• 한국의류학회지
• /
• 제21권3호
• /
• pp.632-640
• /
• 1997

Changes in surface properties and detergency of sunactant mixtures were investigated in order to study the optimum mixing ratio of anionic and nonionic surfactants by measuring surface tension, interfacial tension, suspendability, and emulsification as a Amction of mixing ratio. Also, surface tension and detergency of the surfactant mixtures were determined with the increase of water-hardness or temperature. The results were as follows: the addition of NPE to anionic surfactant solutions (LAS or SDS) by 0.1 mole fraction remarkably decreased surface tension. NPE (n=15)/anionic surfactant mixtures showed a synergistic effect in lowering interfacial tension and emulsification, but NPE (n=7.5)/anionic surfactant mixtures did not. In suspension stability, however, synergism appeared when LAS or 505 was mixed with both of NPE's. With respect to the hydrophile of NPE, NPE (n=15) was more effective than NPE (n=i.5) in improving suspension stability. Detergency of LAS/NPE mixture changed almost linearly with mixing ratio, but that of SDS/NPE mixture increased remarkably by the addition of 0.1 or 0.2 mole fraction of NPE at all temperatures. As the temperature increased, surface tension of surfactant mixtures decreased and detergency was improved, but their synergistic effect decreased. In hard water, the mixtures showed better detergency than single surfactuant solutions.

• 한국자동차공학회논문집
• /
• 제6권1호
• /
• pp.196-204
• /
• 1998

For the experimental measurement of instantaneous surface temperature of the piston of the DI mono cylinder diesel engine, the instantaneous temperature proves, data acquisition system, and grass-hopper type linkage system were developed. The instantaneous temperatures on the piston bowl, crown, lands and skirt were measured and analyzed, and the following conclusions were derived ; (i) The crank angle for the maximum instantaneous temperature during one cycle varies and moves back and forth by the measuring positions and engine speeds. (ii) The engine speeds, the positions of the measuring points and the cooling water temperature had an effect on the instantaneous temperature amplitude. (iii) The instantaneous temperature suing phenomena appeared on the temperature profiles of the piston crown, top and second land of ring, but on the temperature profiles of the parts of the third land of the fing and skirt, they didn't appear, (iv) The isothermal lines in the piston were acquired through the operation of the finite elements method using the measured temperatures as the boundary conditions.

• 한국수산과학회지
• /
• 제16권2호
• /
• pp.111-116
• /
• 1983

1965년부터 1979년까지의 해양관측자료를 사용하여 우리나라 남해에서 일어나는 수온역전현상을 조사하였다. 그 결과를 요약하면 다음과 같다. 1) 역전현상은 여름보다 겨울에 6배정도 많이 일어난다. 2) 겨울의 경우, 남해 서부해역에서는 수온역전이 모든 수심에서 골고루 일어나는 반면, 동부해역에서는 주로 표층에서 일어난다. 3) 여름의 경우, 서부해역에서는 역전층이 주로 수온약층 아래에 형성되는 반면, 동부해역에서는 주로 표층에 형성된다. 겨울의 역전현상은 기본적으로는 표면 냉각효과에 의해서 생기는 것으로 생각된다. 다만, 서부와 동부해역에서 역전층이 형성되는 수심에 차이가 있는 것은 쓰시마난류 영향의 정도가 양해역에서 크게 다르기 때문이라고 보여진다. 여름의 경우 서부해역에서는 쓰시마난류와 황해 저층냉수가 수온약층 밑에서 혼합되는 과정에서 생기는 것으로 보이고, 동부해역에서는 보다 수온이 낮은 물이 표층을 따라 유입하기 때문에 일어나는 것으로 생각된다.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2010년도 춘계학술대회 초록집
• /
• pp.238.2-238.2
• /
• 2010

Recently, environmental pollution and energy depletion problems have been issued over the world. For this reason, many renewable systems have been developing. Of these, the Ocean Thermal Energy Conservation(OTEC) is drawing attention as the upcoming alternative energy source. In this paper, the efficiency of each of OTEC which harness the effluent from nuclear power plant was analyzed by using computer calculation. The result, shows that Ul-jin Nuclear Power Plant is the best place geographically and the regenerative cycle is most outstanding performance cycle for OTEC. The difference of temperature between surface water and deep water temperature should be greater than $20^{\circ}C$ in order to increase the efficiency.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 춘계학술대회논문집D
• /
• pp.164-169
• /
• 2001

There is a chilled ceiling panel which carries out the air conditioning by radiation and convection between the room and cold ceiling panel surface. In order to verify heat transfer characteristics between them in cooling system with radiant chilled ceiling panel, analytical and experimental studies were performed for various design and operating parameters such as tube space and diameter, inlet water temperature, mass flow rate, cooling load, and so on. In this study, we found that the tube space and inlet water temperature were more important elements than the tube diameter and water flow rate for the performance of radiant chilled ceiling panel. The cooling capacity of the radiant chilled ceiling panel had the maximum value of $65W/m^{2}$ because the highest cooling capacity was limited by the condensation on the panel surface. The results of comparison between numerical analysis and experiment showed a resonable agreement qualitatively, especially for low cooling capacity.

