• Journal of the Korean Ceramic Society
• /
• v.37 no.7
• /
• pp.632-637
• /
• 2000

Thermoelectric conversion properties of commercial Fe-Si2 and Fe-Si alloy ingots prepared by RF inductive furnace were investigated. As sintering temperature increased, density of the specimen increased and the phase transformation from metallic phases ($\varepsilon$-FeSi, ${\alpha}$-Fe2Si5) to semiconducting phase (${\beta}$-FeSi2) occurred more effectively. The FeSi phase was detected even after 100hrs of annealing treatment. For the Fesi1.95∼FeSi2.05 specimens prepared by RF inductive furnace, the thermoelectric property improved as the composition of the specimen approached to stoichiometric composition FeSi2. Electrical conductivity of the specimen increased with increasing temperatures showing typical semiconducting behavior. From the electrical conductivity measurements, activation energy in the intrinsic region (above about 700 K) was calculated to be approximately 0.46 eV. In spite of non-doping, the Seebeck coefficient for every specimen exhibited p-type conduction due to Si deficiency. Its maximum value was located at about 475 K, and then decreased abruptly with increasing temperatures. The power factor was governed by the Seebeck coefficient of the specimen more significantly than by electrical conductivity.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.31 no.6 s.261
• /
• pp.499-506
• /
• 2007

This study aims to propose evaluation methods of chemical washing performance and estimate the washing capability by flowing detergent/water solution for application to home appliances such as dishwashers. Standard pollutant is stearic acid. A numerical study is also tried using a SIMPLER code. Preliminary experiments are performed by varying the concentration and temperature of the solution. From the pre-experiments, 10 minute pre-curing time is found to be necessary to remove the stearic acid. Stoichiometric ratio and detergent consumption coefficient of reaction between the detergent and stearic are estimated following a proposed method. Washing experiments of pollutant to compare with the numerical results are performed. The relative errors between the experimental and the numerical results with pre-curing time included are less than 7%. In conclusion, important mechanisms of chemical washing are revealed and methods of predicting washing performance are well established.

• Korean Journal of Materials Research
• /
• v.21 no.10
• /
• pp.542-545
• /
• 2011

Half-Heusler alloys are a potential thermoelectric material for use in high-temperature applications. In an attempt to produce half-Heusler thermoelectric materials with fine microstructures, TiCoSb was synthesized by the mechanical alloying of stoichiometric elemental powder compositions and then consolidated by vacuum hot pressing. The phase transformations during the mechanical alloying and hot consolidation process were investigated using XRD and SEM. A single-phase, half- Heusler allow was successfully produced by the mechanical alloying process, but a minor portion of the second phase of the CoSb formation was observed after the vacuum hot pressing. The thermoelectric properties as a function of the temperature were evaluated for the hot-pressed specimens. The Seebeck coefficients in the test range showed negative values, representing n-type conductivity, and the absolute value was found to be relatively low due to the existence of the second phase. It is shown that the electrical conductivity is relatively high and that the thermal conductivities are compatibly low in MA TiCoSb. The maximum ZT value was found to be relatively low in the test temperature range, possibly due to the lower Seebeck coefficient. The Hall mobility value appeared to be quite low, leading to the lower value of Seebeck coefficient. Thus, it is likely that the single phase produced by mechanical alloying process will show much higher ZT values after an excess Ti addition. It is also believed that further property enhancement can be obtained if appropriate dopants are selectively introduced into this MA TiCoSb System.

• YAKHAK HOEJI
• /
• v.39 no.2
• /
• pp.175-184
• /
• 1995

The interaction of omeprazole(OMP) with $\gamma$-cyclodextrin($\gamma$-CyD) was investigated by solubility study and the complexation was confirmed by means of UV/VIS spectrophotometer, circular dichroism, differential scanning calorimeter, and $^{1}$H nuclear magnetic resonance spectra. The stability, dissolution rate, and partition coefficient of the complex were measured. The results present that the benzimidazole moiety and a part of pyridine ring containing sulfur atom of OMP might be included into the cavity of $\gamma$-CyD and the formation type of inclusion complex appeared to be B$_{s}$. The stoichiometric ratio of OMP to $\gamma$-CyD in the complex was found to be 1:1 and the stability constant of the complex found to be 97.1 M$^{-1}$. And the dissolution rate of OMP was markedly increased by inclusion complex formation with $\gamma$-CyD, and so it was above 90% in 5 min. from solid complex. Oil to water partition coefficient of OMP-$\gamma$-CyD complex was 60, which is significantly higher than that of OMP itself, 36.4. The degradation rate constant of OMP were greater than OMP-$\gamma$-CyD complex in aqueous solutions of various pHs, and the half lives of OMP and OMP-$\gamma$-CyD at pH 9 were 279.2 and 509.9 days, respectively, showing that the complex was more stable than OMP, therefore it was thought that OMP was stabilized by inclusion formation with $\gamma$-CyD.

