• Journal of the Korean Institute of Intelligent Systems
• /
• v.23 no.3
• /
• pp.214-219
• /
• 2013

This paper proposes the robust high-gain observer based SOC estimatro for uncertain RC model of Li-Ion batteries. In general, RC battery model has inevitable uncertainties and it cause some negative effect to estimate the accurate SOC of Li-Ion batteries. The proposed estimator overcomes such weakness with two techniques; high-gain observer design technique and sliding mode control technique. A high-gain observer provides the robustness against model uncertainties to the proposed estimator. A sliding mode control technique helps the proposed estimator by reducing the side effect of adopting a high-gain observer such as peaking phenomenon and perturbation. The performance of the proposed estimator is verified by some simulation.

• Proceedings of the KIPE Conference
• /
• 2019.11a
• /
• pp.194-195
• /
• 2019

배터리는 사용 기간과 회수가 증가함에 따라 수명이 점차 감소한다. SOH(State-Of-Health)는 배터리의 초기 상태와 현재 상태를 비교하여 배터리의 수명 상태를 나타내는 지표이며, 이는 배터리를 사용함에 있어서배터리의 현재 충전상태를 나타내는 SOC(State-Of-Charge)와 함께 정확한 추정을 필요로 한다. 본 논문에서는 리튬이온 배터리를 C-rate에 따라 노화시키며 각 C-rate별 SOH 추정 경향성을 분석하였다. 배터리의 SOC와 SOH는 확장 칼만 필터를 병렬적으로 사용하는 이중 확장 칼만 필터를 활용하여 추정한다. 배터리의 노화실험은 완전충전과 완전충전을 반복하는 전류 프로파일을 인가하였으며, 실험은 상온(25℃)에서 실행하였다.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.22 no.2
• /
• pp.44-51
• /
• 2014

This paper describes system definition of the extended range EV and presents cruising strategy of EV mode and ER mode. Also high voltage battery strategic SOC could be indicated and compared depends on various generator working cycles. A C-segment SUV has been produced and carried out cruising test in order to validate on highway, city and hill climbing road. This paper shows advantages and disadvantages of SOC variation on each road environments and presents the strategies as the cruising test results. On the basis of the test result, this paper suggests future works and research directions for strategy of battery management to extended range EV.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.22 no.3
• /
• pp.300-304
• /
• 2012

This paper presents a nonlinear observer design method for SOC(state-of-charge) estimation of Lithium polymer battery cell. The dynamic equation of the battery cell is modeled as a simple RC electrical circuit with a nonlinear voltage source and the parameters are obtained via nonlinear optimization. Using the sum of squares decomposition, the observer gain is designed such that the error dynamics is asymptotically stable and the decay rate is below the prescribed value. In order to illustrate the performance of the observer, a computer simulation is performed using the experimental data with the UDDS(urban dynamometer driving schedule) current profile.

• Journal of Electrical Engineering and Technology
• /
• v.11 no.6
• /
• pp.1664-1673
• /
• 2016

Lithium rechargeable cells are used in many industrial applications, because they have high energy density and high power density. For an effective use of these lithium cells, it is essential to build a reliable battery management system (BMS). Therefore, the state of charge (SOC) estimation is one of the most important techniques used in the BMS. An appropriate modeling of the battery characteristics and an accurate algorithm to correct the modeling errors in accordance with the simplified model are required for practical SOC estimation. In order to implement these issues, this approach presents the comparative analysis of the SOC estimation performance using equivalent electrical circuit modeling (EECM) and noise suppression technique (NST) in three representative $LiCoO_2/LiFePO_4/LiNiMnCoO_2$ cells extensively applied in electric vehicles (EVs), hybrid electric vehicles (HEVs) and energy storage system (ESS) applications. Depending on the difference between some EECMs according to the number of RC-ladders and NST, the SOC estimation performances based on the extended Kalman filter (EKF) algorithm are compared. Additionally, in order to increase the accuracy of the EECM of the $LiFePO_4$ cell, a minor loop trajectory for proper OCV parameterization is applied to the SOC estimation for the comparison of the performances among the compared to SOC estimation performance.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.64 no.4
• /
• pp.616-622
• /
• 2015