• 한국결정학회지
• /
• 제14권2호
• /
• pp.67-72
• /
• 2003

Graphite powders were coated with ZrO₂ by the controlled hydrolysis of a DI water, ethanol and DI water+ethanol solutions. The hydrolysis process was carried out with temperature control because of the low wettability of Zr ions to the surface of the graphite. PVA was added to the solution for the enhancement of metal ion adsorption. The surface of the graphite powders coated with ZrO₂ was observed by SEM and TEM. There are two types of ZrO₂ particles with the condition of ZrOCl₂°§8H₂O aqueous solutions were used; (a) primary particles a few nm in size and (b) secondary particles with ∼0.1 ㎛ size were obtained. The graphite powders coated in 50% ethanol-50% DI water solution of Zr(SO₄)₂ㆍ4H₂O have the relatively uniform coating layer and the starting temperature of oxidation was 100℃ higher than the raw graphite.

• 한국환경보건학회지
• /
• 제14권1호
• /
• pp.47-53
• /
• 1988

This study was performed to investigate a seasonal and vertical variation of the nutrients, water temperature, pH, DO, BOD, COD in Sukchon lake from May 1985 to Jan. 1986. The results were as follows. 1. Vertical descent of water temperature was the remarkable situation on Jul. and difference between surface layer and bottom layer was 3.5$\circ$C. 2. The value of pH was average 8.0 in both lake. The value of pH in the winter was average 7.6, and Summer was average 8.3. 3. The contents of dissolved oxygen was the highest value (13.0mg/l in surface layer on Jan. and the lowest value (8.1mg/l in bottom layer on Ul. 4. The contents of PO$_4$-P, NH$_3$-N, NO$_3$-N and T-N were 0.03~O.17mg/l 0.12~0.34mg/l 0.36~0.91mg/l and 0.76~1.37mg/l respectively.

• Journal of Advanced Marine Engineering and Technology
• /
• 제33권5호
• /
• pp.705-712
• /
• 2009

The state changes of ocean covered over 70% of earth surface are one of the greatest factor of weather catastrophe. Recently weather extraordinary events are followed by steep increase of sea water temperature and scientists in various fields are studying and warning the weather changes. In this paper, floating buoy is developed to monitor ocean environments via Orbcomm satellite and a method is proposed to increase measurement accuracy of sea water temperature with common low price temperature sensor. Experimental results are presented to illustrate the usability and effectiveness of the developed system. A web-based real time monitoring system is built to monitor ocean environmental information such as sea and air temperature, salinity according to the position of buoy through the internet for user convenience.

• 반도체디스플레이기술학회지
• /
• 제5권4호
• /
• pp.35-40
• /
• 2006

This paper shows that the effect of exposing on the top area and a solution which using a water circulation system. Semiconductor substrate stage is made from Aluminum and is repeated the sequence of exposing (150), turning OFF shutter, taking 30 sec. interval at the top area of stage. So the temperature of substrate temperature rises continuously. On this, we made a waterway at the inner part of the substrate stage and operated a water circulation system. We measured the temperature of a substrate stage surface with a thermocouple attached to the substrate stage. To analyze the top area's temperature, we used Analysis Program ANSYS for analysis and 3D CAD program Solid-Works for modeling.

• 한국환경과학회지
• /
• 제25권6호
• /
• pp.877-888
• /
• 2016

To project the effects of climate-induced change on aquatic environments, it is necessary to determine the thermal constraints affecting different fish species and to acquire time series of the current and projected water temperature (WT). Assuming that a nonlinear regression between the WT at individual stations and the ambient air temperature (AT) at nearby weather stations could represent the best relationship of air-water temperature, This study estimates future WT using a general circulation model (GCM). In addition, assuming that the grid-averaged observations of AT correspond to the AT output from GCM simulation, this study constructed a regression curve between the observations of the local WT and the concurrent GCM-simulated surface AT. Because of its low spatial resolution, downscaling is unavoidable. The projected WT under global warming scenario A2 (B2) shows an increase of about $1.6^{\circ}C$ ($0.9^{\circ}C$) for the period 2080-2100. The maximum/minimum WT shows an amount of change similar to that of the mean values. This study will provide guidelines for decision-makers and engineers in climate-induced river environment and ecosystem management.