• 한국전산유체공학회지
• /
• 제10권3호
• /
• pp.1-8
• /
• 2005

In this study, unsteady aerodynamic analyses of a wedge-type airfoil based on nonlinear piston theory and Euler equations have been performed in supersonic and hypersonic flows. The third-order nonlinear piston theory (NPT) to calculate unsteady lift and moment coefficients is derived and applied in the time-domain. Also, unsteady flow quantities are obtained from the two-dimensional time-dependent Euler equations. For the CFD based unsteady aerodynamic analyses, an arbitrary Lagrangean-Eulerian (ALE) formulation for the Euler equations is used to calculate flow fluxes in the computational flow field with moving boundaries. Numerical comparisons for unsteady lift and moment coefficients are presented between NPT and Euler approaches. The results show very good agreements in the high supersonic and hypersonic flows. It means that the present NPT can be efficiently used to predict unsteady aerodynamic forces ol wedge type airfoils with dynamic motions in the high supersonic and hypersonic flow regimes.

• 한국군사과학기술학회지
• /
• 제10권4호
• /
• pp.12-19
• /
• 2007

In this study, nonlinear flow-induced vibration(flutter) analyses of a 2-DOF launch vehicle airfoil have been conducted in supersonic and hypersonic flow regimes. Advanced aeroelastic analysis system based on computational fluid dynamics and computational structural dynamics is successfully developed and applied to the present analyses. Nonlinear unsteady aerodynamic analyses considering strong shock wave motions are conducted using inviscid Euler equations. Aeroelastic governing equations for the 2-DOF airfoil system is solved by the coupled integration method with interactive CFD and CSD computation procedures. Typical wedge type airfoil shapes with initial angle-of-attacks are considered to investigate the nonlinear flutter characteristics in supersonic(15). Also, the comparison of detailed aeroelastic responses are practically presented as numerical results.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2017년도 제48회 춘계학술대회논문집
• /
• pp.1026-1030
• /
• 2017

본 연구에서는 극초음속 추진기관을 위한 시험설비의 장치인 초음속 디퓨저 설계하였고, 두 가지 수축비를 변수로 선정하여 각각의 디퓨저를 수치해석 및 상온 시험을 진행하였다. 수치해석을 통하여 각각의 마하수와 압력에 대한 내부 유동을 확인하였다. 상온 시험을 통하여 진공챔버에 형성되는 압력과 벽면 압력을 통하여 내부에 형성되는 압력을 확인할 수 있었다. 상온 시험과 수치해석의 차이점을 분석하고, 향후 극초음속 추진기관을 위한 시험설비를 구축할 기초자료를 확보하였다.

• 항공우주시스템공학회지
• /
• 제14권4호
• /
• pp.18-24
• /
• 2020

The counter-flow jet from a supersonic/hypersonic vehicle causes a structural change in the shock wave generated around the aircraft, which can lead to reduced drag and heat loads. Since the idea is to mount a counter-flow jet device for drag reduction in the aircraft, it is necessary to understand the effect of such a device on the entire aircraft. In this study, the effect of drag reduction due to counter-flow jet on a conventional rocket configuration was analyzed through CFD analysis. The results showed that the drag reduction effect was the largest in the blunt region and that the counter-flow jet also affected the downstream of the aircraft. The analysis indicated that the drag reduction effect by the counter-flow jet was about 10 to 25 % when targeting the entire rocket-shaped area, while the effect was as high as 50% when targeting only blunt objects.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2004년도 제22회 춘계학술대회논문집
• /
• pp.75-78
• /
• 2004

Various jet engines (Turbine engine family and RAM Jet engine) have been developed for high speed aircrafts. but their application to hypersonic flight is restricted by principle problems such as increase of total pressure loss and thermal stress. Therefore, the development of next generation propulsion system for hypersonic aircraft is a very important subject in the aerospace engineering field, SCRAM Jet engine based on a key technology, Supersonic Combustion. is supposed as the best choice for the hypersonic flight. Since Supersonic Combustion requires both rapid ignition and stable flame holding within supersonic air stream, much attention have to be given on the mixing state between air stream and fuel flow. However. the wider diffusion of fuel is expected with less total pressure loss in the supersonic air stream. So. in this study the direction of fuel injection is inclined 30 degree to downstream and the total pressure of jet is controlled for lower penetration height than thickness of boundary layer. Under these flow configuration both streams, fuel and supersonic air stream, would not mix enough. To spread fuel wider into supersonic air an aerodynamic force, baroclinic torque, is adopted. Baroclinic torque is generated by a spatial misalignment between pressure gradient (shock wave plane) and density gradient (mixing layer). A wedge is installed in downstream of injector orifice to induce an oblique shock. The schlieren optical visualization from side transparent wall and the total pressure measurement at exit cross section of combustor estimate how mixing is enhanced by the incidence of shock wave into supersonic boundary layer composed by fuel and air. In this study non-combustionable helium gas is injected with total pressure 0.66㎫ instead of flammable fuel to clarify mixing process. Mach number 1.8. total pressure O.5㎫, total temperature 288K are set up for supersonic air stream.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2011년도 제36회 춘계학술대회논문집
• /
• pp.326-330
• /
• 2011

