• 한국안전학회지
• /
• 제20권4호
• /
• pp.46-53
• /
• 2005

Existing study far fire-resistant concrete has been done already. but it is not found out how the waste tyre mixing concrete will be acted against fire. This waste tyre concrete molds under the condition of $0^{\circ}C,\;200^{\circ}C,\;400^{\circ}C,\;600^{\circ}C$ were heated in gas oven. It was worried about that they might be fractured down at about $800^{\circ}C$ so that they can not be tested. compressive strength for the test molds are made with commercially used $180kg/cm^2,\;210kg/cm^2,\;240kg/cm^2,\;270kg/cm^2$ mixing saw dust with proportion such as 0.05%, 0.1%, 0.2%, 0.4%, 0.6%, 0.8%, 1.0%, 1.2%, 1.4%, 1.6%, 1.8%, 2.0% compressive strength at $200^{\circ}C$ was approximately 20% from the original, while approximately 30% deoreased at $400^{\circ}C$. their results are not quite different from the normal concrete condition even though they contains saw dust in it. The higher strength the concrete has, the less strength was decreased. There are almost no difference in strength under the condition of less than $400^{\circ}C$, but damage of concrete structure could be considerable large with more than $400^{\circ}C$.

• 한국안전학회지
• /
• 제16권1호
• /
• pp.53-58
• /
• 2001

Constructions on the soft clay layer of low strength and high compression bring out many problems. Recent studies show that strength of the soft clay layer could be substantially improved by mixing quicklime. For the purpose, a series of uniaxial compression tests were performed, using quicklime, in order to analyze strength characteristics. The major test results are summarized following : When water content is 90%, the strength is observed to precipitously increase between 3～14 days, then, the extent slowly increase in relative terms. When water content is 130%, the strength is observed to precipitously increase up to 28 days. When the strength of water content 90% is compared to that of water content 130%, the initial strength of the former is higher than that of the latter. The analyses show that the improvement of soft clay layers can be realized by the mixture of both quicklime and sand, and by the mixture of quicklime only.

• 한국안전학회지
• /
• 제27권2호
• /
• pp.78-83
• /
• 2012

This is a study to confirm how to improve and substitute the existing re-bar with other material such as a fiber rope, especially super fiber rope having much more strong tensile strength. 6(b) different fiber rope reinforced beam with a section of $20{\times}30cm$ have been made and tasted as variables designed in the study. The larger diameter of fiber rope, the more capacity of the beam, even though fiber reinforced beam are increased with ten(10)percent, each. Lower capacity of fiber-reinforced beam than normal RC beam has been analyzed theoretically and empirically, based on a lot of experiences of the same size beam test. Fiber rope-reinforced concrete beam does not have sufficient capacity than RC beam due to insufficient bonding capacity of fiber rope in concrete. It leads to decrease beam bearing capacity and crack around lower center of the beam. Therefore, bonding reinforcement of fiber rope beam such as pinning a triangles steel pin in each knot of fiber rope contributes to improving bearing capacity of fiber rope reinforcing beam.

• 한국가스학회지
• /
• 제19권5호
• /
• pp.1-6
• /
• 2015

본 연구에서는 퓨즈콕 메인몸체에 대한 강도안전성을 유한요소법으로 해석하였다. 볼밸브와 퓨즈콕 안전장치 연결부 사이에 형성되는 (T)지역의 두께를 변화시켜가면서 응력과 변위량에 대한 거동특성을 고찰하였다. FEM 해석결과에 의하면, 퓨즈콕에 공급된 가스압력이 1.5~3.5MPa일 때 (T)지역에 대한 최적의 두께는 1.55mm~1.6mm 정도인 것으로 나타났다. 이 결과는 퓨즈콕의 메인몸체에 작용하는 강도안전성과 경량화를 고려한 최적치라 할 수 있다.

• 한국안전학회지
• /
• 제26권3호
• /
• pp.8-14
• /
• 2011

The live-line works are very dangerous because of direct contacts with the distribution line or neighboring contacts. So the purpose of this study is to identify the risk factor by accident occurrence form and accident case analysis, and to suggest the quantified risk index by risk occurrence frequency and risk strength analysis. And the risk index assessment is researched by accident cases analysis on work type. Accident cases of transmission distribution line are researched based on data of the Ministry of Employment and Labor in the last ten-year period (2000~2009). In results of this paper, high risk isn't always a priority of safety measures. Risk occurrence frequency and risk strength have to be considered according to detail work types, work methods and conditions of field work. And safety management measures must be planned according to risk occurrence frequency and risk strength.

• 한국군사과학기술학회지
• /
• 제19권3호
• /
• pp.281-287
• /
• 2016

The purpose of this study is to analyze the vibration characteristics and develop a mounting which can improve the strength safety factor to replace the high failure rate APU(auxiliary power unit) imported metal mounts with rubber mount that can be domestically produced. For this study, we analyzed in 3 kinds of rubber mounts hardness for the natural frequency to avoid the average excited frequency of the APU. In addition, allowed vibration acceleration of rubber mount confirmed to 90.8 g by adding a strength safety factor. To assure the validity of the design, we measure the vibration acceleration equipped with a metal mount and rubber mount 2 species(Hs 50 and 60). As a result, the proposed design method in this study is reasonable because the rubber mounts is excellent strength safety factor and vibration transmissibility than metal mounts.