• YAKHAK HOEJI
• /
• v.37 no.4
• /
• pp.331-340
• /
• 1993

Inclusion complex of omeprazole(OMZ) with hydroxypropyl-$\beta$-cyclodextrin(HP-$\beta$-CD) was prepared by freeze-drying method. The complexation was confirmed by means of UV, CD, IR, DSC, XRD and $^{1}$H-NMR spectra. The benzimidazole moiety of OMZ might be found to be included into the cavity of HP-$\beta$-CD and the inclusion complex appeared to be $A_{L}$ type. The stoichiometric ratio of OMZ : HP-$\beta$-CD was found to be 1:1, and the stability constants of the inclusion complex by solubility and UV method were about 34 and 45 M$^{-1}$, respectively. The dissolution of OMZ was significantly enhanced from powder and. yablet of OMZ-HP-$\beta$-CD complex when compared to those of OMZ alone, and oil-to-water partition coefficient of OMZ-HP-$\beta$-CD complex was significantly higher than that of OMZ alone. Therefore, it was expected that the bioavailability of OMZ could be improved markedly by inclusion complexation of OMZ with HP-$\beta$-CD.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.24 no.12
• /
• pp.955-961
• /
• 2011

We investigated the physical properties of stoichiometric and non-stoichiometric oxide doped complex perovskite, $Ba(Zn_{1/3}Ta_{2/3})O_3$ ceramics and their impacts on the microwave dielectric performances using various characterization techniques such as X-ray diffraction, scanning electron microscopy, transmission electron microscopy, and network analyzer. According to the measurement of lattice constant changes, anomalous lattice volume contraction of $ZrO_2$ doped $Ba(Zn_{1/3}Ta_{2/3})O_3$ sample only showed the dielectric quality factor enhancements, which was due to the lattice volume contraction as well as the 1:2 B-site cation ordering. In addition, NiO doping was useful to the stabilization of temperature coefficient of resonance frequency.

• Journal of Sericultural and Entomological Science
• /
• v.31 no.1
• /
• pp.45-54
• /
• 1989

본 연구에서는 견에 대한 산성염료의 염착기구를 규명하기 위하여 전하수가 다른 산성염료에 의한 흡착실험을 수행하여, 견섬유와 피브로인막의 구조와 염료의 구조를 관련시켜서 산성염료의 흡착거동에 관한 해석을 하였다. 산성염료에 sulfonic acid group이 도입됨에 따라서 partition coefficient(Kp)는 감소하였지만 Langmuir type sorption constant(KL)는 증가하였고, 염욕의 pH와 온도의 증가에 따라서도 Kp, KL 값은 증가하였다. 전하수가 1, 2인 Dye I과 Dye II는 견섬유와 피브로인 막에 대하여 stoichiometric adsorption이 잘 적용될 수 있었으나 전하수가 3인 Dye III는 잘 적용되지 않았다. sulfonic acid group이 산성염료에 도입됨에 따라 각각의 sulfonic acid group의 표준친화력은 감소하였고, 모든 엔탈피 값은 음(-)으로 나타난 반면에 엔트로피 값은 양(+)으로 나타났다. 견섬유와 피브로인 막의 흡착 constant를 비교한 결과, 견 피브로인에 대한 산성염료의 흡착거동은 견 피브로인의 구조에 영향을 받는다는 것을 알 수 있다.

• Korean Journal of Crystallography
• /
• v.11 no.4
• /
• pp.191-194
• /
• 2000

Bi/sub 12/SiO/sub 20/, Bi/sub 12/GeO/sub 20/ and Bi/sub 12/O/sub 20/ compounds with the sillenite crystal structure were synthesized and sintered into the dense ceramic bodies. An analyses of the microwave dielectric properties of the Si, Ge and Ti sillenites showed a permittivity (e) of ∼40 and a negative temperature coefficient of the resonant frequency for all analogues (from -20 to -40 ppm/K). The Qxf value of the Si and Ge sillenites was measured to be ∼8.000 GHz. The Ti analogue shows a significantly lower Qxf value(∼2.500 GHz) and is sensitive to the heat-treatment conditions. By increasing the sintering temperature the size of the grains increases, which correlates with an increase in the Qxf value.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.302-302
• /
• 2010

The lead-free piezoelectric ceramics must have high piezoelectric properties and electrical properties for the applications of piezoelectric devices. Therefore, KNN ceramics were investigated as a function of the variation of Nb. The density was increased with the increase of Nb. The density was saturated above 0.8895 mol Nb. The maximum value of electromechanical coupling coefficient(kp) was obtained 0.428 at 0.8895mol Nb. This result can be attributed to the well sintered of specimens. Also, The maximum value of mechanical quality factor(Qm) showed 1554 at 0.8895mol Nb. Therefore, this composition can be used for application of piezoelectric device such as piezoelectric transformer and piezoelectric actuator.

• Journal of the Korean Ceramic Society
• /
• v.30 no.12
• /
• pp.1054-1058
• /
• 1993

The effects of TiO2 addition as a nucleating agent on the cordierite glass-ceramics were investigated. The glass compositiion was stoichiometric cordierite composition of 13.7MgO-34.9Al2O3-51.4SiO2(wt%), and TiO2 as a nucleating agent was added by 5, 10 and 15wt% in addition. The optimum amount of TiO2 addition and appropriate heat treatment schedule were determined by using dilatometer, DTA, XRDA and SEM. The composition containing 10wt% TiO2 was proved to be the best among the investigated compositions. And the optimum heat treatment schedule was 840℃-2h for the nucleation and 1140℃-2h for the crystallization. The properties were as follows. The crystallinity was ∼75%, thermal expansion coefficient 33×10-7/℃(25∼700℃), dielectric constant 7.6(1KHz) and Vicker's hardness 5.1GPa.