back-EMFs. The proposed algorithm is validated by conducting experiments.

• Journal of Power Electronics
• /
• 제12권2호
• /
• pp.294-304
• /
• 2012

This paper proposes a fuzzy speed tracking controller and a fuzzy rotor angular acceleration observer for a surface-mounted permanent magnet synchronous motor (SPMSM) based on the Takagi-Sugeno (T-S) fuzzy model. The proposed observer-based controller is robust to load torque variations since it utilizes rotor angular acceleration information instead of the load torque value. Linear matrix inequality (LMI) sufficient conditions are given to compute the gain matrices of the speed tracking controller and the observer. In addition, it is mathematically verified that the proposed observer-based control system is asymptotically stable. Simulation and experimental results are presented to confirm that the proposed control algorithm assures a better transient behavior and less sensitivity under model parameter variations than the conventional PI control method.

• 조명전기설비학회논문지
• /
• 제24권8호
• /
• pp.27-31
• /
• 2010

EPS(Elctrical Power Steering)에서 전동기의 토크 리플은 조향장치의 진동 문제를 야기한다. 따라서 EPS에서 전동기의 토크 리플 저감은 중요한 문제이며, 본 논문에서는 EPS에서 사용하는 표면부착형 영구자석 동기전동기의 토크 리플 저감에 대해 논하였다. 유한요소법을 이용하여 영구자석과 고정자 슈의 형상 변화를 통해 역기전력을 분석하였으며 이를 바탕으로 토크 리플 저감 방안을 제시하였다.

• Journal of Magnetics
• /
• 제17권2호
• /
• pp.109-114
• /
• 2012

The torque characteristics of a surface-mounted permanent magnet synchronous motor (SPMSM) are analyzed in this study. The harmonics of the back electromotive force (EMF) and cogging torque are analyzed by the finite element method to study their effects on the torque ripple. Although low cogging torque can be achieved by varying geometric parameters such as the permanent magnet (PM) offset and notch depth on the stator teeth, the torque ripple is increased in some cases. The analysis results show that the ripple of the generated torque is determined by not only the amplitudes but also the phases of harmonics for the back EMF and cogging torque.

• 전력전자학회논문지
• /
• 제20권1호
• /
• pp.38-44
• /
• 2015

This paper presents the sensorless drive method for mono inverter dual parallel (MIDP) surface mounted permanent magnet synchronous motor (SPMSM) drive system. MIDP motor drive system is a technique that can reduce the cost of the multi motor driving system. To maximize this merit of the MIDP motor drive system, the sensorless technique is essential to eliminate the position sensors. This paper adopts an appropriate sensorless method for MIDP SPMSM drive system, which uses the reduced order observer and phase locked loop (PLL) to reduce the calculation burden. The I-F control method is implemented for start-up and low speed operation. The validity and performance of the proposed algorithm are shown via experiments with 600-W SPMSMs.

• Journal of Electrical Engineering and Technology
• /
• 제13권6호
• /
• pp.2284-2291
• /
• 2018

This paper deals with optimum design of surface mounted permanent magnet synchronous motor (SPMSM) for automotive component. For a compact system structure, it was designed as a motor with a 14-pole 12-slot concentrated winding and hollow shaft. The motor is a thin type structure which stator outer diameter is relatively large compared to its axial length and is designed to have a high magnetic saturation for increasing the torque density. Since the high magnetic saturation in the stator core increases the axial leakage flux, a 3-dimensional (3-D) finite element analysis (FEA) is indispensable for torque analysis. However, optimum designs using 3-D FEA is inefficient in terms of time and cost. Therefore, equivalent 2-D FEA which is able to consider axial leakage flux is applied to the optimization to overcome the disadvantages of 3-D FEA. The structure for cost reduction is proposed and optimum design using equivalent 2-D FEA has been performed.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 Proceedings ICPE 01 2001 International Conference on Power Electronics
• /
• pp.331-335
• /
• 2001

This paper presents the self-commissioning for surface-mounted permanent magnet synchronous motor. The proposed strategy executes three tests with a standard inverter drive system. To do this, synchronous d-q axes currents are appropriately controlled for each test. From the three tests, armature resistance, armature inductance, equivalent iron loss resistance, and emf coefficient are identified automatically. The validity of the proposed strategy is confirmed by experimental results.

• 조명전기설비학회논문지
• /
• 제24권12호
• /
• pp.184-192
• /
• 2010

This paper proposes a new fuzzy speed controller to precisely regulate the speed of a surface-mounted permanent magnet synchronous motor(SPMSM). The proposed fuzzy controller needs the knowledge of the load torque to realize its robust and accurate control, thus the first-order load torque observer is adopted to estimate it. It is analytically confirmed that the overall control system containing the fuzzy speed controller and the load torque observer is exponentially stable. To prove the validity of the proposed fuzzy speed controller, the simulation and experimental results are shown. It is concluded that the proposed control scheme can be employed to accurately control the speed of a SPMSM motor.