• 한국안전학회지
• /
• 제20권3호
• /
• pp.120-125
• /
• 2005

Formwork is a temporary structure that supports its weight and that of freshly placed concrete as well as construction live loads. Among the accidents and failures that occur during concrete construction, many are formwork failures which usually happen at the time concrete is being placed. In constructions site, pipe supports are usually used as shores which are consisted of the slab formwork. The strength of a pipe support is decreasing as it is frequently being used at the construction site. The objective of this study is to find out the strength change of used pipe support and unused pipe supports according to aging. In this study, 2857 pipe supports were prepared. Among these pipe supports, 2337 pipe supports were lent to the construction companies fire of charge. 520 pipe supports were kept on the outside. Compressive strength was measured by knife edge test and plate test at each 3 month. Test results show that the strength of unused pipe supports as well as used pipe supports was decreasing according to age, use frequency and load carrier, and the strength of used pipe supports was lower than the strength of unused pipe supports at the same age. So, the strength of used pipe supports from 191 days to present day was not satisfied the specification of KS F 8001. According to these results, it shows that attention has to be paid to formwork design using used pipe supports. Therefore, the present study results will be able to provide a firm base to prevent formwork collapses.

• Annals of Rehabilitation Medicine
• /
• 제42권6호
• /
• pp.822-832
• /
• 2018

Objective To determine the socio-demographic, psychologic, hematologic, or other relevant factors associated with hand grip strength in Korean farmers. Methods A total of 528 healthy Korean farmers were enrolled. Hand grip strength was measured in both hands using a hydraulic dynamometer. Socio-demographic characteristics were assessed and anthropometric measurements were obtained. Psycho-cognitive measurements such as sleep quality (Pittsburgh Sleep Quality Index) and Go/No-Go test response time were conducted. In addition to physical measurements, serologic parameters including insulin-like growth factor 1 were measured. The factors associated with hand grip strength were analyzed using multiple linear regression analysis after adjusting for age, height, and weight. Results The mean hand grip strength was associated with the Pittsburgh Sleep Quality Index total score (${\beta}=-0.12$, p=0.01), the Go/No-Go test response time (${\beta}=-0.18$, p=0.001), vitamin D (${\beta}=0.12$, p=0.02), and insulin-like growth factor 1 levels (${\beta}=0.1$, p=0.045). In female farmers, hand grip strength was only associated with the Pittsburgh Sleep Quality Index total score (${\beta}=-0.32$, p<0.001). Conclusion The results of this study demonstrate that hand grip strength was associated with sleep quality and attention in Korean farmers.

• International Journal of Safety
• /
• 제9권1호
• /
• pp.21-29
• /
• 2010

When a new member of a scaffold is developed, it is necessary to follow the standard. Therefore, all scaffolds will assume the same structure. The aim of this study was to establish a new method for evaluating scaffold performance. In the present study, a buckling analysis of prefabricated scaffolds was executed, using the shear rigidity of the vertical and the horizontal frames as parameters. From the results, an equation is proposed for evaluating the strength of prefabricated scaffolds.

• 대한조선학회논문집
• /
• 제32권1호
• /
• pp.25-36
• /
• 1995

확률적인 접근법으로서의 신뢰성 해석법의 소개와 이의 선체 구조 강도 평가 방법에의 적용에 관해 고찰하였다. 당사에서 건조한 유조선 및 살물선 34척을 대상으로 인장 항복강도, 보강판의 압축 최종강도, 그리고 선각 거어더의 최종강도 등 몇몇 대표적인 종강도 파괴양식에 대해 신뢰성 해석을 수행하였다. 해석결과로서 각 선박에 대한 신뢰도 지수를 보이고 종강도에 대한 신뢰성 해석시의 목표 신뢰도 지수를 제시하였다. 배길이와 건조연도에 따른 신뢰도 지수의 변화를 검토하였으며 결과로서 각 선박의 안전도가 큰 차이를 보임을 알 수 있었다. 각 선박에 대해 균일한 수준의 신뢰도를 제공하기 위하여 부분 안전계수를 이용한 새로운 강도 평가 기준을 마련하였다. AFOSM 방법 및 신뢰성 조건(RC) 방법에 따라 부분 안전계수를 계산하고 이를 비교하였으며 원하는 신뢰도를 줄 수 있는 설계식을 RC 방법으로 구하였다. 부분 안전계수로부터 구한 새로운 설계식을 사용하여 신뢰성 해석을 수행한 선박에 대해 재해석을 실시하였다. 그 결과 처음보다 많이 개선된 균일한 수준의 신뢰도를 얻을 수 있었고 이로부터 신뢰성 해석의 적용가능성과 유용성을 확인하였다.