• Polymer(Korea)
• /
• v.36 no.2
• /
• pp.155-162
• /
• 2012

Sulfonated poly(ether ether ketone) (SPEEK) nanofibers were prepared by electrospinning. The nanofibrous membrane for polymer electrolyte membrane fuel cell (PEMFC) was fabricated by compression molding. The maximum degree of sulfonation was 95% and the initial thermal degradation temperature was $280^{\circ}C$ and it's value was lower than that of PEEK. The contact angle of SPEEK increased with decreasing the degree of sulfonation. The optimum voltage, flow rate, tip to collector distance (TCD) and concentration of electrospinning conditions were 22 kV, 0.3 mL/hr, 15 cm, and 23 wt%, respectively. The average nanofibrous diameter was 47.6 nm. The water uptake and ion exchange capacity of SPEEK nanofibrous membrane increased with increasing the sulfonation time and the amount of sulfonating agent. The electrical resistance and proton ionic conductivity of SPEEK membrane increased with decreasing and increasing the sulfonation time, respectively. Their values were 0.58~0.06 ${\Omega}{\cdot}cm^2$and 0.099 S/cm.

• Membrane Journal
• /
• v.25 no.5
• /
• pp.406-414
• /
• 2015

In this study, partially fluorinated cation exchange membranes were prepared by direct sulfonation of Poly(VDF-co-hexafluoropropylene) copolymers (PVDF-co-HFP) followed by a casting method for application in the Membrane capacitive deionization (MCDI). The structure of sulfonated PVDF-co-HFP (SPVDF) was confirmed by Fourier-transform infrared (FT-IR) and $^1H$ Nuclear magnetic resonance ($^1H$ NMR) analysis. For quantitative analysis of the chemical composition, the X-ray Photoelectron Spectroscopy (XPS) was used. The membrane properties such as water uptake, ion exchange capacity and electrical resistance were measured. It was suggested that the optimum direct sulfonation condition of PVDF-co-HFP ion exchange membranes was $60^{\circ}C$ and 7 hours for temperature and duration of sulfonation, respectively. The water uptake of the SPVDF ion exchange membrane was 21.5%. The ion exchange capacity and electrical resistance were 0.89 meq/g and $3.70{\Omega}{\cdot}cm^2$, respectively. It was investigated that if it is feasible to apply these membranes in MCDI at various cell potentials (0.9~1.5 V) and initial flow rates (10~40 mL/min). In the MCDI process, the maximum salt removal rate was 62.5% in repeated absorption-desorption cycles.

• Macromolecular Research
• /
• v.12 no.6
• /
• pp.604-607
• /
• 2004

We report an important and useful method for preparing ${\omega}-sulfonated$ polystyrene-stabilized cadmium sulfide (CdS) nanoclusters. The ${\omega}-sulfonated$ polystyrene $(M_n\;=\;5000\;g/mol)$ was prepared successfully through chain-end sulfonation of poly(styryl)lithium using 1,3-propanesultone; the resulting polymer was used successfully as a polymeric stabilizing agent for the preparation of semiconductor CdS nanoclusters by reduction of cadmium acetate in a mixture of toluene and methanol (9:1, v/v). The nanoclusters that formed were characterized by a combination of transmission electron microscopy, X-ray diffraction, and UVN is spectroscopic analysis. The ${\omega}-sulfonated$ polystyrene-stabilized CdS nanoclusters synthesized in this study exhibited the cubic phase (zinc-blende phase) structure in the range of 2-8 nm.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1997.10a
• /
• pp.137-138
• /
• 1997

1. 서론 : 이온교환막이란 합성 폴리머의 이온교환수지를 막상으로 만든 것으로 고분자 매트릭스에 특정 전하가 고정되어 있어 이러한 성질 때문에 보통의 격막에서는 볼 수 없는 특징을 가지고 있으며 바닷물의 농축에 의한 소금의 제조, 탈염에 의한 공업용수 및 음료수의 제조, 도금공장의 폐수처리, 식품과 의약품공업, 고체 고분자 전해질에 근거한 수소생성 등에서 폭넓게 이용되고 있다. 본 연구에서는 상용막에 대체가능한 이온교환막을 제조하기 위하여 내열성, 내약품성, 내산성과 우수한 기계적성질 등을 가지고 있어 membrane 소재로 널리 사용되는 polyethersulfone(PES)를 술폰화시켜 sulfonated PES를 합성한 후 양이온 교환막을 제조하여 특성을 분석하였다.

• Journal of Environmental Science International
• /
• v.11 no.9
• /
• pp.993-999
• /
• 2002

Waste paper cup was sulfonated to be used as ion exchanger. Removal characteristic of copper and lead ion by prepared ion exchanger was investigated. The sulfonation was conformed by the high intensity band of $SO_3H$ group around 1100~$1160cm^{-1}$. The synthesized ion exchanger had greater removal ability for copper and lead ion than the original waste paper cup. Ion exchange system reached the final equilibrium plateau within 30min. The maximum removal capacities $q_{max}$ were calculated as 9.79mg/g fur copper and 15.95mg/g for lead, respectively. The affinity of lead based on a weight was higher than that of copper. The ion exchange phenomena appeared to follow a typical Freundlich isotherm.

• Membrane and Water Treatment
• /
• v.4 no.2
• /
• pp.83-93
• /
• 2013

In the present investigation, were synthesized composite membranes prepared by simultaneous casting of two polymer solutions using the technique of phase inversion by immersion / precipitation. The support layer was prepared using polyethersulfone and polysulfone as base polymer and for the top layer was used sulfonated polysulfone (SPSU) with 50% sulfonation degree. The morphology of the resulting membranes were characterized by scanning electron microscopy (SEM). The final results showed that it is possible to prepare composite membranes by simultaneous casting of two polymer solutions with adherence between the two layers. Regarding the permeation tests, the developed membranes presented values of hydraulic permeability within the range of commercial nanofiltration (NF) membranes. Values rejection of 80% ammonium ions can be increased by using a SPSU with a greater degree of sulfonation.

• 한국생물공학회:학술대회논문집
• /
• 2002.04a
• /
• pp.30-33
• /
• 2002

We have shown that it is possible to form a fibrilar network of fibronectin on a polyelectrolyte polymer film whose dimensions are similar to those reported on the extra cellular matrix. The fibronectin network was observed to form only when the charge density of the polymer was in excess of the natural charge density of the cell wall. Furthermore, the self-organized fibronectin layer was much thicker than the polymer film, indicating that long ranged interaction may playa key role in the assembly process. It is therefore important to understand the structure of the polymer layer/protein interface. Here we report on a neutron reflectivity study where we explore the structure of the polyelectrolyte layer, in this case sulfonated polystyrene (PSSx,), with varying degree of sulfonation (x<30%), as a function of sulfur content and counter ion concentration. These results are then correlated with systemic study of the adsorption and the multilayer formation of fibronectin as a function of incubation time for various sulfonation levels of $PSSx.^1$

• Proceedings of the Membrane Society of Korea Conference
• /
• 1999.10b
• /
• pp.52-54
• /
• 1999

• Proceedings of the Membrane Society of Korea Conference
• /
• 2003.11a
• /
• pp.184-187
• /
• 2003

• Proceedings of the Korean Ceranic Society Conference
• /
• 2002.10a
• /
• pp.206.2-206
• /
• 2002