이중연소 램제트엔진의 아음속 연소기의 연소가스와 스크램제트 모드로 흡입되는 흡입공기의 혼합 및 초음속 연소를 고려한 이중연소램제트 성능해석 기법을 개발하고 검증하였다. 극초음속 흡입구의 유동특성을 고려하기 위하여 Taylor-Maccoll 방정식을 사용하였으며 초음속 연소기 해석을 위해 준 1차원 연소모델 및 CEA를 이용한 화학 평형 모델을 적용하였다. 개발된 모델을 통하여 계산된 흡입구와 연소기에서의 열역학 데이터를 수치해석 결과와 비교하였다.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2004년도 제22회 춘계학술대회논문집
• /
• pp.649-656
• /
• 2004

Hypersonic wind tunnel test of the rectangular variable geometry intake is performed. For realization of a Precooled turbojet engine, development of a hypersonic ramjet engine is planned. To investigate performance of the intake of the hypersonic ramjet engine, wind tunnel test is done with freestream Mach number of 5.1. The total pressure recovery was 18 % with 12.9 % of ramp bleed. Several reasons for low total pressure recovery are shown. Supersonic internal compression is not enough. Then, the throat Mach number is high (M2.61) and total pressure losses at the terminal shock is large. Supersonic flow at the throat and position of the terminal shock is sensitive to a difference of the second ramp's throat height and the third ramp's throat height. Flow separations at the second ramp's trailing edge and the third ramp's leading edge are seen those could result in the trigger of unstart. The seal mechanism between the ramps and the sidewalls is important.

• 한국전산유체공학회지
• /
• 제2권2호
• /
• pp.35-43
• /
• 1997

An efficient inverse method for 1.he supersonic/hypersonic axisymmetric body design is developed for the parabolized Navier-Stokes equations. The developed method is examined numerically for three extreme testcases in the supersonic(M/sub ∞/=3.0) and hypersonic(M/sub ∞/=6.28) speeds. The first one is a negative pressure distribution near a vacuum pressure and the second one is a positive pressure distribution over the whole region of the body. The last one is the case of abrupt change of pressure distribution to zero in the forward region of the body. These testcases show the robustness of the method. By introducing a regular-falsi method and by using a not-fully converged inverse solution, the convergence behavior was greatly improved.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2010년도 제35회 추계학술대회논문집
• /
• pp.717-722
• /
• 2010

초음속 풍동은 실험하고자 하는 모델 주위에 인공적으로 초음속 유동장을 형성하여 모델에 작용하는 현상을 관찰 및 측정하는 실험 장비이다. 이러한 풍동 실험 장비는 비행체 설계에 있어 시제기를 제작하지 않고도 비행체 외형에 대한 공기역학적 특성을 파악하는데 유용하다. 본 연구에서는 러시아에서 제작된 초음속/극초음속 풍동(MAF : The Model Aerodynamic Facility)을 시험 시간 증가 및 활용성 증가를 목적으로 개조하였다. 안전성 확보 및 원격 작동을 위해 공압 밸브를 설치, 실험 시간의 증가를 위해 새 저장 탱크를 설치했다. 설치한 밸브와 탱크를 이용할 수 있도록 배관 시스템을 개조하였다. 또한 광학적 시험을 위하여 시험부의 광학창을 확장하였다. 개조 후 마하수 2,3,4에 대하여 성능 시험을 수행하였다. 유동가시화 기법중 하나인 Shadow graph 기법을 이용하여 초음속 유동장의 형성을 확인하였으며, 마하수 2,3,4에 대하여 Settling Chamber, Working section의 압력측정을 통해 성능 시험을 수행하였다. 결과로부터 해당 초음속 풍동에 사용가능한 모델 크기 및 시험 시간을 도출하였다.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2001년도 제16회 학술발표회 논문초록집
• /
• pp.35-38
• /
• 2001

차세대 추진 기관으로 연구되고 있는 스크램제트 엔진의 열역학적 특성들을 검토하였다. 유동이 엔진을 통과하면서 연소에 의해 전압력이 손실되고 노즐 출구 마하수가 감소하지만, 고온 연소 가스가 배출되기 때문에 실질적인 속도는 증가하게 되고 추력이 발생한다. 초음속 연소를 모사하기 위해 blowdown 형태의 초음속 연소 풍동 설계를 위한 개념 설계가 이루어졌다. 초음속 풍동 시험부에서 마하 2.5의 속도를 유지하기 위한 작동 압력과 질유량이 계산되었다.