A microgrid which is composed of distributed generation systems, energy storage systems and loads is operated in the grid-connected mode and in the islanded mode. Especially, in the islanded mode, a microgrid should maintain frequency in the allowed range. The frequency is decided by a balance between power supply and power demand. In general, the frequency is controlled by using battery energy storage systems (BESSs) in the microgrid. Especially, droop control is applied to controlling BESSs in the microgrid. Meanwhile, over-charging and deep-discharging of BESS in operation and control cause life-shortening of batteries. In this paper, a fuzzy droop control is proposed to change droop gains adaptively by considering state of charge (SOC) of BESSs to improve the life cycle of the battery. The proposed fuzzy droop control adjusts droop gains based on SOC of BESSs in real time. In other to show the performance of the proposed fuzzy droop control, simulation based on Matlab/Simulink is performed. In addition, comparison of the convention droop control and the proposed fuzzy droop control is also performed.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.7
• /
• pp.1169-1175
• /
• 2016

As an Increased penetration level of renewable resources has caused concerns about primary frequency response, an increase in BESS(Battery Energy Storage System) capacity has been expected because of its fast response to the disturbances in the power system. This paper proposes the Integrated Control Strategy of multiple BESS for effectively providing the primary frequency control in the bulk power systems by coordinating the response, SOC and its recovery of BESS. The proposed strategy prevents multiple BESS from providing exceeding response and keeps the balance between SOC of multiple BESS. In addition, It would recover the SOC of BESS efficiently. The effectiveness of the proposed strategy is verified through various case studies employing Korean power system.

• Journal of ILASS-Korea
• /
• v.29 no.1
• /
• pp.1-6
• /
• 2024

This paper is a numerical analysis study for evaluating the energy efficiency of electric vehicles. Currently, the methods for testing and evaluating the energy consumption efficiency of electric vehicles have limitations such as resources and time. Therefore, there is a need for research on developing models to predict the energy consumption efficiency of electric vehicles. In this study, a numerical analysis research is conducted to predict the energy efficiency of electric vehicles using a vehicle dynamics numerical analysis model. To validate the accuracy of the simulation model, it is compared the results of dynamometer tests with the simulation results and used the Unified Diagnostic Services (UDS) protocol to acquire internal data from the electric vehicle. It is ensured the reliability of the simulation model by comparing data such as motor speed, battery voltage, current, state of charge (SOC), regenerative braking power generation, and total driving distance of the test vehicle with dynamometer test data and simulation model results.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.23 no.3
• /
• pp.174-181
• /
• 2018

This study introduces a systematic approach to selecting the internal parameters applied to the equivalent electrical-circuit model (EECM) of a lithium titanium oxide ($Li_4Ti_5O_{12}$; LTO) rechargeable cell. Based on the dynamic characteristic of the cell, a simplified EECM consisting of an open-circuit voltage (OCV), an ohmic resistance, and an RC ladder is fabricated. To select the internal parameters of a simplified EECM, experiments on discharge capacity, OCV, and discharge/charge resistances are performed using hybrid pulse power characterization and direct current internal resistance (DCIR) measurements over the full state-of-charge (SOC) range. The experimental results of the LTO rechargeable cell highlight the importance of correct selection of internal parameters that can reduce EECM errors. This study clearly provides experimental procedures, internal parameters results, and EECM guidelines for adaptive control-based SOC estimation for LTO rechargeable cells.

• Journal of ILASS-Korea
• /
• v.27 no.3
• /
• pp.155-160
• /
• 2022

Recently, major developed countries have strengthened automobile fuel efficiency regulations and carbon dioxide emission allowance standards to curb climate change caused by global warming worldwide. Accordingly, research and manufacturing on electric vehicles that do not emit pollutants during actual driving on the road are being conducted. Several automobile companies are producing and testing electric vehicles to commercialize them, but it takes a lot of manpower and time to test and evaluate mass-produced electric vehicles with driving mileage of more than 300km on a per-charge. Therefore, in order to reduce this, a simulation model was developed in this study. This study used vehicle information and MCT speed profile of small electric vehicle as basic data. It was developed by applying Simulink, which models the system in a block diagram method using MATLAB software. Based on the vehicle dynamics, the simulation model consisted of major components of electric vehicles such as motor, battery, wheel/tire, brake, and acceleration. Through the development model, the amount of change in battery SOC and the mileage during driving were calculated. For verification, battery SOC data and vehicle speed data were compared and analyzed using CAN communication during the chassis dynamometer test. In addition, the reliability of the simulation model was confirmed through an analysis of the correlation between the result data and the data acquired through CAN communication.